Microbiological response to well pumping

To better constrain sampling strategies for observing biologically sensitive parameters in ground water, we vigorously pumped for 120 h a lightly pumped well completed in a confined glacial aquifer while observing how various physical and chemical parameters evolve in the water produced. The parameters commonly monitored when sampling a well stabilized within about an hour, after 5 wellbore volumes were produced; these parameters include temperature, pH, dissolved oxygen, oxidation-reduction potential (Eh), and electrical conductivity. The concentrations of ferrous iron, sulfide, and sulfate and various biological or biologically sensitive parameters, including the concentrations of dissolved hydrogen and methane, direct cell counts, and the microbial community profile, in contrast, required more than 8 h or 36 well volumes to stabilize. We interpret this result to mean that the zone of influence of the wellbore on biologic processes in the aquifer extends beyond the commonly recognized zone where physical properties are affected. A second period of adjustment of these biologically sensitive parameters began after about 50 h of pumping, following displacement of 230 wellbore volumes, and continued to the end of the experiment. During this period, the cell density and the composition of the microbial community suspended in the water samples changed. This finding indicates that the microbial community in and near the wellbore changed in response to pumping and the changes affected aspects of the composition of water produced from the well. The study demonstrates the importance of allowing adequate pumping time when sampling ground water for the analysis of biologically sensitive parameters.     

The persistence and character of stranded oil on coarse-sediment beaches

Small amounts of oil that can persist for decades in the intertidal zone of coarse-sediment beaches have been documented in a few well-studied cases. Oil that survives attenuation over the short-term (weeks to months) will persist until there is a change in the environmental conditions, as might occur where there is a seasonal storm-wave climate or as a beach undergoes long-term (erosional) changes. Oil residues can persist on the beach surface as tar mats, asphalt-like pavements, or as veneers on sediment particles or hard surfaces. Subsurface oil residues can persist in similar forms or as fill or partial fill of the pore spaces between coarse-sediment particles. Oil penetrates until it reaches fine-grained sediment, the water table, bedrock, or other penetration-limiting layers. Amounts of persistent oil are very small fractions of the volumes that were originally stranded and these protected residues can continue to biodegrade as they become thinner and more discontinuous.     

The Influence of Wellbore Inflow on Electromagnetic Borehole Flowmeter Measurements

This paper describes a combined field, laboratory, and numerical study of electromagnetic borehole flowmeter measurements acquired without the use of a packer or skirt to block bypass flow around the flowmeter. The most significant finding is that inflow through the wellbore screen changes the ratio of flow through the flowmeter to wellbore flow. Experiments reveal up to a factor of two differences in this ratio for conditions with and without inflow through the wellbore screen. Standard practice is to assume the ratio is constant. A numerical model has been developed to simulate the effect of inflow on the flowmeter. The model is formulated using momentum conservation within the borehole and around the flowmeter. The model is embedded in the MODFLOW-2000 ground water flow code.     

Considering dynamic soil structure interaction (SSI) effects on seismic isolation retrofit efficiency and the importance of natural frequency ratio

This paper utilizes and expands on existing coupled BEM–FEM (finite element method) methods for the investigation of the effects of soil structure interaction (SSI) on both an un-retrofitted and seismically isolated typical bridge structure. A simple numerical model of the bridge and surrounding soil is formulated and excited by an earthquake excitation. Utilizing Newmark's β FEM solution method along with the closed form B-spline BIRF method, the structural damped period, composite damping ratio, pier relative displacement, and base shear demand are monitored. From these results, the effects of SSI on this structure are identified. Additionally, the importance of the relative rigidity between the soil-foundation system and the bridge structure is also investigated. The results of the studies indicate that the response of the complete structure system considered is affected by the inclusion of SSI effects. Furthermore, the efficiency of the isolation measures designed using fixed base conditions is decreased by considering SSI over a certain relative rigidity range that is quantified using the structure to soil-foundation natural frequency ratio.     

Application of implicit sub-time stepping to simulate flow and transport in fractured porous media

In general, the accuracy of numerical simulations is determined by spatial and temporal discretization levels. In fractured porous media, the time step size is a key factor in controlling the solution accuracy for a given spatial discretization. If the time step size is restricted by the relatively rapid responses in the fracture domain to maintain an acceptable level of accuracy in the entire simulation domain, the matrix tends to be temporally over-discretized. Implicit sub-time stepping applies smaller sub-time steps only to the sub-domain where the accuracy requirements are less tolerant and is most suitable for problems where the response is high in only a small portion of the domain, such as within and near the fractures in fractured porous media. It is demonstrated with illustrative examples that implicit sub-time stepping can significantly improve the simulation efficiency with minimal loss in accuracy when simulating flow and transport in fractured porous media. The methodology is successfully applied to density-dependent flow and transport simulations in a Canadian Shield environment, where the flow and transport is dominated by discrete, highly conductive fracture zones.     

A generalized transformation approach for simulating steady-state variably-saturated subsurface flow

A numerical method is proposed to accurately and efficiently compute a direct steady-state solution of the nonlinear Richards equation. In the proposed method, the Kirchhoff integral transformation and a complementary transformation are applied to the governing equation in order to separate the nonlinear hyperbolic characteristic from the linear parabolic part. The separation allows the transformed governing equation to be applied to partially- to fully-saturated systems with arbitrary constitutive relations between primary (pressure head) and secondary variables (relative permeability). The transformed governing equation is then discretized with control volume finite difference/finite element approximations, followed by inverse transformation. The approach is compared to analytical and other numerical approaches for variably-saturated flow in 1-D and 3-D domains. The results clearly demonstrate that the approach is not only more computationally efficient but also more accurate than traditional numerical solutions. The approach is also applied to an example flow problem involving a regional-scale variably-saturated heterogeneous system, where the vadose zone is up to 1 km thick. The performance, stability, and effectiveness of the transform approach is exemplified for this complex heterogeneous example, which is typical of many problems encountered in the field. It is shown that computational performance can be enhanced by several orders of magnitude with the described integral transformation approach.     

Smithsonian Institution’s Global Volcanism Network

Information included in this summary is based on more detailed reports published in the Bulletin of the Global Volcanism Network, vol. 32, no. 6, June 2007 (on the Internet at ). Edited by scientists at the Smithsonian, this bulletin includes reports provided by a worldwide network of correspondents. The reports contain the names and contact information for all sources. Please note that these reports are preliminary and subject to change as events are studied in more detail. The Global Volcanism Program welcomes further reports of current volcanism, seismic unrest, monitoring data, and field observations.     

Smithsonian Institution’s Global Volcanism Network

Information included in this summary is based on more detailed reports published in the Bulletin of the Global Volcanism Network, vol. 32, no. 9, September 2007 (on the Internet at ). Edited by scientists at the Smithsonian, this bulletin includes reports provided by a worldwide network of correspondents. The reports contain the names and contact information for all sources. Please note that these reports are preliminary and subject to change as events are studied in more detail. The Global Volcanism Program welcomes further reports of current volcanism, seismic unrest, monitoring data, and field observations.