Isotopic and geochemical characterization of salinization in the shallow aquifers of a reclaimed subsiding zone: The southern Venice Lagoon coastland

The coastal plain bordering the southern Venice Lagoon is a reclaimed lowland characterized by high subsidence rate, and ground level and water-table depth below sea level. In this agricultural region, where the surface hydrologic network is entirely artificially controlled by irrigation/drainage canals, salinization problems have long been encountered in soils and groundwaters. Here we use isotopic and geochemical tracers to improve our understanding of the origin of salinization and mineralization of the semi-confined aquifer (0–40 m), and the freshwater inputs to this hydrological system. Water samples have been collected at different seasons in the coastal Adriatic Sea, lagoon, rivers and irrigation canals, as well as in the semi-confined aquifer at depths between 12 and 35 m (14 boreholes), and in the first confined aquifer (three boreholes drilled between 40 and 80 m depth). Stable isotopes (δ¹⁸O and δD) and conductivity profiles show that direct saline intrusion from the sea or the lagoon is observed only in a restricted coastal strip, while brackish groundwaters are found over the entire topographic and piezometric depression in the centre of the study area. Fresh groundwaters are found only in the most western zone. The sharp isotopic contrast between the western and central regions suggests disconnected hydrological circulations between these two parts of the shallow aquifer. The border between these two regions also corresponds to the limits of the most strongly subsiding zone.Our results can be interpreted in terms of a four end-member mixing scheme, involving (1) marine water from the lagoon or the open sea, (2) alpine and pre-alpine regional recharge waters carried either by the main rivers Adige, Bacchiglione and Brenta (irrigation waters) or by the regional groundwater circulation, (3) local precipitation, and (4) evaporated waters infiltrated from the surface. Infiltration from the surface is also revealed by the stratification of the electrical conductivity profiles, showing that the brackish groundwaters are overlain by a shallow layer of less saline water all over the central depression. In the first confined aquifer, the groundwaters have isotopic compositions similar to the deep groundwaters of the Venetian confined aquifers (40–400 m depth). The isotopic data and the Br/Cl ratio show that the origin of the salinization of the phreatic aquifer can be ascribed to seawater intrusion alone, with no indication of the involvement of deep brines (identified at 450 m depth) in the process.The chemical composition of the saline and brackish groundwaters is characterized by an excess of sodium and a deficit of calcium compared to conservative mixing between fresh groundwaters and seawater. This suggests that the phreatic aquifer is progressively freshening, as a consequence of the beneficial influence of the extensive irrigation/drainage network, including raised canals acting as a hydraulic barrier along the coast. This freshening tendency may have been lasting since the reclamation in the mid-twentieth century, and has probably been accelerated by the ban on groundwater abstraction since the 1970s.     

Meridional circulation in the radiation zones of rotating stars: Origins,behaviors and consequences on stellar evolution

Stellar radiation zones are the seat of meridional currents. This circulation has a strong impact on the transport of angular momentum and the mixing of chemicals that modify the evolution of stars. First, we recall in details the dynamical processes that are taking place in differentially rotating stellar radiation zones and the assumptions which are adopted for their modelling in stellar evolution. Then, we present our new results of numerical simulations which allow us to follow in 2D the secular hydrodynamics of rotating stars, assuming that anisotropic turbulence enforces a shellular rotation law and taking into account the transport of angular momentum by internal gravity waves. The different behaviors of the meridional circulation in function of the type of stars which is studied are discussed with their physical origin and their consequences on the transport of angular momentum and of chemicals. Finally, we show how this work is leading to a dynamical vision of the evolution of rotating stars from their birth to their death. (© 2007 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim)     

Magnetosheath Structure in an Anisotropic Plasma Model

Variations of the magnetic field and plasma parameters across the Earth's magnetosheath are calculated for an anisotropic plasma in the Chew-Goldberger-Low approximation. Additionally, proton pitch-angle diffusion is taken into account as the energy transfer mechanism between the direction perpendicular and parallel to the magnetic field. We discuss the main characteristics of the magnetic barrier for different temperature relaxation times and their dependence on the interplanetary magnetic field orientation. This revised version was published online in July 2006 with corrections to the Cover Date.     

