Hydrogeology and sustainable future groundwater abstraction from the Agua Verde aquifer in the Atacama Desert,northern Chile

The hyper-arid conditions prevailing in Agua Verde aquifer in northern Chile make this system the most important water source for nearby towns and mining industries. Due to the growing demand for water in this region, recharge is investigated along with the impact of intense pumping activity in this aquifer. A conceptual model of the hydrogeological system is developed and implemented into a two-dimensional groundwater-flow numerical model. To assess the impact of climate change and groundwater extraction, several scenarios are simulated considering variations in both aquifer recharge and withdrawals. The estimated average groundwater lateral recharge from Precordillera (pre-mountain range) is about 4,482 m³/day. The scenarios that consider an increase of water withdrawal show a non-sustainable groundwater consumption leading to an over-exploitation of the resource, because the outflows surpasses inflows, causing storage depletion. The greater the depletion, the larger the impact of recharge reduction caused by the considered future climate change. This result indicates that the combined effects of such factors may have a severe impact on groundwater availability as found in other groundwater-dependent regions located in arid environments. Furthermore, the scenarios that consider a reduction of the extraction flow rate show that it may be possible to partially alleviate the damage already caused to the aquifer by the continuous extractions since 1974, and it can partially counteract climate change impacts on future groundwater availability caused by a decrease in precipitation (and so in recharge), if the desalination plant in Taltal increases its capacity.     

南极威德尔海冬季冰脊形拖曳力

利用2006年南极威德尔海冬季科学考察期间由机载激光高度计测得的海冰上表面形态数据,以拖曳分割理论为基础研究了冰脊形拖曳力及其对冰-气总拖曳力的贡献以及中性条件下对应10 m高度处风速的冰-气拖曳系数C_dn(10)。结果显示,在密集冰区,冰脊形拖曳力及其对总拖曳力的贡献随冰脊强度(脊高/脊距)的增大呈递增趋势,而随粗糙长度的增大而减小,对应于威德尔海冬季典型冰脊强度和粗糙长度,占总拖曳力的35%,说明了冰脊形拖曳力在冰-气界面动量交换中的重要作用。C_dn(10)随冰脊强度的增大而增大,但冰脊强度较小时,C_dn(10)随粗糙长度增大而增大;而对较大的冰脊强度,C_dn(10)则随粗糙长度增大而减小。     

Experimental impact cratering: A summary of the major results of the MEMIN research unit

This paper reviews major findings of the Multidisciplinary Experimental and Modeling Impact Crater Research Network (MEMIN). MEMIN is a consortium, funded from 2009 till 2017 by the German Research Foundation, and is aimed at investigating impact cratering processes by experimental and modeling approaches. The vision of this network has been to comprehensively quantify impact processes by conducting a strictly controlled experimental campaign at the laboratory scale, together with a multidisciplinary analytical approach. Central to MEMIN has been the use of powerful two-stage light-gas accelerators capable of producing impact craters in the decimeter size range in solid rocks that allowed detailed spatial analyses of petrophysical, structural, and geochemical changes in target rocks and ejecta. In addition, explosive setups, membrane-driven diamond anvil cells, as well as laser irradiation and split Hopkinson pressure bar technologies have been used to study the response of minerals and rocks to shock and dynamic loading as well as high-temperature conditions. We used Seeberger sandstone, Taunus quartzite, Carrara marble, and Weibern tuff as major target rock types. In concert with the experiments we conducted mesoscale numerical simulations of shock wave propagation in heterogeneous rocks resolving the complex response of grains and pores to compressive, shear, and tensile loading and macroscale modeling of crater formation and fracturing. Major results comprise (1) projectile–target interaction, (2) various aspects of shock metamorphism with special focus on low shock pressures and effects of target porosity and water saturation, (3) crater morphologies and cratering efficiencies in various nonporous and porous lithologies, (4) in situ target damage, (5) ejecta dynamics, and (6) geophysical survey of experimental craters.     

Sediment transport in high‐speed flows over a fixed bed: 2. Particle impacts and abrasion prediction

Single bed load particle impacts were experimentally investigated in supercritical open channel flow over a fixed planar bed of low relative roughness height simulating high‐gradient non‐alluvial mountain streams as well as hydraulic structures. Particle impact characteristics (impact velocity, impact angle, Stokes number, restitution and dynamic friction coefficients) were determined for a wide range of hydraulic parameters and particle properties. Particle impact velocity scaled with the particle velocity, and the vertical particle impact velocity increased with excess transport stage. Particle impact and rebound angles were low and decreased with transport stage. Analysis of the particle impacts with the bed revealed almost no viscous damping effects with high normal restitution coefficients exceeding unity. The normal and resultant Stokes numbers were high and above critical thresholds for viscous damping. These results are attributed to the coherent turbulent structures near the wall region, i.e. bursting motion with ejection and sweep events responsible for turbulence generation and particle transport. The tangential restitution coefficients were slightly below unity and the dynamic friction coefficients were lower than for alluvial bed data, revealing that only a small amount of horizontal energy was transferred to the bed. The abrasion prediction model formed by Sklar and Dietrich in 2004 was revised based on the new equations on vertical impact velocity and hop length covering various bed configurations. The abrasion coefficient k_v was found to be vary around k_v ~ 10⁵ for hard materials (tensile strength f_t > 1 MPa), one order of magnitude lower than the value assumed so far for Sklar and Dietrich's model. Copyright © 2017 John Wiley & Sons, Ltd.     

