Chemical and structural study of 1M- and 2M 1-phlogopites coexisting in the same Kasenyi kamafugitic rock (SW Uganda)

In the present work, crystal chemical variations between 1M and 2M ₁ phlogopites coexisting in the same rock sample from kamafugite of Kasenyi (southwest Uganda, west branch of the East African Rift) were explored by electron probe microanalyses, single crystal X-ray diffraction and M?ssbauer spectroscopy. Chemical analyses revealed close similarity both within and between the two polytypic arrangements as well as high TiO₂ (~4.9?wt%) and Al₂O₃ (~12.9?wt%), and low Cr₂O₃ (~0.8?wt%), F (~0.3?wt%) and BaO (~0.2?wt%) contents. Room temperature ⁵⁷Fe M?ssbauer investigation proved that the studied mica is a tetraferriphlogopite with: ^IVFe³⁺?=?19(1)?%, ^VIFe²⁺?=?58(1)?%, ^VIFe³⁺?=?23(1)?%. Single crystal refinement showed that both polytypes have narrow range of variation in terms of some relevant unit cell parameters and similar values in terms of mean bond lengths, mean atomic numbers and distortion parameters. Similar substitutions were active in the structure of the 1M and 2M ₁ studied phlogopites. However, in 2M ₁ polytypes the oxy-type substitutions were found to occur to a greater extent. Comparison of unit layer of 1M mica (in the 2M ₁ setting) with that of the 2M ₁ ones showed that the 2M ₁ polytypes are affected to different extent by relative shifts of the upper and lower triads of octahedral oxygens along the ±b directions. This effect did not cause any symmetry lowering in the T-O-T layer of the studied samples.     

Stratigraphic evolution of the nearshore to fluvial plain of the Upper Cuyo Group,Neuquén,Argentina

The upper portion of the Cuyo Group in the Zapala region, south‐eastern Neuquén Basin (Western Argentina), encompasses marine and transitional deposits (Lajas Formation) overlain by alluvial rocks (Challacó Formation). The Challacó Formation is covered by the Mendoza Group above a second‐order sequence boundary. The present study presents the stratigraphic framework and palaeophysiographic evolution of this Bajocian to Eo‐Calovian interval. The studied succession comprises the following genetic facies associations: (i) offshore and lower shoreface–offshore transition; (ii) lower shoreface; (iii) upper shoreface; iv) intertidal–subtidal; (v) supratidal–intertidal; (vi) braided fluvial to delta plain; (vii) meandering river; and (viii) braided river. The stratigraphic framework embraces four third‐order depositional sequences (C1 to C4) whose boundaries are characterized by the abrupt superposition of proximal over distal facies associations. Sequences C1 to C3 comprise mostly littoral deposits and display well‐defined, small‐scale transgressive–regressive cycles associated with fourth‐order depositional sequences. Such high‐frequency cycles are usually bounded by ravinement surfaces associated with transgressive lags. At last, the depositional sequence C4 delineates an important tectonic reorganization probably associated with an uplift of the Huincul Ridge. This is suggested by an inversion of the transport trend, north‐westward during the deposition of C1 to C3 depositional sequences (Lajas Formation) to a south‐west trend during the deposition of the braided fluvial strata related to the C4 depositional sequence (Challacó Formation).     

Stratigraphic evolution of a fluvial–eolian succession: The example of the Upper Jurassic—Lower Cretaceous Guará and Botucatu formations, Paraná Basin, Southernmost Brazil

The Guará and Botucatu formations comprise an 80 to 120 m thick continental succession that crops out on the western portion of the Rio Grande do Sul State (Southernmost Brazil). The Guará Formation (Upper Jurassic) displays a well-defined facies shift along its outcrop belt. On its northern portion it is characterised by coarse-grained to conglomeratic sandstones with trough and planar cross-bedding, as well as low-angle lamination, which are interpreted to represent braided river deposits. Southwards these fluvial facies thin out and interfinger with fine- to medium-grained sandstones with large-scale cross-stratification and horizontal lamination, interpreted as eolian dune and eolian sand sheets deposits, respectively. The Botucatu Formation is characterised by large-scale cross-strata formed by successive climbing of eolian dunes, without interdune and/or fluvial accumulation (dry eolian system). The contact between the Guará and the Botucatu formations is delineated by a basin-wide deflation surface (supersurface). The abrupt change in the depositional conditions that took place across this supersurface suggests a major climate change, from semi-arid (Upper Jurassic) to hyper-arid (Lower Cretaceous) conditions. A rearrangement of the Paraná Basin depocenters is contemporaneous to this climate change, which seems to have changed from a more restrict accumulation area in the Guará Formation to a wider sedimentary context in the Botucatu Formation.     

