Deep-ocean vertical noise directionality

The structure of beam noise measured at the output of a vertical array in a range dependent ocean basin was investigated using the modified wide-angle parabolic equation (PE). Noise sources were distributed throughout the basin, and the field due to each noise source at an array located in the midbasin was calculated. The response of the array to the superposition of the noise sources was found by beamforming. An efficient and direct approach that superimposes the noise sources on the PE field as the field is marched toward the array was developed. Downslope calculations of the midbasin vertical directionality were made between 50 and 400 Hz with this technique. Use of a geoacoustic model shows that the bottom behaves as a low-pass filter     

Inverted echo sounder measurement of dynamic height through an ENSOcycle in the central equatorial Pacific

A four-year record from an inverted echo sounder deployed near Palmyra Island at 6°N in the central Pacific Ocean is compared with a simultaneous record of subsurface pressure from this island lagoon. A factor m, converting round-trip acoustic travel time to surface dynamic height relative to a deep pressure level, was estimated from the ratio of the spectra of the two records in the energetic synoptic oscillation band. Year-to-year variation in m was not statistically significant. For the overall record, m was found to be -70±8 dynamic m/s, where the error bounds represent a 90% confidence interval. This is consistent with first-baroclinic-mode excitation     

A time series analysis of sound propagation in a strongly multipathshallow water environment with an adiabatic normal mode approach

Measured time series were generated by small omnidirectional explosive sources in a shallow water area. A bottom-mounted hydrophone recorded sound signals that propagated over a sloping bottom. The time series in the 250-500 Hz band were analyzed with a broad-band adiabatic normal mode approach. The measured waveforms contain numerous bottom interacting multipaths that are complicated by the subbottom structure that contains high-velocity layers near the water-sediment interface. Several of the details of the geoacoustic structure and the depth of the water column at the receiver are inferred from comparisons of the measured data to simulated time series. The sensitivity of broad-band matched-field ambiguity surfaces in the range-depth plane for a single receiver to selected waveguide parameters is examined. A consistent analysis is made where the simulated time series are compared to the measured time series along with the single-receiver matched-field localization solutions for ranges out to 5 km. In this range interval, it was found that the peak cross-correlation between the measured and simulated time series varied between 0.84 and 0.69. The difference between the GPS range and the range obtained from the matched-field solution varied from 0 to 63 m. The geoacoustic structure obtained in the analysis consists of an 8-m low-velocity sediment layer over an 8-m high-velocity layer followed by a higher velocity, infinite half-space     

Exposure history of the Torino meteorite

Abstract— We determined He, Ne, Ar, ¹⁰Be, ²⁶Al, ³⁶Cl, and ¹⁴C concentrations, as well as cosmic-ray track densities and halogen concentrations in different specimens of the H6 chondrite Torino, in order to constrain its exposure history to cosmic radiation. The Torino meteoroid had a radius of ～20 cm and travelled in interplanetary space for 2.5–10 Ma. Earlier, Torino was part of a larger body. The smallest possible precursor had a radius of 55 cm and a journey through space longer than ～65 Ma. If the first-stage exposure took place in a body with a radius of >3 m or in the parent asteroid, then it lasted nearly 300 Ma. The example of Torino shows that it is easy to underestimate first-stage exposure ages when constructing two-stage histories.     

Evolution of 2:1 layered silicates in low-grade metamorphosed Liassic shales of Central Switzerland

