Estimating recharge rates with analytic element models and parameter estimation

Quantifying the spatial and temporal distribution of recharge is usually a prerequisite for effective ground water flow modeling. In this study, an analytic element (AE) code (GFLOW) was used with a nonlinear parameter estimation code (UCODE) to quantify the spatial and temporal distribution of recharge using measured base flows as calibration targets. The ease and flexibility of AE model construction and evaluation make this approach well suited for recharge estimation. An AE flow model of an undeveloped watershed in northern Wisconsin was optimized to match median annual base flows at four stream gages for 1996 to 2000 to demonstrate the approach. Initial optimizations that assumed a constant distributed recharge rate provided good matches (within 5%) to most of the annual base flow estimates, but discrepancies of >12% at certain gages suggested that a single value of recharge for the entire watershed is inappropriate. Subsequent optimizations that allowed for spatially distributed recharge zones based on the distribution of vegetation types improved the fit and confirmed that vegetation can influence spatial recharge variability in this watershed. Temporally, the annual recharge values varied >2.5-fold between 1996 and 2000 during which there was an observed 1.7-fold difference in annual precipitation, underscoring the influence of nonclimatic factors on interannual recharge variability for regional flow modeling. The final recharge values compared favorably with more labor-intensive field measurements of recharge and results from studies, supporting the utility of using linked AE-parameter estimation codes for recharge estimation.     

Paleoproterozoic gold deposits in the Bald Hill and Coyote areas, Western Tanami, Western Australia

Significant gold deposits in the western Tanami region of Western Australia include deposits in the Bald Hill and Coyote areas. The ca. 1,864 Ma Bald Hill sequence of turbiditic and mafic volcanic rocks hosts the Kookaburra and Sandpiper deposits and a number of smaller prospects. The ca. 1,835 Ma turbiditic Killi Killi Formation hosts the Coyote deposit and several nearby prospects. The Kookaburra deposit forms as a saddle reef within a syncline, and the Sandpiper deposit is localized within graphitic metasedimentary rocks along a limb of an anticline. Gold in these deposits is hosted by anastomosing quartz–(–pyrite–arsenopyrite) veins within quartz–sericite schist with disseminated arsenopyrite, pyrite, and marcasite (after pyrrhotite). Based on relative timing relationships with structural elements, the auriferous veins are interpreted to have been emplaced before or during the ca. 1,835–1,825 Ma Tanami Orogeny (regional D₁). Gold deposition is thought to have been caused by pressure drops associated with saddle reef formation (Kookaburra) and chemical reactions with graphitic rocks (Sandpiper). The Coyote deposit, the largest in the western Tanami region, consists of a number of ore lenses localized along the limbs of the Coyote Anticline, which formed during the Tanami Orogeny. The largest lenses are associated with the Gonzalez Fault, which is located along the steeply dipping southern limb of this fold. Gold was introduced at ca. 1,790 Ma into dilatant zones that formed in local perturbations along this fault during later reactivation (regional D₅) towards the end of a period of granite emplacement. Gold is associated with quartz–chlorite–pyrite–(arsenopyrite–galena–sphalerite) veins with narrow (<?5 mm) chloritic selvages. A quartz–muscovite–biotite–K–feldspar–(tourmaline–actinolite–arsenopyrite) assemblage, which is interpreted to relate to granite emplacement, overprints the regional greenschist facies metamorphic assemblage. The mineralogical similarity between this overprinting assemblage and the vein assemblage suggests that the auriferous veins at the Coyote deposit are associated with the granite-related metamorphic–metasomatic assemblage. Gold deposition is thought to have been caused by pressure drops within dilatant zones.     

