Spectral development of a solar X-ray burst observed on OSO-7

The UCSD solar X-ray instrument on the OSO-7 satellite observes X-ray bursts in the 2–300 keV range with 10.24 s time resolution. Spectra obtained from the proportional counter and scintillation counter are analyzed for the event of November 16, 1971, at 0519 UT in terms of thermal (exponential spectrum) and non-thermal (power law) components. The energy content of the approximately 20 × 10⁶K thermal plasma increased with the 60 s duration hard X-ray burst which entirely preceded the 5 keV soft X-ray maximum. If the hard X-rays arise by thick target bremsstrahlung, the nonthermal electrons above 10 keV have sufficient energy to heat the thermally emitting plasma. In the thin target case the collisional energy transfer from non-thermal electrons suffices if the power law electron spectrum is extrapolated below 10 keV, or if the ambient plasma density exceeds 4 × 10¹⁰ cm^–3.Formerly at UCSD.     

A current ribbon model for energy storage and release with application to the flare of 7 January 1992

Observations of the flare on 7 January 1992 are interpreted using a topological model of the magnetic field. The model, developed here, applies a theory of three-dimensional reconnection to the inferred magnetic field configuration for 7 January. In the model field a new bipole ( 10²¹ Mx) emerges amidst pre-existing active region flux. This emergence gives rise to two current ribbons along the boundaries (separators) separating the distinct, new and old, flux systems. Sudden reconnection across these boundary curves transfers 3 ×10²⁰ Mx of flux from the bipole into the surrounding flux. The model also predicts the simultaneous (sympathetic) flaring of the two current ribbons. This explains the complex two-loop structure noted in previous observations of this flare. We subject the model predictions to comparisons with observations of the flare. The locations of current ribbons in the model correspond closely with those of observed soft X-ray loops. In addition the footpoints and apexes of the ribbons correspond with observed sources of microwave and hard X-ray emission. The magnitude of energy stored by the current ribbons compares favorably to the inferred energy content of accelerated electrons in the flare.     

Heights of formation of non-magnetic solar lines suitable for velocity studies

Heights of formation of lines that do not exhibit Zeeman splitting are calculated using an LTE, partial non-LTE, and full non-LTE approach. Non-magnetic (g=0) lines are valuable for velocity investigations in quiet-Sun magnetic field regions, and a knowledge of their formation heights is useful for obtaining three dimensional velocity profiles in these regions. Presently at Sacramento Peak Observatory. Operated by the Association of Universities for Research in Astronomy, Inc., under contract with the National Science Foundation.     

The stellar content of a spiral arm of NGC 4321

The effects of the passage of a spiral arm through the disc of the giant Virgo Sc galaxy NGC 4321 are investigated with Hubble Space Telescope WFPC2 images in two colours. Concentrating on a portion of the southern spiral arm of NGC 4321, we have applied a new program to solve for the star formation histories in the arm and interarm regions separately. The observational uncertainties and the variable crowding across the spiral arm are taken into account using the results of artificial star tests. In the interarm regions the data are consistent with a constant star formation rate for the last 50 Myr while the stars in the arm region show a star formation rate four times larger than in the interarm regions in the last 5 Myr.     

New insights on the QSO radio-loud/radio-quiet dichotomy: SDSS spectra in the context of the 4D eigenvector1 parameter space

We search for a dichotomy/bimodality between radio-loud (RL) and radio-quiet (RQ) type 1 active galactic nuclei (AGN). We examine several samples of Slogan Digital Sky Survey (SDSS) quasi-stellar objects (QSOs) with high signal-to-noise ratio optical spectra and matching Faint Images of the Radio Sky at Twenty-cm/NRAO VLA Sky Survey (FIRST/NVSS) radio observations. We use the radio data to identify the weakest RL sources with a Fanaroff–Riley type II (FR II) structure to define a RL/RQ boundary which corresponds to log   L _1.4 GHz= 31.6  erg s⁻¹ Hz⁻¹. We measure the properties of broad-line Hβ and Fe  ii emission to define the optical plane of a 4DE1 spectroscopic diagnostic space. The RL quasars occupy a much more restricted domain in this optical plane compared to the RQ sources, which a 2D Kolmogorov–Smirnov test finds to be highly significant. This tells us that the range of broad-line region kinematics and structure for RL sources is more restricted than for the RQ QSOs, which supports the notion of dichotomy. FR II and CD RL sources also show significant 4DE1 domain differences that likely reflect differences in line-of-sight orientation (inclined versus face-on, respectively) for these two classes. The possibility of a distinct radio-intermediate (RI) population between RQ and RL source is disfavoured because a 4DE1 diagnostic space comparison shows no difference between RI and RQ sources. We show that searches for dichotomy in radio versus bolometric luminosity diagrams will yield ambiguous results mainly because in a reasonably complete sample, the radio brightest RQ sources will be numerous enough to blur the gap between RQ and RL sources. Within resolution constraints of NVSS and FIRST, we find no FR I sources among the broad-line quasar population.     

