Fracture energy release and size effect in borehole breakout

The paper presents a simple approximate analytical solution of the remote stresses that cause the collapse of a borehole or other circular cylindrical cavity in an infinite elastic space. Regions of parallel equidistant splitting cracks are assumed to form on the sides of the cavity. Their boundary is assumed to be an ellipse of a growing horizontal axis, the other axis remaining equal to the borehole diameter. The slabs of rock between the splitting cracks are assumed to buckle as slender columns, and their post-critical stress is considered as the residual stress in the cracked rock. The buckling of these slab columns is assumed to be resisted not only by their elastic bending stiffness but also shear stresses produced on rough crack faces by relative shear displacements. The energy release from the infinite medium caused by the growth of the elliptical cracking region is evaluated according to Eschelby's theorem. This release is set equal to the energy dissipated by the formation of all the splitting cracks, which is calculated under the assumption of constant fracture energy. This yields the collapse stress as a function of the elastic moduli, fracture energy, ratio of the remote principal stresses, crack shear resistance characteristic and borehole diameter. The collapse stress as a function of crack spacing is found to have a minimum, and the correct crack spacing is determined from this minimum. For small enough diameters, the crack spacing increases as the (4/5)-power of the borehole diameter, while for large enough diameters a constant spacing is approached. In contrast to plastic solutions, the breakout stress exhibits a size effect, such that for small enough diameters the breakout stress decreases as the (? 2/5)-power of the borehole diameter, while for large enough diameters a constant limiting value is approached. Finally, some numerical estimates are given and the validity of various simplifying assumptions made is discussed.     

Estimation of the sub-iron-iron flux ratio in cosmic rays over alice springs using a balloon flight experiment with a CR-39 detector

The sub-iron-iron flux ratio in cosmic rays at an atmospheric depth of 9.8 g cm^–2 has been estimated using a balloon-borne CR-39 (HCB) stack launched from Alice Springs for 32 hours. The recovered and chemically etched plates were analysed optically and the measured etch pit diameters yielded the sub-iron-iron flux ratio at the flight altitude. The sub-iron-iron flux ratio has been corrected for the top of the atmosphere by considering the loss of heavy ions due to nuclear interaction and fragmentation. The present result has been compared with the result expected from the source composition derived by Protheroeet al. as well as other authors.     

The estimation of the shape of an array using a hidden Markov model

A hidden Markov model (HMM) technique for the estimation of the shape of a towed array is presented. It is assumed that there is a far-field source radiating sound containing possibly weak spectral lines. The technique uses either the Fourier coefficients at a given frequency computed from a single time block or the maximal eigenvector of a sample spectral covariance matrix. The technique is illustrated using several simulations. The results of these simulations indicate that the HMM technique yields shape and bearing estimates more accurate than those provided by a maximum-likelihood array shape estimation technique     

Shakedown in layered pavements under moving surface loads

Elastic–plastic deformations in pavements consisting of layers of different frictional materials are investigated. The upper bound, kinematic shakedown theorem is used to obtain estimates of the critical shakedown loads. Fully general three-dimensional deformations are considered. The influence of the loading distribution, interactions between loads, and the effect of varying the thickness, stiffness and strength of the layers are explored. Consequences of this investigation for particular existing designs of flexible pavements are investigated. In particular, it is found that the strength of the subgrade has no effect on the magnitude of the critical shakedown load.     

Upscaling of elastic properties for large scale geomechanical simulations

Large scale geomechanical simulations are being increasingly used to model the compaction of stress dependent reservoirs, predict the long term integrity of under‐ground radioactive waste disposals, and analyse the viability of hot‐dry rock geothermal sites. These large scale simulations require the definition of homogenous mechanical properties for each geomechanical cell whereas the rock properties are expected to vary at a smaller scale. Therefore, this paper proposes a new methodology that makes possible to define the equivalent mechanical properties of the geomechanical cells using the fine scale information given in the geological model. This methodology is implemented on a synthetic reservoir case and two upscaling procedures providing the effective elastic properties of the Hooke's law are tested. The first upscaling procedure is an analytical method for perfectly stratified rock mass, whereas the second procedure computes lower and upper bounds of the equivalent properties with no assumption on the small scale heterogeneity distribution. Both procedures are applied to one geomechanical cell extracted from the reservoir structure. The results show that the analytical and numerical upscaling procedures provide accurate estimations of the effective parameters. Furthermore, a large scale simulation using the homogenized properties of each geomechanical cell calculated with the analytical method demonstrates that the overall behaviour of the reservoir structure is well reproduced for two different loading cases. Copyright © 2004 John Wiley & Sons, Ltd.     

