Analysing Debris-Flow Impact Models, Based on a Small Scale Modelling Approach

The objective of this study is to analyse adaptable debris-flow impact models, which are very important for mitigation measurements and buildings using their sphere of influence. For this reason, 16 debris-flow experiments, on a small-scale modelling approach, were performed. Impact forces were measured with a force plate panel, consisting of 24 aluminium devices, coaxially mounted with resistance strain gauges. Flow velocities, flow heights as well as horizontal impact forces were sampled with a frequency of 2.4 kHz. Sub datasets of sampled raw force data were defined by applying an average median filter, a low-pass filter routine. Further, estimated peak pressure values as well as empirical coefficients of hydraulic impact models were compared, and the influence of signal processing is discussed.     

Oxygen isotope and chemical compositions of magnetite and olivine in the anomalous CK3 Watson 002 and ungrouped Asuka‐881595 carbonaceous chondrites: Effects of parent body metamorphism

We report in situ O isotope and chemical compositions of magnetite and olivine in chondrules of the carbonaceous chondrites Watson‐002 (anomalous CK3) and Asuka (A)‐881595 (ungrouped C3). Magnetite in Watson‐002 occurs as inclusion‐free subhedral grains and rounded inclusion‐bearing porous grains replacing Fe,Ni‐metal. In A‐881595, magnetite is almost entirely inclusion‐free and coexists with Ni‐rich sulfide and less abundant Ni‐poor metal. Oxygen isotope compositions of chondrule olivine in both meteorites plot along carbonaceous chondrite anhydrous mineral (CCAM) line with a slope of approximately 1 and show a range of Δ¹⁷O values (from approximately ?3 to ?6‰). One chondrule from each sample was found to contain O isotopically heterogeneous olivine, probably relict grains. Oxygen isotope compositions of magnetite in A‐881595 plot along a mass‐dependent fractionation line with a slope of 0.5 and show a range of Δ¹⁷O values from ?2.4‰ to ?1.1‰. Oxygen isotope compositions of magnetite in Watson‐002 cluster near the CCAM line and a Δ¹⁷O value of ?4.0‰ to ?2.9‰. These observations indicate that magnetite and chondrule olivine are in O isotope disequilibrium, and, therefore, not cogenetic. We infer that magnetite in CK chondrites formed by the oxidation of pre‐existing metal grains by an aqueous fluid during parent body alteration, in agreement with previous studies. The differences in Δ¹⁷O values of magnetite between Watson‐002 and A‐881595 can be attributed to their different thermal histories: the former experienced a higher degree of thermal metamorphism that led to the O isotope exchange between magnetite and adjacent silicates.     

Optimal and sustainable extraction of groundwater in coastal aquifers

Four examples are investigated for the optimal and sustainable extraction of groundwater from a coastal aquifer under the threat of seawater intrusion. The objectives and constraints of these management scenarios include maximizing the total volume of water pumped, maximizing the profit of selling water, minimizing the operational and water treatment costs, minimizing the salt concentration of the pumped water, and controlling the drawdown limits. The physical model is based on the density-dependent advective-dispersive solute transport model. Genetic algorithm is used as the optimization tool. The models are tested on a hypothetical confined aquifer with four pumping wells located at various depths. These solutions establish the feasibility of simulating various management scenarios under complex three-dimensional flow and transport processes in coastal aquifers for the optimal and sustainable use of groundwater.     

Bayesian maximum entropy approach and its applications: a review

The present paper reviews the conceptual framework and development of the Bayesian Maximum Entropy (BME) approach. BME has been considered as a significant breakthrough and contribution to applied stochastics by introducing an improved, knowledge-based modeling framework for spatial and spatiotemporal information. In this work, one objective is the overview of distinct BME features. By offering a foundation free of restrictive assumptions that limit comparable techniques, an ability to integrate a variety of prior knowledge bases, and rigorous accounting for both exact and uncertain data, the BME approach was coined as introducing modern spatiotemporal geostatistics. A second objective is to illustrate BME applications and adoption within numerous different scientific disciplines. We summarize examples and real-world studies that encompass the perspective of science of the total environment, including atmosphere, lithosphere, hydrosphere, and ecosphere, while also noting applications that extend beyond these fields. The broad-ranging application track suggests BME as an established, valuable tool for predictive spatial and space–time analysis and mapping. This review concludes with the present status of BME, and tentative paths for future methodological research, enhancements, and extensions.     

