Numerical and simplified methods for the calculation of the total horizontal wave force on a perforated caisson with a top cover

The VOF method and the k–ε model, combined with the equation of state of air at constant temperature, have been used to calculate the total horizontal wave force caused by monochromatic waves acting on a perforated caisson with a top cover. From comparison of various parameters, such as the total horizontal force, the pressure difference on the front wall, the pressure on the back wall and the pressure on the top cover, between the numerical results and test data, it can be seen that the numerical results agree well with the test data. It is concluded that the method described in this paper can be utilized to calculate wave forces acting on perforated caissons with a top cover in the case of nonovertopping, nonbreaking waves. A simplified method to calculate the total horizontal force has been developed, based on test data, using a least-squares method. A comparison between the numerical results and the values calculated from the simplified equations shows good agreement. Therefore the simplified equations can be used in engineering applications to evaluate the total horizontal force on a perforated caisson with a top cover.     

湄洲湾表层沉积物中重金属的地球化学特征

根据1984年湄洲湾表层沉积物中重金属的分析资料,讨论了它们的地球化学特征和主要来源。沉积物中重金属的含量(Fe、Mn、Cu、Ni 的质量分数均值分别为3.21%、730×10~(-6)、19.4×10~(-6)、44×10~(-6)分布比较均匀,Pb、Zn 和Co 含量(质量分数均值分别为47.0×10~(-6)、25.8×10~(-6)和243×10~(-6))偏高,微量金属含量不受Fe-Mn 氧化物和有机物控制,本地区的金属来源受陆源输入的影响明显。     

扇贝的养殖环境及其体内的细菌学分析

自1992年9月～1994年11月，对青岛胶州湾养殖的扇贝及环境中的细菌组成和某些生态学特性进行了调查。养殖区表层海水中异养菌和弧菌平均数各波动于（21．2～39．7）×102／cm3和（7．3～19．2）×102／cm3之间。其中1号和4号站位的菌数比其它越位都高，这和它们靠近码头，受到附近的排水污染有关。在扇贝的消化盲囊和性腺内也分离到异养菌和弧菌，分别为103～105个g和103～105个／g。这些细菌可能因扇贝遇到环境改变防御能力下降时，扩散到其它器官并大量繁殖，因而造成感染而死亡。从对分离菌的药物敏感试验结果看，近年一些菌株对原来敏感的药物产生了抗药性，如四环索和链霉素，今后在育苗过程中避免滥用抗菌药物是十分重要的。     

Optimal Design for Main Dimensions of a 75000t Floating Production and Storage Vessel

The basis, process and results of the demonstration of the main dimensions of a 75000t floating production and storage vessel are discussed in this paper. A simple but reliable orthogonal design method is applied in the main dimension optimization. The ideas of gradual approximation and feedback from various aspects are put into effect. During the demonstration, in order to make the model tally with the actual situation, the draft design is closely related to the computational analysis, so that the demonstration model can be verified at any time; the handling of the overall system is closely related to the research of each item, which is beneficial not only to the mastery of various regularities, but also to the balance of decisions. Finally, according to the computational results and the regularities obtained from analysis, the main dimensions are determined.     

三峡工程对河口及邻近海域渔业影响的初步探讨

河口只是河流与海洋之间的一小部分水域,但对人类社会的发展和生物的进化起着重要的作用。它不仅是生物种群繁殖、育幼和栖息的场所,而且是溯河和降海鱼类洄游的必经之路,因此,河口对生物种群的繁衍延续和资源补充,以及保持生态平衡具有十分重要的意义。 然而,河口又是生态环境十分脆弱和敏感的水域,同时也是受人类干扰最为严重的区域。因此,河口的生态环境问题愈来愈引起人们的关注,其中包括长江三峡水库的兴建对长江口及其附近海域生态、环境的影响,特别是对位于河口两侧的我国著名两大渔场——舟山渔场和吕四渔场的影响问题。影响渔业资源的因子是多方面而且错综复杂的。本文主要通过长江径流的变化与环境因子变量的相关分析,并根据三峡水库不同蓄水方案,对河口近海渔业的影响问题进行初步探讨。     

