Measurements of Trace Gases in the Inflow of South China Sea Background Air and Outflow of Regional Pollution at Tai O, Southern China

We present a 16-month record of ozone (O₃), carbon monoxide (CO), total reactive nitrogen (NO_y), sulphur dioxide (SO₂), methane (CH₄), C₂ – C₈ non-methane hydrocarbons (NMHCs), C₁ – C₂ halocarbons, and dimethyl sulfide (DMS) measured at a southern China coastal site. The study aimed to establish/update seasonal profiles of chemically active trace gases and pollution tracers in subtropical Asia and to characterize the composition of the `background' atmosphere over the South China Sea (SCS) and of pollution outflow from the industrialized Pearl River Delta (PRD) region and southern China. Most of the measured trace gases of anthropogenic origin exhibited a winter maximum and a summer minimum, while O₃ showed a maximum in autumn which is in contrast to the seasonal behavior of O₃ in rural eastern China and in many mid-latitude remote locations in the western Pacific. The data were segregated into two groups representing the SCS background air and the outflow of regional continental pollution (PRD plus southern China), based on CO mixing ratios and meteorological conditions. NMHCs and halocarbon data were further analyzed to examine the relationships between their variability and atmospheric lifetime and to elucidate the extent of atmospheric processing in the sampled air parcels. The trace gas variability (S) versus lifetime (τ) relationship, defined by the power law, S_lnx = Aτ^{− b}, (where X is the trace gas mixing ratio) gives a fit parameter A of 1.39 and exponent b of 0.42 for SCS air, and A of 2.86 and b of 0.31 for the regional continental air masses. An examination of ln[n-butane]/ln[ethane] versus ln[propane]/ln[ethane] indicates that their relative abundance was dominated by mixing as opposed to photochemistry in both SCS and regional outflow air masses. The very low ratios of ethyne/CO, propane/ethane and toluene/benzene suggest that the SCS air mass has undergone intense atmospheric processing since these gases were released into the atmosphere. Compared to the results from other polluted rural sites and from urban areas, the large values of these species in the outflow of PRD/southern China suggest source(s) emitting higher levels of ethyne, benzene, and toluene, relative to light alkanes. These chemical characteristics could be unique indicators of anthropogenic emissions from southern China.     

Inverted-polarity electrical structures in thunderstorms in the Severe Thunderstorm Electrification and Precipitation Study (STEPS)

Balloon-borne electric field soundings and lightning mapping data have been analyzed for three of the storms that occurred in the Severe Thunderstorm Electrification and Precipitation Study field program in 2000 to determine if the storms had inverted-polarity electrical structures. The polarities of all or some of the vertically stacked charge regions in such storms are opposite to the polarities observed at comparable heights in normal storms. Analyses compared the charge structures inferred from electric field soundings in the storms with charges inferred from three-dimensional lightning mapping data. Charge structures were inferred from electric field profiles by combining the one-dimensional approximation of Gauss's law with additional information from three-dimensional patterns in the electric field vectors. The three different ways of inferring the charge structure in the storms were found to complement each other and to be consistent overall. Charge deposition by lightning possibly occurred and increased the charge complexity of one of the storms.Many of the cloud flashes in each case were inverted-polarity flashes. Two storms produced ground flash activity comprised predominantly of positive ground flashes. One storm, which was an isolated thunderstorm, produced inverted-polarity cloud flashes, but no flashes to ground. The positive and negative thunderstorm charge regions were found at altitudes where, respectively, negative and positive charge would be found in normal-polarity storms. Thus, we conclude that these storms had anomalous and inverted-polarity electrical structures. Collectively, these three cases (along with the limited cases in the refereed literature) provide additional evidence that thunderstorms can have inverted-polarity electrical structures.     

跨断裂水准剖面观测在地震监测中的应用

由于活动地块的相对运动和变形，其边界带往往构造活动强烈，是反映地壳运动的敏感部位。基于上述思路，昆仑山口西8．1级大震发生后，通过大范围监测布设在青藏块体北部地区及周边主要构造带上的水准剖面，在短期内快速获取了大范围的断裂活动信息和不同断裂带对大区域构造应力场变化的响应特征。实践证明，这种监测方式灵活、作业周期短、资料处理快，能及时对震情趋势做出估计，不失为当前区域形变监测工作的一种新的探索。     

Quality control algorithms for rainfall measurements

One of the basic requirements for a scientific use of rain data from raingauges, ground and space radars is data quality control. Rain data could be used more intensively in many fields of activity (meteorology, hydrology, etc.), if the achievable data quality could be improved. This depends on the available data quality delivered by the measuring devices and the data quality enhancement procedures. To get an overview of the existing algorithms a literature review and literature pool have been produced. The diverse algorithms have been evaluated to meet VOLTAIRE objectives and sorted in different groups. To test the chosen algorithms an algorithm pool has been established, where the software is collected. A large part of this work presented here is implemented in the scope of the EU-project VOLTAIRE (Validation of multisensors precipitation fields and numerical modeling in Mediterranean test sites).     

