Diagenetic processes on metals in hypersaline mudflat sediments from a subtropical saltmarsh (SE Gulf of California): Postdepositional mobility and geochemical fractions

To understand the biogeochemical cycles of trace metals (Cd, Cu, Fe, Mn, Ni and Zn) in a hypersaline subtropical marsh, geochemical studies of both interstitial and solid phases were conducted on sediment cores from Chiricahueto marsh, SE Gulf of California. The sequential extraction procedure proposed by Tessier was used to estimate the percentages of the metals present in each geochemical phase of the sediment. Metal concentrations in the solid phase were found to be enriched in the upper layers and mainly associated with reactive fractions such as organic matter, Fe–Mn oxyhydroxides and carbonates (46–74% of Ni, Mn and Cd, and 11–19% of Cu and Zn). Principal factor analysis (PFA) and Spearman correlation analysis revealed a strong positive association of metals and their reactive phases with OC (the diagenetic component), and a negative or non-association with the mud content, Al, Fe and Li (the lithogenic component). Diagenetically released metals are mainly mobilized within hypersaline sediments by buoyancy transport (>90% of total flux) in response to an extreme salinity gradient by input of fresh groundwater (3–6 psu cm⁻¹). The molecular diffusion due to the gradient of metals in porewater (maximum and higher levels at 5–7 and below 20 cm depth, respectively) is significantly less important to the advective transport. Most of the metals mobilized by diffusion–advection processes are re-precipitated in the sediments by authigenic minerals, only <10% of most metals are extruded out to the overlying water column. Authigenic accumulation rates were estimated as 1.42–7.09 mg m⁻² a⁻¹ for Cd; 58.8–378 for Cu; 6922–17,985 for Fe; 38.2–345 for Mn; 20.8–263 for Ni; and 282–2956 mg m⁻² a⁻¹ for Zn. The Mn–Fe oxyhydroxides (40–85% of reactive metals) in the upper oxic–suboxic layers (<5 cm below surface) and sulfide minerals (75–97%) in anoxic sediment layers (7–18 cm) constitute the main scavengers for metals.     

Drought and institutional adaptation in the Great Plains of Alberta and Saskatchewan, 1914–1939

Agriculture in the southern Great Plains of Canada has been particularly vulnerable to prolonged episodes of drought. Using climate data and a precipitation minus potential evapotranspiration index, the extent of the region’s exposure to drought is examined. Between 1914 and 1917, the Dry Belt was particularly vulnerable to drought, whereas after 1928, a much larger region known as the Palliser Triangle covering most of southern Alberta and Saskatchewan was much more exposed to drought. These droughts provoked major institutional adaptation, in particular the establishment of the Special Areas Board by the Government of Alberta, and the creation of the Prairie Farm Rehabilitation Administration by the Government of Canada. Both organizations have proved to be relatively permanent public adaptations to the natural hazard of drought in the region. Moreover, these earlier experiences with prolonged drought as well as institution-building may be of value in helping the residents of the Palliser Triangle adapt to predicted climate changes in the future as well as anticipate some of the barriers to effective institutional adaptation.     

Modeling households’ decisions on reconstruction of houses damaged by earthquakes––Japanese case study

In this study, households’ decisions on reconstruction of damaged houses were modeled, using questionnaire data in Japan. Characteristics of households’ decisions were investigated using parameter estimation results. The effects of subsidizing policy were evaluated as follows. First, subsidy for rebuilding may be effective for the households whose houses were heavily damaged. Second, there is a possibility that subsidy accelerated rebuilding of houses by the households having children. Third, subsidy for rebuilding may not be effective for elderly people’s households and households in depopulated areas.     