An integrated approach for evaluating the effectiveness of landslide risk reduction in unplanned communities in the Caribbean

Despite the recognition of the need for mitigation approaches to landslide risk in developing countries, the delivery of ‘on-the-ground’ measures is rarely undertaken. With respect to other ‘natural’ hazards, it is widely reported that mitigation can pay. However, the lack of such an evidence base in relation to landslides in developing countries hinders advocacy amongst decision makers for expenditure on ex-ante measures. This research addresses these limitations directly by developing and applying an integrated risk assessment and cost–benefit analysis of physical landslide mitigation measures implemented in an unplanned community in the Eastern Caribbean. In order to quantify the level of landslide risk reduction achieved, landslide hazard and vulnerability were modelled (before and after the intervention), and project costs, direct and indirect benefits were monetised. It is shown that the probability of landslide occurrence has been substantially reduced by implementing surface-water drainage measures and that the benefits of the project outweigh the costs by a ratio of 2.7–1. This paper adds to the evidence base that ‘mitigation pays’ with respect to landslide risk in the most vulnerable communities—thus strengthening the argument for ex-ante measures. This integrated project evaluation methodology should be suitable for adoption as part of the community-based landslide mitigation project cycle, and it is hoped that this resource, and the results of this study, will stimulate further such programmes.     

Petrology of a portion of the Eastern Peninsular Ranges mylonite zone,Southern California

Peraluminous and metaluminous plutonic rocks of the Peninsular Ranges batholith near Borrego Springs in southern California were mylonitized in the large shear zone known as the eastern Peninsular Ranges mylonite zone (EPRMZ). Accompanying mylonitization in this portion of the EPRMZ was metamorphism at intermediate-low-pressure amphibolite-facies conditions. Deformation in the zone overlapped in time with Cretaceous intrusion of the batholith. In the San Ysidro Mountain — Pinyon Ridge area, four north-south trending zones of differing intensity of deformation have been defined; from east to west the degree and style of deformation gradually change from undeformed or weakly deformed rocks to strongly mylonitized rocks. Electron microprobe analysis shows that recrystallized hornblende, biotite, and plagioclase are variable in composition, probably reflecting a range of metamorphic conditions accompanying deformation. Comparison of mineral compositions with those from mafic schists of Vermont suggests conditions ranged from andalusite-staurolite through sillimanite-muscovite grades as defined for pelitic rocks. Stability of muscovite+quartz in mylonite assemblages and lack of remelting of granitic rocks indicate that temperature did not exceed about 650° C during mylonitization and lithostatic pressure did not exceed about 5 kbar. Over time, any given rock volume experienced a range of temperature, lithostatic pressure, and perhaps fluid pressure and differential stress. Mineral reactions in the zone involved hydration, requiring introduction of water. The possibility of large-scale migration of K and Fe is suggested by whole-rock chemical data. Brittle and ductile deformation features are closely associated in one part of the EPRMZ. The combined evidence suggests the presence of a pore fluid with fluid pressure close to lithostatic pressure. Short periods of low fluid pressure and possible high differential stress cannot be ruled out.     

Paleoecology of a Middle Wisconsin Deposit from Southern California

Analysis of a buried deposit in the Diamond Valley of southern California has revealed well-preserved pollen, wood, and diatom remains. Accelerator mass spectrometry dates of 41,200±2100 and 41,490±1380 ¹⁴C yr B.P. place this deposit in marine isotope stage 3. Diatoms suggest a shallow lacustrine environment. Pollen data suggest that several plant communities were present near the site, with grassland, scrub, chaparral, forest, and riparian communities represented. Comparison with modern pollen suggests similarities with montane forests in the nearby San Bernardino and San Jacinto ranges, indicating vegetation lowering by at least 900 m elevation and temperatures 4°–5°C cooler than today. An increase in high-elevation conifer pollen documents climatic cooling near the profile top. Early-profile diatoms are typical of warm water with high alkalinity and conductivity, whereas later diatoms suggest a higher flow regime and input of cooler water into the system. We suggest that the sequence is part of the cooling phase of an interstadial Dansgaard–Oeschger cycle. Records of the middle Wisconsin period are rare in southern California, but the Diamond Valley site is similar to records from Tulare Lake in the San Joaquin Valley and the ODP Site 893A record from Santa Barbara Basin. It is probable that the Diamond Valley assemblage is a local expression of a vegetation type widespread in the ranges and basins of southwestern California during the middle Wisconsin.     

