Methodology for construction, calibration and validation of a national hydrological model for Denmark

An integrated groundwater/surface water hydrological model with a 1 km² grid has been constructed for Denmark covering 43,000 km². The model is composed of a relatively simple root zone component for estimating the net precipitation, a comprehensive three-dimensional groundwater component for estimating recharge to and hydraulic heads in different geological layers, and a river component for streamflow routing and calculating stream–aquifer interaction. The model was constructed on the basis of the MIKE SHE code and by utilising comprehensive national databases on geology, soil, topography, river systems, climate and hydrology. The present paper describes the modelling process for the 7330 km² island of Sjælland with emphasis on the problems experienced in combining the classical paradigms of groundwater modelling, such as inverse modelling of steady-state conditions, and catchment modelling, focussing on dynamic conditions and discharge simulation. Three model versions with different assumptions on input data and parameter values were required until the performance of the final, according to pre-defined accuracy criteria, model was evaluated as being satisfactory. The paper highlights the methodological issues related to establishment of performance criteria, parameterisation and assessment of parameter values from field data, calibration and validation test schemes. Most of the parameter values were assessed directly from field data, while about 10 ‘free’ parameters were subject to calibration using a combination of inverse steady-state groundwater modelling and manual trial-and-error dynamic groundwater/surface water modelling. Emphasising the importance of tests against independent data, the validation schemes included combinations of split-sample tests (another period) and proxy-basin tests (another area).     

南极威德尔海冬季冰脊形拖曳力

利用2006年南极威德尔海冬季科学考察期间由机载激光高度计测得的海冰上表面形态数据,以拖曳分割理论为基础研究了冰脊形拖曳力及其对冰-气总拖曳力的贡献以及中性条件下对应10 m高度处风速的冰-气拖曳系数C_dn(10)。结果显示,在密集冰区,冰脊形拖曳力及其对总拖曳力的贡献随冰脊强度(脊高/脊距)的增大呈递增趋势,而随粗糙长度的增大而减小,对应于威德尔海冬季典型冰脊强度和粗糙长度,占总拖曳力的35%,说明了冰脊形拖曳力在冰-气界面动量交换中的重要作用。C_dn(10)随冰脊强度的增大而增大,但冰脊强度较小时,C_dn(10)随粗糙长度增大而增大;而对较大的冰脊强度,C_dn(10)则随粗糙长度增大而减小。     

The fusion crust of the Winchcombe meteorite: A preserved record of atmospheric entry processes

Fusion crusts form during the atmospheric entry heating of meteorites and preserve a record of the conditions that occurred during deceleration in the atmosphere. The fusion crust of the Winchcombe meteorite closely resembles that of other stony meteorites, and in particular CM2 chondrites, since it is dominated by olivine phenocrysts set in a glassy mesostasis with magnetite, and is highly vesicular. Dehydration cracks are unusually abundant in Winchcombe. Failure of this weak layer is an additional ablation mechanism to produce large numbers of particles during deceleration, consistent with the observation of pulses of plasma in videos of the Winchcombe fireball. Calving events might provide an observable phenomenon related to meteorites that are particularly susceptible to dehydration. Oscillatory zoning is observed within olivine phenocrysts in the fusion crust, in contrast to other meteorites, perhaps owing to temperature fluctuations resulting from calving events. Magnetite monolayers are found in the crust, and have also not been previously reported, and form discontinuous strata. These features grade into magnetite rims formed on the external surface of the crust and suggest the trapping of surface magnetite by collapse of melt. Magnetite monolayers may be a feature of meteorites that undergo significant degassing. Silicate warts with dendritic textures were observed and are suggested to be droplets ablated from another stone in the shower. They, therefore, represent the first evidence for intershower transfer of ablation materials and are consistent with the other evidence in the Winchcombe meteorite for unusually intense gas loss and ablation, despite its low entry velocity.     

Attenuation Correction Procedures for Water Vapour Fluxes from Closed-Path Eddy-Covariance Systems

Evapotranspiration is a source of water vapour to the atmosphere, and as a crucial indicator of landscape behaviour its accurate measurement has widespread implications. Here we investigate errors that are prevalent and systematic in the closed-path eddy-covariance measurement of latent heat flux: the attenuation of fluxes through dampened cospectral power at high frequencies. This process is especially pronounced during periods of high relative humidity through the adsorption and desorption of water vapour along the tube walls. These effects are additionally amplified during lower air temperature conditions. Here, we quantify the underestimation of evapotranspiration by a closed-path system by comparing its flux estimate to simultaneous and adjacent measurements from an open-path sensor. We apply models relating flux loss to relative humidity itself, to the lag time of the cross-correlation peak between the water vapour and vertical wind velocity signals, and to models of cospectral attenuation relative to the cospectral power of simultaneous sensible heat-flux measurements. We find that including the role of temperature in modifying the attenuation–humidity relationship is essential for unbiased flux correction, and that physically based cospectral attenuation methods are effective characterizers of closed-path instrument signal loss relative to the unattenuated flux value.     

On the use of synthetic tropical cyclones and hypothetical events for storm surge assessment under climate change

Natural Hazards - This study presents a new approach to assess storm surge risk from tropical cyclones under climate change by direct calculation of the local flood levels using a limited number of...     

Intra-oceanic settings of the western Mexico Late Jurassic-Early Cretaceous arc sequences. Implications for the Pacific-Tethys geodynamic relationships during the Cretaceous

Abstract

The Guerrero suspect terrane composed of Late Jurassic-Early Cretaceous sequences, extends from Baja California up to Acapulco and is considered to be coeval with the Late Mesozoic igneous and sedimentary arc sequences of the Greater Antilles, Venezuela and Western Cordillera of Colombia. New geological, petrological and geochemical data from central and southern Mexico, led us to propose a new model for the building of the Alisitos-Teloloapan arc. This arc, partly built on the Pacific oceanic lithosphere and partly on continental fragments, could be related to the subduction of an oceanic basin - the Arperos basin - under the Paleo-Pacific plate. This subduction was dipping southwest.

At the beginning of the magmatic activity of the oceanic segment of this arc, depleted tholeiitic basalts were emitted in a submarine environnement below the CCD. While subduction was going on, the arc magmas evolved from LREE depleted tholeiites to slightly LREE enriched tholeiites and then, to calc-alkaline basalts and andesites enriched in LREE and HFSE. Concurrently, the arc sedimentary environment changed from deep oceanic to neritic with the deposition of Aptian-Albian reefal limestones, at the end of the arc building. In the continent-based segment, the arc magmas are exclusively differentiated calc-alkaline suites depleted in HREE and Y, formed of predominantly siliceous lavas and pyroclastic rocks, emitted in a sub-aerial or shallow marine environment.

Thus, taking into account this above mentioned model, the Cretaceous volcanic series, accreted to the margins of cratonal America, in Colombia, Venezuela, Greater Antilles and Mexico, could be related to the same west-south-west dipping subduction of oceanic basins, fringing the North and South American continental cratons and connected directly with the inter-American Tethys. While the subduction was proceeding, this magmatic arc drifted towards the North and South American cratons and finally, collided with the continental margins at different periods during the Cretaceous.