Flux and dispersion of gases from the “Drachenschlund” hydrothermal vent at 8°18' S, 13°30' W on the Mid-Atlantic Ridge

Hydrothermal emission of mantle helium appears to be directly related to magma production rate, but other processes can generate methane and hydrogen on mid-ocean ridges. In an on-going effort to characterize these processes in the South Atlantic, the flux and distribution of these gases were investigated in the vicinity of a powerful black smoker recently discovered at 8°17.9' S, 13°30.4' W. The vent lies on the shoulder of an oblique offset in the Mid-Atlantic Ridge and discharges high concentrations of methane and hydrogen. Measurements during expeditions in 2004 and 2006 show that the ratio of CH₄ to ³He in the neutrally buoyant plume is quite high, 4 × 10⁸. The CTD stations were accompanied by velocity measurements with lowered acoustic Doppler current profilers (LADCP), and from these data we estimate the methane transport to have been 0.5 mol s^− 1 in a WSW-trending plume that seems to develop during the ebb tidal phase. This transport is an order of magnitude greater than the source of CH₄ calculated from its concentration in the vent fluid and the rise height of the plume. From this range of methane fluxes, the source of ³He is estimated to be between 0.14 and 1.2 nmol s^− 1. In either case, the ³He source is significantly lower than expected from the spreading rate of the Mid-Atlantic Ridge. From the inventory of methane in the rift valley adjacent to the vent, it appears that the average specific rate of oxidation is 2.6 to 23 yr^− 1, corresponding to a turnover time between 140 and 16 days. Vertical profiles of methane in the surrounding region often exhibited Gaussian-like distributions, and the variances appear to increase with distance from the vent. Using a Gaussian plume model, we obtained a range of vertical eddy diffusivities between 0.009 and 0.08 m²m² s^− 1. These high values may be due to tidally driven internal waves across the promontory on which the vent is located.     

The Zn abundance and isotopic composition of diatom frustules,a proxy for Zn availability in ocean surface seawater

We have developed cleaning methods for extracting diatomopal from bulk marine sediment samples, for measurement of both zinc (Zn) abundance and isotope composition. This cleaning technique was then applied to a set of Holocene core-top samples from the Southern Ocean. The measured δ⁶⁶Zn (reported relative to the JMC_Lyon standard) and Zn/Si ratios from the Southern Ocean diatom_opal samples range from 0.7 to 1.5‰, and from 14 to 0.9 μmol/mol, respectively. The Zn abundance and isotope composition data show a clear correlation with opal burial rates and other oceanographic parameters. In common with previous work, we interpret the systematic changes in the Zn/Si ratio to be linked to the variability in the concentrations of bioavailable Zn in the ambient surface seawater where the diatom opal is formed. This variability is likely to be primarily controlled by the degree to which Zn is taken up into phytoplankton biomass. The observed systematic pattern in the δ⁶⁶Zn compositions of the diatom_opal core-top samples is, similarly, likely to reflect changes in the δ⁶⁶Zn composition of the ambient Zn in the surface waters above the core-top sites, which is progressively driven towards isotopically heavier values by preferential incorporation of the lighter isotopes into phytoplankton organic material. Thus, the systematic relationship between Zn isotopes and abundance observed in the core-top diatom_opal samples suggests a potential tool for investigating the biogeochemical cycling of Zn in the past surface ocean for down-core diatom_opal material. In this respect, it may be possible to test hypotheses that attribute variations in atmospheric CO₂ on glacial–interglacial timescales to the degree to which trace metals limited primary productivity in HNLC zones.     