Efficiency of heavy liquid separation to concentrate magnetic particles

Low-temperature rock magnetic measurements have distinct diagnostic value. However, in most bulk marine sediments the concentration of ferrimagnetic and antiferromagnetic minerals is extremely low, so even sensitive instrumentation often responds to the paramagnetic contribution of the silicate matrix in the residual field of the magnetometer. Analysis of magnetic extracts is usually performed to solve the problems raised by low magnetic concentrations. Additionally magnetic extracts can be used for several other analyses, for example electron microscopy or X-ray diffraction. The magnetic extraction technique is generally sufficient for sediments dominated by magnetite. In this study however, we show that high-coercivity components are rather underrepresented in magnetic extracts of sediments with a more complex magnetic mineralogy. We test heavy liquid separation, using hydrophilic sodium polytungstenate solution Na₆[H₂W₁₂O₄₀], to demonstrate the efficiencies of both concentration techniques. Low-temperature cycling of zero-field-cooled, field-cooled and saturation isothermal remanent magnetization acquired at room temperature was performed on dry bulk sediments, magnetic extracts, and heavy liquid separates of clay-rich pelagic sediments originating from the Equatorial Atlantic. The results of the thermomagnetic measurements clarify that magnetic extraction favours components with high spontaneous magnetization, such as magnetite and titanomagnetite. The heavy liquid separation is unbiased with respect to high- and low-coercive minerals, thus it represents the entire magnetic assemblage.     

Centrifuge Modeling of Rock Slopes Susceptible to Block Toppling

Summary This paper presents the results of centrifuge tests that were aimed at validating the Goodman-Bray method for rock slope toppling analysis. The Goodman-Bray method was extended by the authors to accommodate non-persistent basal planes of rock columns. Two gypsum column models, with and without anchors were used to represent the failure modes. Measured critical centrifuge accelerations were in agreement with the results obtained from numerical modeling. A background of the toppling slope failures associated with a large hydropower project in China instigated the need for the centrifuge study. The centrifuge model tests used an artificial rock. The observed failure mode did not follow a straight failure plane as proposed by Goodman and Bray. The failures revealed a bi-planar slip surface with a deep-seated portion near the toe of the slope. The outcomes of the centrifuge tests illustrated the need to search for the critical failure surface when performing a toppling analysis. The search technique is similar to that usually performed in a conventional sliding analysis.     

Coupling of oceanic and continental crust during Eocene eclogite-facies metamorphism: evidence from the Monte Rosa nappe,western Alps

High precision U–Pb geochronology of rutile from quartz–carbonate–white mica–rutile veins that are hosted within eclogite and schist of the Monte Rosa nappe, western Alps, Italy, indicate that the Monte Rosa nappe was at eclogite-facies metamorphic conditions at 42.6 ± 0.6 Ma. The sample area [Indren glacier, Furgg zone; Dal Piaz (2001) Geology of the Monte Rosa massif: historical review and personal comments. SMPM] consists of eclogite boudins that are exposed inside a south-plunging overturned synform within micaceous schist. Associated with the eclogite and schist are quartz–carbonate–white mica–rutile veins that formed in tension cracks in the eclogite and along the contact between eclogite and surrounding schist. Intrusion of the veins at about 42.6 Ma occurred at eclogite-facies metamorphic conditions (480–570°C, >1.3–1.4 GPa) based on textural relations, oxygen isotope thermometry, and geothermobarometry. The timing of eclogite-facies metamorphism in the Monte Rosa nappe determined in this study is identical to that of the Gran Paradiso nappe [Meffan-Main et al. (2004) J Metamorphic Geol 22:261–281], confirming that these two units have shared the same Alpine metamorphic history. Furthermore, the Gran Paradiso and Monte Rosa nappes underwent eclogite-facies metamorphism within the same time interval as the structurally overlying Zermatt-Saas ophiolite [∼50–40 Ma; e.g., Amato et al. (1999) Earth Planet Sci Lett 171:425–438; Mayer et al. (1999) Eur Union Geosci 10:809 (abstract); Lapen et al. (2003) Earth Planet Sci Lett 215:57–72]. The nearly identical P–T–t histories of the Gran Paradiso, Monte Rosa, and Zermatt-Saas units suggest that these units shared a common Alpine tectonic and metamorphic history. The close spatial and temporal associations between high pressure (HP) ophiolite and continental crust during Alpine orogeny indicates that the HP internal basement nappes in the western Alps may have played a key role in exhumation and preservation of the ophiolitic rocks through buoyancy-driven uplift. Coupling of oceanic and continental crust may therefore be critical in preventing permanent loss of oceanic crust to the mantle.     

