Methods of array element localization for a towed underwateracoustic array

The location of the hydrophones on a towed underwater acoustic array as a function of time (array element localization) is needed for signal processing. Methods to perform this localization using least squares polynomial fitting to data from depth sensors, heading sensors, and sensors detecting a ping from a single source are discussed. Arc distance along the array is used as the independent parameter so that all solutions are constrained to be space curves. Examples of application to real data are presented, and techniques to discriminate against bad sensor data are discussed     

Metamorphism in Archaean greenstone belts: calculated fluid compositions and implications for gold mineralization

An inescapable consequence of the metamorphism of greenstone belt sequences is the release of a large volume of metamorphic fluid of low salinity with chemical characteristics controlled by the mineral assemblages involved in the devolatilization reactions. For mafic and ultramafic sequences, the composition of fluids released at upper greenschist to lower amphibolite facies conditions for the necessary relatively hot geotherm corresponds to those inferred for greenstone gold deposits (X_CO2= 0.2–0.3). This result follows from the calculation of mineral equilibria in the model system CaO–MgO–FeO–Al₂O₃–SiO₂–H₂O–CO₂, using a new, expanded, internally consistent dataset. Greenstone metamorphism cannot have involved much crustal over-thickening, because very shallow levels of greenstone belts are preserved. Such orogeny can be accounted for if compressive deformation of the crust is accompanied by thinning of the mantle lithosphere. In this case, the observed metamorphism, which was contemporaneous with deformation, is of the low-P high-T type. For this type of metamorphism, the metamorphic peak should have occurred earlier at deeper levels in the crust; i.e. the piezothermal array should be of the ‘deeper-earlier’type. However, at shallow crustal levels, the piezothermal array is likely to have been of ‘deeper-later’type, as a consequence of erosion. Thus, while the lower crust reached maximum temperatures, and partially melted to produce the observed granites, mid-crustal levels were releasing fluids prograde into shallow crustal levels that were already retrograde. We propose that these fluids are responsible for the gold mineralization. Thus, the contemporaneity of igneous activity and gold mineralization is a natural consequence of the thermal evolution, and does not mean that the mineralization has to be a consequence of igneous processes. Upward migration of metamorphic fluid, via appropriate structurally controlled pathways, will bring the fluid into contact with mineral assemblages that have equilibrated with a fluid with significantly lower X_CO2. These assemblages are therefore grossly out of equilibrium with the fluid. In the case of infiltrated metabasic rocks, intense carbonation and sulphidation is predicted. If, as seems reasonable, gold is mobilized by the fluid generated by devolatilization, then the combination of processes proposed, most of which are an inevitable consequence of the metamorphism, leads to the formation of greenstone gold deposits predominantly from metamorphic fluids.     

Response of circular footings and anchor plates in non-homogeneous elastic soils

The axisymmetric elastic response of circular footings and anchor plates in a linearly non-homogeneous elastic soil is analysed. It is assumed that footings/anchors are flexible and subjected to axisymmetric vertical loads. The response of the footing/anchor is modelled by using the classical Poisson–Kirchhoff thin plate theory. A variational technique is used to analyse the interaction problem. A representation for the contact stress is established by using a fundamental solution corresponding to a unit vertical pressure acting over an annular region in the interior of the non-homogeneous soil. The fundamental solution can be derived by using rigorous analytical procedures. The influence of the footing flexibility and the degree of soil non-homogeneity on the displacements, bending moments and contact stresses of a surface footing is examined over a wide range of governing parameters. In the case of anchor plates the influence of depth of embedment, degree of soil non-homogeneity and anchor flexibility on the anchor displacement is investigated.     