White mica from the Liassic black shales and slates in Central Switzerland was analysed by transmission electron microscopy (TEM) and electron microprobe to determine its textural and compositional evolution during very low-grade prograde metamorphism. Samples were studied from the diagenetic zone, anchizone and epizone (T ≈100°–450 °C). Phyllosilicate minerals analysed include illite/smectite (I/S), phengite, muscovite, brammallite, paragonite, margarite and glauconite. Textural evolution primarily is towards larger, more defect-free grains with compositions that approach those of their respective end-members. The smectite-to-illite transformation reduced the amounts of the exchange components SiK_?1Al_?1, MgSiAl_?2, and Fe³⁺Al_?1. These trends continue to a lesser degree in the anchizone and epizone. Correlations between the proportion of smectite in I/S and the composition of I/S indicate that smectite layers may contain a high layer charge. Illite in I/S bears a compositional resemblance to macrocrystalline phengite in some samples, but is different in others. Paragonite first appears in the upper diagenetic zone or lower anchizone as an interlayer-deficient brammallite, and it may be mixed with muscovite on the nanometre scale. Owing to the small calculated structure factor for paragonite-muscovite superstructures, conventional X-ray powder diffraction cannot distinguish between mixed-layer structures and a homogeneous compositionally intermediate solid solutions. However, indirect TEM evidence shows that irregularly shaped domains of Na- and K-rich mica exist below 10 nm. Subsequent coarsening of domains at higher grades produced discrete paragonite grains at the margins of muscovite crystals or in laths parallel to the basal plane of the host muscovite. Margarite appears in the epizone and follows a textural evolution similar to paragonite in that mixtures of margarite, paragonite, and muscovite may initially occur on the nanometre scale. However, no evidence of interlayer-poor margarite has been found.     

REMOTE SENSING FOREST BIOMASS: AN EVALUATION USING HIGH RESOLUTION REMOTE SENSOR DATA AND LOBLOLLY PINE PLOTS

Eight-year-old Loblolly pine (Pinus taeda) plots located in South Carolina were evaluated using high resolution aircraft multispectral scanner data to determine if biomass could be accurately measured. Sixteen pine plots located on both sandy and clay soils were treated with 0, 180, or 360 kg. (approximately 0, 400, or 800 lb.) of nitrogen per plot. Indices of biomass from remote sensing data were significantly correlated with in situ biomass measurements made in each plot. A ratio of infrared (.9–1.1 μm) and red (.65–.70 μm) channels yielded the best correlation. The indices were not sensitive to differences in soil type (sandy or clay).     

The exchange of organic carbon in basin mangrove forests in a southwest Florida estuary

The magnitude and seasonality of organic carbon exchange was estimated for two basin mangrove forests in Rookery Bay, Florida. Runoff and tidal inundation in the forests were seasonal with half the annual total of each occurring from August to October. In each forest there were 152 tides yr^?1 with a cumulative depth of about 12 m. Total organic carbon increased in bay waters exporting from the mangroves following a flood tide and peak concentrations were associated with export due to rainfall. The amount of net export from each basin forest was similar, although the concentration of organic carbon in each were different. Monthly net organic carbon export was proportional to the cumulative tidal amplitude within the forest. Total organic carbon export was 64 gC m^?2 yr^?1 and DOC was 75% of the total. A comparison of organic carbon export among riverine, fringe and basin mangroves suggests that tidal hydrology influences the proportion of litter fall that is exported from mangroves; and the magnitude of this organic carbon export from mangroves is related to the cumulative tidal amplitude within the forests.     

Stable isotope geochemistry and structural elements of the Sabina region (Central Apennines, Italy)

Various tectonic features are present in the Meso-Cenozoic basin units of the Sabina region (Central Apennines, Italy): Mio-Pliocene northeasterly verging thrusts are followed by Plio-Pleistocene, N-S oriented right-lateral strike-slip faults. Stable isotope geochemistry and examination of meso- and microstructures show that strain conditions differed through the course of tectonic history. Carbon and oxygen isotope analyses of the calate-filled extensional fractures, the sigmoidal veins present between stylolitic cleavage surfaces, and fault plane surfaces with differing motion, demonstrate those different geneses.
The "C/'" C of the older calcite-filling fractures (present both in the thrust and the strike-slip systems) suggests a deposition from shallow, fresh water circulation. Furthermore, the calcite fill of en echelon systems, that occur in the southernmost Plio-Pleistocene units, is clearly the result of a more recent, right-lateral strike-slip movement, connected with shallow water circulation within Mesozoic limestones.
The sigmoidal vein fills are derived from solid-state pressure solution processes which were the result of strike-slip movement. The deformation pattern related to the older thrust system is similar, but less intense; this also demonstrates general recrystallization processes in a closed system.
This suggests that the total shortening of the deformed sections is lower than that obtained on the basis of solution on stylolitic planes, because a sigruficant volume of dissolved carbonates remained in the system.
Stable isotope analysis also confirms that the deformational history of strongly cleaved rocks in the Sabina region took place in two phases and that extensional fractures formed before stylolithic planes, as suggested by structural and field observations.