Magnetic fabrics and rock magnetism of Proterozoic dike swarm from the southern São Francisco Craton, Minas Gerais State, Brazil

Magnetic fabric and rock magnetism studies were performed on 32 mafic dikes of a Proterozoic dike swarm from the southern São Francisco Craton (SFC; Minas Gerais State, SE Brazil). Magnetic anisotropies were determined by applying anisotropy of low-field magnetic susceptibility (AMS) and anisotropy of remanent magnetization (ARM). The latter was performed imposing both anhysteretic (total (AAR) and partial pAAR)) and isothermal remanence magnetizations (AIRM). Partial anhysteretic remanence anisotropy was performed based on remanent coercivity spectra from a pilot specimen of each site. In most sites, AMS is dominantly carried by ferromagnetic minerals, however, in some sites, the paramagnetic contribution exceeds 70% of bulk susceptibility. Rock magnetism and thin section analysis allow classifying the dikes as non-hydrothermalized and hydrothermalized. Magnetic measurement shows that the mean magnetic susceptibility is usually lower than 5×10⁻³ (SI). Ti-poor titanomagnetites up to pure magnetite pseudo-single-domain (PSD) grain sizes carry the majority of magnetic fabrics for non-hydrothermalized dikes whereas coarse to fine grained Ti-poor titanomagnetites carry the majority of magnetic fabrics for hydrothermalized dikes.Three primary AMS fabrics are recognized which are coaxial with ARM fabric, except for two dikes, from both non-hydrothermalized and hydrothermalized dikes. Normal AMS fabric surprisingly is not dominant (31%). The parallelism between AMS, pAAR_0–30, pAAR_30–60 and pAAR_60–90 fabrics in the hydrothermalized dikes indicates that magnetic grains formed due to late-stage crystallization or to remobilization of iron oxides due to hydrothermal alteration after dike emplacement have acquired a mimetic fabric coaxial with the primary fabric given by coarse-grained early crystallized Ti-poor titanomagnetites. This fabric is interpreted as magma flow in which the analysis of K_max inclination permitted the inference that the dikes were fed by horizontal or subhorizontal fluxes (K_max<30°). Intermediate AMS fabric is the most important (41%) in the investigated swarm. It is interpreted as due to vertical compaction of a static magma column with the minimum stress along the dike strike. ARM determinations for these sites also remained intermediate except for two dikes. In one of them, AIRM fabric resulted in normal AMS fabric while for the other AAR fabric resulted in inverse AMS fabric. A combination of AMS and ARM fabrics suggest that magmatic fabric for both dikes were overprinted by some late local event, probably related to Brasiliano orogenic processes after dike emplacement. InverseInverse AMS fabric is a minority (four dikes). ARM determinations also remained inverse suggesting a primary origin for inverse AMS fabric.     

Vegetation dynamics during the late Pleistocene in the Barreirinhas region, Maranhão State, northeastern Brazil, based on carbon isotopes in soil organic matter

The study place is in the Barreirinhas region, Maranhão State, northeastern Brazil. A vegetation transect of 78 km was studied among four vegetation types: Restinga (coastal vegetation), Cerrado (woody savanna), Cerradão (dense woody savanna), and Forest, as well as three forested sites around Lagoa do Caçó, located approximately 10 km of the transect. Soil profiles in this transect were sampled for δ¹³C analysis, as well as buried charcoal fragments were used for ¹⁴C dating. The data interpretation indicated that approximately between 15,000 and ∼9000 ¹⁴C yr B.P., arboreal vegetation prevailed in the whole transect, probably due to the presence of a humid climate. Approximately between ∼9000 and 4000-3000 ¹⁴C yr B.P., there was the expansion of the savanna, probably related to the presence of drier climate. From ∼4000-3000 ¹⁴C yr B.P. to the present, the results indicated an increase in the arboreal density in the area, due to the return to a more humid and probably similar climate to the present. The presence of buried charcoal fragments in several soil depths suggested the occurrence of palaeofires during the Holocene. The vegetation dynamic inferred in this study for northeastern Brazil is in agreement with the results obtained in areas of Amazon region, based on pollen analysis of lake sediments and carbon isotope analysis of soil organic matter (SOM), implying than similar climatic conditions have affected these areas during the late Pleistocene until the present.     

