Normal faulting vs regional subsidence and sedimentation rate

Normal faults occur in a variety of geodynamic environments, both in areas of subsidence and uplift. Normal faults may have slip rates faster or slower than regional subsidence or uplift rates. The total subsidence may be defined as the sum of the hangingwall subsidence generated by the normal fault and the regional subsidence or uplift rate. Positive total subsidence obviously increases the accommodation space (e.g., passive margins and back-arc basins), in contrast with negative total subsidence (e.g., orogens). Where the hangingwall subsidence rate is faster than the sedimentation rate in cases of both positive and negative total subsidence, the facies and thickness of the syntectonic stratigraphic package may vary from the hangingwall to the footwall. A hangingwall subsidence rate slower than sedimentation rate only results in a larger thickness of the strata growing in the hangingwall, with no facies changes and no morphological step at the surface. The isostatic footwall uplift is also proportional to the amount and density of the sediments filling the half-graben and therefore it should be more significant when the hangingwall subsidence rate is higher than sedimentation rate.     

Hydrodynamic and isotopic investigations for evaluating the mechanisms and amount of groundwater seepage through a rockslide dam

This study addresses the influence of landslide dams on surface water drainage and groundwater flow. In the study area of Scanno Lake and Sagittario River (Central Italy), a limestone rockslide‐avalanche formed a lake, which has an outlet that is occasionally active, showing infiltration into the rockslide dam. Several springs are present at the lake's base and are partly fed by seepage through the rockslide debris. Piezometric surveys, discharge measurements, pumping tests and chemical analyses are tools used to build a conceptual model of the groundwater flow and to evaluate the flow through the rockslide debris. Seasonal water isotopic signatures validate the assumed model, showing a mixing of infiltration recharge and groundwater seepage throughout the rockslide debris. Various recharge areas have been found for springs, pointing out those directly fed by the rockslide debris aquifer. Hypotheses about seasonal groundwater mixing between the regional carbonate aquifer and the rockslide debris aquifer are supported by isotope results. Seasonal changes in groundwater table level due to recharge and surface losses from seasonal outlet have been correlated with isotopic groundwater composition from the rockslide debris aquifer and the downstream springs; this relationship highlights the role of the rockslide dam body on the hydrodynamics of the studied area. Relationships between surface waters and groundwater in the area have been completely understood on the basis of water isotopic fingerprinting, finally obtaining a complete evaluation of groundwater renewable resources and its regimen. Copyright © 2010 John Wiley & Sons, Ltd.     

Azimut di una geodetica ellissoidica passante per due punti molto lontani fra loro

Riassunto L'Autore presenta un procedimento per la ricerca dell'azimut di una geodetica ellissoidica passante per due punti molto lontani fra loro. Istituisce dapprima una corrispondenza fra la geodetica ed un arco di cerchio massimo, corrispondenza definita con l'imporre uguali coordinate agli estremi dei due archi e la latitudine sferica normale uguale a quella ellissoidica. Sviluppa poi la longitudine ellissoidicaw in funzione di quella sferical, e poichè l fra gli estremi dell'arco di cerchio deve essere uguale a w, ne deduce una equazione per ricavare l'azimut.

---

Summary The Author outlines a procedure to research the azimuth of an ellipsoidal geodesic, which passes through two points far distant from another. A corrispondence is first instituted between the geodesic and a bow of maximum circle; this correspondence may be defined by imposing the same coordinates to the extreme parts of the two bows and the spherical normal latitude equal to the ellipsoidal one. The ellipsoidal longitudew is next developed as a function of the spherical onel and, as l between the extreme parts of the circle bow must equal w, an equation is hereby deduced to find out the azimuth.