Reconstructing fluvial bar surfaces from compound cross‐strata and the interpretation of bar accretion direction in large river deposits

The interpretation of fluvial styles from the rock record is based for a significant part on the identification of different types of fluvial bars, characterized by the geometric relationship between structures indicative of palaeocurrent and surfaces interpreted as indicative of bar form and bar accretion direction. These surfaces of bar accretion are the boundaries of flood‐related bar increment elements, which are typically less abundant in outcrops than what would be desirable, particularly in large river deposits in which each flood mobilizes large volumes of sediment, causing flood‐increment boundary surfaces to be widely spaced. Cross‐strata set boundaries, on the other hand, are abundant and indirectly reflect the process of unit bar accretion, inclined due to the combined effect of the unit bar surface inclination and the individual bedform climbing angle, in turn controlled by changes in flow structure caused by local bar‐scale morphology. This work presents a new method to deduce the geometry of unit bar surfaces from measured pairs of cross‐strata and cross‐strata set boundaries. The method can be used in the absence of abundant flood‐increment bounding surfaces; the study of real cases shows that, for both downstream and laterally accreting bars, the reconstructed planes are very similar to measured bar increment surfaces.     

Raman spectroscopic studies of carbonates part I: High-pressure and high-temperature behaviour of calcite,magnesite, dolomite and aragonite

The room-temperature Raman spectra of aragonite, magnesite and dolomite have been recorded up to 30 GPa and 25 GPa, respectively and no phase changes were observed during compression, unlike calcite. The effect of temperature on the room-pressure Raman spectra of calcite, aragonite, magnesite and dolomite is reported up to 800–1100 K. The measured relative pressure and temperature-shifts of the Raman lines are greater for the lattice modes than for the internal modes of the CO₃ groups. These shifts are used to calculate the mode anharmonic parameters of the observed Raman modes; they are negative and their absolute values are smaller (close to 0) for the internal CO₃ modes than for the lattice modes (4–17 10^?5 K^?1). The temperature shifts of the lattice modes in calcite are considerably larger than those for dolomite and magnesite, and a marked non-linear increase in linewidth is observed above 400° C for calcite. This is consistent with an increasing relaxational component to the libration of the CO₃ groups about their threefold axes, premonitory to the rotational order-disorder transition at higher temperature. This behaviour is not observed for the other calcite structured minerals in this study. We examine systematic variations in the lattice mode frequencies and linewidths with composition, to begin to understand these differences in their anharmonic behaviour. Finally, we have used a simple Debye-Waller model to calculate atomic displacements in calcite, magnesite and dolomite with increasing temperature from the vibrational frequency data, to provide a direct comparison with atomic positional data from high-temperature structure refinements.     

An Observational Study of the Mesoscale Mistral Dynamics

We investigate the mesoscale dynamics of the mistral through the wind profiler observations of the MAP (autumn 1999) and ESCOMPTE (summer 2001) field campaigns. We show that the mistral wind field can dramatically change on a time scale less than 3 hours. Transitions from a deep to a shallow mistral are often observed at any season when the lower layers are stable. The variability, mainly attributed in summer to the mistral/land–sea breeze interactions on a 10-km scale, is highlighted by observations from the wind profiler network set up during ESCOMPTE. The interpretations of the dynamical mistral structure are performed through comparisons with existing basic theories. The linear theory of R. B. Smith [Advances in Geophysics, Vol. 31, 1989, Academic Press, 1–41] and the shallow water theory [Schär, C. and Smith, R. B.: 1993a, J. Atmos. Sci. 50, 1373–1400] give some complementary explanations for the deep-to-shallow transition especially for the MAP mistral event. The wave breaking process induces a low-level jet (LLJ) downstream of the Alps that degenerates into a mountain wake, which in turn provokes the cessation of the mistral downstream of the Alps. Both theories indicate that the flow splits around the Alps and results in a persistent LLJ at the exit of the Rhône valley. The LLJ is strengthened by the channelling effect of the Rhône valley that is more efficient for north-easterly than northerly upstream winds despite the north–south valley axis. Summer moderate and weak mistral episodes are influenced by land–sea breezes and convection over land that induce a very complex interaction that cannot be accurately described by the previous theories.     