Flood hazard delineation combining geomorphological and hydrological methods: an example in the Northern Iberian Peninsula

Flood mapping requires the combination and integration of geomorphological and hydrological-hydraulic methods; however, despite this, there is very little scientific literature that compares and validates both methods. Two types of analysis are addressed in the present article. On the one hand, maps of flood plains have been elaborated using geomorphological evidence and historical flood data in the mountainous area of northwestern Spain, covering an area of more then 232 km² of floodplains. On the other hand, a hydrometeorological model has been developed (Clark semidistributed unit hydrograph) in the Sarria River basin (155 km², NW Spain). This basin is not gauged, hence the model was subjected to a goodness-of-fit test of its parameter (curve number) by means of Monte Carlo simulation. The peak flows obtained by means of the hydrological model were used for hydraulic modeling (one-phase, one-dimensional and steady flow) in a 4 km² urban stretch of the river bed. The delineation of surface areas affected by floods since 1918, as well as those analyzed subsequent to the geomorphological study, reveals a high degree of reliability in the delineation of the flooded areas with frequent recurrence intervals (<50 years). If we compare these flooded surface areas with the estimate obtained by the hydrological-hydraulic method we can see that the latter method overestimates the extent of the surface water by 144% for very frequent recurrence intervals (>10 years) and underestimates it as the recurrence interval increases, by up to 80% less floodplain for exceptional events (>500 years). Finally, a management map is put forth combining the most reliable results available by integrating both methods. Originally presented at the Sixth International Conference on Geomorphology.     

Impact of lightning on organic matter-rich soils: influence of soil grain size and organic matter content on underground fires

A detailed study was carried out on a piece of land that had been struck by lightning during the violent rainstorm that raged over the Island of S?o Miguel (Azores Archipelago) in late October 2006. Temperature and gas measurements (CO₂, CO, H₂S and CH₄) were performed in four study trenches, dug in an area of ∼3 m², where an underground fire had been initiated by the impact with a lightning stroke, followed by the emission of a column of gases and smoke. The soil under study was originally a well-pedogenized about 80 cm thick bed, made of volcanic clayey to silty tephra fallouts and contained 5.5–9.7% of organic matter. The underground fire was monitored for one week and revealed a peak release of 404 ppm CO and 3.4% CO₂ originating from a horizon located about 45 cm under the soil surface. Measurements of temperature, performed one week after the impact, indicated a maximum value of 326°C inside the soil, while 516.5°C were measured on the surface of a lava block interred about 20 cm under the surface. Subsequently, a stratigraphic and sedimentologic study proved the role of the grain-size of the soil and of the organic matter content of the different horizons of the impact area, in determining the ratio between anoxic/oxidised combustion conditions and in the progress of the process itself. It was also noticed that combustion was not total all over in the soil bed and that the process had slightly migrated toward SW during the observation period. The combustion process went on for about ten days, in spite of several other violent rainstorms, until it was artificially extinguished through the excavations made to obtain study trenches. This particular circumstance evidenced the potential natural hazard represented by this kind of atmospheric event, especially in a land where the volcanic nature of the soil may easily mislead inexperienced observers and, consequently, delay proper action.     

Rain-induced debris and mudflow triggering factors assessment in the Santiago cordilleran foothills,Central Chile

Debris and mudflows are some of the main geological hazards in the mountain foothills of the Chilean capital city of Santiago. There, the risk of flows triggered in the basins of ravines that drain the range into the city increases with time due to the city growth. A multivariate statistical study based on the logistic regression method is presented. The model provides equations that allow the computation of combined meteorological triggering factors associated with a probability of rain-induced flow occurrence. Daily rainfall, accumulated rainfall and the snowfall level, traditionally considered as the relevant factors, are analysed for a 25-year period. The results show a strong relevance of the rainfall on the day of the flow event over the other factors. However, the relatively low probabilities returned for some real flow events suggest that the model does not capture all the significant variables and the problem is more complex than as it has been traditionally assumed, and further investigations are needed to develop predictive models of flow triggering.     

Room-temperature equation of state of Li<Subscript>2</Subscript>VOSiO<Subscript>4</Subscript> up to 8.5 GPa

High-pressure single-crystal X-ray diffraction measurements of lattice parameters of the compound Li₂VOSiO₄, which crystallises with a natisite-type structure, has been carried out to a pressure of 8.54(5) GPa at room temperature. Unit-cell volume data were fitted with a second-order Birch-Murnaghan EoS (BM-EoS), simultaneously refining V ₀ and K ₀ using the data weighted by the uncertainties in V. The bulk modulus is K ₀ = 99(1) GPa, with K′ fixed to 4. Refinements of third order equations-of-state yielded values of K′ that did not differ significantly from 4. The compressibility of the unit-cell is strongly anisotropic with the c axis (K ₀(c) = 49.7 ± 0.5 GPa) approximately four times more compressible than the a axis (K ₀(a) = 195 ± 3 GPa).     

