Cenozoic erosion and the preglacial uplift of the Svalbard–Barents Sea region

The creation of the huge fans observed in the western Barents Sea margin can only be explained by assuming extremely high glacial erosion rates in the Barents Sea area. Glacial processes capable of producing such high erosion rates have been proposed, but require the largest part of the preglacial Barents Sea to be subaerial. To investigate the validity of these proposals we have attempted to reconstruct the western preglacial Barents Sea. Our approach was to combine erosion maps based on prepublished data into a single mean valued erosion map covering the whole western Barents Sea and consequently use it together with a simple Airy isostatic model to obtain a first rough estimate of the preglacial topography and bathymetry of the western Barents Sea margin. The mean valued erosion map presented herein is in good volumetric agreement with the sediments deposited in the western Barents Sea margin areas, and as a direct consequence of the averaging procedures employed in its construction we can safely assume that it is the most reliable erosion map based on the available information. By comparing the preglacial sequences with the glacial sequences in the fans we have concluded that 1/2 to 2/3 of the total Cenozoic erosion was glacial in origin and therefore a rough reconstruction of the preglacial relief of the western Barents Sea could be obtained. The results show a subaerial preglacial Barents Sea. Thus, during interglacials and interstadials the area may have been partly glaciated and intensively eroded up to 1 mm/y, while during relatively brief periods of peak glaciation with grounded ice extending to the shelf edge, sediments have been evacuated and deposited at the margins at high rates. The interplay between erosion and uplift represents a typical chicken and egg problem; initial uplift is followed by intensive glacial erosion, compensated by isostatic uplift, which in turn leads to the maintenance of an elevated, and glaciated, terrain. The information we have on the initial tectonic uplift suggests that the most likely mechanism to cause an uplift of the dimensions and magnitude of the one observed in the Barents Sea is a thermal mechanism.     

Linear response functions to project contributions to future sea level

We propose linear response functions to separately estimate the sea-level contributions of thermal expansion and solid ice discharge from Greenland and Antarctica. The response function formalism introduces a time-dependence which allows for future rates of sea-level rise to be influenced by past climate variations. We find that this time-dependence is of the same functional type, R(t) ～ t ^α, for each of the three subsystems considered here. The validity of the approach is assessed by comparing the sea-level estimates obtained via the response functions to projections from comprehensive models. The pure vertical diffusion case in one dimension, corresponding to α =  ?0.5, is a valid approximation for thermal expansion within the ocean up to the middle of the twenty first century for all Representative Concentration Pathways. The approximation is significantly improved for α =  ? 0.7. For the solid ice discharge from Greenland we find an optimal value of α =  ?0.7. Different from earlier studies we conclude that solid ice discharge from Greenland due to dynamic thinning is bounded by 0.42 m sea-level equivalent. Ice discharge induced by surface warming on Antarctica is best captured by a positive value of α = 0.1 which reflects the fact that ice loss increases with the cumulative amount of heat available for softening the ice in our model.     

Rock bursting phenomena in a superficial rock mass in southern central Sweden

SummaryRock Bursting Phenomena in a Superficial Rock Mass in Southern Central Sweden Rock bursting phenomena have been observed in connection with excavation of two shallow sited rock tunnels in the Forsmark area in southern, central Sweden. The tunnels are excavated in gneiss granite and the rock cover varies between 5–15 m. The stress release occurred locally in the tunnels which indicates significant variations in rock stresses.In situ measurements of the triaxial stress situation carried out in the area show values of the principal stresses in the horizontal plane of a magnitude in excess of 20 MPa in the superficial rock mass. The rock stress measurements indicate a clear correspondence of the directions of the highest compressive stress and the rock foliation. There is also a clear correspondence between the directions of a vertical and a horizontal joint set and the highest compressive stress. The three-dimensional stress tensor indicates that the horizontal fractures are exposed to the smallest closure pressure, i. e. the vertical stress, which set should therefore be most open. The horizontal joint set in the superficial rock mass has a significantly higher value of aperture than the vertical sets which may be a consequence of the stress situation in the rock mass. The rock bursting is not attributed to a breakage of the rock matrix, but merely to a propagation of already existing small fractures and potential fractures. The stress situation in the Forsmark area may be regarded as an uniaxial stress field in the horizontal plane.With 12 Figures     

