Dissociative excitation of SO2 by controlled electron impact

The fragmentation of SO₂ following dissociative electron impact excitation has been studied under single collision conditions for incident electron energies up to 500 eV. The emission spectrum in the far v.u.v. spectral range (450–1100Å) shows many features arising from excited neutral oxygen and ionized oxygen and sulphur fragments. Absolute emission cross sections have been measured for the most intense lines and the maximum values were found to range from 1–12 × 10^?19 cm² with an uncertainty of approx. ± 35%. Dissociation mechanisms are discussed and in some cases the dissociation path could be uniquely identified. The striking differences between the v.u.v. emission spectrum produced by single step dissociation of SO₂ and the spectra emitted by the plasma torus around Jupiter are discussed.     

Volume diffusion of Ytterbium in YAG: thin-film experiments and combined TEM–RBS analysis

In this study, we address volume diffusion of ytterbium in yttrium aluminum garnet (YAG) using thin-film single crystal diffusion couples. We employ analytical transmission electron microscopy (ATEM) as a tool for combined microstructural and microchemical analysis and compare the results to Rutherford backscattering (RBS) analysis. Given the high spatial resolution of the method, we focus on microstructural changes of the thin-film diffusant source during the diffusion anneal. We evaluate the potential influence of the associated changes in its transport properties on the evolution of concentration profiles in the single crystal substrate. This approach allows us to test the reliability of determination of volume diffusion coefficients from thin-film diffusion experiments. We found that for the chosen experimental setting, the influence of thin-film re-crystallization is small when compared with the experimental uncertainty and good estimates for the volume diffusion coefficients of Yb in YAG can be obtained using standard assumptions. Both Yb-concentration profiles analyzed with ATEM and with RBS give similar results. At 1,450°C and 1 bar, we infer log D _Yb (m²/s) values of −19.37 ± 0.07 (TEM) and −19.84 ± 0.02 (RBS). Although the change in thin-film transport properties associated with successive crystallization during the diffusion anneal does not play a major role for our experimental setup, this effect cannot generally be ignored.     

Environmental Radioxenon Levels in Europe: a Comprehensive Overview

Activity concentration data from ambient radioxenon measurements in ground level air, which were carried out in Europe in the framework of the International Noble Gas Experiment (INGE) in support of the development and build-up of a radioxenon monitoring network for the Comprehensive Nuclear-Test-Ban Treaty verification regime are presented and discussed. Six measurement stations provided data from 5 years of measurements performed between 2003 and 2008: Longyearbyen (Spitsbergen, Norway), Stockholm (Sweden), Dubna (Russian Federation), Schauinsland Mountain (Germany), Bruyères-le-Châtel and Marseille (both France). The noble gas systems used within the INGE are designed to continuously measure low concentrations of the four radioxenon isotopes which are most relevant for detection of nuclear explosions: ^131mXe, ^133mXe, ¹³³Xe and ¹³⁵Xe with a time resolution less than or equal to 24 h and a minimum detectable concentration of ¹³³Xe less than 1 mBq/m³. This European cluster of six stations is particularly interesting because it is highly influenced by a high density of nuclear power reactors and some radiopharmaceutical production facilities. The activity concentrations at the European INGE stations are studied to characterise the influence of civilian releases, to be able to distinguish them from possible nuclear explosions. It was found that the mean activity concentration of the most frequently detected isotope, ¹³³Xe, was 5–20 mBq/m³ within Central Europe where most nuclear installations are situated (Bruyères-le-Châtel and Schauinsland), 1.4–2.4 mBq/m³ just outside that region (Stockholm, Dubna and Marseille) and 0.2 mBq/m³ in the remote polar station of Spitsbergen. No seasonal trends could be observed from the data. Two interesting events have been examined and their source regions have been identified using atmospheric backtracking methods that deploy Lagrangian particle dispersion modelling and inversion techniques. The results are consistent with known releases of a radiopharmaceutical facility.     

Earthquakes,catastrophic sediment additions and the response of urban stream communities

Disturbance events can regularly impact stream ecosystems; however, large-scale catastrophic disturbances are rare. From September 2010 to September 2011 Christchurch City experienced over 8500 earthquakes including a magnitude 7.1. One consequence was catastrophic additions of silt and sand into waterways throughout the city. Of 161 km of permanent waterways, 102 km (63%) were affected by earthquake siltation. Benthic invertebrates and fish communities were compared across 16 streams with differing siltation. Invertebrate taxonomic richness decreased significantly (mean 17 taxa reduced to 10 taxa) and EPT taxa (Ephemeroptera, Plecoptera and Trichoptera) were removed entirely from streams receiving heavy siltation. Fish richness and density decreased significantly, with fish absent from some heavily silted streams. Many of these urban streams are sourced from springs and their stable flows and low gradient limit their ability to flush sediment. We predict that without human intervention there will be a long-term sediment legacy and it may take many years for these streams to recover from this catastrophic disturbance.     

Enhancement of aquifer vulnerability indexing using the analytic-element method

Indexing methods are used for the evaluation of aquifer vulnerability and establishing guidelines for the protection of ground-water resources. The principle of the indexing method is to rank influences on groundwater to determine overall vulnerability of an aquifer to contamination. The analytic element method (AEM) of ground-water flow modeling is used to enhance indexing methods by rapidly calculating a potentiometric surface based primarily on surface-water features. This potentiometric map is combined with a digital-elevation model to produce a map of water-table depth. This is an improvement over simple water-table interpolation methods. It is physically based, properly representing surface-water features, hydraulic boundaries, and changes in hydraulic conductivity. The AEM software, SPLIT, is used to improve an aquifer vulnerability assessment for a valley-fill aquifer in western New York State. A GIS-based graphical user interface allows automated conversion of hydrography vector data into analytic elements.     

Use of deuterated water as a conservative artificial groundwater tracer

Conservative tracers are necessary to obtain groundwater transport velocities at the field scale. Deuterated water is an effective tracer for this purpose due to its similarity to water, chemical stability, non-reactivity, ease of handling and sampling, relatively neutral buoyancy, and reasonable price. Reliable detection limits of 0.1 mg deuterium/L may be obtained in field tests. A field example is presented in which deuterated water, bromide, and pentafluorobenzoic acid are used as groundwater tracers. Deuterated water appeared to be transported conservatively, producing almost identical breakthrough curves as that of other soluble tracers. Electronic Publication     

Neuerscheinungen

Ohne Zusammenfassung