Peculiar earthquake damage on a reinforced concrete building in San Gregorio (L��Aquila, Italy): site effects or building defects?

In San Gregorio (L’Aquila, Italy) a three-story, reinforced concrete (RC) building had the first floor collapsed following the earthquake of April 6, 2009. The remaining two stories fell with a displacement in the horizontal projection of about 70 cm. This unusual behaviour is made more puzzling by the fact that buildings located at a short distance and with similar features had little or no damage reported. To understand the causes of the collapse we performed strong motion recordings, microtremor measurements, a detailed geological survey, a high-resolution geo-electrical tomography, a borehole with a down-hole test. On the building we performed a geometrical survey and laboratory tests on concrete cores. The acceleration and noise recordings have shown a high amplification with uphill-downhill direction. The geological survey has revealed the presence of co-seismic fractures on stiff soils. Geo-electrical tomography has shown an unexpected, strong discontinuity just below the building. Taking advantage of excavations in adjacent lots, we have highlighted rare cataclastic decimetric bands with a very low resistance material incorporated in well-stratified calcarenites. The same soft material has been founded in the borehole down to 17 m from ground level, showing a shear wave velocity that starts at 250 m/s, increases with depth and has an abrupt transition in calcarenites at 1,150 m/s. The surface geophysical measurements in the vicinity of the site have not shown similar situations, with flat HVSR curves as expected for a rock outcrop, except for a lateral extension of the soft zone. The analysis on the quality of the building materials has yielded values higher than average for the age and type of construction, and no special design or construction deficiencies have been observed. A strong, peculiar site effect thus appears to be the most likely cause of the damage observed.     

Discussion 2 on "Introspection on improper seismic retrofit of Basilica Santa Maria di Collemaggio after 2009 Italian earthquake" by G.P.Cimellaro,A.M.Reinhorn and A.De Stefano

This discussion will address two aspects found in the paper:lack of proper information and some mistakes. Lack of proper information In Section 2 of the paper,a short review of the seismic events suffered by the Basilica and of the interventions of reconstruction which have followcd is presented,but the main effects of these events are not sufficiently highlightcd.In what follows,additional information is provided to allow a better understanding of the most recent retrofit intervention and of the seismic behavior of the Basilica in 2009.     

Generation of complete theoretical seismograms for SH-III

Summary. Earlier efforts to generate the entire theoretical seismograms, including both body and surface waves for realistic sources buried in a radially heterogeneous anelastic, spherical earth, are extended to include the summation of 16 modes. The comparison between a real seismogram and theoretical time series, relative to different attenuation models in the upper mantle, yields information concerning the anelasticity under the Pacific Ocean.     

Capacity models for shear strength of exterior joints in RC frames: experimental assessment and recalibration

Several theoretical models are currently available in the scientific literature for evaluating the shear capacity of both exterior and interior beam-to-column joints in reinforced concrete (RC) frames. A reasonably wide set of those models, based on either analytical or empirical formulations, has been summarised within a companion work. The present paper firstly presents a wide database which collects results obtained in about two-hundred experimental tests carried out on RC joints. Those results are employed for assessing the above mentioned capacity models by considering a set of experimental data much wider than those usually utilised in the original formulation of such models. Accuracy and reliability of the various models are measured by quantifying some statistical parameters actually describing the relationship between the experimental evidence and the prediction of the various capacity models under consideration. Three relevant classes of joints (namely unreinforced, under reinforced and code-compliant) are considered with the aim of emphasising that the various models perform in a rather different way when applied to those different classes. Finally, a possible recalibration of the various models is proposed with the objective of enhancing their predictive capacity with respect to both the database as a whole and the three classes of RC joints mentioned above.     

Laboratory measurements of super-resolving Toraldo pupils for radio astronomical applications

The concept of super-resolution refers to various methods for improving the angular resolution of an optical imaging system beyond the classical diffraction limit. Although several techniques to narrow the central lobe of the illumination Point Spread Function have been developed in optical microscopy, most of these methods cannot be implemented on astronomical telescopes. A possible exception is represented by the variable transmittance filters, also known as “Toraldo Pupils” (TPs) since they were introduced for the first time by G. Toraldo di Francia in 1952 (Toraldo di Francia, Il Nuovo Cimento (Suppl.) 9, 426, 1952). In the microwave range, the first successful laboratory test of TPs was performed in 2003 (Mugnai et al. Phys. Lett. A 311, 77–81, 2003). These first results suggested that TPs could represent a viable approach to achieve super-resolution in Radio Astronomy. We have therefore started a project devoted to a more exhaustive analysis of TPs, in order to assess their potential usefulness to achieve super-resolution on a radio telescope, as well as to determine their drawbacks. In the present work we report on the results of extensive microwave measurements, using TPs with different geometrical shapes, which confirm the correctness of the first experiments in 2003. We have also extended the original investigation to carry out full-wave electromagnetic numerical simulations and also to perform planar scanning of the near-field and transform the results into the far-field.     