     

Late Holocene glacial and periglacial evolution in the upper Orco Valley, northwestern Italian Alps

The sediments present in some areas of the Orco Valley provide indications on climatic variations that occurred during the last 6000 years on the southern slopes of the Alps. In particular, distribution and ages of peat layers help define periods and extent of glacial fluctuation in the last 2200 years. Sampling of soils involved in periglacial processes provided a basis for development of a chronological framework of late Holocene environmental change. The data indicate a trend toward cooler climate in the second half of the Holocene. A strong relationship exists between phases of River Po flooding and expansion/retreat phases of the Swiss glaciers: major glacial advances were coeval with periods of intense flooding of the River Po, whereas the phases of glacial retreat coincided with periods of little flooding of the Po. Only in three cases do relationships between glacier activity and floods show weak correlations; two of the cases relate to the warmest periods in approximately the last 2200 years, while the third is the present period. Paleoclimatic evidence from the study region indicates the relatively warm Roman Period between about 2200 and 1900 cal yr BP appears to better represent modern conditions than does the Medieval Warm Period.     

The 15 m.y. geomagnetic reversal periodicity: a quantitative test

We have analyzed the three most commonly used geomagnetic polarity time scales that cover the past 100 m.y.. In the three cases, different spectral analyses show a 13–16 m.y. periodicity in the rate of reversal occurrence. To test whether this periodicity is real or simply arises from a random generator we have compared these polarity time scales with a large number of synthetic sequences produced by a random process, characterized by a linear time variation of its mean activity. Geomagnetic and generated sequences were regularly sampled by using sliding windows, anf then the Fourier spectra of the obtained frequency signals were compared. This test shows that the detected periodicity is presumably not a simple statistical fluctuation of an aperiodic generator, and consequently that a long-term periodicity in the geodynamo must be seriously considered.     

Separation of PP- and PS-wave reflected seismic data using two-dimensional finite offset common-reflection-surface traveltime approximation

Recently, the interest in PS-converted waves has increased for several applications, such as sub-basalt layer imaging, impedance estimates and amplitude-versus-offset analysis. In this study, we consider the problem of separation of PP- and PS-waves from pre-stacked multicomponent seismic data in two-dimensional isotropic medium. We aim to demonstrate that the finite-offset common-reflection-surface traveltime approximation is a good alternative for separating PP- and PS-converted waves in common-offset and common shot configurations by considering a two-dimensional isotropic medium. The five parameters of the finite-offset common-reflection-surface are firstly estimated through the inversion methodology called very fast simulated annealing, which estimates all parameters simultaneously. Next, the emergence angle, one of the inverted parameters, is used to build an analytical separation function of PP and PS reflection separation based on the wave polarization equations. Once the PP- and PS-converted waves were separated, the sections are stacked to increase the signal-to-noise ratio using the special curves derived from finite-offset common-reflection-surface approximation. We applied this methodology to a synthetic dataset from simple-layered to complex-structured media. The numerical results showed that the inverted parameters of the finite offset common-reflection-surface and the separation function yield good results for separating PP- and PS-converted waves in noisy common-offset and common shot gathers.     

Carbon dioxide degassing and thermal energy release in the Monte Amiata volcanic-geothermal area (Italy)