Computation of Viscous Uniform and Shear Flow over A Circular Cylinder by A Finite Element Method

The incompressible viscous uniform and shear flow past a circular cylinder is studied. The two-dimensional Navier-Stokes equations are solved by a finite element method. The governing equations are discretized by a weighted residual method in space. The stable three-step scheme is applied to the momentum equations in the time integration. The numerical model is firstly applied to the computation of the lid-driven cavity flow for its validation. The computed results agree well with the measured data and other numerical results. Then, it is used to simulate the viscous uniform and shear flow over a circular cylinder for Reynolds numbers from lO0 to lO00. The transient time interval before the vortex shedding occurs is shortened considerably by introduction of artificial perturbation. The computed Strouhal number, drag and lift coefficients agree well with the experimental data. The computation shows that the finite element model can be successfully applied to the viscous flow problem.     

Variation in Water Masses on Shelf of Northern Bering Sea in September 2016-2018

Abstract

Based on hydrological data obtained during the 7th to 9th Chinese National Arctic Research Expeditions in the summers of 2016–2018, the main water structure on the shelf of the northern Bering Sea and the volume and heat fluxes of the Bering Strait throughflow were analyzed. Distinct variability was identified in the three Pacific water masses feeding the strait - Anadyr Water (AW), Bering Shelf Water (BSW) and Alaskan coastal water (ACW). Overall, the temperature and salinity of the entire section increased each year, with 2018 showing significant anomalies, i.e., a temperature anomaly of up to 1?°C and a maximum salinity anomaly of 2. From 2016 to 2018, the extent of the ACW gradually narrowed in the eastern part of this section, while the AW expanded eastward each year. The net volume transport through each of the three sections increased poleward from 1.65?Sv to 2.76?Sv, with the AW increasing from 0?Sv to 1.03?Sv, the BSW varying between 0.52–1.65?Sv, and the ACW gradually decreasing from 1.04?Sv to disappearing completely. The net heat fluxes were also poleward, varying between 25.77 TW and 61.50 TW, and showing a significant increase. Significant variations in magnitude and extent were observed in each water mass of the Bering Strait throughflow, which could produce widespread effects in the Arctic Ocean and the global ocean beyond.     

Numerical simulation of solitary wave scattering by a circular cylinder array

The interaction of a solitary wave with an array of surface-piercing vertical circular cylinders is investigated numerically. The wave motion is modeled by a set of generalized Boussinesq equations. The governing equations are discretized using a finite element method. The numerical model is validated against the experimental data of solitary wave reflection from a vertical wall and solitary wave scattering by a vertical circular cylinder respectively. The predicted wave surface elevation and the wave forces on the cylinder agree well with the experimental data. The numerical model is then employed to study solitary wave scattering by arrays of two circular cylinders and four circular cylinders respectively. The effect of wave direction on the wave forces and the wave runup on the cylinders is quantified.     

Numerical simulation of the hydrodynamic behaviour of submerged plane nets in current

The aim of this paper is to investigate the shape and tension distribution of fishing nets in current. A numerical model is developed, based on lumped mass method to simplify the net. The motion equation is set up for each lumped mass. The Runge–Kutta–Verner fifth-order and sixth-order method is used to solve these simultaneous equations, and then the displacement and tension of each lumped mass are obtained. In order to verify the validity of the numerical method, model tests have been carried out. The results by the numerical simulation agree well with the experimental data.     

黄海、渤海底层温度数值预报方法的研究

根据文献［ｌ］建立的底层温度（ＴＨ）与其水柱垂向平均温度（）的经验关系，结合流体动力学方程和（垂向平均）热传导方程，发展了以水气温差和风速为已知量的底层温度二维数值预报模式。该模式避开了海面热量和动量输入在垂直水柱中分配的复杂物理过程而直接报出底层水温场，具有较好的实用性；此外，从试报结果看，效果令人满意。