Geophysical characterization of the lithological control on the kinematic pattern in a large clayey landslide (Avignonet,French Alps)

Lithology variation is known to have a major control on landslide kinematics, but this effect may remain unnoticed due to low spatial coverage during investigation. The large clayey Avignonet landslide (French Alps) has been widely studied for more than 35 years. Displacement measurements at 38 geodetic stations over the landslide showed that the slide surface velocity dramatically increases below an elevation of about 700 m and that the more active zones are located at the bottom and the south of the landslide. Most of the geotechnical investigation was carried out in the southern part of the landslide where housing development occurred on lacustrine clay layers. In this study, new electrical prospecting all across the unstable area revealed the unexpected presence of a thick resistive layer covering the more elevated area and overlying the laminated clays, which is interpreted as the lower part of moraine deposits. The downslope lithological boundary of this layer was found at around 700 m asl. This boundary coincides with the observed changes in slide velocity and in surface roughness values computed from a LiDAR DTM acquired in 2006. This thick permeable upper layer constitutes a water reservoir, which is likely to influence the hydromechanical mechanism of the landslide. The study suggests a major control of vertical lithological variations on the landslide kinematics, which is highlighted by the relation between slide velocity and electrical resistivity.     

Submersible observations of Equatorial Atlantic mantle: The St. Paul Fracture Zone region

The St. Paul F.Z. is a large structural domain made up of multiple transform faults interrupted by several Intra-Transform Ridge (ITR) spreading segments. Two regions were studied in details by submersible: (1) The ITR short (<20 km in length) segment near 0° 37N–25° 27W and 1° N–27° 42W and (2) The St. Peter and St. Paul's Rocks (SPPR) massif located at 29° 25W (¡3700 m depth). (1) The short ITR segments consist of a magma starved rift valley with recent volcanic activities at 4700 m depth. A geological profile made along the rift valley wall showed localized volcanics (basalts and dykes) which are believed to overlay and intrude the ultramafics. The geological setting and the high ultramafic/volcanic ratio suggest an extremely low magmatic supply and crustal-mantle uplift during lithospheric stretching and denudation. (2) The St. Peter and St. Paul's Rocks (SPPR) massif consists of a sigmoidal ridge within the active transform zone. The SPPR is divided into two different geological domains called the North and the South Ridges. The North Ridge consists of strongly tectonized fault scarps composed of banded and mylonitized peridotite, sporadic gabbros (3900–2500 m) and metabasalts (2700–1700 m). The South Ridge is less tectonized with undeformed, serpentinized spinel lherzolite (2000–1400 m) and basalts. Extensional motion and denudation accompanied by diapirism affected the South Ridge within a transform domain. Instead, the North Ridge was formed during an important strike-slip and faulting motion resulting in the uplifted portion of the St. Paul F.Z. transverse ridge. There is a regional compositional variation of the volcanics where E-MORBs and alkali basalts are produced on the SPPR massif and are comparable to the adjacent northern segments of the Mid-Atlantic Ridge. On the other hand, N and T- MORBs collected from the eastern part of the St. Paul F.Z. (25° 27W IRT) are similar to the volcanics from the southern segments of the MAR. The peridotites exposed in these provinces (SPPR and ITR) are similar in their REE and trace element distribution. Different degrees (3–15%) of partial melting of a mixed composite mantle consisting of spinel and amphibole bearing lherzolite veined with 5–40% clinopyroxenite gave rise to the observed MORBs and alkali basalts.     

Total oxyradical scavenging capacity and cell membrane stability of haemocytes of the Arctic scallop,Chlamys islandicus,following benzo(a)pyrene exposure

Industrial activities, notably oil and gas industries, are expanding in the Arctic. Most of the biomarkers were developed using temperate organisms living at temperatures above 10 degrees C. Little is known about the biomarker responses of organisms living between -1.88 and 5 degrees C. Therefore, assessment of the toxicity of chemicals to cold-water adapted species is required. In this study, the Arctic scallop, Chlamys islandicus, was selected as a key species for bio-monitoring because of wide distribution in Arctic waters and its commercial value. Test animals, stored in seawater at 2 degrees C, were injected with benzo(a)pyrene (diluted in cod liver oil 5 mg ml(-1)) in the adductor muscle every 24 h for four days giving a final dose of 0, 74 and 90.6 mg kg(-1) wet weight for control, low and high dose, respectively. The biomarkers used were total oxyradical scavenging capacity (TOSC) in the digestive gland and cell membrane stability of haemocytes. TOSC values were significantly reduced (ca. 30%) in exposed groups (P < 0.05), indicating a depletion in oxyradical molecular scavengers. The antioxidant defences appeared to be overwhelmed by the reactive oxygen species as the plasma membranes of haemocytes were destabilised (P < 0.05) probably due to lipid peroxidation. These data indicate that reactive oxygen species (ROS) were produced by Arctic scallops via the metabolisation of benzo(a)pyrene at 2 degrees C.     