柴达木盆地北缘古生代超高压带中花岗质岩浆作用

祁连南缘古生代超高压变质带 (榴辉岩年龄为 4 6 6～ 4 95 Ma)上一套中高级变质岩系 (达肯大坂片麻岩 )中存在三类花岗岩组合 : 类 :石英二长闪长岩 -花岗闪长岩 -二长花岗岩 , 类 :二长花岗岩 -二云母花岗岩-含白云母花岗岩 -正长花岗岩 , 类 :花岗闪长岩 -二长花岗岩 -黑云母花岗岩。 类岩石组合中的二长花岗岩锆石SHRIMP年龄为 4 73Ma, 类岩石组合中的正长花岗岩锆石 SHRIMP年龄为 4 4 6 Ma, 类岩石组合中的二长花岗岩锆石 SHRIMP年龄为 397Ma。从三类花岗岩组合的组成矿物来看 , 类和 类的矿物组合主要为斜长石、角闪石、石英、碱性长石、黑云母 , 类的矿物组合为钾长石、石英、白云母、黑云母、斜长石 ;从岩石地球化学特征上看 , 类和 类花岗岩为 型花岗岩 ,岩石的 Si O2 =6 1%～ 6 9% ,Na2 O/ K2 O>1,ANK<1,δEu=0 .7～ 1.0 ; 类花岗岩为 S型花岗岩 ,岩石的 Si O2 =70 %～ 76 % ,Na2 O/ K2 O<1,ANK>1,δEu=0 .1～ 0 .3;从构造环境上看 , 类花岗岩形成于岛弧环境或活动大陆边缘 , 类花岗岩形成于同碰撞 , 类花岗岩形成于碰撞后。结合区域地质特征 ,我们认为 ,早奥陶世 ,南祁连洋板块向北俯冲于祁连陆块之下 ,规模不大的南祁连洋很快闭合 ,但俯冲下去的大洋板块仍拖动柴达木陆块继续俯冲 ,俯冲     

Measured And Simulated Latent And Sensible Heat Fluxes At Two Marine Sites In The Baltic Sea

In this study, turbulent heat flux data from two sites within the Baltic Sea are compared with estimates from two models. The main focus is on the latent heat flux. The measuring sites are located on small islands close to the islands of Bornholm and Gotland. Both sites have a wide wind direction sector with undisturbed over-water fetch. Mean parameters and direct fluxes were measured on masts during May to December 1998.The two models used in this study are the regional-scale atmospheric model HIRLAM and the ocean model PROBE-Baltic. It is shown that both models overestimate the sensible and latent heat fluxes. The overestimation can, to a large extent, be explained by errors in the air-water temperature and humidity differences. From comparing observed and modelled data, the estimated 8-month mean errors in temperature and humidity are up to 1 °C and 1 g kg^-1, respectively. The mean errors in the sensible and latent heat fluxes for the same period are approximately 15 and 30 W m^-2, respectively.Bulk transfer coefficients used for calculating heat and humidity fluxes at the surface were shown to agree rather well with the measurements, at least for the unstable data. For stable stratification, the scatter in data is generally large, and it appears that the bulk formulation chosen overestimates turbulent heat fluxes.     