Multiple-source localization using GPS technology and receivedarrival time structure analysis in an air-deployed system

An efficient and robust method has been developed to locate multiple impulsive sources in an ocean environment. Global position system (GPS) receivers were installed on sonobuoys to obtain their locations within a few meters of accuracy. A sonobuoy field was deployed in a ring-type pattern. Charges were then set off at arbitrary locations within the ring, High-resolution plots were used to obtain direct path and/or first bottom bounce arrivals on each buoy. A model grid of arrival times was constructed, corresponding to the dimensions of the buoy field. A ray model previously developed here at the Applied Research Laboratories at the University of Texas at Austin (ARL:UT) was used to obtain model travel times. The minimum value of the least-square-type error between the real arrival times and the modeled travel times resulted in an unambiguous location of the source, within the limits of the grid spacing chosen. This value was calculated by picking one receiver as the reference and then summing the timing errors of the remaining receivers relative to the reference. Successive iterations with finer grid spacings result in source localization within the accuracy of the buoy locations. The localization routine was extended by allowing permutations of the pulse arrivals on each buoy to account for multiple sources closely separated in time and/or space. An automated correlation technique is presented as an alternative to the leading edge-detection method used here for obtaining relative arrival times. Two proof-of-concept experiments were performed and some results of data obtained at Lake Travis and the Gulf of Mexico are presented     

Umbral Three-Minute Oscillations and Running Penumbral Waves

We present results of investigations into chromospheric velocity oscillations in sunspots, carried out at the Sayan Solar Observatory. It is shown that the “chevron” structures in the space-time diagrams demonstrate wavetrain properties. Such structures are indicators of a propagating wave process and they are typical of many sunspots. In the authors’ opinion, three-minute umbral oscillations are not the source of running penumbral waves (RPW). It is very likely that umbral oscillations and RPW initially propagate along different magnetic field lines. We explain the decrease in RPW propagation velocity and frequency in the outer penumbra, as compared with the inner, by the combined action of different frequency modes. To better reveal the properties of these modes, frequency filtering was used. Our measurements of the RPW (five-minute mode) wavelength and RPW propagation velocity in different sunspots vary from 12^″ to 30^″ and from 28 to 60 – 70 km s⁻¹ correspondingly.     

Chronology and evolution of the northern Iceland Plateau

New aeromagnetic data, K-Ar age determinations of dredged marine igneous rocks, as well as other geophysical evidence have shed light on the chronology, nature and evolution of the northern Iceland Plateau. Correspondence between seismic refraction profiles taken on the Jan Mayen Ridge and westward through Jan Mayen Island, suppressed aeromagnetic anomalies, earthquake surface wave studies, and ages of dredged igneous rocks suggest these strata may form an extended region of thickened crust, possibly of Caledonian age, extending westward toward the Kolbeinsey Ridge and northwest to the south wall of the Jan Mayen Fracture Zone.     

Characterization of soil's structural crust by spectral reflectance in the SWIR region (1.2–2.5 μm)

Structural crust is a thin layer formed on the soil surface after a rainstorm. The crust is the result of a physical segregation and rearrangement of soil particles in a way that affects some of the soil properties, such as infiltration, runoff and soil erosion. In practice, there is no rapid, in situ method for monitoring, assessing and mapping crust intensity and quality. In this study, a controlled spectral investigation of the structural crust across the NIR–SWIR spectral region was conducted on three selected Israeli soils, to study the potential of reflectance radiation to detect structural crust in soils. Two major factors served as the driving forces for this study: (1) there is no valid method for in situ assessment of the crust's characteristics in the agriculture field, and (2) the crust might bias thematic remote sensing of soils, because the thin layer of crust blocks photon–matter interaction, which represents the relevant soil body. Through the use of a laboratory rainfall simulator and a sensitive spectrometer, it was revealed that for three selected soils, significant spectral differences occurred between the crust and its bulk soil. The spectral information was found to be related to changes in particle size distribution and texture at the surface of the soil. This conclusion was based on indications of absorption of OH in clay lattice, OH in adsorbed water and CO₃ in carbonates. It was concluded that the structural crust is a phenomenon that should not be ignored by remote-sensing users. In fact, in the field of agriculture, the spectral properties of crust can be used as tools for estimating the crust's intensity.