On the interpretation of slow ground deformation precursory to the 1976 Friuli earthquake

During three years preceding the 1976 Friuli earthquake, a continuous southward ground tilt was recorded by a tiltmeter placed near Tolmezzo, 15 km north-west of the epicentre of the impending earthquake. The cumulative ground tilt amounted to as much as 3 minutes of arc. Since the tiltmeter was placed in the proximity of an active fault, such a tilt can be explained if the fault slipped aseismically on its shallower section during the same three year period. Aseismic slip on the fault might have been caused by the same mechanism which concentrated stress in the region and eventually produced the 1976 earthquake.     

Magnetic features of the magmatic intrusion that occurred in the 2007 eruption at Stromboli Island (Italy)

Significant changes in the local magnetic field marked the resumption of eruptive activity at Stromboli volcano on February 27, 2007. After differential magnetic fields were obtained by filtering out external noise using adaptive filters and seasonal thermal noise using temperature data, we identified step-like changes of 1–4 nT coincident with the opening of eruptive fissures in the upper part of the Sciara del Fuoco. The magnetic variations detected at two stations are closely related to the propagation of a shallow NE–SW magmatic intrusion extending beyond the summit craters area. These observations are consistent with those calculated using piezomagnetic models in which stress-induced changes in rock magnetization are produced by the magmatic intrusion. No significant magnetic changes were observed when the first fractures opened along the NE crater rim. Indeed, the stress-induced magnetization caused by this magmatic activity is expected to be too low because of the structural weakness and/or thermal state of the summit area. The continuous long-term decay characterizing the post-eruptive magnetic pattern can be related to a time-dependent relaxation process. A Maxwell rheology was assumed and the temporal evolution of the piezomagnetic field was evaluated. This allowed us to estimate the rheological properties of the medium; in particular, an average viscosity ranging between 10¹⁶ and 10¹⁷ Pa⋅s was a relaxation time τ of about 38 days.     

Downslope flow models of a Bingham liquid: Implications for lava flows

It is widely recognized that lavas behave as Bingham liquids, which are characterized by a yield stress σ and a plastic viscosity η. We consider two models describing downslope flows of a Bingham liquid with different aspect ratios A (= flow height/flow width): model 1 with A 1 and model 2 with A ≈ 1. Sufficiently uphill with respect to the front, such flows can be considered as laminar and locally isothermal. For both models, we obtain analytically the steady-state solution of the Navier-Stokes equations and the constitutive equation for a Bingham liquid. We study the flow height and velocity as functions of flow rate, rheological parameters and ground slope. It is found that such flows remain in the Newtonian regime at low yield stresses (σ 10³dyne/cm²), but the transition to the Bingham regime also depends on flow rate and occurs at higher values of σ for higher flow rates: for instance, a high aspect ratio flow (model 2) is still very close to the Newtonian regime at σ = 10⁴ dyne/cm², if the flow rate is greater than 10⁵ g/s. In the Bingham regime, flow heights are generally greater and flow velocities are smaller than in the Newtonian regime; moreover, flow heights are independent of flow rate, so that a change in flow rate results exclusively in a velocity change. After assuming a specific temperature dependence of σ and η between the solidus and the liquidus temperatures of an ideal Bingham liquid (1000°C and 1200 °C respectively), flow heights and velocities are examined as functions of temperature along the flow. Several effects observed in lava flows are predicted by these models and allow a more quantitative insight into the behaviour of lava flows.     

Comparison of the ENEAR peculiar velocities with the PSCz gravity field

We present a comparison between the peculiar velocity field measured from the ENEAR all-sky D _n– σ catalogue and that derived from the galaxy distribution of the IRAS Point Source Catalog Redshift Survey (PSC z ). The analysis is based on a modal expansion of these data in redshift space by means of spherical harmonics and Bessel functions. The effective smoothing scale of the expansion is almost linear with redshift reaching 1500 km s⁻¹ at 3000 km s⁻¹. The general flow patterns in the filtered ENEAR and PSC z velocity fields agree well within 6000 km s⁻¹, assuming a linear biasing relation between the mass and the PSC z galaxies. The comparison allows us to determine the parameter     where Ω is the cosmological density parameter and b is the linear biasing factor. A likelihood analysis of the ENEAR and PSC z modes yields     in good agreement with values obtained from Tully–Fisher surveys.