Heat flow near obstacles in the solar convection zone

Disturbances in the heat flow in the solar convection zone are calculated with a turbulent thermal diffusion coefficient based on a mixing length approximation. As a consequence of the radiative boundary condition at the surface and the strong increase of the diffusion coefficient with depth, the convection zone resembles a thermally superconducting shell enclosed between a thin surface layer and an interior core of low thermal conductivity. Thermal disturbances originating in the convection zone do not penetrate into the interior, and penetrate only weakly through the solar surface. A thermally isolating obstacle buried entirely in the convection zone casts a shadow of reduced temperature at the solar surface; the brightening surrounding this shadow is undetectable. The shadow is weak unless the object is located close to the surface (less than 2000 km). Assuming a sunspot to be an area of reduced thermal conductivity which extends a finite depth into the convection zone, the heat flow around this obstacle is calculated. The heat flux blocked below the spot (missing flux) spreads over a very extended area surrounding the spot. The brightening corresponding to this missing flux is undetectable if the reduction of the thermal conductivity extends to a depth greater than 1000 km. It is concluded that no effect other than a decrease of the convective efficiency is needed to explain the temperature change observed at the solar surface in and around a sunspot. The energy balance is calculated between magnetic flux tubes, oriented vertically in the solar surface, (magnetic elements in active regions and the quiet network) and their surroundings. Near the visible surface radiation enters the tube laterally from the surrounding convection zone. The heating effect of this influx is important for small tubes (less than a few arcseconds). Due to this influx tubes less than about 1 in diameter can appear as bright structures irrespective of the amount of heat conveyed along the tube itself. Through the lateral influx, small tubes such as are found in the quiet network act as little leaks in the solar surface through which an excess heat flux escapes from the convection zone.     

Inferring erosional resistance of bedrock units in the east Tennessee mountains from digital elevation data

Measures of local relief, regional relief, and slope were calculated from digital elevation models (DEMs) for 50 bedrock units in the Ridge and Valley and Blue Ridge provinces of Tennessee. Each of these measures was normalized and the three were then averaged to produce the erosional resistance index (ERI). Bedrock units with higher ERI values include coarse clastics, intermediate clastics, and metaplutonics. Units with lower values include shales, limestones, limestones plus dolostones, and carbonates plus fine clastics. Dolostones tend to have intermediate values. The calculated ERI values were compared with subjective ratings by a geologist with decades of field experience in east Tennessee. Generally, the agreement between the two ratings was good, the most glaring exception being several shales with improbably high ERI values. These turned out to be thin units cropping out beneath very hard sandstones, allowing them to stand higher and steeper than would otherwise be possible. A systematic method for detecting such erroneously high ERI values is suggested. Inspection of a drainage map superimposed on the geology map shows that in a given area, streams tend to flow on rock units with the lowest ERI values. In addition, statistical analysis shows that bedrock units with the lowest ERI values are, on average, almost three times closer to the nearest stream and six times as likely to have streams flowing on them than are units with highest values. Further, the effect of ERI on stream location is strongest for streams with drainage areas between 1 and 30 km². Thus, small streams appear to be subject to greater lithologic control than are larger streams.     

SENSITIVITY OF MALARIA, SCHISTOSOMIASIS AND DENGUE TO GLOBAL WARMING

Global assessment of the potential impacts of anthropogenically-induced climate change on vector-borne diseases suggests an increase in extent of the geographical areas susceptible to transmission of malarial Plasmodium parasites, dengue Flavivirus and Schistosoma worms. The transmission potential of the three associated vector-borne diseases studied is highly sensitive to climate changes on the periphery of the currently endemic areas and at higher altitudes within such areas. Our findings vis-à-vis the present endemic areas indicate that the increase in the epidemic potential of malaria and dengue transmission may be estimated at 12–27% and 31–47%, respectively, while in contrast, schistosomiasis transmission potential may be expected to exhibit a 11–17% decrease.     

Late Cretaceous rift-related upwelling and melting of the Trindade starting mantle plume head beneath western Brazil

High mantle potential temperatures and local extension, associated with the Late-Cretaceous impact of the Trindade mantle plume, produced substantial widespread and voluminous magmatism around the northern half of the Paraná sedimentary basin. Our previous studies have shown that, above the central and eastern portions of the postulated impact zone where lithosphere extension is minimal, heat conducted by the plume caused large-scale melting of the more fusible parts of the subcontinental lithospheric mantle beneath the margin of the São Francisco craton and the surrounding Brasilía mobile belt. Here we combine geochemical data and field evidence from the Poxoreu Igneous Province, western Brazil to show how more intense lithospheric extension above the western margin of the postulated impact zone permitted greater upwelling and melting of the Trindade plume than further east. Laser ⁴⁰Ar/³⁹Ar age determinations indicate that rift-related basaltic magmas of the Poxoreu Igneous Province were emplaced at ? 84 Ma. Our detailed geochemical study of the mafic magmas shows that the parental melts underwent polybaric crystal fractionation within the crust prior to final emplacement. Furthermore, some magmas (quartz-normative) appear to have assimilated upper crust whereas others (nepheline- and hypersthene-normative) appear to have been unaffected by open-system crustal magma chamber processes. Incompatible trace element ratios (e.g. chondrite-normalised La/Nb?=?1) and isotopic ratios (⁸⁷Sr/⁸⁶Sr?=?0.704 and ¹⁴³Nd/¹⁴⁴Nd?=?0.51274) of the Hy-normative basalts resemble those of oceanic islands (OIB). We therefore propose that these “OIB-like” magmas were predominantly derived from convecting-mantle-source melts (i.e. Trindade mantle plume). Inverse modelling of rare-earth element (REE) abundances suggests that the initial melts were predominantly generated within the depth range of ?80–100 km, in mantle with a potential temperature of ?1500 °C.     

Genauigkeitserwartung photographischer Sternpositionen bei geschlossener Blockausgleichung

The theoretical accuracy of photographically determined star positions is studied, based on the assumption that the whole sphere is covered by a net of fields, 4 plates each, and that all the plates are adjusted simultaneously in a closed block. The influence of the number of fields on the accuracy is estimated by computing schematized spheric blocks containing only a few reference stars. If the plates are taken with a focal length of 2 meters, the block will consist of 2500 fields, and a mean accuracy of star position of 0.1 can be expected.