Isolation of resonance in acoustic backscatter from elastic targetsusing adaptive estimation schemes

It has been shown that at certain frequencies the acoustic backscatter from elastic targets exhibits certain resonance behavior which closely relates to the physical properties of the target such as dimension, thickness, and composition. The purpose of this paper is to develop an automated approach for identifying the presence of resonance in the acoustic backscatter from an unknown underwater target by isolating the resonance part from the specular contribution. An adaptive transversal filter structure is used to estimate the specular part of the backscatter and consequently the error signal would provide an estimate of the resonance part. An important aspect of this scheme lies in the fact that it does not require an underlying model for the elastic return. The adaptation rule is based upon fast recursive least squares (RLS) learning. The approach taken in this paper is general in the sense that it can be applied to targets of unknown geometry and thickness and, further, does not require any a priori information about the target and/or the environment. Test results on acoustic data are presented which indicate the effectiveness of the proposed approach     

The geochemistry of lead in rivers,estuaries and the continental shelf of the Southeastern United States

Transport by southeastern rivers has insignificant influence on the lead concentration of southeastern shelf waters. If the rate of mobilization and transport of lead by these rivers is representative of uncontaminated fluvial transport during the Pleistocene, only about 5% of the prehistoric output of lead to the North Atlantic can be accounted for by river input.Lead concentrations in southeastern shelf waters are similar to those of North Atlantic Water from the upper 1000 m, which is probably similar to the intrusion source water for the shelf. Atmospheric inputs to the shelf of the same magnitude as observed for the Western North Atlantic are difficult to reconcile given the residence time of shelf waters and their lead concentration unless the rate of loss of lead to shelf sediments is about the same as the atmospheric flux.     

Interplay between erosion and tectonics in the Western Alps

Bedrock fission‐track analysis, high‐resolution petrography and heavy mineral analyses of sediments are used to investigate the relationships between erosion and tectonics in the Western Alps. Along the Aosta Valley cross‐section, exhumation rates based on fission‐track data are higher in the fault‐bounded western block than in the eastern block (0.4–1.5 vs. 0.1–0.3 mm yr⁻¹). Erosion rates based on the analysis of bed‐load in the Dora Baltea drainage display the same pattern and have similar magnitudes in the relative sub‐basins (0.4–0.7 vs. 0.04–0.08 mm yr⁻¹). Results highlight that climate, relief and lithology are not the controlling factors of erosion in the Western Alps. The main driving force behind erosion is instead tectonics that causes the differential upward motion of crustal blocks.     

P‐wave transmission across fractures with nonlinear deformational behaviour

Stress wave attenuation across fractured rock masses is a great concern of underground structure safety. When the wave amplitude is large, fractures experience nonlinear deformation during the wave propagation. This paper presents a study on normal transmission of P‐wave across parallel fractures with nonlinear deformational behaviour (static Barton–Bandis model). The results show that the magnitude of transmission coefficient is a function of incident wave amplitude, nondimensional fracture spacing and number of fractures. Two important indices of nondimensional fracture spacing are identified, and they divide the area of nondimensional fracture spacing into three parts (individual fracture area, transition area and small spacing area). In the different areas, the magnitude of transmission coefficient has different trends with nondimensional fracture spacing and number of fractures. In addition, the study reveals that under some circumstances, the magnitude of transmission coefficient increases with increasing number of fractures, and is larger than 1. Copyright © 2006 John Wiley & Sons, Ltd.     

Reef exploration in the East Sengkang Basin,Sulawesi, Indonesia

Reconnaissance seismic shot in 1971/72 showed a number of well defined seismic anomalies within the East Sengkang Basin which were interpreted as buried reefs. Subsequent fieldwork revealed that Upper Miocene reefs outcropped along the southern margin of the basin. A drilling programme in 1975 and 1976 proved the presence of shallow, gas-bearing, Upper Miocene reefs in the northern part of the basin. Seismic acquisition and drilling during 1981 confirmed the economic significance of these discoveries, with four separate accumulations containing about 750 × 10⁹ cubic feet of dry gas in place at an average depth of 700 m. Kampung Baru is the largest field and contains over half the total, both reservoir quality and gas deliverability are excellent. Deposition in the East Sengkang Basin probably started during the Early Miocene. A sequence of Lower Miocene mudstones and limestones unconformably overlies acoustic basement which consists of Eocene volcanics. During the tectonically active Middle Miocene, deposition was interrupted by two periods of deformation and erosion. Carbonate deposition became established in the Late Miocene with widespread development of platform limestones throughout the East Sengkang Basin. Thick pinnacle reef complexes developed in the areas where reef growth could keep pace with the relative rise in sea level. Most reef growth ceased at the end of the Miocene and subsequent renewed clastic sedimentation covered the irregular limestone surface. Late Pliocene regression culminated in the Holocene with erosion. The Walanae fault zone, part of a major regional sinistral strike-slip system, separates the East and West Sengkang Basins. Both normal and reverse faulting are inferred from seismic data and post Late Pliocene reverse faulting is seen in outcrop.     