The mobilization and deposition of mud deposits in a coastal plain estuary

Muddy sediments with their potential for containing contaminants are commonly deposited and remobilized by tidal currents in estuarine environments. We examined the mobilization and subsequent redeposition of mud in a coastal plain estuary located in the southeastern United States. Time-series data for salinity, suspended sediment concentrations and quality (percent organic matter and pigment concentrations) were obtained over a 13-hour tidal cycle. We found that fast-settling mud particles are found during the highest tidal current speeds. Particle quality analyses suggest that all the material is of similar origin, and that phaeopigment can be used as a tracer of particles in this system. These particles settle onto the bed when current speeds approach slack conditions. We speculate that the quantity of mud mobilized during neap tide is less than during spring tide resulting in an opportunity for the mud to partially consolidate on the bottom and be removed from resuspension. We further speculate that the muddy sediments are mainly derived from fringing marshes in this estuary.     

Elastic response of catamaran wetdeck to liquid impact

The impact of an elastic plate onto the compressible fluid without free surface deformation is considered. The ability of the liquid volume to be deformed is geometrically limited which leads to severe impact conditions. The present analysis is focused on the stresses in the plate and the hydrodynamic loads under the impact. The motivation for this research comes from ship hydrodynamics, where the hulls of a catamaran restrict the liquid outflow and the water impacts onto the wetdeck. The influence of the air on the impact process is investigated. The analysis did not reveal any great advantage of utilizing the air-cushion effect or ejection of air into the water near the impact region to prevent high stresses in the elastic plate. It was found that in the problem considered, the stress peaks far from the plate centre and the one-mode approximation does not provide correct information about the stress level.     

Noril’sk–Talnakh Cu–Ni–PGE deposits: a revised tectonic model

The Norilsk mining district is located at the northwest margin of the Tunguska basin, in the centre of the 3,000×4,000 km Siberian continental flood basalt (CFB) province. This CFB province was formed at the Permo-Triassic boundary from a superplume that ascended into the geometric centre of the Laurasian continent, which was surrounded by subducting slabs of oceanic crust. We suggest that these slabs could have reached the core–mantle boundary, and they may have controlled the geometric focus of the superplume. The resulting voluminous magma intruded and erupted in continental rifts and related extensive flood basalt events over a 2–4 Ma period. Cu–Ni–PGE sulfide mineralization is found in olivine-bearing differentiated mafic intrusions beneath the flood basalts at the northwestern margin of the Siberian craton and also in the Taimyr Peninsula, some 300 km east of a triple junction of continental rifts, now buried beneath the Mesozoic–Cenozoic sedimentary basin of western Siberia. The Norilsk-I and Talnakh-Oktyabrsky deposits occur in the Norilsk–Kharaelakh trough of the Tunguska CFB basin. The Cu–Ni–PGE-bearing mineralized intrusions are 2–3 km-wide and 20 km-long differentiated chonoliths. Previous studies suggested that parts of the magma remained in intermediate-level crustal chambers where sulfide saturation and accumulation took place before emplacement. The 5–7-km-thick Neoproterozoic to Palaeozoic country rocks, containing sedimentary Cu mineralization and evaporites, may have contributed additional metal and sulfur to this magma. Classic tectonomagmatic models for these deposits proposed that subvertical crustal faults, such as the northeast-trending Norilsk–Kharaelakh fault, were major trough-parallel conduits providing access for magmas to the final chambers. However, geological maps of the Norilsk region show that the Norilsk–Kharaelakh fault offsets the mineralization, which was deformed into folds and offset by related reverse faults, indicating compressional deformation after mineralization in the Late Triassic to Early Jurassic. In addition, most of the intrusions are sills, not dykes as should be expected if the vertical faults were major conduits. A revised tectonic model for the Norilsk region takes into account the fold structure and sill morphology of the dominant intrusions, indicating a lateral rather than vertical emplacement direction for the magma into final chambers. Taking into account the fold structure of the country rocks, the present distribution of the differentiated intrusions hosting the Norilsk-I and Talnakh–Oktyabrsky deposits may represent the remnants of a single, >60 km long, deformed and eroded palm-shaped cluster of mineralized intrusions, which are perceived as separate intrusions at the present erosional level. The original direction of sill emplacement may have been controlled by a northeast-trending paleo-rise, which we suggest is present at the southeastern border of the Norilsk–Kharaelakh trough based on analysis of the unconformity at the base of the CFB. The mineralized intrusions extend along this rise, which we interpret as a structure that formed above the extensionally tilted block in the metamorphic basement. Geophysical data indicate the presence of an intermediate magma chamber that could be linked with the Talnakh intrusion. In turn, this T-shaped flat chamber may link with the Yenisei–Khatanga rift along the northwest-trending Pyasina transform fault, which may have served as the principal magma conduit to the intermediate chamber. It then produced the differentiated mineralized intrusions that melted through the evaporites with in situ precipitation of massive, disseminated, and copper sulfide ore. The Norilsk–Kharaelakh crustal fault may not relate to mineralization and possibly formed in response to late Mesozoic spreading in the Arctic Ocean.Editorial handling: P. Lightfoot