Thermal convection in ice-I shells of Titan and Enceladus

Cassini-Huygens observations have shown that Titan and Enceladus are geologically active icy satellites. Mitri and Showman [Mitri, G., Showman, A.P., 2005. Icarus 177, 447-460] and McKinnon [McKinnon, W.B., 2006. Icarus 183, 435-450] investigated the dynamics of an ice shell overlying a pure liquid-water ocean and showed that transitions from a conductive state to a convective state have major implications for the surface tectonics. We extend this analysis to the case of ice shells overlying ammonia-water oceans. We explore the thermal state of Titan and Enceladus ice-I shells, and also we investigate the consequences of the ice-I shell conductive-convective switch for the geology. We show that thermal convection can occur, under a range of conditions, in the ice-I shells of Titan and Enceladus. Because the Rayleigh number Ra scales with δ³/ηb, where δ is the thickness of the ice shell and ηb is the viscosity at the base of the ice-I shell, and because ammonia in the liquid layer (if any) strongly depresses the melting temperature of the water ice, Ra equals its critical value for two ice-I shell thicknesses: for relatively thin ice shell with warm, low-viscosity base (Onset I) and for thick ice shell with cold, high-viscosity base (Onset II). At Onset I, for a range of heat fluxes, two equilibrium states—corresponding to a thin, conductive shell and a thick, convective shell—exist for a given heat flux. Switches between these states can cause large, rapid changes in the ice-shell thickness. For Enceladus, we demonstrate that an Onset I transition can produce tectonic stress of ∼500 bars and fractures of several tens of km depth. At Onset II, in contrast, we demonstrate that zero equilibrium states exist for a range of heat fluxes. For a mean heat flux within this range, the satellite experiences oscillations in surface heat flux and satellite volume with periods of ∼50-800 Myr even when the interior heat production is constant or monotonically declining in time; these oscillations in the thermal state of the ice-I shell would cause repeated episodes of extensional and compressional tectonism.     

An in situ investigation of the preservation and alteration of presolar silicates in the Miller Range 07687 chondrite

Dust grains that formed around ancient stars and in stellar explosions seeded the early solar protoplanetary disk. While most of such presolar grains were destroyed during solar system formation, a fraction of such grains were preserved in primitive materials such as meteorites. These grains can provide constraints on stellar origins and secondary processing such as aqueous alteration and thermal metamorphism on their parent asteroids. Here, we report on the nature of aqueous alteration in the Miller Range (MIL) 07687 chondrite through the analysis of four presolar silicates and their surrounding material. The grains occur in the Fe-rich and Fe-poor lithologies, reflecting relatively altered and unaltered material, respectively. The O-isotopic compositions of two grains, one each from the Fe-rich and Fe-poor matrix, are consistent with formation in the circumstellar envelopes of low-mass Asymptotic Giant Branch (AGB)/Red Giant Branch (RGB) stars. The other two grains, also one each from the Fe-rich and Fe-poor matrix, have O-isotopic compositions consistent with formation in the ejecta of type-II supernovae (SNe). The grains derived from AGB/RGB stars include two polycrystalline pyroxene grains that contain Fe-rich rims. The SNe grains include a polycrystalline Ca-bearing pyroxene and a polycrystalline assemblage consistent with a mixture of olivine and pyroxene. Ferrihydrite is observed in all focused ion beam sections, consistent with parent-body aqueous alteration of the fine-grained matrix under oxidizing conditions. The Fe-rich rims around presolar silicates in this study are consistent with Fe-diffusion into the grains resulting from early-stage hydrothermal alteration, but such alteration was not extensive enough to lead to isotopic equilibration with the surrounding matrix.     

Experimental analysis of arsenic precipitation during microbial sulfate and iron reduction in model aquifer sediment reactors

