Observations of rapid mean flow produced in mercury by a moving heater

Abstract

Experimental and theoretical results are described for the moving flame experiment, where a heat source moves under a horizontal, annular channel filled with liquid mercury. The physical range under discussion consists of the creep flow limit, in which inertial forces are less than viscous forces. A mean surface flow was observed on the mercury. This flow was up to four times greater than the heater speed, and in an opposite direction. The ratio of mean flow to heater speed was theoretically and experimentally found to be proportional to the square of the thermal amplitude, in agreement with a special limit of Davey's earlier results. The basic flow here, as contrasted to those flows analyzed by earlier theories, appears to be generated by surface tension. However, the Reynolds stress mechanism which generates the mean flow is the same. Some experimental flows were so rapid that the range of validity of the present, as well as some earlier theories, was exceeded. The present theory suggests that the higher order nonlinearities may have cancellative effects, which implies that the present and some earlier theories are valid beyond their normal range of validity.     

Local hydraulic gradient estimator analysis of long-term monitoring networks

Three measurements of head at unique locations form a three-point estimator of the local magnitude and orientation of the hydraulic gradient. The relative head measurement error (RHME) is defined here as the measurement error normalized by the head drop across the three-point estimator. Monte Carlo simulation results show that estimators with base to height ratios between 0.5 and 5.0 and that are large enough to keep the RHME below 0.05 create the most accurate gradient estimates and provide criteria for identifying good estimators. These criteria are applied to an example ground water monitoring network design problem in the Culebra dolomite near the Waste Isolation Pilot Plant repository to both analyze temporal changes and modify and expand the current monitoring network. Limiting the three-point estimators to those that meet the shape and RHME criteria reduces the number of possible estimators by >50% and leads to approximately 1 order of magnitude decrease in the average estimated magnitude of the gradient relative to using all estimators. Application of these criteria also reduces the variability in estimated gradient magnitude and orientation between the two time periods of measurements. Redundant wells in the network are identified by removing each existing well in turn and determining which removals yield the smallest decrease in the number of acceptable estimators. Optimal new well locations are identified by mapping the increase in total number of acceptable estimators for a single new well placed in the study domain.     

Mineralogical, chemical, and crystallographic properties of supergene jarosite-group minerals from the Xitieshan Pb-Zn sulfide deposit, northern Tibetan Plateau, China

Supergene jarosite-group minerals are widespread in weathering profiles overlying Pb-Zn sulfide ores at Xitieshan, northern Tibetan Plateau, China. They consist predominantly of K-deficient natrojarosite, with lesser amounts of K-rich natrojarosite and plumbojarosite. Electron microprobe (EMP) analyses, scanning electron microcopy (SEM) investigation, and X-ray mapping reveal that the jarosite-group minerals are characterized by spectacular oscillatory zoning composed of alternating growth bands of K-deficient and K-bearing natrojarosite (K₂O >1 wt.%). Plumbojarosite, whenever present, occurs as an overgrowth in the outermost bands, and its composition can be best represented by K_0.29Na_0.19Pb_0.31Fe_2.66Al_0.22(SO₄)_1.65(PO₄)_0.31(AsO₄)_0.04(OH)_7.37. The substitution of monovalent for divalent cations at the A site of plumbojarosite is charge balanced by the substitution of five-valent for six-valent anions in XO₄ at the X site. Thermogravimetric analysis (TGA) of representative samples reveal mass losses of 11.46 wt.% at 446.6 °C and 21.42 wt.% at 683.4 °C due to dehydroxylation and desulfidation, respectively. TGA data also indicate that the natrojarosite structure collapses at 446.6 °C, resulting in the formation of NaFe(SO₄)₂ and minor hematite. The decomposition products of NaFe(SO₄)₂ are hematite and Na₂SO₄. Powder X-ray diffraction (XRD) analyses show that the jarosite-group minerals have mean unit-cell parameters of a?=?7.315 Å and c?=?016.598 Å. XRD and EMP data support the view that substitutions of Na for K in the A site and full Fe occupancy in the B site can considerably decrease the unit-cell parameter c, but only slightly increase a. The results from this study suggest that the observed oscillatory zoning of jarosite-group minerals at Xitieshan resulted mainly from substitutions of K for Na at the A site and P for S at the X site.     

