南充市城区地质环境质量分区模糊评价

在收集了大量的地质资料的基础上,结合地理信息系统的数据库和空间分析功能,通过专家一层次分析法确定权重,运用模糊评判法对南充市城市地质环境质量进行分区评价。地质环境是城市建设和发展的基础,随着城市化进程加快,城市地质环境问题越来越突出。因此,对城市地质环境条件进行定量评价,对于城市规划和建设具有重要的指导意义：评价的结果将南充市城市地质环境划分为3个区11个亚区,各区地质环境质量有明显的差异,并提出城市建设合理的发展方向。     

Spin rate estimation of sounding rockets using GPS wind-up

Carrier phase wind-up is a well-known effect that arises from the relative rotation between a transmitting and receiving antenna. In GPS measurements at L1 frequency, this effect translates into an error of 19.029 cm per full relative rotation of antennas. Since this effect is independent of the satellite elevation for pure rotation about the antenna boresight axis, it is usually absorbed by the clock estimation in navigation algorithms. Therefore, the impact of wind-up is usually neglected for applications that do not require accuracies to the cm level like RTK. However, in receiving platforms with high rotation rate, the accumulated wind-up value can be important and actually be larger than receiver noise or even ionospheric variations. Therefore, in such scenarios, the wind-up contribution can be isolated and used as a source of information to compute the spin rate of such platforms using an appropriate combination of GPS observables. This work shows some results of a coarse, yet simple, approach to monitor the rotation angle and spin-rate of spin stabilized sounding rockets flown by DLR.     

基于WiMAX的地质灾害应急无线通信系统探索

基于OFDM核心技术的WiMAX(全球微波接入互操作性)具有4G技术的特点。与3G和WiFi无线通讯技术相比具有明显的高速率、大容量数据传输优势。本文就基于WiMAX的地质灾害应急通讯系统的几种技术方案加以详细论述,说明WiMAX在地质灾害应急指挥中具有广阔前景。     

实验变差函数计算方法的研究与运用

本文系统、详尽地分析讨论了不同样品数据条件下实验变差函数的计算方法。在实验变差函数计算流程的设计和有效样品搜索域的确定方面提出了自己独特的见解。最后用一个矿山的控矿工程教据对文中介绍的方法进行了测试。结果表明,利用本文的方法,容易得到稳健、准确、信息量高的实验变差函数。     

Fluid inclusion and stable isotope characteristics of the Karalar (Gazipaşa,Antalya) barite-galena deposits,Southern Turkey

The Karalar galena-barite deposits are typical examples of the carbonate-hosted barite-galena deposits widely occurring in the Central Tauride Belt. These deposits are located in Permian limestones as ore veins along fault zones that are discordant to the bedding planes and as thin veinlets within hardly brecciated bottom zones of Permian limestones. The ore deposits contain mainly barite and galena and small amounts of sphalerite, pyrite, fahlore, limonite, quartz, and calcite. Barites occur during the earlier episode of mineralization and were mylonitized before the formation of galena. Galena and other minerals occur epigenetically with barite along porous zones between brecciated barite crystals and are especially abundant in the hardly mylonitized zones. Fluid inclusion studies indicate that the ore deposits of the area were developed by hydrothermal fluids with following characteristics: they contained NaCl, CaCl₂, and MgCl₂; the salinity of the fluids was relatively high and their temperature was low during the crystallization of barites in the earlier episode of mineralization; and the salinity of the fluids decreased and their temperature increased during the crystallization of sulfide minerals through the later episode of mineralization. δ₁₈O and the δD results indicate that the water in the mineralizing fluid was of meteoric origin. The deposits were formed by deep meteoric water circulating through marine sediments. Shallow circulating and slightly warmed fluids dissolved Ba and sulfate from marine sediments of the basement and transported them to the mineralization environment during the early episode, while deep circulating and more heated fluids dissolved Pb, Zn, and other elements from the basement and reached the environment during the later episode of mineralization. The text was submitted by the authors in English.     