Vertical migration of municipal wastewater in deep injection well systems,South Florida,USA

Deep well injection is widely used in South Florida, USA for wastewater disposal largely because of the presence of an injection zone (“boulder zone” of Floridan Aquifer System) that is capable of accepting very large quantities of fluids, in some wells over 75,000 m³/day. The greatest potential risk to public health associated with deep injection wells in South Florida is vertical migration of wastewater, containing pathogenic microorganisms and pollutants, into brackish-water aquifer zones that are being used for alternative water-supply projects such as aquifer storage and recovery. Upwards migration of municipal wastewater has occurred in a minority of South Florida injection systems. The results of solute-transport modeling using the SEAWAT program indicate that the measured vertical hydraulic conductivities of the rock matrix would allow for only minimal vertical migration. Fracturing at some sites increased the equivalent average vertical hydraulic conductivity of confining zone strata by approximately four orders of magnitude and allowed for vertical migration rates of up 80 m/year. Even where vertical migration was rapid, the documented transit times are likely long enough for the inactivation of pathogenic microorganisms.     

Tellurides from Sunrise Dam gold deposit, Yilgarn Craton, Western Australia: a new occurrence of nagyágite

Summary The Cu–Fe–Au–Mo (W) deposits in southeastern Hubei are an important component of the Middle–Lower Yangtze River metallogenic belt. Molybdenite from the Fengshandong Cu- (Mo), Ruanjiawan W–Cu- (Mo), Qianjiawan Cu–Au, Tongshankou Cu–Mo and Tonglüshan Cu- (Fe) deposits yielded Re–Os ages of 144.0 ± 2.1 Ma, 143.6 ± 1.7 Ma, 137.7 ± 1.7 Ma, 142.3 ± 1.8–143.7 ± 1.8 Ma and 137.8 ± 1.7–138.1 ± 1.8 Ma, respectively. Phlogopite from the Tieshan Fe- (Cu) deposit yielded an Ar–Ar age of 140.9 ± 1.2 Ma. These data and other published isotopic ages (Re–Os molybdenite and Ar–Ar mica ages) for the Cu–Fe–Au–Mo (W) deposits in the Middle–Lower Yangtze River metallogenic belt show that Cu–Fe–Au–Mo (W) mineralisation in the Tongling, Anqing, Jiurui and Edong ore districts developed in a narrow time span between 135.5 and 144.9 Ma, reflecting an important regional metallogenic event. An integrated study of available petrological and geochronological data, together with relationships to magmatism and the regional geodynamic framework, indicate that the Cu–Fe–Au–Mo (W) mineralisation in the Middle–Lower Yangtze River belt occurred during a regime of lithospheric extension. This extension is probably related to Late Mesozoic processes of lower crustal delamination and lithospheric thinning in East China.     

Lithosphere formation in the central Slave Craton (Canada): plume subcretion or lithosphere accretion?

Major-element compositions of minerals in peridotite xenoliths from the Lac de Gras kimberlites provide constraints on the mode of lithosphere formation beneath the central Slave Craton, Canada. Magnesia contents of reconstructed whole rocks correlate positively with NiO and negatively with CaO contents, consistent with variable partial melt extraction. Alumina and Cr₂O₃ contents are broadly positively correlated, suggestive of melt depletion in the absence of a Cr–Al phase. Garnet modes are high at a given Al₂O₃ content (a proxy for melt depletion), falling about a 7 GPa melt depletion model. These observations, combined with high olivine Mg# and major-element relationships of FeO-poor peridotites (<7.5 wt%) indicative of melt loss at pressures >3 GPa (residual FeO content being a sensitive indicator of melt extraction pressure), and similar high pressures of last equilibration (∼4.2 to 5.8 GPa), provide multiple lines of evidence that the mantle beneath the central Slave Craton has originated as a residue from high-pressure melting, possibly during plume subcretion. Apparent low melt depletion pressures for high-FeO peridotites (>7.5 wt%) could suggest formation in an oceanic setting, followed by subduction to their depth of entrainment. However, these rocks, which are characterised by low SiO₂ contents (<43 wt%), are more likely to be the result of post-melting FeO-addition, leading to spuriously low estimates of melt extraction pressures. They may have reacted with a silica-undersaturated melt that dissolved orthopyroxene, or experienced olivine injection by crystallising melts. A secular FeO-enrichment of parts of the deep mantle lithosphere is supported by lower average Mg# in xenolithic olivine (91.7) compared to olivine inclusions in diamond (92.6).