Comparison of soil solution chemistry sampled by centrifugation, two types of suction lysimeters and zero-tension lysimeters

The choice of sampling method for soil solution is of great importance. In this paper soil solution chemistry sampled by centrifugation, two types of suction lysimeters and zero-tension lysimeters have been studied with the purpose of investigating systematic differences between them. The samples were taken at 4 depths from an acidified forest soil as well as from adjacent lime and ash treated soils. A centrifugation drainage method was compared with two types of suction lysimeters (‘Rhizon’ and ‘Prenart’) and zero-tension lysimeters. About half of the 27 variables measured showed a significant difference between the sampling methods used. Typically the centrifuged samples had lower pH (4.0 vs. 4.4), Ca (21 μM vs. 30 μM) and Mg (25 μM vs. 34 μM) concentrations and higher Cl (330 μM vs. 230 μM) and DOC (4.4 mM vs. 3.2 mM) concentrations than the Rhizon lysimeters. Also the other lysimeters showed significant differences compared to the centrifuged samples for about half the number of analytes. Centrifuged samples had higher concentrations of all analytes except NO₃ and PO₄ compared to zero-tension lysimeters and also for all analytes except NO₃ and Al compared to Prenart lysimeters. Among the environmental factors considered depth showed an influence to some extent, while sampling occasion had a great significant impact on the difference between the centrifugation method and the Rhizon lysimeters. Factors like individual pits or soil treatment did not show any influence on the difference between the methods.     

Large-scale mass wasting in ancient volcanic materials

Giant landslides are significant hazards associated with many active volcanic edifices. We describe a similar feature on ancient (>4 Ma) volcanic deposits subject to active tectonism. The landslide is approximately 3 km long by 1 km wide, with an estimated depth of 400 m. Side margins are straight and parallel, mimicking regional structure; narrow valleys incised down these margins provide low-strength side-release surfaces. Between these is a giant slump consisting of at least four, largely intact, discrete blocks that have moved down-dip a distance of >500 m. A series of flows with areal extents ranging from 0.01 to 0.5 km² extends from the front of the failure. The materials represent an eroded sequence of andesite flows on the flanks of a stratovolcano. These have undergone two phases of hydrothermal alteration, and are deeply weathered to low-density (1040±80 kg m⁻³) silt (59%) and clay (35%) materials with strength properties typical of weathered silts (c=26±3 kN m⁻²; φ=42±8°). The size and location of this landslide preclude detailed geotechnical investigation of the failure. The worth of numerical stability analysis as an alternative technique in assessing the nature of the failure and hence the risk it poses to nearby communities is investigated. Sensitivity analysis identified likely conditions under which initial failure may have occurred: analyses for sensitivity to strength and earthquake acceleration needed conversion to critical combinations (F=1.0) of water table and strength/acceleration to remove the overriding influence of water table fluctuations. Failure was likely initiated either by a high water table level (83-84%), or some combination of intensity VII-IX earthquake waves together with water table heights of 40-80%. A general hazard assessment indicates that the risk associated with creep and catastrophic failure of the main mass is small, whereas the risk from flow failures near the toe of the landslide may be high. Important parameters (hydrological regime, flow failure morphology, age of initiation, and rates of movement) requiring closer investigation are identified. Development of a model is crucial to assessing the hazard associated with a feature such as that described here. With limited resources, a detailed stability analysis is a powerful tool as an initial stage in hazard analysis.     

Localization and characterization of an active fault in an urbanized area in central Guatemala by means of geoelectrical imaging

The Polochic and Motagua faults define the active plate boundary between the North American and Caribbean plates in central Guatemala. A splay of the Polochic Fault traverses the rapidly growing city of San Miguel Uspantán that is periodically affected by destructive earthquakes. This fault splay was located using a 2D electrical resistivity tomography (ERT) survey that also characterized the fault damage zone and evaluated the thickness and nature of recent deposits upon which most of the city is built. ERT images show the fault as a ~50 m wide, near-vertical low-resistivity anomaly, bounded within a few meters by high resistivity anomalies. Forward modeling reproduces the key aspects of the observed electrical resistivity data with remarkable fidelity thus defining the overall location, geometry, and internal structure of the fault zone as well as the affected lithologies. Our results indicate that the city is constructed on a ~20 m thick surficial layer consisting of poorly consolidated, highly porous, water-logged pumice. This soft layer is likely to amplify seismic waves and to liquefy upon moderate to strong ground shaking. The electrical conductivity as well as the major element chemistry of the groundwater provides evidence to suggest that the local aquifer might, at least in part, be fed by water rising along the fault. Therefore, the potential threat posed by this fault splay may not be limited to its seismic activity per se, but could be compounded its potential propensity to enhance seismic site effects by injecting water into the soft surficial sediments. The results of this study provide the basis for a rigorous analysis of seismic hazard and sustainable development of San Miguel Uspantán and illustrate the potential of ERT surveying for paleoseismic studies.     

