Morphology of HCN and CN in Comet Hale-Bopp (1995 O1)

We compare images of Comet Hale-Bopp (1995 O1) in HCN and CN taken near perihelion (April 1, 1997) to determine the origin of CN in comets. We imaged the J=1→0 transition of HCN at λ=3 mm with the BIMA Array. Data from two weeks around perihelion were summed within four phase bins based on the rotational period of the comet. This increases both the signal-to-noise ratio and the u-v coverage while decreasing the smearing of the spatial features. The similarly phased narrowband CN images were taken at Lowell Observatory within the same range of dates as the HCN images. We find that there is a better correlation between HCN and CN than between HCN and the optically dominant dust. If the CN in jets does have a dust source it would have to have a very low albedo and/or small particle size. The production rates are consistent with HCN being a primary parent of CN, although there are discrepancies between the HCN destruction scalelength and the CN production scalelength which we discuss.     

The ‘Stained Glass Procedure’, a new method to compare classification performance of images acquired with different pixel sizes

Objective comparison of classification performance of earth observation images, acquired at different spatial resolutions (e.g. NOAA-AVHRR, IRS-MOS, IRS-WiFS, Landsat-TM, IRS-LISS), is complicated because both class definition and training site selection are hampered by the inherent scale differences. This paper presents a new, generic method to compare the information content of such a set of images, the “Stained Glass Procedure”. It overcomes the stated problems by computing the scale-dependent, internal spectral variation in an image and by using this as an indicator for land cover information. The Stained Glass Procedure creates segments in the images and calculates the internal spectral variation in a high-spatial-resolution image for each segment. For each image from the set the average variance, weighted to area, is calculated. The Stained Glass Procedure can be used to predict the performance of sensors that are not available, yet, or to roughly determine the optimal spatial resolution for the classification of a specific area.The procedure was applied to images with pixel sizes ranging from 23 to 1100 m. Classification detail of Envisat-MERIS (300 m pixel size), not included in the image set, could be predicted accurately using the Stained Glass Procedure.The Stained Glass Procedure applies one procedure to all images, without any subjective decision during the analysis, thus offering a method to compare images with different pixel sizes in terms of classification detail that is truly objective.     

Character of the O–C Variation of Four W UMa Type Stars: AW UMa, AP Leo, AG Vir and AH Vir

An analysis was carried out of the secular period variation of four WU Ma type stars (AW UMa, AP Leo, AG Vir and AH Vir) using some newly determined times of minima as well as others reported in the literature. It was found that two stars show period increases, one a period decrease and the remaining shows no variation in period. This revised version was published online in July 2006 with corrections to the Cover Date.     

The inner Galaxy resolved at IJK using DENIS data

We present the analysis of three-colour optical/near-infrared images, in IJK , taken for the DEep Near Infrared Southern Sky Survey (DENIS) project. The region considered covers 17.4 deg² and lies within <5°, b <1.°5. The adopted methods for deriving photometry and astrometry in these crowded images, together with an analysis of the deficiencies nevertheless remaining, are presented. The numbers of objects extracted in I , J and K are 748 000, 851 000 and 659 000 respectively, to magnitude limits of 17, 15 and 13. Eighty per cent completeness levels typically fall at magnitudes 16, 13 and 10 respectively, fainter by about 2 mag than the usual DENIS limits as a result of the crowded nature of these fields. A simple model to describe the disc contribution to the number counts is constructed, and parameters for the dust layer are derived. We find that a formal fit of parameters for the dust plane, from these data in limited directions, gives a scalelength and scaleheight of 3.4±1.0 kpc and 40±5 pc respectively, and a solar position 14.0±2.5 pc below the plane. This latter value is likely to be affected by localized dust asymmetries. We convolve a detailed model of the systematic and random errors in the photometry with a simple model of the Galactic disc and dust distribution to simulate expected colourmagnitude diagrams. These are in good agreement with the observed diagrams, allowing us to isolate those stars from the inner disc and bulge. After correcting for local dust-induced asymmetries, we find evidence for longitude-dependent asymmetries in the distant J and K sources, consistent with the general predictions of some Galactic bar models. We consider complementary L -band observations in the companion paper.     

Long-term evolution of the aerosol debris cloud produced by the 2009 impact on Jupiter

We present a study of the long-term evolution of the cloud of aerosols produced in the atmosphere of Jupiter by the impact of an object on 19 July 2009 (Sánchez-Lavega, A. et al. [2010]. Astrophys. J. 715, L155-L159). The work is based on images obtained during 5 months from the impact to 31 December 2009 taken in visible continuum wavelengths and from 20 July 2009 to 28 May 2010 taken in near-infrared deep hydrogen-methane absorption bands at 2.1-2.3 μm. The impact cloud expanded zonally from ∼5000 km (July 19) to 225,000 km (29 October, about 180° in longitude), remaining meridionally localized within a latitude band from 53.5°S to 61.5°S planetographic latitude. During the first two months after its formation the site showed heterogeneous structure with 500-1000 km sized embedded spots. Later the reflectivity of the debris field became more homogeneous due to clump mergers. The cloud was mainly dispersed in longitude by the dominant zonal winds and their meridional shear, during the initial stages, localized motions may have been induced by thermal perturbation caused by the impact’s energy deposition. The tracking of individual spots within the impact cloud shows that the westward jet at 56.5°S latitude increases its eastward velocity with altitude above the tropopause by 5-10 m s⁻¹. The corresponding vertical wind shear is low, about 1 m s⁻¹ per scale height in agreement with previous thermal wind estimations. We found evidence for discrete localized meridional motions with speeds of 1-2 m s⁻¹. Two numerical models are used to simulate the observed cloud dispersion. One is a pure advection of the aerosols by the winds and their shears. The other uses the EPIC code, a nonlinear calculation of the evolution of the potential vorticity field generated by a heat pulse that simulates the impact. Both models reproduce the observed global structure of the cloud and the dominant zonal dispersion of the aerosols, but not the details of the cloud morphology. The reflectivity of the impact cloud decreased exponentially with a characteristic timescale of 15 days; we can explain this behavior with a radiative transfer model of the cloud optical depth coupled to an advection model of the cloud dispersion by the wind shears. The expected sedimentation time in the stratosphere (altitude levels 5-100 mbar) for the small aerosol particles forming the cloud is 45-200 days, thus aerosols were removed vertically over the long term following their zonal dispersion. No evidence of the cloud was detected 10 months after the impact.