The effects of gas flaring on crops in the Niger Delta,Nigeria

Flaring of associated gas from oil exploitation has several consequences on the environment. This study explores the spatial variability effects of gas flaring on the growth and development of cassava (Manihot esculenta), waterleaf (Talinum triangulare), and pepper (Piper spp.) crops commonly cultivated in the Niger Delta, Nigeria. Data was collected on soil and atmospheric temperature and moisture at a 20-m interval, starting at 40 m from the flare point to a distance of 140 m. Lengths and widths of crop leaves, height of crop plants and cassava yields were measured at the specified distances. The amino acid, ascorbic acid, starch, and sugar constituents of the cassava yields were determined. The results suggest that a spatial gradient exists in the effects of gas flares on crop development. Retardation in crop development manifests in decreased dimensions of leaf lengths and widths of cassava and pepper crops closer to the gas flare point. Statistical analysis also confirms that cassava yields are higher at locations further away from the flare point. In addition, the amount of starch and ascorbic acid in cassava decreased when the plant is grown closer to the gas flare. High temperatures around the gas flare appear to be the most likely cause of this retardation. The waterleaf crop, on the other hand, appears to thrive better around the gas flare point.     

Stability at high-pressure,elastic behaviour and pressure-induced structural evolution of CsAlSi<Subscript>5</Subscript>O<Subscript>12</Subscript>, a potential host for nuclear waste

The elastic and structural behaviour of the synthetic zeolite CsAlSi₅O₁₂ (a = 16.753(4), b = 13.797(3) and c = 5.0235(17) Å, space group Ama2, Z = 2) were investigated up to 8.5 GPa by in situ single-crystal X-ray diffraction with a diamond anvil cell under hydrostatic conditions. No phase-transition occurs within the P-range investigated. Fitting the volume data with a third-order Birch–Murnaghan equation-of-state gives: V ₀ = 1,155(4) ų, K _T0 = 20(1) GPa and K′ = 6.5(7). The “axial moduli” were calculated with a third-order “linearized” BM-EoS, substituting the cube of the individual lattice parameter (a ³, b ³, c ³) for the volume. The refined axial-EoS parameters are: a ₀ = 16.701(44) Å, K _T0a = 14(2) GPa (β_a = 0.024(3) GPa^?1), K′ _a = 6.2(8) for the a-axis; b ₀ = 13.778(20) Å, K _T0b = 21(3) GPa (β_b = 0.016(2) GPa^?1), K′ _b = 10(2) for the b-axis; c ₀ = 5.018(7) Å, K _T0c = 33(3) GPa (β_c = 0.010(1) GPa^?1), K′ _c = 3.2(8) for the c-axis (K _T0a:K _T0b:K _T0c = 1:1.50:2.36). The HP-crystal structure evolution was studied on the basis of several structural refinements at different pressures: 0.0001 GPa (with crystal in DAC without any pressure medium), 1.58(3), 1.75(4), 1.94(6), 3.25(4), 4.69(5), 7.36(6), 8.45(5) and 0.0001 GPa (after decompression). The main deformation mechanisms at high-pressure are basically driven by tetrahedral tilting, the tetrahedra behaving as rigid-units. A change in the compressional mechanisms was observed at P ≤ 2 GPa. The P-induced structural rearrangement up to 8.5 GPa is completely reversible. The high thermo-elastic stability of CsAlSi₅O_12, the immobility of Cs at HT/HP-conditions, the preservation of crystallinity at least up to 8.5 GPa and 1,000°C in elastic regime and the extremely low leaching rate of Cs from CsAlSi₅O₁₂ allow to consider this open-framework silicate as functional material potentially usable for fixation and deposition of Cs radioisotopes.