Analysis of Triphenyltin in Fish

A procedure to analyse triphenyltin and other organotins in fish tissues is described. The method consists of the following steps: homogenization of the fish, extraction by heating under reflux in a water/hexane mixture, centrifugation, separation of the hexane layer followed by reduction of the volume by evaporation, methylation of the organotin with a Grignard reaction, clean-up of the fish extract by column chromatography, and detection by gas chromatography with flame photometric detection. The extraction was carried out without adding acid or base to the aqueous phase, as the extraction efficiency was independent of pH. The methylation was successfully carried out in the fish extract. For clean-up of the fish extract a florisil column was used, from which the triphenylmethyltin was eluted with hexane. Using this method, triphenyltin has a recovery of 77 ± 10%, with a limit of detection of 0·8 ng/g for 0·1 g fish samples.     

On the use of poorly soluble hygroscopic substances for modification of warm clouds and fogs

From analysis of the relationships between the equilibrium state of condensation nuclei and the relative humidity, a conclusion is made concerning the preferred use of poorly soluble substances for the generation of artificial condensation nuclei (ACN) designed for modification of warm clouds and fogs with the purpose of their dissipation and precipitation formation. The advantage of poorly soluble substances over commonly used soluble salts is that the finely dispersed part of the spectrum of the poorly soluble ACN does not deliquesce and so is not involved in the formation of cloud droplets. For experimental testing of the conclusions, preference was given to cement, whose main soluble substance is calcium oxide with a solubility of about 1 g/l. The spectrum of dispersed cement particles was measured and compared with the spectra of pyrotechnic flares widely used for modification at present. The process of formation of the cloud droplet spectra was simulated in the aerosol chamber of the Institute of Experimental Meteorology by decreasing the preliminarily generated excess pressure. It was found in these experiments that, compared to the spectra of particles formed on background condensation nuclei, the introduction of dispersed cement leads to the broadening of spectra and to a decrease in the concentration of droplets. Even at the early stage of condensation, droplets with radii of ∼20 μm appear. In this case, no “overseeding” phenomenon is observed, which, for soluble substances, manifests itself in an increase in the concentration of cloud droplets with a large ACN concentration. These effects indicate that, according to the existing concepts about the mechanism of warm-cloud modification with hygroscopic substances, the introduction of poorly soluble ACN (in particular, dispersed cement) below the base of cumulus clouds should stimulate coagulation processes and accelerate rain-formation processes. Considerations are given that the introduction of poorly soluble ACN into the already existing cumulus or stratocumulus clouds or fogs should also result in the acceleration of precipitation-formation processes or cloud dispersal. Comparison of cement powder with the well-known means of warm-cloud and fog modification is carried out. Original Russian Text ? N.P. Romanov, A.S. Drofa, N.S. Kim, A.V. Savchenko, G.F. Yaskevich, 2006, published in Izvestiya AN. Fizika Atmosfery i Okeana, 2006, Vol. 42, No. 1, pp. 80–91.     

Robust Range-Only Beacon Localization

In this paper, we present a system capable of simultaneously estimating the position of an autonomous underwater vehicle (AUV) and the positions of stationary range-only beacons. Notably, our system does not require beacon positions a priori, and our system performs well even when range measurements are severely degraded by noise and outliers. We present a powerful outlier rejection method that can identify groups of range measurements that are consistent with each other, and a method for initializing beacon positions in an extended Kalman filter (EKF). We have successfully applied our algorithms to real-world data and have demonstrated a simultaneous localization and mapping (SLAM) system whose navigation performance is comparable to that of systems that assume known beacon locations     

Transient biouptake flux and accumulation by microorganisms: The case of two types of sites with Langmuir adsorption

The uptake of a chemical species by an aquatic microorganism is modelled considering two kinds of sites where Langmuirian adsorption is followed by first order internalisation kinetics. Simpler models, such as only one internalisation route (while most of the adsorption takes place on non-internalising sites) or a linear isotherm for adsorption on one or both sites, become limiting cases of this double-Langmuirian model. The model considers the sites located on the spherical (or semi-spherical) surface of the organism, and takes diffusion from the medium into explicit account. The numerical solution for the internalisation flux shows a maximum. We provide an estimate for the time needed to reach a certain proximity to steady state. The transient solution confirms that the analytical expressions for the steady-state flux are usually valid and that the accumulated amounts reflect the impact of the short-time uptake. The Instantaneous Steady-State Approximation (ISSA), where an intercept of the linear regression of accumulated amount as a function of time is interpreted as an adsorbed amount, can be critically assessed with the transient numerical code for two cases: (i) when the total burden of metal on the cell is the input data and (ii) when an extraction procedure provides further information on the adsorbed and internalised amount.     

A community-wide intercomparison exercise for the determination of dissolved iron in seawater

The first large-scale international intercomparison of analytical methods for the determination of dissolved iron in seawater was carried out between October 2000 and December 2002. The exercise was conducted as a rigorously “blind” comparison of 7 analytical techniques by 24 international laboratories. The comparison was based on a large volume (700 L), filtered surface seawater sample collected from the South Atlantic Ocean (the “IRONAGES” sample), which was acidified, mixed and bottled at sea. Two 1-L sample bottles were sent to each participant. Integrity and blindness were achieved by having the experiment designed and carried out by a small team, and overseen by an independent data manager. Storage, homogeneity and time-series stability experiments conducted over 2.5 years showed that inter-bottle variability of the IRONAGES sample was good (< 7%), although there was a decrease in iron concentration in the bottles over time (0.8–0.5 nM) before a stable value was observed. This raises questions over the suitability of sample acidification and storage.     

On non-causal impulse response functions related to propagating water waves

Particular attention is drawn to the non-causality of two impulse response functions, one of which relates the excitation force on an immersed body to the incident wave elevation at the body's reference position, while the other relates the incident wave elevations at two different positions along the line of wave propagation. An explanation is proposed for the non-causality of the impulse response functions, in spite of the fact wave propagation is a causal process. An indication is given of how far ‘upstream’ the incident wave elevation should be measured in order to be able to know, with reasonable accuracy, the current heave excitation force on a floating truncated cylinder with vertical axis, given current and past wave-elevation measurements. This provides a method for wave prediction, which is required for optimum control of the oscillation of the immersed body.