Multiple longshore sand bars in the upper Chesapeake Bay

In the upper Chesapeake Bay (Maryland, U.S.A.) field surveys were conducted at 18 multiple longshore sand bar sites. The multiple bar systems were found in water depths less than approximately 2 m (mean sea level), and exhibited mild bottom slopes of 0·0052 or less. The number of bars composing each system ranged from four to 17 and the spacing between the crests typically increased in the offshore direction, ranging from 12 to 70 m. Bar height also typically increased with distance offshore and ranged from 0·03 to 0·61 m. A grain size analysis of crest and trough sediment did not reveal any significant differences and the sediment was categorized as ‘fine sand’. A review of the literature data indicated that the Chesapeake Bay multiple bars possessed similar characteristics to those found in Gelding Bay (Baltic Sea); similarities in fetch, wave height and tidal range between the two bays may account for this finding. The surf-scaling parameter indicated that the multiple bar systems were extremely dissipative with regard to wave energy, and wave height appeared to be an important factor in controlling bar spacing and bar height. A multiple wave break point hypothesis was discussed as a possible mechanism for the formation of Chesapeake Bay multiple longshore bars, and limited observational evidence appeared to support such a mechanism.     

Sonar cross sections of bodies partially insonified by finite sound beams

An object that is partially insonified by a collimated sound beam may have a scattering cross section sometimes much larger than when the object is totally covered by the incident beam. We quantitatively study this partial insonification problem here, under the classical method of physical optics. The importance of this study stems from the fact that partial coverage of the target by the beam is the situation most likely to occur in many cases of practical importance. We consider several basic target shapes partially insonified by finite beams. These shapes include the spherical, the infinite and finite cylinder, the flat plate, and the capped sphere. High-frequency approximations of the resulting integrals, obtained by means of the saddle-point method, show the relative importance of the scattering centers located at the beam's specular reflection points, or at the edges of the spots that the beam shines on the scatterers. The physical-optics method is extended to obtain formulas for the bistatic cross sections of partially insonified objects. The results are numerically evaluated and graphically displayed in many pertinent instances and compared to the predictions of approaches, such as the Fresnel-zones method and the Geometrical Theory of Diffraction (GTD). The predictions of the physical-optics method have all the advantages and deficiencies of this method and, with very minor modifications, hold equally well for the partial illumination of objects by beams of electromagnetic radiation.     

Fluid production and isograd reactions at contacts of carbonate-rich and carbonate-poor layers during progressive metamorphism

ABSTRACT With increasing temperature during prograde metamorphism reactions will occur first at the lithological contacts of mixed pelite and calcsilicate terranes. At these interfaces, a fluid of lower chemical potential of H₂O and CO₂ than that required to produce a fluid in either layer can be produced whether reaction is caused by fluid infiltration or is initially fluid absent. If the interface region does not allow fluid transport then as temperature increases, a fluid pressure greater than lithostatic can develop. At some degree of over-pressure relative to rock pressure, the fluid hydraulically fractures the rock and a gradient in fluid composition away from the contact can be produced. These phenomena occur at the compositional interfaces whenever univariant reactions in the differing layers cross on a temperature vs. mole fraction of CO₂ diagram with slopes of opposite sign. The first occurrence of these reaction products at lithological contacts delineates an isograd that defines temperature as well as the mole fraction of CO₂ at constant pressure in systems open to fluid transport. These isograds can be contrasted with fluid-producing isograds in closed systems. As an illustration of possible effects, the reactions quartz + clinozoisite + muscovite = anorthite + K-feldspar + H₂O and phlogopite + quartz + calcite = tremolite + K-feldspar + H₂O + CO₂ at 4 kbar are analysed and equations for fluid production and transport are developed.