Coexisting pyroxenes — a multivariate statistical approach

A population of 117 coexisting nonalkaline pyroxene pairs has been studied statistically to evaluate compositional and thermal effects on the element distribution. K_DMg^opx-cpx is influenced by the Fe/Mg-ratio, by the Ca content—especially of clinopyroxene—and by the content of tetrahedral Al. Fe and tetrahedral Al are found to be negatively correlated. A principal component analysis based on the variation of Si, Al^IV, Al^VI, Fe, Mg, Mn, Ca is performed. Dropping of highly correlated variables does not affect the result significantly. The first principal component reflects the major chemical variation in Fe and Mg. When using ferrous and ferric iron as separate entries of the analysis, either the second or the third component demonstrates a temperature dependence. It is, however, not possible to obtain pure temperature and chemical components due to the composition not being uncorrelated to temperature of formation. From these components a graph reflecting temperature of formation has been constructed.     

Rheological properties of Na-smectite gels used for rock sealing

The use of Na-smectite clay gels for sealing rock fractures is studied in phase 3 of the Strips project. The rheological properties of these gels and the mathematical formulations necessary to simulate the behaviour are presented in this article, including the breakdown of the structure at small strains as well as the flow behaviour of the vibrated and unvibrated gel.

An important conclusion is that the flow properties of an unvibrated gel do not follow Newton's classical viscosity law, while the shear resistance of the gel affected by vibrations is strongly reduced and the flow behaviour is Newtonian.     

Isotopic anomalies of noble gases in meteorites and their origins—VII. C3V carbonaceous chondrites

Noble gases were measured in bulk samples of the C3V chondrites Grosnaja, Vigarano, and Leoville, and in HF,HCl-insoluble residues before and after etching with HNO₃. The residues were characterized by INAA and SEM. Gas components were determined, directly or by subtraction, for the following fractions: HF,HCl-solubles (?98% of the meteorite), ‘sphase Q’, a poorly characterized trace mineral that is insoluble in HCl-HF but soluble in HNO₃, and an insoluble residue, consisting of ferrichromite, carbonaceous matter, and spinel.Bulk meteorites show some correlation of the noble-gas pattern with McSween's subclasses: two ‘oxidized’ C3V's—Allende (LEWIS et al, 1975) and Grosnaja— have lower Ar/Xe but higher Ne/Xe ratios than the ‘reduced’ C3V's—Vigarano and Leoville—which are transitional to LL3's and C3O chondrites in both respects. An HCl-soluble mineral of high Ar/Xr ratio seems to be responsible. In other respects, the 3 C3V's of this study resemble Allende, with only moderate differences. Phase Q contains most of the Ar, Kr, Xe, but only small amounts of Ne; the etched residues contain planetary Ne ($\text{Ne}{}^{20}\text{Ne}{}^{22}\text{? 8.5}$) and the controversial CCFXe component, enriched in the heavy Xe isotopes ($\text{Xe136}\text{Xe132 ? 0.4–0.5}$). The CCFXe is accompanied by an ‘L-Xe’ component that is enriched in the light Xe isotopes. The proportion of the two is virtually constant in C3V's. as in all other C-chondrites. in contrast to the ~ 2-fold variation in ordinary chondrites.C3V's have systematically higher $\text{Xe}{}^{136}\text{Xe}{}^{132}$ ratios, and hence higher ratios of CCFXe to planetary Xe, than do other chondrite classes. This may reflect some peculiarity in their formation conditions, favoring uptake of CCFXe.     

A study on the fractionation of organic matter in natural water by ultrafiltration techniques

Diaflo ultrafilters have been studied for the fractionation of organic matter in natural water. One method for their use, including pretreatment, is described. The filter retention is not only depending on the weight of the molecule but also on the charge as shown by experiments with dyestuffs and inorganic ions. For pure solutions of phosphate and nitrate the retentions were 77 and 27% respectively. Filter UM 2, with a nominal molecular weight cutoff at 1,000, retained coloured and total organic matter to 94 and 91% respectively. UM 10 (10,000) retained coloured matter to 88%. Through filtrations the binding of calcium to organic in water was found to be 1 to 10%.