川西南周公山及邻区下二叠统碳酸盐岩成岩作用对储集性的影响

川西南周公山及邻区下二叠统的中-低孔、中-低渗碳酸盐岩储层的储集空间以次生成因的溶孔、溶洞和构造裂缝为主.研究认为,多世代方解石胶结、化学充填作用以及埋藏期的压实(溶)作用是孔隙很难得到保存的主要原因;同生-准同生期的混合水云化作用和表生期、埋藏期的流体溶蚀作用则产生了大量的次生溶孔、洞,使储层的孔渗性得到明显的改善;构造破裂作用可以产生新的储集空间,还影响各储集体之间及单一储集体内部空隙的连通.成岩相分为混合水云化-溶蚀-破裂相、溶蚀-胶结相和胶结-压实-压溶相.各种成岩作用的叠加形成了现今下二叠统油气储层的分布格局.     

相控建模技术在羊二庄油田的应用

羊二庄油田的明馆储层非均质性严重,高含水、高开发后期的剩余油分布比较复杂,第一次油藏描述中应用传统的确定性建模方法已经不能满足剩余油挖潜的需要.采用RMS相控建模软件,通过构造建模、沉积微相建模、储层物性建模,建立羊二庄油田三维可视化相控地质模型,并实现了与数模软件的无缝接口.     

基于光谱和纹理的SVM矿化蚀变信息提取研究

针对传统矿化信息提取方法单一,利用光谱或纹理、信息量相对较少、需要大量样本的缺陷,利用基于光谱和纹理的支持向量机(SVM)原理,建立矿化信息提取模型.选择青海泽库县析界日地区作为典型研究区.首先提取研究区光谱和纹理信息,选取训练样本;然后求解最优超平面,进而确定决策函数;最后泛化推广识别其他待识别的样本.通过所提取的遥感蚀变异常信息与重砂异常点叠加分析,叠加基本吻合;从野外实地验证来看,均发现了不同程度的矿化现象,并指出了5个重点异常区.     

Accuracy assessment of lidar-derived digital elevation models

Despite the relatively high cost of airborne lidar-derived digital elevation models (DEMs), such products are usually presented without a satisfactory associated estimate of accuracy. For the most part, DEM accuracy estimates are typically provided by comparing lidar heights against a finite sample of check point coordinates from an independent source of higher accuracy, supposing a normal distribution of the derived height differences or errors. This paper proposes a new methodology to assess the vertical accuracy of lidar DEMs using confidence intervals constructed from a finite sample of errors computed at check points. A non-parametric approach has been tested where no particular error distribution is assumed, making the proposed methodology especially applicable to non-normal error distributions of the type usually found in DEMs derived from lidar. The performance of the proposed model was experimentally validated using Monte Carlo simulation on 18 vertical error data-sets. Fifteen of these data-sets were computed from original lidar data provided by the International Society for Photogrammetry and Remote Sensing Working Group III/3, using their respective filtered reference data as ground truth. The three remaining data-sets were provided by the Natural Environment Research Council's Airborne Research and Survey Facility lidar system, together with check points acquired using high precision kinematic GPS. The results proved promising, the proposed models reproducing the statistical behaviour of vertical errors of lidar using a favourable number of check points, even in the cases of data-sets with non-normally distributed residuals. This research can therefore be considered as a potentially important step towards improving the quality control of lidar-derived DEMs.     

遥感技术在地质找矿中的应用及发展前景

遥感技术作为矿产勘查的一种手段应用于找矿,并取得了一定成就.遥感技术的直接应用是蚀变遥感信息的提取,遥感技术的间接应用包括地质构造信息、植被的光谱特征及矿床改造信息等方面.遥感找矿具有很大的发展前景的领域主要有:高光谱数据、数据融合技术、3S的紧密结合、计算机技术的发展.     

The characteristics and sources of natural gases from Ordovician weathered crust reservoirs in the Central Gas Field in the Ordos Basin

The Central Gas Field is a famous large-sized gas field in the Ordos Basin of China. However, identification of main gas sources of the Ordovician reservoirs in this gas field remains puzzling. On the basis of a lot of geochemical data and geological research on natural gases, the characteristics and sources of natural gases from Ordovician weathered crust reservoirs in the Central Gas Field in the Ordos Basin were studied. The results indicated that natural gases from Ordovician weathered crust reservoirs in the Central Gas Field in the Ordos Basin have similar chemical and isotopic compositions to highly mature and over-mature dry gases. Both coal-derived gases and oil-type gases coexist in the Central Gas Field in the Ordos Basin. The former was derived mainly from Carboniferous-Permian coal measures and the latter from Lower Paleozoic marine carbonates. It is suggested that coal-derived gases occur in the eastern part of the Central Gas Field while oil-type gases may be produced mainly in the northern, western and southern parts of the Central Gas Field in the Ordos Basin.     