Origin of dacites of Taupo Volcanic Zone, New Zealand

Dacites form a relatively small proportion of lavas in the Taupo Volcanic Zone, New Zealand (5km³), and occur mainly on the eastern side. In this paper their origin is considered in terms of three processes: (a) partial melting of crustal rocks; (b) fractional crystallisation of basalt and andesite; and (c) sub-surface mixing of basic and acid magma. Modelling techniques are used to calculate the most acceptable degree of fractional crystallisation and magma mixing to fit major-element data, and these values are used to compare calculated and observed trace-element values. The success or failure of the model is determined by the closeness of the two sets of values. For partial-melt models, trace-element values alone are calculated by the batch-melting equation.Results indicate that White Island dacite can best be modelled by fractional crystallisation; Manawahe by fractional crystallisation plus limited crustal contamination; Maungaongaonga by partial melting of Western Basement greywacke, and Tauhara by partial melting of this greywacke together with minor mixing with a more basic magma. Results from Parekauau and Horohoro indicate that these lavas are unlikely to have formed by any of the processes examined.     

THREE-WAY METHODS FOR THE CALIBRATION OF CHROMATOGRAPHIC SYSTEMS:COMPARING PARAFAC AND THREE-WAY PLS

For the calibration of chromatographic systems,different methods can be used.One class of methodsutilizes three-way approaches.The calibration problem is stated in such a way that the decompositionof a three-way array can serve for the prediction of retention on new stationary phases.Two three-way approaches are presented:the Unfold-PCA and PARAFAC models.The theory ofboth methods is presented and the differences are highlighted,the main difference being that PARAFACis a trilinear decomposition whereas Unfold-PCA is not.Both three-way methods are evaluated on asmall data set consisting of retention measurements of eight solutes at six mobile phase compositions onsix stationary phases.The differences in performance of the two models are minor,For calibration purposes,two variants of the methods are discussed:three-way PLS and an extensionof PARAFAC.Again the theory and differences between the two methods are explained.The predictiveperformance of the two methods is compared using the same data set as earlier.The differences inpredictive performance,however,are minor.Both methods are capable of predicting 98% of thevariation in the test sets.Yet,there are other considerations when comparing methods than predictiveperformance,e.g.the quality of the predictions.     

Correction of the ionospheric distortion on the MARSIS surface sounding echoes

Mars Advanced Radar for Subsurface and Ionospheric Sounding (MARSIS) on the Mars Express (MEX) spacecraft has made numerous measurements of the Martian surface and subsurface. However, all of these measurements are distorted by the ionosphere and must be compensated before any analysis. We have developed a technique to compensate for the ionospheric distortions. This technique provides a powerful tool to derive the total electron content (TEC) and other higher-order terms of the limited expansion of the plasma dispersion function that are related to overall shape of the electron column profile. The derived parameters are fitted by using a Chapman model to derive ionospheric parameters like n₀, electron density primary peak (maximum for solar zenith angle (SZA) equal 0), and the neutral height scale H.

Our estimated ionospheric parameters are in good agreement with Mars Global Surveyor (MGS) radio-occultation data. However, since MARSIS does not have the observation geometry limitations of the radio occultation measurements, our derived parameters extend over a large range of SZA for each MEX orbit.

The first results from our technique have been discussed by Safaeinili et al. [2007, Estimation of the total electron content of the Martian ionosphere using radar sounder surface echoes. Geophys. Res. Lett. 34, L23204, doi:10.1029/2007GL032154].     

The formation of small cones in Isidis Planitia,Mars through mobilization of pyroclastic surge deposits

We investigate the distinctive distribution and pattern of subkilometer-sized cones in Isidis Planitia, and their relationship to the material that fills the basin. We observe that: (1) the cones show uniform size, spacing, and morphology across the entire basin; (2) they have large central depressions (relative to cone basal diameters) that are generally filled in and commonly show layering; (3) cone chains form highly organized spatial patterns; cones are also found in isolation and in dense fields; (4) many adjacent chains are parallel, and evenly spaced, creating a pattern that mimics lava flows that have experienced compressional folding; (5) no flows are associated with the cones, even where summit crater rims are breached; (6) the cones are at least temporally related to basin fill; (7) the basin fill material is largely fine-grained, but with locally indurated layers at shallow depth; blocks ejected by small craters from these locally indurated layers are commonly dark in color; and (8) relationships between cones along a chain show no systematic temporal formation sequence along the chain. We conclude that the basin was likely inundated by one or more hot, partially welded pyroclastic flows; devolatilization of these flows remobilized volcaniclastic material to form the cones without associated lava flows. The volume of gas required to account for the observed number of cones is low and does not require the presence of ground water or ice.