Methodology for construction, calibration and validation of a national hydrological model for Denmark

An integrated groundwater/surface water hydrological model with a 1 km² grid has been constructed for Denmark covering 43,000 km². The model is composed of a relatively simple root zone component for estimating the net precipitation, a comprehensive three-dimensional groundwater component for estimating recharge to and hydraulic heads in different geological layers, and a river component for streamflow routing and calculating stream–aquifer interaction. The model was constructed on the basis of the MIKE SHE code and by utilising comprehensive national databases on geology, soil, topography, river systems, climate and hydrology. The present paper describes the modelling process for the 7330 km² island of Sjælland with emphasis on the problems experienced in combining the classical paradigms of groundwater modelling, such as inverse modelling of steady-state conditions, and catchment modelling, focussing on dynamic conditions and discharge simulation. Three model versions with different assumptions on input data and parameter values were required until the performance of the final, according to pre-defined accuracy criteria, model was evaluated as being satisfactory. The paper highlights the methodological issues related to establishment of performance criteria, parameterisation and assessment of parameter values from field data, calibration and validation test schemes. Most of the parameter values were assessed directly from field data, while about 10 ‘free’ parameters were subject to calibration using a combination of inverse steady-state groundwater modelling and manual trial-and-error dynamic groundwater/surface water modelling. Emphasising the importance of tests against independent data, the validation schemes included combinations of split-sample tests (another period) and proxy-basin tests (another area).     

Eutrephoceras subplicatum (Steinmann, 1895) is a junior synonym of Eutrephoceras dorbignyanum (Forbes in Darwin, 1846) (Cephalopoda, Nautiloidea) from the Maastrichtian Quiriquina Formation of Chile

Nautilus subplicatusSteinmann, 1895 is a latest Cretaceous species of nautiloid which is common in southern South America (Chile, Argentina) and the Antarctic Peninsula and which is best assigned to the genus EutrephocerasHyatt, 1894. Nautilus dorbignyanusForbes in Darwin, 1846 and Nautilus valenciennii Hupé in Gay, 1854 are here considered to be senior synonyms which later authors have apparently overlooked. The type material of these two taxa is reillustrated. On the basis of this and additional material it is demonstrated that only a single nautiloid species occurs in the Quiriquina Formation of late Maastrichtian age. For this we propose to use N. dorbignyanus as the oldest available name.     

On the use of synthetic tropical cyclones and hypothetical events for storm surge assessment under climate change

Natural Hazards - This study presents a new approach to assess storm surge risk from tropical cyclones under climate change by direct calculation of the local flood levels using a limited number of...     

Intra-oceanic settings of the western Mexico Late Jurassic-Early Cretaceous arc sequences. Implications for the Pacific-Tethys geodynamic relationships during the Cretaceous

Abstract

The Guerrero suspect terrane composed of Late Jurassic-Early Cretaceous sequences, extends from Baja California up to Acapulco and is considered to be coeval with the Late Mesozoic igneous and sedimentary arc sequences of the Greater Antilles, Venezuela and Western Cordillera of Colombia. New geological, petrological and geochemical data from central and southern Mexico, led us to propose a new model for the building of the Alisitos-Teloloapan arc. This arc, partly built on the Pacific oceanic lithosphere and partly on continental fragments, could be related to the subduction of an oceanic basin - the Arperos basin - under the Paleo-Pacific plate. This subduction was dipping southwest.

At the beginning of the magmatic activity of the oceanic segment of this arc, depleted tholeiitic basalts were emitted in a submarine environnement below the CCD. While subduction was going on, the arc magmas evolved from LREE depleted tholeiites to slightly LREE enriched tholeiites and then, to calc-alkaline basalts and andesites enriched in LREE and HFSE. Concurrently, the arc sedimentary environment changed from deep oceanic to neritic with the deposition of Aptian-Albian reefal limestones, at the end of the arc building. In the continent-based segment, the arc magmas are exclusively differentiated calc-alkaline suites depleted in HREE and Y, formed of predominantly siliceous lavas and pyroclastic rocks, emitted in a sub-aerial or shallow marine environment.

Thus, taking into account this above mentioned model, the Cretaceous volcanic series, accreted to the margins of cratonal America, in Colombia, Venezuela, Greater Antilles and Mexico, could be related to the same west-south-west dipping subduction of oceanic basins, fringing the North and South American continental cratons and connected directly with the inter-American Tethys. While the subduction was proceeding, this magmatic arc drifted towards the North and South American cratons and finally, collided with the continental margins at different periods during the Cretaceous.