Ground deformation of the southern sector of the Aeolian islands volcanic arc from geodetic data

The deformation pattern and the dynamics of the southern sector of the Aeolian archipelago are investigated. A study on the ground deformation, measured over the last 20 years in the trilateration geodetic network between the islands of Vulcano and Lipari, has been conducted. Analysis of the relative displacements and the uniform strain tensor parameters, as well as the comparison between areal dilatation and the vertical variations deduced by precise levelling, allow distinguishing different phases associated both with the regional dynamics and the local volcanic context of the area. These phases, however, appear to be closely interrelated. The analysis of the deformation pattern allows to constrain the predominance of a roughly E–W trending extension and a N–S contraction at a regional scale. This regime is consistent with right-lateral movements along a NW–SE striking fault system.     

Monitoring and modelling of pore water pressure changes and riverbank stability during flow events

Pore water pressures (positive and negative) were monitored for four years (1996–1999) using a series of tensiometer‐piezometers at increasing depths in a riverbank of the Sieve River, Tuscany (central Italy), with the overall objective of investigating pore pressure changes in response to ?ow events and their effects on bank stability. The saturated/unsaturated ?ow was modelled using a ?nite element seepage analysis, for the main ?ow events occurring during the four‐year monitoring period. Modelling results were validated by comparing measured with computed pore water pressure values for a series of representative events. Riverbank stability analysis was conducted by applying the limit equilibrium method (Morgenstern‐Price), using pore water pressure distributions obtained by the seepage analysis. The simulation of the 14 December 1996 event, during which a bank failure occurred, is reported in detail to illustrate the relations between the water table and river stage during the various phases of the hydrograph and their effects on bank stability. The simulation, according to monitored data, shows that the failure occurred three hours after the peak stage, during the inversion of ?ow (from the bank towards the river). A relatively limited development of positive pore pressures, reducing the effective stress and annulling the shear strength term due to the matric suction, and the sudden loss of the con?ning pressure of the river during the initial drawdown were responsible for triggering the mass failure. Results deriving from the seepage and stability analysis of nine selected ?ow events were then used to investigate the role of the ?ow event characteristics (in terms of peak stages and hydrograph characteristics) and of changes in bank geometry. Besides the peak river stage, which mainly controls the occurrence of conditions of instability, an important role is played by the hydrograph characteristics, in particular by the presence of one or more minor peaks in the river stage preceding the main one. Copyright © 2004 John Wiley & Sons, Ltd.     

Major changes in volcano behaviour after a sector collapse: insights from Stromboli, Italy

In recent years, increasing numbers of volcanoes are being recognized as having undergone large sector collapses. How far such events can change the succeeding behaviour of the volcano is poorly known, despite the importance for natural hazards and economic applications. By analysing the last 100‐kyr geological history of Stromboli (Italy), which has involved multiple collapses, this paper illuminates the feedback effect between sector collapse and magma upwelling and emplacement. The collapsed zone of Stromboli is episodically unbuttressed, draining magma preferentially with formation of eruptive centres in the collapse amphitheatre and dyking along the collapse shoulders. After a collapse, there were no further linear eruptions across the cone on opposing middle–lower slopes, but these occurred again after rebuilding of the cone. The time‐averaged eruption rate increased immediately before the first collapse and remained higher during the succeeding period of frequent collapses.     

A complex, Subplinian-type eruption from low-viscosity, phonolitic to tephri-phonolitic magma: the AD 472 (Pollena) eruption of Somma-Vesuvius, Italy

The combined use of field investigation and laboratory analyses allowed the detailed stratigraphic reconstruction of the Pollena eruption (472 AD) of Somma-Vesuvius. Three main eruptive phases were recognized, related either to changes in the eruptive processes and/or to relative changes of melt composition. The eruption shows a pulsating behavior with deposition of pyroclastic fall beds and generation of dilute and dense pyroclastic density currents (PDC). The eruptive mechanisms and transportation dynamics were reconstructed for the whole eruption. Column heights were between 12 and 20 km, corresponding to mass discharge rates (MDR) of 7×10⁶ kg/s and 3.4×10⁷ kg/s. Eruptive dynamics were driven by magmatic fragmentation of a phono-tephritic to tephri-phonolitic magma during Phases I and II, whereas phreatomagmatic fragmentation dominated Phase III. Magma composition varies between phonolitic and tephritic-phonolitic, with melt viscosity likely not in excess of 10³ Pa s. The volume of the pyroclastic fall deposits, calculated by using of proximal isopachs, is 0.44 km³. This increases to 1.38 km³ if ash volumes are extrapolated on a log thickness vs. square root area diagram using one distal isopach and column height.Editorial responsibility: R Cioni     

Climate control on stacked paleosols in the Pleistocene of the Po Basin (northern Italy)

Paleosols are recurrent features in alluvial successions and provide information about past sedimentary dynamics and climate change. Through sedimentological analysis on six sediment cores, the mud-dominated succession beneath the medieval ‘Two Towers’ of Bologna was investigated down to 100 m depth. A succession of weakly developed paleosols (Inceptisols) was identified. Four paleosols (P1, P2, P3 and PH) were radiocarbon-dated to 40–10 cal ka bp . Organic matter and CaCO₃ determinations indicate low groundwater levels during soil development, which spanned periods < 5 ka. The development and burial of soils, which occurred synchronously in the Bologna region and in other sectors of the Po Plain, are interpreted to reflect climatic and eustatic variations. Climatic oscillations, at the scale of the Bond cycles, controlled soil development and burial during Marine Isotope Stage (MIS) 3 (P1 and P2). Rapid sea-level oscillations probably induced soil development at the MIS 3/2 transition (P3) and favored burial of PH after 10 ka bp . Weakly developed paleosols in alluvial successions can provide clues to millennial-scale climatic and environmental variations. In particular, the paleosol-bearing succession of the Po Plain represents an unprecedent record of environmental changes across the Late Pleistocene (MIS 3 and 2) in the Mediterranean region.     