Potential spread of recently naturalised plants in New Zealand under climate change

Climate change and biological invasions are major causes of biodiversity loss and may also have synergistic effects, such as range shifts of invaders due to changing climate. Bioclimatic models provide an important tool to assess how the threat of invasive species may change with altered temperature and precipitation regimes. In this study, potential distributions of three recently naturalised plant species in New Zealand are modelled (Archontophoenix cunninghamiana, Psidium guajava and Schefflera actinophylla), using four different general circulation models (CCCMA-CGCM3, CSIRO-Mk3.0, GFDL-CM2.0 and UKMO-HADCM3) with two emission scenarios (A2 and B1) each. Based on a maximum entropy approach, models were trained on global data using a small set of uncorrelated predictors. The models were projected to the country of interest, using climate models that had been statistically downscaled to New Zealand, in order to obtain high resolution predictions. This study provides evidence of the potential range expansion of these species, with potentially suitable habitat increasing by as much as 169 % (A. cunninghamiana; with up to 115,805 km² of suitable habitat), 133 % (P. guajava; 164,450 km²) and 208 % (S. actinophylla; 31,257 km²) by the end of the century compared to the currently suitable habitat. The results show that while predictions vary depending on the chosen climate scenario, there is remarkable consistency amongst most climate models within the same emission scenario, with overlaps in areas of predicted presence ranging between 81 % and 99.5 % (excluding CSIRO-Mk3.0). By having a better understanding of how climate change will affect distribution of invasive plants, appropriate management measures can be taken.     

Evolution of the winonaite parent body: Clues from silicate mineral trace element distributions

Abstract— We have measured the trace element compositions of individual plagioclase, pyroxene, and olivine grains in 6 different winonaites that span the range of textures and mineralogies observed in these meteorites. Textural evidence in these meteorites, including the presence of a plagioclase/clinopyroxene‐rich lithology and coarse‐grained olivine lithologies, suggests that they may have experienced some silicate partial melting. However, trace element distributions in these lithologies do not show any clear signatures for such an event. Pyroxene trace element compositions do exhibit systematic trends, with abundances generally lowest in Pontlyfni and highest in Winona. The fact that the same trends are present for both incompatible and compatible trace elements suggests, however, that the systematics are more likely the result of equilibration of minerals with initially heterogeneous and distinct compositions, rather than partial melting of a compositionally homogeneous precursor. The winonaites have experienced brecciation and mixing of lithologies, followed by varying degrees of thermal metamorphism on their parent body. These factors probably account for the variable bulk rare earth element (REE) patterns noted for these meteorites and may have led to re‐equilibration of trace elements in different lithologies.     

Lunar meteorite LaPaz Icefield 04841: Petrology,texture, and impact‐shock effects of a low‐Ti mare basalt

Abstract— Found during the 2004 U.S. Antarctic Search for Meteorites season, LaPaz Icefield (LAP) 04841 represents an addition to the LaPaz lunar basalts suite and brings the total mass collected to 1.93 kg. The presence of FeNi grains, troilite, and the anorthositic composition of plagioclase are evidence for the lunar origin of this meteorite. Pyroxene and olivine Mn/Fe values plot along the trend set for lunar basalts. Analyses of chromite grains provide a V/(Al + Cr) ratio of 1.33 ± 13, translating to an fO₂ one log unit below the IW buffer, in accordance with previous fO₂ estimates for lunar basalts. Application of the Zr‐cooling speedometer, for ilmenite and ulvöspinel pairs, gives a cooling rate of 5.2 °C/day, matching previous estimates of cooling rates for the LaPaz lunar meteorites and Apollo mare basalts. Mineral modes and chemistries, as well as trace‐element patterns, provide compelling evidence for pairing of this meteorite to others in the LaPaz lunar basalt suite.     

A late Holocene paleoclimatic history of Lake Tanganyika, East Africa

A nearshore core (LT03-05) from the north basin of Lake Tanganyika provides diatom, pollen, and sedimentary time series covering the last ca. 3800 yr at 15-36 yr resolution. A chronology supported by 21 AMS dates on terrestrial and lacustrine materials allows us to account for ancient carbon effects on ¹⁴C ages and to propose refinements of the region's climatic history. Conditions drier than those of today were followed after ca. 3.30 ka by an overall wetting trend. Several century-scale climate variations were superimposed upon that trend, with exceptionally rainy conditions occurring 1.70-1.40 ka, 1.15-0.90 ka, 0.70-0.55 ka, and 0.35-0.20 ka. Around 0.55-0.35 ka, during the Spörer sunspot minimum, drier conditions developed in the northern Tanganyika basin while more humid conditions were registered at Lakes Victoria and Naivasha. This indicates significant variability in the nature and distribution of near-equatorial rainfall anomalies during much of the Little Ice Age.