Production of selected cosmogenic radionuclides by muons: 2. Capture of negative muons

We have determined the production yields for radionuclides in Al₂O₃, SiO₂, S, Ar, K₂SO₄, CaCO₃, Fe, Ni and Cu targets, which were irradiated with slow negative muons at the Paul Scherrer Institute in Villigen (Switzerland). The fluences of the stopped negative muons were determined by measuring the muonic X-rays. The concentrations of the long-lived and short-lived radionuclides were measured with accelerator mass spectrometry (AMS) and γ-spectroscopy, respectively. Special emphasis was put on the radionuclides ¹⁰Be, ¹⁴C and ²⁶Al produced in quartz targets, ²⁶Al in Al₂O₃ and S targets, ³⁶Cl in K₂SO₄ and CaCO₃ targets, and ⁵³Mn in Fe₂O₃ targets. These targets were selected because they are also the naturally occurring target minerals for cosmic ray interactions in typical rocks. We also present results of calculations for depth-dependent production rates of radionuclides produced after cosmic ray μ⁻ capture, as well as cosmic ray-induced production rates of geologically relevant radionuclides produced by the nucleonic component, by μ⁻ capture, by fast muons and by neutron capture.     

Identification of Mining Blasts at Mid- to Far-regional Distances Using Low Frequency Seismic Signals

—?This paper reports results from two recent monitoring experiments in Wyoming. Broadband seismic recordings of kiloton class delay-fired cast blasts and instantaneous calibration shots in the Black Thunder coal mine were made at four azimuths at ranges from 1° to 2°. The primary focus of this experiment was to observe and to explain low-frequency signals that can be seen at all azimuths and should routinely propagate above noise to mid-regional distances where most events will be recorded by International Monitoring System (IMS) stations.¶The recordings clearly demonstrate that large millisecond delay-fired cast blasts routinely produce seismic signals that have significant spectral modulations below 10?Hz. These modulations are independent of time, the azimuth from the source and the orientation of the sensor. Low-frequency modulations below 5?Hz are seen beyond 9°. The modulations are not due to resonance as they are not produced by the calibration shots. Linear elastic modeling of the blasts that is guided by mine-blast reports fails to reproduce the fine detail of these modulations but clearly indicates that the enhanced “spectral roughness” is due to long interrow delays and source finiteness. The mismatch between the data and the synthetics is likely due to source processes, such as nonlinear interactions between shots, that are poorly understood and to other effects, such as variations of shot time and yield from planned values, that are known to be omnipresent but cannot be described accurately. A variant of the Automated Time-Frequency Discriminant (Hedlin, 1998b), which uses low-frequency spectral modulations, effectively separates these events from the calibration shots.¶The experiment also provided evidence that kiloton class cast blasts consistently yield energetic 2–10 second surface waves. The surface waves are strongly dependent on azimuth but are seen beyond 9°. Physical modeling of these events indicates that the surface waves are due mainly to the extended source duration and to a lesser extent to the slap-down of spalled material. The directionality is largely a path effect. A discriminant that is based on the partitioning of energy between surface and body waves routinely separates these events from the calibration shots.¶The Powder River Basin has essentially no natural seismic activity. How these mining events compare to earthquake observations remains to be determined.     

The Influence of 3-D Structure on the Propagation of Seismic Waves Away from Earthquakes

-- The seismic records from significant earthquakes are profoundly affected by 3-D variations in crustal structure both in the source zone itself and in propagation to some distance. Even in structurally complex zones such as Japan and Mexico relatively coherent arrivals are found associated with different classes of propagation paths. The presence of strong lateral variations can disrupt the arrivals, and impose significant variations in propagation characteristics for different directions from the source as illustrated by observations for the 1995 Kobe and 2000 Tottori-ken Seibu earthquakes in western Japan. Such effects can be modelled in 3 dimensions using a hybrid scheme with a pseudospectral representation for horizontal coordinates and finite differences in depth. This arrangement improves parallel implementation by minimising communication costs. For a realistic 3-D model for the structure in western Japan the 3-D simulations to frequencies close to 1 Hz provide a good representation of the observations from subduction zones events such as the 1946 Nankai earthquake and the 2000 Tottori-ken Seibu earthquake. The model can therefore be used to investigate the pattern of ground motion expected for future events e.g., in current seismic gaps.     

Moment Tensor Inversion of Regional Phases: Application to a Mine Collapse

—?The aim of our study consists of analyzing potentially non-double-couple seismic events recorded at regional distances. In order to define the nature of the seismic source, a moment tensor inversion is carried out as this method is general enough not to initially constrain the source mechanism. In this paper we present an application to a seismic event induced by a mine collapse which occurred near the town of Halle in Germany. Because of its induced nature, many parameters such as the location and geometry of this seismic source are known. This information allows us to test the influence of inadequate propagation modeling on the moment tensor obtained from the inversion. Green's functions have been computed with the reflectivity method in a flat layered medium, using the European model EurID (Du et? al., 1998; Dufumier et al., 1997). From the inversion of P-wave seismograms recorded by the German Regional Seismic Network will, we obtained a source time function which can be decomposed into two subevents. The first one has a large isotropic part and a deviatoric mechanism with near vertical nodal planes. No volume change is observed for the second subevent, but a deviatoric component opposite of the first one. The addition of S-waves does not change the results of the inversion which are stable. Surface waves were not used because of their poor dispersion curves. Based on the moment tensor obtained from these inversions, the physical process at the source is compatible with a large cavity collapse.     