Composition and origin of clasts and inclusions in the Abee enstatite chondrite breccia

The concentrations of 25 major, minor and trace elements have been determined in four clasts, a metal-rich inclusion and two dark metal-poor inclusions from the Abee enstatite chondrite. The clasts are heterogeneous, displaying 2-fold enrichments or depletions in some elements. The data suggest that there are two generations of metal, one with low, the other with high concentrations of refractory siderophiles. The other elemental patterns can be understood in terms of variations in the abundance of major minerals. We infer that Sc and Mn are located largely in the niningerite ((Fe,Mg)S), V in the troilite (FeS) and rare earth elements in the oldhamite (CaS).Heterogeneities among the clasts are probably primary, resulting from the accretion-agglomeration process, although shock processes in a regolithic setting remain a possibility provided that they were followed by a period of metamorphism sufficient to erase petrologic evidence.In the dark inclusions the concentrations of the rare earths, Eu excepted, are 4 × higher than mean EH levels; this infers enhanced amounts of CaS. The dark inclusions are low in siderophiles, Sc, Mn, K, Na and Al, implying low amounts of metal, niningerite and feldspar. The origin of the dark inclusions is unclear; they do not appear to be the result of a simple, single-stage process.     

Rates of cave and landform development in the Yorkshire Dales from speleothem age data

Uranium-series ages have been obtained for 87 speleothems collected from nine major cave systems in the Craven district of northern England. Large systems such as Ease Gill Caverns, the West Kingsdale caves, and Gaping Gill-Ingleborough Cave, which contain relict high-level tunnels, are found to be older than 350,000 years (the limit of the ²³⁰Th/²³⁴U dating method). There is little evidence to indicate a significant enlargement of these passages since this time. Estimates of the age of Victoria Cave from ²³⁴U/²³⁸U isotopic ratios suggest that the cave has been fully relict for more than 500,000 years. Ages of in situ speleothems immediately adjacent to local base level cave streams show that mean maximum downcutting rates in limestone channels are about 2 to 5 cm 1000 yr. These rates are significantly lower than those obtained from direct measurements on limestone bedrock in stream channels but are comparable to areal denudation rates based on solute budgets. Using the present elevation of caves with respect to adjacent valley floor levels, mean maximum valley entrenchment rates are found to range between 5 cm/ky and < 20cm/ky, which corresponds to 6 m to < 24 m of lowering per glacial/interglacial cycle. These rates suggest that upper beds of the limestone were incised to form the Yorkshire Dales between 1 and 2 million years ago. The results indicate that the erosional effects of individual glaciations are not as severe as previously proposed in the literature.     

Aragonite dissolution on the Bermuda pedestal: Its depth and geochemical significance

The depth distribution of pteropod and planktonic foram tests, and fine-grained (<62 μm) aragonite, high-Mg calcite (12 mode mol.% MgCO₃), and low-Mg calcite has been determined for surface sediments of an area of the eastern slope of the Bermuda pedestal. Over the range 1800–3000 m, fine-grained aragonite and fine-grained high-Mg calcite gradually disappear relative to fine-grained low-Mg calcite, and pteropods gradually disappear relative to planktonic forams. This is interpreted as preferential dissolution of aragonite (and high-Mg calcite) relative to low-Mg calcite over this depth range. Coarse aragonitic debris derived from shallow-water organisms living on the Bermuda platform does not show consistent disappearance over the same depth zone. Chemical analyses of bottom water samples taken at the same time as some of the sediment samples indicate that the degree of saturation with respect to aragonite Ω_A over the zone of aragonite disappearance ranges from 0.55 to 0.85; i.e. major dissolution occurs only at Ω_A values distinctly less than one. These results lend credence to the hypothesis that CaCO₃ dissolution in the oceans, both as aragonite and as calcite, takes place mainly as a response to complex chemical kinetic phenomena and not as a result of the simple attainment of undersaturation (thermodynamic hypothesis) or the resuspension of bottom sediment (hydrodynamic hypothesis).     

A two-dimensional photochemical model of the stratosphere with Rayleigh scattering

Computations of concentrations of minor stratospheric gases using a two-dimensional model of the stratosphere are reported. The model includes Rayleigh scattering. This results in an increase in the photodissociation rate computation time by a factor of 1.5. The effect of ground albedo is assessed by comparing our results with a calculation of photolysis rates for a constant albedo with latitude. Comparison of results with a reference model including only molecular absorption are also made. The largest differences (50%) occur in NO and OH. An approximate expression for including the effects of Rayleigh scattering and surface reflectance in multi-dimensional models is suggested.     