Effect of adsorbed metal ions on the transport of Zn- and Ni-EDTA complexes in a sand and gravel aquifer

Adsorption, complexation, and dissolution reactions strongly influenced the transport of metal ions complexed with ethylenediaminetetraacetic acid (EDTA) in a predominantly quartz-sand aquifer during two tracer tests conducted under mildly reducing conditions at pH 5.8 to 6.1. In tracer test M89, EDTA complexes of zinc (Zn) and nickel (Ni), along with excess free EDTA, were injected such that the lower portion of the tracer cloud traveled through a region with adsorbed manganese (Mn) and the upper portion of the tracer cloud traveled through a region with adsorbed Zn. In tracer test S89, Ni- and Zn-EDTA complexes, along with excess EDTA complexed with calcium (Ca), were injected into a region with adsorbed Mn. The only discernable chemical reaction between Ni-EDTA and the sediments was a small degree of reversible adsorption leading to minor retardation. In the absence of adsorbed Zn, the injected Zn was displaced from EDTA complexes by iron(III) [Fe(III)] dissolved from the sediments. Displacement of Zn by Fe(III) on EDTA became increasingly thermodynamically favorable with decreasing total EDTA concentration. The reaction was slow compared to the time-scale of transport. Free EDTA rapidly dissolved aluminum (Al) from the sediments, which was subsequently displaced slowly by Fe. In the portion of tracer cloud M89 that traveled through the region contaminated with adsorbed Zn, little displacement of Zn complexed with EDTA was observed, and Al was rapidly displaced from EDTA by Zn desorbed from the sediments, in agreement with equilibrium calculations. In tracer test S89, desorption of Mn dominated over the more thermodynamically favorable dissolution of Al oxyhydroxides. Comparison with results from M89 suggests that dissolution of Al oxyhydroxides in coatings on these sediment grains by Ca-EDTA was rate-limited whereas that by free EDTA reached equilibrium on the time-scale of transport. Rates of desorption are much faster than rates of dissolution of Fe oxyhydroxides from sediment-grain surfaces and, therefore, adsorbed metal ions can strongly influence the speciation of ligands like EDTA in soils and sediments, especially over small temporal and spatial scales.     

A review of environmental and genetic factors that affect height inSpartina alterniflora loisel. (Salt marsh cord grass)

The salt marsh cord grass,Spartina alterniflora Loisel., occurs in markedly distinct short and tall growth forms. Both forms have the same number of chromosomes, although polyploidy is well established in the genus. Previous studies have shown that height is primarily affected by nitrate availability and environmental stresses such as increased soluble salt concentrations. These studies have shown that, within a marsh, height differences cannot be attributed to genetic, chromosomal differences or electrophoretic banding. However, more subtle genetic differences may be involved. Other studies suggest that between marshes,S. alterniflora, in response to a latitudinal gradient on the Atlantic coast, has evolved ecotypes differing in height, color and flowering period. This review paper points out that plant height inS. alterniflora may be determined by a combination of environmental and genetic factors.     

Measured elastic moduli of single-crystal MgO up to 1800 K

Using the rectangular parallelepiped resonance method we measured the temperature dependence of the adiabatic elastic moduli of single-crystal MgO over the temperature range 300–1800 K. The high temperature limit of our measurements extends by 500 K the upper limit over which elasticity data on MgO are now available. Although our measured temperature dependence of C _ij ^s are generally in good agreement with previous measurements over a more narrow range in temperature, we found that C ₄₄ ^s decreases more rapidly with temperature, for T > 1000 K, than previous studies suggest. We also found that each of the slopes (?C ₁₁ ^s /?T)_p, (?K_s/?T)_p, and (C ₄₄ ^s /?T)_p become less negative with increasing temperature for T > 1400 K. From our measurements on elasticity we are able to confirm that the Grüneisen parameter at zero pressure is nearly constant with temperature up to 1800 K, with only a slight decrease above 1000 K. Utilizing our new data we present calculations showing the temperature dependence of thermodynamic parameters important in studies of earth's interior.