"THREE DIMENSIONAL MATHEMATICAL MODEL OF SEDIMENT TRANSPORT IN ESTUARINE REGIONS-- A CASE STUDY OF THE HAIHE RIVER MOUTH" Yuchuan Bai,Huanting SHEN and Shixiong HU

The paper presents the 3D finite element simulation of tidal flow and Sediment transport in the estuarine region of the Haihe river. The proposed model adopts sigma-transformation of the hydrodynamic and sediment transport equations. The hydrodynamic and sediment transport models are verified in case of a simple test problem for which analytical solutions are available. Finally the models are applied to muddy Haihe river estuary of North China and it is claimed that hydrodynamic and sediment transport models give a reliable comparison with the observed field data. However, there are certain discrepancies, and some reasonable questions regarding the present state-of-art, in the modeling of three-dimensional multilevel hydrodynamics and sediment transport, which are provided below for answer.     

用于地震调查的航空红外遥感实时传输系统研究

该系统提供了航空红外遥感资料的袢时采集和传输，为及时开展地震野外调查工作提供了一个有力的手段。该系统由红外传感器系统、机载站图像和数据实时处理系统、机载站通信系统、转发站通信系统、地面站接收系统、地面站图像和数据实时处理系统组成。     

Causes of Geochemical Diversity of Carbon Dioxide Water in Crystalline Rock Masses

The problem of the diversity of the geochemical types of carbon dioxide waters (CDW) in petrografically and mineralogically uniform crystalline rock masses is solved with allowance made for the effect of different boundary conditions (physicochemical parameters) on the geochemical effect of interaction in the rock–water system. The formation of the entire geochemical spectrum of CDW in crystalline rock masses is shown to be explicable on the basis of a model of interaction in granite–water systems at different mass ratios of reacting rock (S) and water (L), different temperatures T, and equilibrium concentrations of dissolved CO₂ (P _CO2).     

Precursory seismic crustal deformation in the area of southern Albanides

On the basis of growing evidence thatstrong earthquakes are preceded by a periodof accelerating seismicity of moderatemagnitude earthquakes, an attempt is madeto search for such seismicity pattern in NWAegean area. Accelerating seismic crustaldeformation has been identified in the areaof southern Albanides mountain range(border region between Greece, formerYugoslavia and Albania). Based on certainproperties of this activity and on itssimilarity with accelerating seismicdeformation observed before a strongearthquake which occurred in the sameregion on 26 May 1960 (M = 6.5), we canconclude that a similar earthquake may begenerated in the same region during thenext few years. This conclusion is inagreement with independent results whichhave been derived on the basis of the timepredictable model.     

河北平原水系密度与隐伏活动构造的关系

以1926年出版的比例尺为1：5万的顺直地形图作为基础图件，用地理信息系统技术对河北平原作水系密度计量分析，揭示隐伏在第四纪巨厚的沉积物之下活动构造的信息，研究结果证实水系线密度统计图与使用其它地球科学方法获得的成果，例如基底活动断块图，地貌类型图和第四纪厚度图都有很好的对应，特别与布格重力图对应更好，研究结果发现水系密度图与布格重力异常图在总体一致性较好的前提下，多处反向异常区均为近代强震发生的区域，提出这种地表水系密度统计研究的成果不仅可以揭示深部隐伏的活动构造，而且具有较明确的时间含义。     

Geo–ecology and management of sensitive montane landscapes

Montane (alpine) areas are generally of high value for nature conservation. Such environments and the habitats they support are dynamic and often fragile. They are vulnerable to disturbance from a range of human activities and are responsive to climate changes over short and long timescales. Biodiversity and conservation values are closely linked to geological history, geomorphological processes and soils, and it is crucial that management systems are based on understanding these links.
There are many similarities between the Cairngorm Mountains (Scotland), the Giant Mountains (Czech Republic) and Abisko Mountains (Sweden) in terms of geology, geomorphology, ecology, links with biodiversity and high conservation importance. Comparable pressures and management issues involve, to varying degrees, a history of human use and impacts from deforestation, pasturing, grazing, recreation and atmospheric pollution. Landscape change therefore involves a complex interplay between natural and anthropogenic factors. Managing such change requires better understanding of the geo–ecological processes involved and the factors that determine landscape sensitivity. This is illustrated through a simple framework and examples from the three areas. Comparison of landscape sensitivity between similar montane areas, but in different geographic locations and climatic environments, should allow more informed management planning and a precautionary approach in advance of further changes in human activity and from predicted global warming scenarios.