Environmental Redox Changes of the Ancient Sea in the Yangtze Area during the Ordo-Silurian Transition

Extensive organic-matter （OM） rich facies （black shales） occur in the Ordo-Silurian boundary successions in the Yangtze area, South China. To investigate the redox changes of the Yangtze Sea during the Ordo-Silurian transition, two OM sections （Wangjiawan in Yichang, Hubei Province, and Sanjiaguan in Zhangjiajie, Hunan Province） straddling the Ordo-Silurian boundary are studied. The measurements finished in this study include contents of the total organic carbon （TOC）, pyrite sulphur, and different species of Fe, including dithionite-extractable Fe （FED）, pyrite Fe （FeP）, HCl-extractable Fe （FeH）, and total Fe （FeT）, in black shales, as well as other redox proxies, such as the SIC ratio, the ratio between highly reactive Fe （FeHR = FeD ＋ FeP） and FeT, and the FeP/（FeP ＋ FeH） ratio, known as the degree of pyritization （DOP）. In the Wangjiawan section, the Middle Ashgill sediments have high FeHR/FeT ratios （0.20-0.77; avg. 0.45）, high DOP values （0.21-0.72; avg. 0.54）, and a relatively constant sulfur content independent of the organic carbon content. By the contrast, the mid-early Hirnantian deposits generally have low FeHR/FeT ratios （0.10-0.35; avg. 0.21）, low DOP values （0.11- 0.40; avg. 0.28）, and SIC values are clustering on the normal marine value （SIC = 0.36）. The late Hirnantian and early Rhuddanian deposits, similar to those of the Middle Ashgill deposits, are characterized by high FeHR/FeT ratios （0.32-0.49; avg. 0.41）, high DOP values （0.46-0.68; avg. 0.53） and fairly constant sulfur contents. These data suggest the occurrences of marine anoxia on the Yangtze Sea shelf during intervals of the Mid Ashgill, Late Hirnantian and Early Rhuddanian, and ventilated and oxygenated marine conditions during the mid-early Hirnantian time. The mid-early Hirnantian ventilated event was concomitant with the global glacial period, likely resulted from the glacio-eustatic sea-level fall and subsequent circulation of cold, dense oxygenated waters     

下庄矿田湖子地区铀矿找矿方向探讨

湖子地区位于NNE向诸广-新兴铀成矿带与近EW向大东山-漳州大断裂复合部位,是华南早、晚两期铀成矿热液活动叠加区、放射性高场区,既有"硅化带大脉"型铀矿产出,又有"交点"型铀矿存在,找矿前景良好.文章在论述下庄矿田铀成矿地质环境、铀成矿特征及铀矿定位条件基础上,分析了湖子地区铀成矿条件与找矿前景,指出该区今后铀矿找矿方向是:① 6009号硅化断裂带,在其北段找硅化带大脉型铀矿,在其南段找"交点"型铀矿;②新桥-下庄硅化断裂带和6009号带之间成矿部位,寻找硅化带型和"交点"型铀矿;③NW向、近EW向辉绿岩脉与NNE向、NE向构造交汇部位(交点),寻找"交点"型铀矿.     

From 2D TO 3D Through Modelling Based On A Single Image

Three-dimensional modelling from single images remains an interesting topic of investigation in the research community, even though range sensors are becoming a common alternative for the generation of 3D information. The interest in single-image-based modelling is motivated by a wide spectrum of applications such as cultural heritage, civil engineering, urban planning and even criminology. In this paper a complete new production flowline is presented for modelling based on a single image. The modelling process consists of a series of familiar steps in photogrammetry and computer vision: feature extraction, vanishing point computation, camera self-calibration, 3D reconstruction and dimensional analysis. In particular, the methodology developed for single-image-based modelling takes a scientific approach combining several proven techniques with robust estimators. Finally, in order to demonstrate its capabilities, the reported examples include several real situations applied in different contexts.