Evaluation of the Flow Measurement Performance of Compound Sharp-Crested Over-Fall Weirs and Optimized Discharge Measurement in Data Scarce Areas

Water Resources - The hydraulic relationships of flow through the weir of different common shapes were investigated in this study. The hydraulic performances of weirs were carried out...     

Boundary-Layer Turbulence Over The Nebraska Sandhills

Data from National Centre for Atmospheric Research (NCAR) Queen Air boundary-layer flights over the Nebraska Sandhills are analyzed to investigate the effects of these low hills on boundary-layer turbulence. The Sandhills are an area of anisotropic rolling terrain with characteristic wavelengths of order 2km and rms height variations of order 25m. The biggest impact is found in early morning flight data where horizontal velocity perturbations appear at the same wavelengths as the terrain and variances (normalised by u ² , where u is the local friction velocity) are significantly enhanced relative to standard flat terrain values. By contrast the vertical velocity variance seems less affected and terrain effects are much less evident in data from the afternoon convective boundary layer.     

Metal contamination of the environment by placer and primary gold mining in the Adola region of southern Ethiopia

Primary and placer gold mining sites in southern Ethiopia were studied to see the contribution of mining to the accumulation of metals in different environmental media. Sediment, water and plant samples were analyzed for Al, Mn, Fe, As, Ni, Cr, Cu, Co, Pb, W, Sb, Mo, Zn and V. Water parameters (pH, Eh, TDS, anions and cations) were also measured. The sediment analyses results show that the most abundant metals are Ni (average 224.7 mg/kg), Cr (199 mg/kg), Cu (174.2 mg/kg), V (167.3 mg/kg), Zn (105.5 mg/kg), Pb (61.5 mg/kg) and As (59.7 mg/kg) in the primary gold mining sites while the placer sites show high concentration of V (average 301.2 mg/kg), Cr (260.4 mg/kg), Zn (179 mg/kg), Ni (113.4 mg/kg), Cu (46.7 mg/kg), As (32.2 mg/kg) and Co (31 mg/kg). The metals Cu, Ni, W, Cr, As and Pb in primary and Sb, W, Cr, Ni, Zn, As and Mo in placer gold mining sites have geoaccumulation indexes (I _geo) from one to four indicating considerable accumulation of these metals. Waters from both primary and placer mining sites are near neutral to alkaline. Arsenic (average 92.8 μg/l), Ni (276.6 μg/l), Pb (18.7 μg/l), Sb (10.7 μg/l), Mn (1 mg/l), Fe (8.3 mg/l) and Al (23.8 mg/l) exceeded the guideline value for drinking water. Plants show high concentration of Cr (average 174.5 mg/kg), Ni (163.5 mg/kg), Zn (96 mg/kg) and W (48 mg/kg). Zinc, W, Mo, Ni and Cr show the maximum biological absorption coefficient (BAC) ranging 0.4–1.7, 0.1–104.6, 1.1–2.6, 0.2–1.6 and 0.2–3.6, respectively, and the results suggest bioaccumulation of these elements in plants. The minerals especially sulfides in the ore aggregate are the ultimate source of the metals. The release of the metals into the environmental media is facilitated (in addition to normal geologic processes) by human activities related to gold mining.     

Sinkhole formation and subsidence along the Dead Sea coast,Israel

More than 4,000 sinkholes have formed since the 1980s within a 60-km-long and 1-km-wide strip along the western coast of the Dead Sea (DS) in Israel. Their formation rate accelerated in recent years to >400 sinkholes per year. They cluster mostly in specific sites up to 1,000 m long and 200 m wide, which align parallel to the general direction of the fault systems associated with the DS Rift. The abrupt appearance of the sinkholes reflects changes to the groundwater regime around the shrinking DS. The eastward retreat of the shoreline and the lake-level drop (1 m/year in recent years) cause an eastward and downward migration of the fresh/saline groundwater interface. Consequently, a subsurface salt layer, which was previously enveloped by saline groundwater, is gradually being invaded and submerged by relatively fresh groundwater, and cavities form due to the rapid dissolution of the salt. Collapse of the overlying sediments into these cavities results in sinkholes at the surface. An association between sinkhole sites and land subsidence is revealed by interferometric synthetic aperture radar (InSAR) measurements. On a broad scale (hundreds of meters), subsidence occurs due to compaction of fine-grained sediments as groundwater levels decline along the retreating DS shoreline. At smaller scales (tens of meters), subsidence appears above subsurface cavities in association with the sinkholes, serving in many cases as sinkhole precursors, a few weeks to more than a year before their actual appearance at the surface. This paper overviews the processes of sinkhole formation and their relation to land subsidence.     

The role of hydrogeological base level in the formation of sub-horizontal caves horizons, example from the Dead Sea Basin, Israel

This paper deals with the hydrogeological relationship between base levels of saline lakes and the formation of sub-horizontal caves. The mechanism presented here suggests that many horizontal cave levels in carbonate sequences are created adjacent to the saline lakes shorelines because of the converging of the groundwater flow above the fresh–saline water interface. The main factors that control enhanced carbonate dissolution and cave formation are high groundwater flow velocities in the shallow phreatic zone during a relative long steady state of the water table. High groundwater flow velocities are evident close to the Dead Sea due to the convergent fast flows above the shallow interface adjacent to the shoreline. The same could prevail in the case of previous paleo-lakes that existed in the basin. The synergetic combination of the above preconditions for enhanced cave formation seems to be responsible for the formation of elevation-controlled alignment of paleo-near shore cave levels in the central and southern (Dead Sea) portion of the study area. These are found on the western fault escarpment and basin margin in different stratigraphic horizons of carbonate lithology. Many of the cave levels can be linked to late Quaternary–Holocene lake levels obtained from dated lake sediments within the basin. The most common cave’s elevation was found to be around 200 m below sea level which was the elevation of the Lisan Lake during part of its history. On the other hand, the Hula Basin in the northern part of the Dead Sea Basin was not occupied by saline water bodies since its formation as a base level, and thus the above preconditions for enhanced cave formation did not prevail. Indeed, this is evident by the lack of horizontal cave levels on its western carbonate margins unlike the situation in the south.     