Dissolution of calcitic marble and dolomitic rock in high iron concentrated acid mine drainage: application to anoxic limestone drains

Oxidation of sulphide mining waste can generate acid mine drainage (AMD) that has the potential to seriously affect the ecosystems. Acid mine drainage is characterised by a high acidity, high concentrations of sulphates and metals. To reduce the environmental impacts due to AMD, neutralisation using limestone drains is an option proposed in the literature and used around the world. The present study focuses on the influence of the carbonate rock mineralogy and their particle size on the neutralising capacity. The tests were performed in two different anoxic conditions: in batch reactors, and in columns having a hydraulic retention time of 15?h. The results showed that the neutralisation capacity of calcite was more important than for dolomitic rock, and smaller particle size gave higher alkalinity production (fine calcite dissolved faster in contact with AMD). A characterization of metal precipitate in sludge and in limestone coating was performed and demonstrated that gypsum, lepidocrocite and goethite were the predominant secondary minerals to be formed. Finally, this study underlines that anoxic limestone drain cannot be used alone to treat high iron concentrated AMD.     

Diffusion effects on oxygen isotope temperatures of slowly cooled igneous and metamorphic rocks

Recently obtained data on oxygen diffusion in feldspars, quartz, and hornblende permit the prediction of the apparent¹⁸O¹⁶O temperatures that would be measured in a rock that consisted only of those three minerals, and cooled slowly from high temperature. The computed temperatures would be based on the differences in the¹⁸O¹⁶O ratios between coexisting pairs of minerals. The present calculation takes into account the diffusion rates for oxygen as a function of temperature, the cooling rate of the rock, the mineral grain sizes, and the mode of the rock. For mineral grains 1 mm in radius, and a cooling rate of 10°C/m.y., the minimum difference in apparent temperature between quartz-feldspar and feldspar-hornblende pairs will be 115°C, despite the assumption of a normal, uneventful, slow cooling history to room temperature. Further, the apparent quartz-hornblende temperature will range over 30°C (590–620°C) depending on the mode of the rock. For a cooling rate of 1000°C/m.y., the apparent difference in temperature can be as much as 400°C. Consequently, consistency in temperatures obtained by oxygen isotope analysis should not be expected in most high-grade metamorphic rocks or igneous rocks which are cooled slowly. Departures from the pattern of temperatures obtained in this model would imply a very rapid quench from high temperature, or a complex history for the rock. For some minerals, including hornblende, the relation between temperature and the equilibrium fractionation of oxygen isotopes between coexisting phases has been derived from observed relations in natural specimens. The choice of the specimens used for such calibrations needs to be re-evaluated in light of these findings. This may result in a change in the equilibrium equation constants.An example from the literature, the San Jose tonalite, Baja California, Mexico, was modelled and yieldsδ¹⁸O concentrations in the minerals that correspond closely with the measured values. This suggests that the model used is appropriate, that the rock has had a simple thermal history, and that it cooled at 100–200°C/m.y. over the temperature range 800–500°C. The set of paleotemperatures obtained for a rock will, in general, yield neither the mineral closure temperatures nor the formation or crystallization temperatures. On the other hand, the cooling rate of the rock may be derived from the data. This, in turn, may have important tectonic implications with regard to denudation and uplift rates.