Spatio-temporal changes in totally and enzymatically hydrolyzable amino acids of superficial sediments from three contrasted areas

Spatio-temporal changes in totally and enzymatically hydrolyzable amino acids (THAA and EHHA) and EHAA/THAA ratios of superficial sediments were assessed during 1997-1999 in three areas (i.e., the Gulf of Lions, the Bay of Biscay, and Central Chile) differing in their primary productivity. In all three areas, and even off Central Chile where a strong El Niño event took place during 1997-1998, spatial changes were always much greater than temporal ones. The factors affecting the spatial distributions of amino acid concentrations differed among areas. In the Gulf of Lions, sediment granulometry was apparently the most important driving force of THAA, EHAA, and EHAA/THAA, and there was no marked difference between stations located on the open slope and those in submarine canyons. Conversely, in the Bay of Biscay, there were clear differences between the stations located off Cap-Breton, on the open slope, and those in the Cap-Ferret canyon; the latter two featuring lower EHAA and THAA but higher EHAA/THAA. This pattern is likely to result from the predominance of different sources of organic matter and especially from the importance of continental inputs to the Cap-Breton canyon. Off Central Chile, amino acid concentrations and ratios were both maximal around 100 m depth, probably reflecting the interaction between the primary productivity gradient and the presence of an oxygen minimum zone (OMZ) reducing the degradation of sedimentary organics. When comparing the average values collected in the three areas studied, THAA and EHAA were highest in Central Chile, intermediate in the Bay of Biscay and lowest in the Gulf of Lions. EHAA/THAA ratios were also highest in Central Chile but were lowest in the Bay of Biscay. Differences between the Gulf of Lions and the Bay of Biscay could have been affected by sampling design. In Central Chile, the use of labile organic carbon to total organic carbon (C-LOM/TOC) and EHAA/THAA as indices of organic matter lability led to very similar results. This was not the case in the Bay of Biscay. It is therefore argued that the use of C-LOM/TOC should be restricted to highly productive areas.     

Limiting similarity, niche filtering and functional diversity in coastal lagoon fish communities

The fundamental idea behind the study of biodiversity patterns is the presumed connection between the shape of species assemblages and the functional ways in which they are organized, this functional organization referring to how species are related to one another, as competitors or members of a web of interactions and to how species are facing similar environmental constraints. Amongst the different facets of biodiversity, functional diversity is certainly a key for ecosystem processes in coastal areas. However, surprisingly, patterns of functional diversity have received little attention until now. After presenting a common framework linking functional diversity patterns to species coexistence theories, the aim of our study was twofold: (1) to seek assembly rules in brackish lagoon fish communities drove by functional traits. To this aim we used null models to examine the influence of two opposing forces acting on community structure: interspecific competition that might prevent the coexistence of the most similar species, and environmental filters that might result in the most similar species to coexist. (2) To seek relationships between fish functional diversity and environmental gradients, if any. Fish sampling was carried out in two coastal lagoons where stations differ considerably in terms of physicochemical parameters. Using morphological functional traits, functional diversity of fish communities was estimated using two recently published indices as well as a new proposed index. Firstly our study was not able to demonstrate a limitation of similarity in coexisting lagoon fishes due to interspecific competition. Conversely our results support the niche filtering hypothesis preventing species too dissimilar from one another to co-occur at the same station. Secondly, salinity was positively related to the functional diversity of fishes in both lagoons suggesting that within species assemblages near the channel species are less redundant than at stations far from the channel where species tend to be functionally similar (benthic and eating zooplankton).     

Failure and size effect for notched and unnotched concrete beams

Modelling failure in geomaterials, concrete or other quasi‐brittle materials and proper accounting for size effect, geometry and boundary effects are still pending issues. Regularised failure models are capable of describing size effect on specimens with a specific geometry, but extrapolations to other geometries are rare, mostly because experimental data presenting size effect for different geometries and for the same material are lacking. Three‐point bending fracture tests of geometrically similar notched and unnotched specimens are presented. The experimental results are compared with numerical simulations performed with an integral‐type non‐local model. Comparisons illustrate the shortcomings of this classical formulation, which fails to describe size effect over the investigated range of geometries and sizes. Finally, experimental results are also compared with the universal size effect law. Copyright © 2013 John Wiley & Sons, Ltd.