Three-dimensional configuration and dynamics of the fresh–saline water interface near two saline lakes with different levels (Middle East)

A typical fresh–saline water interface in a coastal aquifer is characterized by saline-water circulation below the interface and freshwater flow above. Both flows are perpendicular to the shoreline. The flow pattern near two separated saline lakes is more complicated. For example, in the Middle East, the Dead Sea northern basin and the evaporation ponds of the Dead Sea Works are adjacent to each other but separated. The northern basin level is dropping by 1.1 m/year and the evaporation ponds’ levels are increasing by 0.2 m/year. The fresh–saline water interface in such situation is numerically simulated. Streamlines parallel or semiparallel to the shoreline are significant. Moreover, the fresh–saline water interface intrudes landward adjacent to the higher saline lake and is pushed lakeward adjacent to the lower saline lake. The simulation results support field observations showing that the interface migrates vertically at a faster rate relative to the changes in the water table and the lake levels.

     

Line-source multi-tracer test for assessing high groundwater velocity

Segmented line-source multi-tracer injection is suggested as an effective method for assessing groundwater velocities and flow directions in subsurfaces characterized by high water flux. Modifying the common techniques of injecting a tracer into a well became necessary after point-source natural and forced gradient tracer tests ended with no reliable information on the local groundwater flow. The tracer's line-source increases the likelihood of success of the test and could provide additional information regarding the lateral heterogeneity of the aquifer. In a field experiment conducted in the northwestern part on the Dead Sea coast, tracers were injected into an 8-m-long line injection system perpendicular to the assumed flow direction. The injection system was divided into four separate segments with four different tracers. An array of five boreholes located within a 10 × 10 m area downstream was used for monitoring the tracers' transport. Two dye tracers (uranine and Na naphthionate) were injected in a long pulse of several hours into two of the injection pipe segments. Two other tracers (Rhenium oxide and Gd-DTPA) were instantaneously injected into the other two segments. The tracers were detected 0.7 to 2.3 h after injection in four of the five observation wells, located 2.3 to 10 m away from the injection system. The groundwater velocity was determined to be ～80 to 170 m/d, based on the recoveries of the tracers. The groundwater flow direction was derived based on the arrival of the tracers and was found to be quite consistent with the apparent direction of the hydraulic gradient.     

Human–Wildlife Conflicts and their Associated Livelihood Impacts in and Around Chebera-Churchura National Park,Ethiopia

Human–wildlife conflict is one of the major challenges in conservation biology. Here, we investigated the human–wildlife conflicts and their impacts in and around Chebera-Churchura National Park, Ethiopia. We conducted semistructured interview for 300 people and five focus group discussions from November 2010 to January 2011. In addition, scats of 60 spotted hyenas were collected and analyzed. Totally, 12 carnivores, 6 herbivores, and 2 primate species posing a significant problem were identified. Intensive human–wildlife conflict was observed in Churchura, Sere, and Chebera villages which were very close to the park. The carnivore’s attacks during 2007–2011 had caused about 30.49% of livestock losses. The overall economic loss by wildlife attacks was estimated to be US$ 75,234 (US$ 83/household/year). Scat analysis confirmed a substantial contribution (59%) of livestock to spotted hyena’s diet. Thus, combined strategies like improving livestock husbandries and strengthen the capacity of managers are imperative to mitigate the problems.     

Ground fissures within the Main Ethiopian Rift: Tectonic,lithological and piping controls

Ground fissures, especially if they open due to a sudden collapse of the surface, is a serious risk for populated areas. Their common occurrence in unconsolidated sediments of the Main Ethiopian Rift was found to be mostly a result of piping. The fissures start by piping in linear sub-horizontal underground voids, which often propagate upwards resulting in ceiling collapse and formation of deep and long ground fissures with vertical walls. In the southern and central Main Ethiopian Rift the fissures pose a serious risk to infrastructure and settlements. The ground fissures are often linear (up to several kilometres long and often tens of metres deep) and accompanied by sinkholes (along the length). A detailed field mapping of the geological (rock composition, orientation and character of lithological boundaries, primary fabrics and brittle structures) and geomorphological features (especially a length, width and depth of fissures, sinkholes and gullies) followed by in situ seismic anisotropy measurements and a laboratory determination of the geomechanical properties of volcanoclastic deposits was carried out to investigate the ground fissures' origin. The conditions and factors leading to the formation of the ground fissures have been linked to: (a) the presence of regional normal faults and the associated extensional joints and (b) the alternation of lithological units with contrasting hydraulic permeability. The latter corresponds to a sequence of less permeable hard rocks (e.g., rhyolitic ignimbrites) overlain by heterogeneous, soft and permeable, unconsolidated volcaniclastic deposits with a low amount of clay (less than 10%). The ground fissures' occurrence has shown affiliation to areas which have a significantly high seismic anisotropy (more than 20% at the study sites), which can be used as a proxy to map out high risk areas prone to piping and ground fissure formation.