Microbial SO₄²⁻ reduction limits accumulation of aqueous As in reducing aquifers where the sulfide that is produced forms minerals that sequester As. We examined the potential for As partitioning into As- and Fe-sulfide minerals in anaerobic, semi-continuous flow bioreactors inoculated with 0.5% (g mL⁻¹) fine-grained alluvial aquifer sediment. A fluid residence time of three weeks was maintained over a ca. 300-d incubation period by replacing one-third of the aqueous phase volume of the reactors with fresh medium every seven days. The medium had a composition comparable to natural As-contaminated groundwater with slightly basic pH (7.3) and 7.5 μM aqueous As(V) and also contained 0.8 mM acetate to stimulate microbial activity. Medium was delivered to a reactor system with and without 10 mmol L⁻¹ synthetic goethite (α-FeOOH). In both reactors, influent As(V) was almost completely reduced to As(III). Pure As-sulfide minerals did not form in the Fe-limited reactor. Realgar (As₄S₄) and As₂S₃(am) were undersaturated throughout the experiment. Orpiment (As₂S₃) was saturated while sulfide content was low (∼50 to 150 μM), but precipitation was likely limited by slow kinetics. Reaction-path modeling suggests that, even if these minerals had formed, the dissolved As content of the reactor would have remained at hazardous levels. Mackinawite (Fe_1 + xS; x ? 0.07) formed readily in the Fe-bearing reactor and held dissolved sulfide at levels below saturation for orpiment and realgar. The mackinawite sequestered little As (<0.1 wt.%), however, and aqueous As accumulated to levels above the influent concentration as microbial Fe(III) reduction consumed goethite and mobilized adsorbed As. A relatively small amount of pyrite (FeS₂) and greigite (Fe₃S₄) formed in the Fe-bearing reactor when we injected a polysulfide solution (Na₂S₄) to a final concentration of 0.5 mM after 216, 230, 279, and 286 days. The pyrite, and to a lesser extent the greigite, that formed did sequester As from solution, containing 0.84 and 0.23 wt.% As on average, respectively. Our results suggest that As precipitation during Fe-sulfide formation in nature occurs mainly in conjunction with pyrite formation. Our findings imply that the effectiveness of stimulating microbial SO₄²⁻ reduction to remediate As contamination may be limited by the rate and extent of pyrite formation and the solubility of As-sulfides.     

The connection of geodynamics with seismicity patterns

When a study is to be made of seismic risks, the present-day geodynamic conditions are of fundamental importance: Earthquakes do not happen by themselves, they do have a cause. The cause of earthquakes is that the tectonic stresses exceed a critical limit. The build-up of these stresses is conditioned by the geodynamic processes occurring in the region in question. A knowledge of the geodynamics characteristic of a region is therefore fundamental for seismic risk studies. The general methodology for making such a geodynamic study is based on the entire set of manifestations of the plate-tectonic conditions of that region: these include the mechanism of earthquakes, the stresses observed in mines, the orientation of surface joints and even the direction of river valleys. Examples of geodynamic studies and their bearing on seismic risks are shown from various areas of the world, notably from China, India, and Colombia.     

Temporal association of arc–continent collision,progressive magma contamination in arc volcanism and formation of gold-rich massive sulphide deposits on Wetar Island (Banda arc)

Whole-rock ⁸⁷Sr/⁸⁶Sr and δ¹⁸O analyses of volcanic rocks and ³He/⁴He analyses of sulphides and sulphates from mineralized rocks on Wetar, Indonesia indicate a variable contribution of assimilated crustal material or sediment sourced from the subducted Australian craton to the south. These new data support the idea of progressive source contamination with precisely dated events showing that Wetar Island hosts the most extreme examples of crustal assimilation in the region. The increased continental contamination occurs during the Pliocene (Zanclian to Piacenzian) during distinct magmatic events between 5 and 4 Ma, and at 2.4 Ma when ⁸⁷Sr/⁸⁶Sr ratios in unaltered lavas, with whole-rock δ¹⁸O values between 5.7 and 9.6‰, increase from 0.707484 to extreme radiogenic values of 0.711656.The earlier of these magmatic events is important in the generation of the hydrothermal systems responsible for the mineralization recorded on Wetar. Samples from this yield radiogenic ³He/⁴He ratios between 0.5 and 1.4 R/R_A, similar to the data from volcanic rocks on nearby Romang. The later magmatic event coincides with the arrival of the Australian Continental Margin at the subduction zone along the Banda arc. Progressive incorporation of continental-sourced components into the source region below the Wetar Island edifice coincides with the formation of gold-rich volcanogenic massive sulphide deposits hosted within the contaminated volcanic pile.     

Unravelling the evolution of an Alpine to post-glacially active fault in the Swiss Alps

The Gemmi fault is a prominent NW–SE striking lineament that crosses the Gemmi Pass in the central Swiss Alps. A multidisciplinary investigation of this structure that included geological mapping, joint profiling, cathodoluminescence and scanning electron microscopy, stable isotope measurements, luminescence- and U-TH-dating, 3D ground penetrating radar (GPR) surveying and trenching reveals a history of fault movements from the Miocene to the Holocene. The main fault zone comprises a 0.5–3 m thick calcite cataclasite formed during several cycles of veining and brittle deformation. Displaced Cretaceous rock layers show an apparent dextral slip of 10 m along the fault.A detailed study of a small sediment-filled depression that crosses the fault provides evidence for a post-glacial reactivation of the fault. A trench excavated across the fault exposed a Late-Glacial-age loess layer and late Holocene colluvial-like slope-wash deposits that showed evidence for fault displacement of a few centimeters, indicating a recent strike-slip reactivation of the fault. Focal mechanisms of recent instrumentally recorded earthquakes are consistent with our findings that show that the fault at the Gemmi Pass, together with other parallel faults in this area, may be reactivated in today's stress field. Taking together all the observations of its ancient and recent activity, the Gemmi fault can be viewed as a window through geological space and time.