Rapid entrenchment of stream profiles in the salt caves of Mount Sedom,Israel

Rock salt is approximately 1000 times more soluble than limestone and thus displays high rates of geomorphic evolution. Cave stream channel profiles and downcutting rates were studied in the Mount Sedom salt diapir, Dead Sea rift valley, Israel. Although the area is very arid (mean annual rainfall ≈ 50 mm), the diapir contains extensive karst systems of Holocene age. In the standard cave profile a vertical shaft at the upstream end diverts water from a surface channel in anhydrite or clastic cap rocks into the subsurface route in the salt. Mass balance calculations in a sample cave passage yielded downcutting rates of 0–2 mm s^?1 during peak flood conditions, or about eight orders of magnitude higher than reported rates in any limestone cave streams. However, in the arid climate of Mount Sedom floods have a low recurrence interval with the consequence that long-term mean downcutting rates are lower: an average rate of 8·8 mm a^?1 was measured for the period 1986–1991 in the same sample passage. Quite independently, long-term mean rates of 6·2mm a^?1 are deduced from ¹⁴C ages of driftwood found in upper levels of 12 cave passages. These are at least three orders of magnitude higher than rates established for limestone caves. Salt cave passages develop in two main stages: (1) an early stage characterized by high downcutting rates into the rock salt bed, and steep passage gradients; (2) a mature stage characterized by lower downcutting rates, with establishment of a subhorizontal stream bed armoured with alluvial detritus. In this mature stage downcutting rates are controlled by the uplift rate of the Mount Sedom diapir and changes of the level of the Dead Sea. Passages may also aggrade. These fast-developing salt stream channels may serve as full-scale models for slower developing systems such as limestone canyons.     

Tafoni on coastal slopes,South Devon,U.K.

Cavernous weathering (tafoni development) occurs on coastal slopes in greenschist bedrock at elevations up to 40 m above sea level. The freshly weathered surfaces of the cavern interiors are irregular in morphology, discordant to major rock structure, formed by substantially weakened rock and associated with granular weathering debris. The weathering debris contains soluble elements in proportions similar to those present in seawater, and the penetration of elements associated with sea salts into the weathering surface to estimated depths of at least 0·1–0·2 m is indicated by the presence of chlorine. Scanning electron microscopy and microprobe analyses suggest that rock breakdown occurs principally through limited chemical weathering at grain boundaries. The mechanism for the emplacement of marine salts within sheltered rock surfaces in the tafoni is postulated to be a combination of dry deposition under turbulent atmospheric conditions and wetting by coastal fog.     

The evolution of pore pressure fields around standard and ball penetrometers: influence of penetration rate

Rate effects are examined in the steady pore pressure distribution induced as a result of penetration of standard and ball penetrometers. The incompressible flow field, which develops around the penetrometer is used to define the approximate soil velocity field local to the penetrometer tip. This prescribes the Lagrangian framework for the migration of the fluid saturated porous medium, defining the advection of induced pore pressures relative to the pressure‐monitoring locations present on the probe face. In two separate approaches, different source functions are used to define the undrained pore fluid pressures developed either (i) on the face of the penetrometer or (ii) in the material comprising the failure zone surrounding the penetrometer tip. In the first, the sources applied at the tip face balance the volume of fluid mobilized by the piston displacement of the advancing penetrometer. Alternately, a fluid source distribution is evaluated from plasticity solutions and distributed throughout the tip process zone: for a standard penetrometer, the solution is for the expansion of a spherical cavity, and for the ball penetrometer, the solution is an elastic distribution of stresses conditioned by the limit load embedded within an infinite medium. For the standard penetrometer, the transition from drained to undrained behavior occurs over about two orders of magnitude in penetration rate for pore pressures recorded at the tip (U1) and about two‐and‐a‐half orders of magnitude for the shoulder (U2). This response is strongly influenced by the rigidity of the soil and slightly influenced by the model linking induced total stresses to pore pressures. For the ball penetrometer, the transition from drained to undrained behavior also transits two‐and‐a‐half orders of magnitude in penetration rate, although it is offset to higher dimensionless penetration rates than for standard penetration. Copyright © 2012 John Wiley & Sons, Ltd.