Simulations of 3D DC borehole resistivity measurements with a goal-oriented <Emphasis Type="Italic">hp</Emphasis> finite-element method. Part II: through-casing resistivity instruments

We simulate direct current (DC) borehole resistivity measurements acquired in steel-cased deviated wells for the assessment of rock formation properties. The assumed data acquisition configuration considers one current (emitter) and three voltage (collector) electrodes that are utilized to measure the second difference of the electric potential along the well trajectory. We assume a homogeneous, 1.27-cm-thick steel casing with resistivity equal to 10^− 5 Ω· m. Simulations are performed with two different numerical methodologies. The first one is based on transferring two-dimensional (2D) axisymmetric optimal grids to a three-dimensional (3D) simulation software. The second one automatically produces optimal 3D grids yielded by a 3D self-adaptive goal-oriented algorithm. Both methodologies utilize high-order finite elements (FE) that are specially well-suited for problems with high-contrast coefficients and rapid spatial variations of the electric field, as it occurs in simulations that involve steel-cased wells. The method based on transferring 2D-optimal grids is efficient in terms of CPU time (few seconds per logging position). Unfortunately, it may produce inaccurate 3D simulations in deviated wells, even though the error remains below 1% for the axisymmetric (vertical) well. The method based on optimal 3D grids, although less efficient in terms of CPU time (few hours per logging position), produces more accurate results that are validated by a built-in a posteriori error estimator. This paper provides the first existing simulations of through-casing resistivity measurements in deviated wells. Simulated resistivity measurements indicate that, for a 30° deviated well, measurements in conductive layers 0.01 Ω· m) are similar to those obtained in vertical wells. However, in resistive layers (10,000 Ω· m), we observe 100% larger readings in the 30° deviated well. This difference becomes 3,000% for the case of a 60° deviated well. For this highly-deviated well, readings corresponding to the conductive formation layer are about 30% smaller in magnitude than those in a vertical well. Shoulder effects significantly vary in deviated wells.     

Water balance in the playa-lakes of an arid environment,Monegros, NE Spain

The playa-lakes of the Monegros desert in north-east Spain are saline wetlands in an arid environment, a rare phenomenon in Europe. These extremely valuable habitats are threatened by changes associated with agricultural expansion and incorporation of new irrigated areas. An understanding of the present hydrologic regime will enable changes to be identified, particularly those brought about by flooding and pollution caused by irrigation surplus. This study sets out to show the results of applying a daily water balance in three selected playa-lakes. The balance was in two parts and consisted of: (1) the average balance for all the endorheic basin using the BALAN_11 program, and (2) the water balance in some playa-lakes, applying discharge flows obtained from the previous balance. The resulting volumes of water were converted to water depths and contrasted with reference volumes taken from field and Landsat images. The model was calibrated by applying various hypotheses of function which enabled the results to be adjusted. The proposed balance is an acceptable reproduction of field water measurements during this period, and underlines the consistency of the conceptual model. The methodology used is appropriate for understanding the playa-lakes function and for monitoring them for conservation purposes.     

Hydrogeochemistry and isotope analyses used to determine groundwater recharge and flow in low-gradient catchments of the province of Buenos Aires,Argentina

The region known as Pampa Plain, in Argentina, is a vast area characterized by slopes of less than 0.05%. The surface sediment is silty sand, mainly Aeolian, referred to as Pampean Loess, which is a phreatic aquifer unit of utmost importance for the water supply of the region. On account of the slight gradient, hydrogeological analyses using only hydraulic measurements are difficult to perform, often leading to confusing results. Thus, the study presented relies on hydrochemical modeling and isotopic determinations as well. The study area comprises three catchments in the inter-mountainous area corresponding to El Moro, Tamangueyú and Seco creeks, and covering 2,570 km² in the province of Buenos Aires. Measurements of piezometric levels and samples of groundwater, surface water and rainwater were carried out between January and March 2005. Major ion results were analyzed by means of hydrochemical graphs and hydrogeochemical modelling using NETPATH. The resulting data show that it is possible to identify local changes in recharge, flow direction and stream/groundwater relationship by using hydrochemical and isotopic information, which may become a useful and more precise tool for the study of particularly flat landscapes.     

Sediment Organic Carbon in Todos Santos Bay, Baja California, Mexico

Sediment grain size and organic carbon (OC) data collected over the past 50 years, together with δ¹³C values of OC in recently collected samples, were analyzed to improve understanding of sediment OC distribution and abundance in Todos Santos Bay. Sediments in the submarine canyon at the mouth of the bay and in quiet-water locations along the shore are fine grained, high in OC, and have generally low δ¹³C values; sediments in high-energy environments are low in OC and have high δ¹³C values. A bivariate isotopic mixing model indicates that none of the sediments contain >50% terrigenous OC (average ~30%), and that the terrigenous OC content of the sediments is a small proportion of the OC content of local soils. Sediment OC composition is apparently controlled by energy-related sorting and deposition, oxidation of much of the original terrigenous OC, and replacement of some terrigenous OC by marine OC.