The quaternary volcanic complex of Mount Amiata is located in southern Tuscany (Italy) and represents the most recent manifestation of the Tuscan Magmatic Province. The region is characterised by a large thermal anomaly and by the presence of numerous CO₂-rich gas emissions and geothermal features, mainly located at the periphery of the volcanic complex. Two geothermal systems are located, at increasing depths, in the carbonate and metamorphic formations beneath the volcanic complex. The shallow volcanic aquifer is separated from the deep geothermal systems by a low permeability unit (Ligurian Unit). A measured CO₂ discharge through soils of 1.8 × 10⁹ mol a⁻¹ shows that large amounts of CO₂ move from the deep reservoir to the surface. A large range in δ¹³C_TDIC (−21.07 to +3.65) characterises the waters circulating in the aquifers of the region and the mass and isotopic balance of TDIC allows distinguishing a discharge of 0.3 × 10⁹ mol a⁻¹ of deeply sourced CO₂ in spring waters. The total natural CO₂ discharge (2.1 × 10⁹ mol a⁻¹) is slightly less than minimum CO₂ output estimated by an indirect method (2.8 × 10⁹ mol a⁻¹), but present-day release of 5.8 × 10⁹ mol a⁻¹ CO₂ from deep geothermal wells may have reduced natural CO₂ discharge. The heat transported by groundwater, computed considering the increase in temperature from the infiltration area to the discharge from springs, is of the same order of magnitude, or higher, than the regional conductive heat flow (>200 mW m⁻²) and reaches extremely high values (up to 2700 mW m⁻²) in the north-eastern part of the study area. Heat transfer occurs mainly by conductive heating in the volcanic aquifer and by uprising gas and vapor along fault zones and in those areas where low permeability cover is lacking. The comparison of CO₂ flux, heat flow and geological setting shows that near surface geology and hydrogeological setting play a central role in determining CO₂ degassing and heat transfer patterns.     

A new insight into land use classification based on aggregated mobile phone data

Land-use classification is essential for urban planning. Urban land-use types can be differentiated either by their physical characteristics (such as reflectivity and texture) or social functions. Remote sensing techniques have been recognized as a vital method for urban land-use classification because of their ability to capture the physical characteristics of land use. Although significant progress has been achieved in remote sensing methods designed for urban land-use classification, most techniques focus on physical characteristics, whereas knowledge of social functions is not adequately used. Owing to the wide usage of mobile phones, the activities of residents, which can be retrieved from the mobile phone data, can be determined in order to indicate the social function of land use. This could bring about the opportunity to derive land-use information from mobile phone data. To verify the application of this new data source to urban land-use classification, we first construct a vector of aggregated mobile phone data to characterize land-use types. This vector is composed of two aspects: the normalized hourly call volume and the total call volume. A semi-supervised fuzzy c-means clustering approach is then applied to infer the land-use types. The method is validated using mobile phone data collected in Singapore. Land use is determined with a detection rate of 58.03%. An analysis of the land-use classification results shows that the detection rate decreases as the heterogeneity of land use increases, and increases as the density of cell phone towers increases.     

Geomorphometric analysis based on discrete wavelet transform

This work presents a geomorphometric approach for outlining anomalies of the topographic surface that may be related to geological structures or to geomorphological phenomena. It is based on 2D discrete wavelet transform of digital elevation models. This transform is used to extract singularities of a series of data. This is specifically applied to a digital elevation model, in order to get its detail coefficients and to have evidence about their variations and values. In particular, this approach can be helpful for the delineation and identification of landforms singularities, like landslides and geological structures. The potential and effectiveness of this approach is shown by an application to a case study about a large deep-seated landslide, located at the central-south front of the Apennine in South Italy.     

基于分布式大流域径流模型的中国西北黑河流域水文模拟

水资源短缺是中国西北干旱地区长期的问题,区域人口增加、城市化扩张,加之气候变化的影响进一步加剧了西北地区水资源短缺,也使生活用水、灌溉用水、工业用水和维持生态系统稳定的用水危险加剧.采用分布式大流域径流模型(DLBRM)模拟黑河流域水文(中国第二大内陆河,流域面积128 000 km2)来理解区域的冰川和积雪融化水、地下水、地表水、蒸散发等方面的分布,评估气候变化对水文的影响和冰川退缩对中游和下游来水量的影响.模拟结果表明,黑河流域的大部分产流那源于黑河上游地区的祁连山.模拟1990-2000年黑河河流日流量变化结果认为,黑河中游正义峡给下游的供水为10×108m3,其中地表径流占51%,层间流占49%.中游地区沙土具有较高的蒸腾发能力,近一半的地表水被蒸发掉.模拟实践证明,分布式大流域径流模型可以结合气候变化、水资源管理方面的成果,改进流域水文模拟的精度.