Chemical and textural equilibration of garnet during amphibolite facies metamorphism: The influence of coupled dissolution–reprecipitation

Metamorphic equilibration requires chemical communication between minerals and may be inhibited through sluggish volume diffusion and or slow rates of dissolution in a fluid phase. Relatively slow diffusion and the perceived robust nature of chemical growth zoning may preclude garnet porphyroblasts from readily participating in low‐temperature amphibolite facies metamorphic reactions. Garnet is widely assumed to be a reactant in staurolite‐isograd reactions, and the evidence for this has been assessed in the Late Proterozoic Dalradian pelitic schists of the Scottish Highlands. The 3D imaging of garnet porphyroblasts in staurolite‐bearing schists reveals a good crystal shape and little evidence of marginal dissolution; however, there is also lack of evidence for the involvement of either chlorite or chloritoid in the reaction. Staurolite forms directly adjacent to the garnet, and its nucleation is strongly associated with deformation of the muscovite‐rich fabrics around the porphyroblasts. “Cloudy” fluid inclusion‐rich garnet forms in both marginal and internal parts of the garnet porphyroblast and is linked both to the production of staurolite and to the introduction of abundant quartz inclusions within the garnet. Such cloudy garnet typically has a Mg‐rich, Mn‐poor composition and is interpreted to have formed during a coupled dissolution–reprecipitation process, triggered by a local influx of fluid. All garnet in the muscovite‐bearing schists present in this area is potentially reactive, irrespective of the garnet composition, but very few of the schists contain staurolite. The staurolite‐producing reaction appears to be substantially overstepped during the relatively high‐pressure Barrovian regional metamorphism reflecting the limited permeability of the schists in peak metamorphic conditions. Fluid influx and hence reaction progress appear to be strongly controlled by subtle differences in deformation history. The remaining garnet fails to achieve chemical equilibrium during the reaction creating distinctive patchy compositional zoning. Such zoning in metamorphic garnet created during coupled dissolution–reprecipitation reactions may be difficult to recognize in higher grade pelites due to subsequent diffusive re‐equilibration. Fundamental assumptions about metamorphic processes are questioned by the lack of chemical equilibrium during this reaction and the restricted permeability of the regional metamorphic pelitic schists. In addition, the partial loss of prograde chemical and textural information from the garnet porphyroblasts cautions against their routine use as a reliable monitor of metamorphic history. However, the partial re‐equilibration of the porphyroblasts during coupled dissolution–reprecipitation opens possibilities of mapping reaction progress in garnet as a means of assessing fluid access during peak metamorphic conditions.     

Late‐glacial to Holocene depositional architecture of the Ombrone palaeovalley system (Southern Tuscany,Italy): Sea‐level,climate and local control in valley‐fill variability

The Ombrone palaeovalley was incised during the last glacial sea‐level fall and was infilled during the subsequent Late‐glacial to Holocene transgression. A detailed sedimentological and stratigraphic study of two cores along the palaeovalley axis led to reconstruction of the post‐Last Glacial Maximum valley‐fill history. Stratigraphic correlations show remarkable similarity in the Late‐glacial to early‐Holocene succession, but discrepancy in the Holocene portion of the valley fill. Above the palaeovalley floor, about 60 m below sea‐level, Late‐glacial sedimentation is recorded by an unusually thick alluvial succession dated back to ca 18 cal kyr bp . The Holocene onset was followed by the retrogradational shift from alluvial to coastal facies. In seaward core OM1, the transition from inner to outer estuarine environments marks the maximum deepening of the system. By comparison, in landward core OM2, the emplacement of estuarine conditions was interrupted by renewed continental sedimentation. Swamp to lacustrine facies, stratigraphically equivalent to the fully estuarine facies of core OM1, represent the proximal expression of the maximum flooding zone. This succession reflects location in a confined segment of the valley, just landward of the confluence with a tributary valley. It is likely that sudden sediment input from the tributary produced a topographic threshold, damming the main valley course and isolating its landward segment from the sea. The seaward portion of the Ombrone palaeovalley presents the typical estuarine backfilling succession of allogenically controlled incised valleys. In contrast, in the landward portion of the system, local dynamics completely overwhelmed the sea‐level signal, following marine ingression. This study highlights the complexity of palaeovalley systems, where local morphologies, changes in catchment areas, drainage systems and tributary valleys may produce facies patterns significantly different from the general stratigraphic organization depicted by traditional sequence‐stratigraphic models.