Using a regional numerical weather prediction model for GNSS positioning over Brazil

The global navigation satellite system (GNSS) can provide centimeter positioning accuracy at low costs. However, in order to obtain the desired high accuracy, it is necessary to use high-quality atmospheric models. We focus on the troposphere, which is an important topic of research in Brazil where the tropospheric characteristics are unique, both spatially and temporally. There are dry regions, which lie mainly in the central part of the country. However, the most interesting area for the investigation of tropospheric models is the wet region which is located in the Amazon forest. This region substantially affects the variability of humidity over other regions of Brazil. It provides a large quantity of water vapor through the humidity convergence zone, especially for the southeast region. The interconnection and large fluxes of water vapor can generate serious deficiencies in tropospheric modeling. The CPTEC/INPE (Center for Weather Forecasting and Climate Studies/Brazilian Institute for Space Research) has been providing since July 2012 a numerical weather prediction (NWP) model for South America, known as Eta. It has yield excellent results in weather prediction but has not been used in GNSS positioning. This NWP model was evaluated in precise point positioning (PPP) and network-based positioning. Concerning PPP, the best positioning results were obtained for the station SAGA, located in Amazon region. Using the NWP model, the 3D RMS are less than 10 cm for all 24 h of data, whereas the values reach approximately 60 cm for the Hopfield model. For network-based positioning, the best results were obtained mainly when the tropospheric characteristics are critical, in which case an improvement of up to 7.2 % was obtained in 3D RMS using NWP models.     

Estimation of transit trip production using Factorial Kriging with External Drift: an aggregated data case study

Studies in transportation planning routinely use data in which location attributes are an important source of information. Thus, using spatial attributes in urban travel forecasting models seems reasonable. The main objective of this paper is to estimate transit trip production using Factorial Kriging with External Drift (FKED) through an aggregated data case study of Traffic Analysis Zones in São Paulo city, Brazil. The method consists of a sequential application of Principal Components Analysis (PCA) and Kriging with External Drift (KED). The traditional Linear Regression (LR) model was adopted with the aim of validating the proposed method. The results show that PCA summarizes and combines 23 socioeconomic variables using 4 components. The first component is introduced in KED, as secondary information, to estimate transit trip production by public transport in geographic coordinates where there is no prior knowledge of the values. Cross-validation for the FKED model presented high values of the correlation coefficient between estimated and observed values. Moreover, low error values were observed. The accuracy of the LR model was similar to FKED. However, the proposed method is able to map the transit trip production in several geographical coordinates of non-sampled values.     

Bioadsorption by sugarcane bagasse for the reduction in oil and grease content in aqueous effluent

Several techniques have been used to reduce the oil and grease content in aqueous streams; one excellent is bioadsorption. With a view to provide a sustainable method for the treatment of oily effluents, the aim of this study was to evaluate sugarcane bagasse as bioadsorbent to reduce the oil and grease content of aqueous effluents. Analysis of the material was performed, and the adsorption experiments were in a batch system, using a synthetic effluent. The results showed that the kinetic equilibrium occurred in 0.08 h of contact. The study of influence of pH of the aqueous phase and the temperature showed that the adsorption capacity was proportional to the pH value, but inversely proportional to the temperature. The adsorption isotherm was obtained at a temperature of 298.15 K using the Langmuir and Langmuir–Freundlich models, and the maximum adsorption capacity obtained was 6.65 kg of hydrocarbon per kg of bioadsorbent. It was verified that sugarcane bagasse represents an excellent material for application in the treatment of oily aqueous effluents, since it is associated with low cost and a high adsorption capacity. The variation in the adsorption capacity observed as a function of pH of the aqueous phase was not found to be significant. This is an important characteristic of the material in terms of its industrial application, verifying the possibility for its implementation in any treatment process, demonstrating the great potential of sugarcane bagasse for use as a sustainable alternative in the reduction in oil and grease in aqueous effluents.