Preliminary organic petrography of Palaeozoic rocks from the Grand Banks,Newfoundland

Samples of lower Palaeozoic bedrock from the Grand Banks of Newfoundland were examined using reflected light microscopy and Rock-Eval pyrolysis. These samples contained organic material which included bitumen (structureless organic material), acritarchs, chitinozoa, scolecodonts and graptolites. The reflectance of the organic material increased from acritarchs towards graptolites with bitumen showing a wide range of reflectance. Multiple phases of oil migration through one sample were inferred by examination of the bitumens: the lowest reflecting being more recent than the highest reflecting bitumen. Combined reflectance and Rock-Eval analysis indicate that these samples are mature to overmature. The two oldest samples (Arenig-Llanvirn, Ordovician) are assessed as mature and as having potential for generation of liquid hydrocarbons, but must be considered as mainly gas prone.     

The middle pleistocene deposits of Waverley Wood Pit,Warwickshire, England

A complex of channels underlying the Baginton-Lillington Gravel (Baginton Formation) at Waverley Wood Quarry, Warwickshire is described. Fossil pollen and plant macrofossils, Coleoptera, Ostracoda, Mollusca and Mammalia are described from the channel-fill deposits. Consideration of all the evidence allows the identification of four separate stages of channel fill which largely occurred under a cool temperate climate. At the top of Channel 2 evidence for a cold, continental climatic episode can be recognised, suggesting that the whole complex was deposited under a fluctuating climate at the end of a temperate stage. At two levels in the channels human artefacts were recovered confirming the presence of Palaeolithic people in Warwickshire during the deposition of the sediments. Amino-acid geochronology suggests an age within the ‘Cromerian Complex’ Stage for the channels. The small vertebrate and molluscan faunas indicate that the deposits are no older than the latter part of the ‘Cromerian Complex’ Stage of East Anglia. The regional stratigraphic significance of the Waverley Wood succession is outlined.     

Contribution of storms to groundwater recharge in the semi‐arid region of Karnataka,India

This paper describes the application of environmental isotopes and injected tracer techniques in estimating the contribution of storms as well as annual precipitation to groundwater recharge and its circulation, in the semi‐arid region of Bagepalli, Kolar district, Karnataka. Environmental isotopes ²H, ¹⁸O and ³H were used to study the effect of storms on the hydrological system, and an isotope balance was used to compute the contribution of a storm component to the groundwater. Some of the groundwater samples collected during the post‐storm periods were highly depleted in stable isotope content with higher deuterium excess relative to groundwater from the pre‐storm periods. Significant variation in deuterium excess in groundwater from the same area, collected in two different periods, indicates the different origin of air masses. The estimated recharge component of a storm event of 600 mm to the groundwater was found to be in the range of 117–165 mm. There was no significant variation in environmental tritium content of post‐storm and pre‐storm groundwater, indicating the fast circulation of groundwater in the system. After completion of the environmental isotope work, an injected radiotracer ³H technique was applied to estimate the direct recharge of total precipitation to the groundwater. The estimated recharge to the groundwater is 33 mm of the 550 mm annual precipitation during 1992. Copyright © 2003 John Wiley & Sons, Ltd.     

Magnetic Field Geometry in `Red' and `Blue' BL Lacs

We compare the systematics of the magnetic field geometry in the `red' low-energy peaked BL Lacs (LBLs) and `blue' high-energy peaked BL Lacs (HBLs) using VLBI polarimetric images. The LBLs are primarily `radio-selected' BL Lacs and the HBLs are primarily `X-ray selected'. In contrast to the LBLs, which show predominantly transverse jet magnetic fields, the HBLs show predominantly longitudinal fields. Thus, while the SED peaks of core-dominated quasars, LBLs and HBLs form a sequence of increasing frequency, the magnetic field geometry does not follow an analogous sequence. We briefly investigate possible connections between the observed parsec-scale magnetic field structures and circular polarization measurements in the literature on various spatial scales.