Multi-decadal synthesis of benthic–pelagic coupling in the western arctic: Role of cross-shelf advective processes

Using geographic information systems (GIS) software and geostatistical techniques, we utilized three decades of water-column chlorophyll a data to examine the relative importance of autochthonous versus allochthonous sources of reduced carbon to benthic communities that occur from the northern Bering to the eastern Beaufort Sea shelf. Spatial trend analyses revealed areas of high benthic biomass (>300 g m⁻²) and chlorophyll (>150 mg m⁻²) on both the southern and northern Chukchi shelf; both areas are known as depositional centers for reduced organic matter that originates on the Bering Sea shelf and is advected northward in Anadyr and Bering shelf water masses. We found a significant correlation between biomass and chlorophyll a in the Chukchi Sea, reflective of the strong benthic–pelagic coupling in a system that is utilized heavily by benthic-feeding marine mammals. In contrast, there was no significant correlation between biomass and chlorophyll in the Beaufort Sea, which by comparison, is considerably less productive (biomass and chlorophyll, <75 g m⁻² and <50 mg m⁻², respectively). One notable exception is an area of relatively high biomass (50–100 g m⁻²) and chlorophyll (80 mg m⁻²) near Barter Island in the eastern Beaufort Sea. Compared to other adjacent areas in the Beaufort Sea, the chlorophyll values in the vicinity of Barter Island were considerably higher and likely reflect a long-hypothesized upwelling in that area and close coupling between the benthos and autochthonous production. In the Bering Sea, a drop in benthic biomass in 1994 compared with previous measurements (1974–1993) may support earlier observations that document a decline in biomass that began between the 1980s and 1990s in the Chirikov Basin and south of St. Lawrence Island. The results of this study indicate that the benthos is an excellent long-term indicator of both local and physical advective processes. In addition, this work provides further evidence that secondary production on arctic shelves can be significantly augmented by reduced carbon advected from highly productive adjacent shelves.     

Investigation of ammonia removal from polluted waters by Clinoptilolite zeolite

Ammonia nitrogen compounds in the wastewaters and effluents have harmful effects on water resources. Ion exchange with zeolites is a separation process for ammonia removal from effluents. The objective of this research was to study the efficiency of an ammonia removal and the factor affecting to this process. The Clinoptilolite was obtained from Semnan mines at the north part of Iran. The samples were grounded and sieved based on the U.S. standard mesh number 20, 30, 40 and conditioned by ammonia sulfate and sodium chloride solutions. The characteristics of samples for ammonia removal and the selectivity sequence for adsorbing interfering cations were then determined. Results shown that the average ion exchange capacity of zeolite in batch and continuous systems were 6.65–16 and 16.31–19.5 mg NH₄ ⁺ /g zeolite weight, respectively. In study on the zeolite for selective cations showed the ranking of K⁺, NH₄ ⁺, Na⁺, Ca²⁺ and Mg²⁺ respectively. Results indicated that high level of regeneration (95–98%) might be achieved with NaCl solution. Based on the results, Clinoptilolite may be effective applied in wastewater treatment, both from technical and economical aspects.     

Subpollen Particles as Atmospheric Cloud Condensation Nuclei

Izvestiya, Atmospheric and Oceanic Physics - Bioparticles constitute a significant fraction of atmospheric aerosol. Their size range varies from nanometers (macromolecules) to hundreds of...     

Suitable gravity interpolation technique for large data gaps in Africa

Studia Geophysica et Geodaetica - The gravity database for the IAG African Geoid Project contains significantly large data gaps. These large data gaps affect the interpolation precision of the...     

A six-step practical approach to semivariogram modeling

Geostatistical prediction and simulation are being increasingly used in the earth sciences and engineering to address the imperfect knowledge of attributes that fluctuate over large areas or volumes—pollutant concentration, electromagnetic fields, porosity, thickness of a geological formation. Central to the application of such techniques is the need to know the spatial continuity, knowledge that is commonly condensed in the form of covariance or semivariogram models. Their preparation is subdivided here into the following steps: (1) Data editing, (2) Exploratory data analysis, (3) Semivariogram estimation, (4) Directional investigation, (5) Simple modeling, (6) Nested modeling. I illustrate these stages practically with a real data set from a geophysical survey from Elk County, Kansas, USA. The applicability of the approach is not limited by the physical nature of the attribute of interest.     

Structure Function Analysis of Two-Scale Scalar Ramps. Part II: Ramp Characteristics and Surface Renewal Flux Estimation

Ramp features in the turbulent scalar field are associated with turbulent coherent structures, which dominate energy and mass fluxes in the atmospheric surface layer. Although finer scale ramp-like shapes embedded within larger scale ramp-like shapes can readily be perceived in turbulent scalar traces, their presence has largely been overlooked in the literature. We demonstrate the signature of more than one ramp scale in structure functions of the turbulent scalar field measured from above bare ground and two types of short plant canopies, using structure-function time lags ranging in scale from isotropic to larger than the characteristic coherent structures. Spectral analysis of structure functions was used to characterize different scales of turbulent structures. By expanding structure function analysis to include two ramp scales, we characterized the intermittency, duration, and surface renewal flux contribution of the smallest (i.e., Scale One) and the dominant (i.e., Scale Two) coherent structure scales. The frequencies of the coherent structure scales increase with mean wind shear, implying that both Scale One and Scale Two are shear-driven. The embedded Scale One turbulent structure scale is ineffectual in the surface-layer energy and mass transport process. The new method reported here for obtaining surface renewal-based scalar exchange works well over bare ground and short canopies under unstable conditions, effectively eliminating the α calibration for these conditions and forming the foundation for analysis over taller and more complex surfaces.