Decoupled seismic analysis of an earth dam

The seismic stability of an earth dam is evaluated via the decoupled displacement analysis using the accelerograms obtained by ground response analysis to compute the earthquake-induced displacements. The response analysis of the dam is carried out under both 1D and 2D conditions, incorporating the non-linear soil behaviour through the equivalent linear method. Ten artificial and five real accelerograms were used as input motions and four different depths were assumed for the bedrock.1D and 2D response analyses were in a fair agreement with the exception of the top third of the dam where only a 2D modelling of the problem could ensure that the acceleration field is properly described. The acceleration amplification ratio obtained in the 2D analyses was equal to about 2 in all the cases considered, consistently with data from real case histories.The maximum permanent displacements computed by the sliding block analysis were small, being less than 10% of the service freeboard; a satisfactory performance of the dam can then be envisaged for any of the seismic scenarios considered in the analyses.     

Contamination source detection in water distribution networks using belief propagation

Stochastic Environmental Research and Risk Assessment - We present a Bayesian approach for the Contamination Source Detection problem in water distribution networks. Assuming that contamination is...     

Ostreopsis cf. ovata bloom in the northern Adriatic Sea during summer 2009: ecology, molecular characterization and toxin profile

Intense blooms of the benthic dinoflagellate Ostreopsis cf. ovata have occurred in the northern Adriatic Sea since 2006. These blooms are associated with noxious effects on human health and with the mortality of benthic organisms because of the production of palytoxin-like compounds. The O. cf. ovata bloom and its relationships with nutrient concentrations at two stations on the Conero Riviera (northern Adriatic Sea) were investigated in the summer of 2009. O. cf. ovata developed from August to November, with the highest abundances in September (1.3 × 10⁶ cells g⁻¹ fw corresponding to 63.8 × 10³ cells cm⁻²). The presence of the single O. cf. ovata genotype was confirmed by a PCR assay. Bloom developed when the seawater temperature was decreasing. Nutrient concentrations did not seem to affect bloom dynamics. Toxin analysis performed by high resolution liquid chromatography-mass spectrometry revealed a high total toxin content (up to 75 pg cell⁻¹), including putative palytoxin and all the ovatoxins known so far.     

Wavefield Migration plus Monte Carlo Imaging of 3D Prestack Seismic Data

Prestack wave‐equation migration has proved to be a very accurate shot‐by‐shot imaging tool. However, 3D imaging with this technique of a large field acquisition, especially one with hundreds of thousands of shots, is prohibitively costly. Simply adapting the technique to migrate many superposed shot‐gathers simultaneously would render 3D wavefield prestack migration cost‐effective but it introduces uncontrolled non‐physical interference among the shot‐gathers, making the final image useless. However, it has been observed that multishot signal interference can be kept under some control by averaging over many such images, if each multishot migration is modified by a random phase encoding of the frequency spectra of the seismic traces. In this article, we analyse this technique, giving a theoretical basis for its observed behaviour: that the error of the image produced by averaging over M phase encoded migrations decreases as M^?1 . Furthermore, we expand the technique and define a general class of Monte‐Carlo encoding methods for which the noise variance of the average imaging condition decreases as M^?1 ; these methods thus all converge asymptotically to the correct reflectivity map, without generating prohibitive costs. The theoretical asymptotic behaviour is illustrated for three such methods on a 2D test case. Numerical verification in 3D is then presented for one such method implemented with a 3D PSPI extrapolation kernel for two test cases: the SEG–EAGE salt model and a real test constructed from field data.     

Improving Scatterometry Retrievals of Wind in Hurricanes Using Non-Simultaneous Passive Microwave Estimates of Precipitation and a Split-Step Advection/Convection Model

One of the current problems in the accurate estimation of over-ocean wind from scatterometry observations is the proper accounting for precipitation. Specific cases such as hurricanes are particularly difficult, because precipitation in the eye wall and rain bands can be quite heavy, and therefore, affect the scatterometer signatures so drastically that a category-4 hurricane can appear, to the scatterometer, to have category-1 winds. We have developed an approach to infer and account for the signature of the precipitation from non-simultaneous passive-microwave measurements of rain, with the help of geostationary IR measurements. In this note, we describe the basic approach, and the results of applying it to the data taken by the Tropical Rainfall Measurement Mission Microwave Imager measurements several hours before and after the QuikSCAT observation of Hurricane Rita in September 2005. We also describe how we are enhancing the approach with more realism in the assimilation of the IR information.     

Mouvements voisins de collision quadruple dans le probleme trapezoidal des 4 corps

Celestial Mechanics and Dynamical Astronomy - On reprend ici l'étude du problème trapezoïdal des 4 corps, qui a été commencée par l'auteur dans [2]. En...     

Optimal instrumentation of uncertain structural systems subject to earthquake ground motions

A criterion is proposed for making decisions regarding the optimal location of a given number of sensors to record the seismic response of a structure for identification purposes. The optimal location of the sensors is selected so that the expected value of a Bayesian loss function, expressed in terms of the Fisher information in the recordings, is minimized. The criterion is applied to the case of multi-degree-of-freedom systems with uncertain structural properties subjected to earthquake ground motions modelled as stationary stochastic processes. The use and capabilities of the criterion are thoroughly illustrated by means of an example. Results are used to assess the influence of record duration, recording noise, and ground motion frequency content and amplitude, on the optimal location of accelerometers as well as on the reduction of prior uncertainty about the structural parameters. © 1998 John Wiley & Sons, Ltd.