Monitoring of fault healing after the 1999 Kocaeli, Turkey, earthquake

The North Anatolian fault zone that ruptured during the mainshock of theM 7.4 Kocaeli (Izmit) earthquake of 17 August 1999 has beenmonitored using S wave splitting, in order to test a hypothesisproposed by Tadokoro et al. (1999). This idea is based on the observationof the M 7.2 1995 Hyogo-ken Nanbu (Kobe) earthquake, Japan.After the Hyogo-ken Nanbu earthquake, a temporal change was detectedin the direction of faster shear wave polarization in 2–3 years after the mainshock (Tadokoro, 1999). Four seismic stations were installed within andnear the fault zone at Kizanlik where the fault offset was 1.5 m, about80 km to the east of the epicenter of the Kocaeli earthquake. Theobservation period was from August 30 to October 27, 1999. Preliminaryresult shows that the average directions of faster shear wave polarization attwo stations were roughly parallel to the fault strike. We expect that thedirection of faster shear wave polarization will change to the same directionas the regional tectonic stress reflecting fault healing process. We havealready carried out a repeated aftershock observation at the same site in2000 for monitoring the fault healing process.     

Atmospheric gravity waves identified by ground-based observations of the intensity and rotational temperature of OH airglow

Spectroscopic observations of OH airglow undertaken on May 2, 2006 at Uji, Japan reveal variations in intensity and rotational temperature related to the passage of an atmospheric gravity wave. The variations exhibit a period of approximately 1 h and magnitudes of 2–6% in intensity and 0.5–2% in rotational temperature. The vertical wavelength and intrinsic frequency of the atmospheric gravity wave were determined from the horizontal wavelength derived by an OH airglow imager, the background horizontal wind velocity obtained by the middle and upper atmosphere (MU) radar, and the dispersion relationship. The observed variations are consistent with the values calculated using the model of Liu, A.Z., Swenson, G.R. [2003. A modeling study of O₂ and OH airglow perturbations induced by atmospheric gravity waves. J. Geophys. Res. 108 (No. D4), 4151. doi:10.1029/2002JD002474].     

Physical parameters identification for full-scale ten-story reinforced concrete building with degrading tri-linear model by modal iterative error correction method

To assess the post-earthquake seismic safety of buildings, it is crucial to predict seismic response, and it is necessary to set the appropriate physical parameters of the response analysis model. Numerous methods have been proposed to identify physical parameters. However, most of them are limited to linear systems, and previous researches on nonlinear systems have difficulties in practical applications. In this paper, a nonlinear response analysis model is identified for a full-scale ten-story reinforced concrete building with the degrading tri-linear stiffness model by the modal iterative error correction (MIEC) method, and the accuracy of this technique is discussed by comparing with the shaking table test.     

Groundwater flow system in Bengal Delta,Bangladesh revealed by environmental isotopes

A total number of 328 groundwater samples are analysed to evaluate the groundwater flow systems in Bengal Delta aquifers, Bangladesh using environmental isotope (²H, ¹⁸O, ¹³C, ³H, and ¹⁴C) techniques. A well-defined Local Meteoric Water Line (LMWL) δ²H = 7.7 δ¹⁸O + 10.7 ‰ is constructed applying linear correlation analyses to the monthly weighted rainfall isotopic compositions (δ¹⁸O and δ²H). The δ¹⁸O and δ²H concentrations of all groundwater samples in the study area are plotted more or less over the LMWL, which provides compelling evidence that all groundwaters are derived from rainfall and floodwater with a minor localized evaporation effects for the shallow groundwaters. Tritium concentration is observed in 40 samples out of 41 with values varying between 0.3 and 5.0 TU, which represents an evidence of young water recharge to the shallow and intermediate aquifers. A decreasing trend of ¹⁴C activity is associated with the heavier δ¹³C values, which indicates the presence of geochemical reactions affecting the ¹⁴C concentration along the groundwater flow system. Both vertical and lateral decrease of ¹⁴C activity toward down gradient show the presence of regional groundwater flow commencing from the unconfined aquifers, which discharges along the coastal regions. Finally, shallow, intermediate, and deep groundwater flow dynamics has revealed in the Bengal Delta aquifers, Bangladesh.     

Supernova Nucleosynthesis, Chemical Evolution, and Cosmic Supernova Rate

In the chemical evolution of the Galaxy, Type II supernovae (SNe II)have contributed to the early metal enrichment and later Type Iasupernovae (SNe Ia) have contributed to the delayed enrichment of Fe.In principle, hypothetical pre-galactic population III objects couldcause the earliest heavy element enrichment. Here we present our twonew findings. 1) The peculiar abundance pattern among iron peakelements (Cr, Mn, Co, and Fe) in the very metal poor can be reproducedwith SN II nucleosynthesis yields without invoking the contributionfrom Pop III objects. 2) The observed chemical evolution in the solarneighborhood is well reproduced with the metallicity dependentoccurrence of SNe Ia, where SNe Ia do not occur if the iron abundanceof the progenitors is as low as [Fe/H] ≲ -1. We make theprediction that the cosmic SN Ia rate drops at z ∼ 1-2 because ofthe low-iron abundance, which can be observed with the Next GenerationSpace Telescope. This revised version was published online in July 2006 with corrections to the Cover Date.     

Rare earth elements in metagabbros from the Mid-Atlantic Ridge and their possible implications for the genesis of alkali olivine basalts as well as the lizard peridotite

Two foliated metagabbros from the Mid-Atlantic Ridge near 30° N were analyzed for rare earth elements. The chondrite-normalized rare earth pattern for one of them is quite similar to those for abyssal tholeiites. The pattern for another sample, however, is somewhat different from the above one. A new set of bulk partition coefficients for rare earth elements has been estimated correspondingly. This set throws a new light on the interpretation that many alkali olivine basalts were produced by a zone melting or partial melting of primary-liquid-type material. Also the same partition coefficients lead us to an inference that the high-temperature peridotite intrusion in the Lizard area, Cornwall, England, is a secondary-solid-type material which was once in equilibrium with a primary-solid-type material, whereas the pyroxenite, Canyon Mountain, Oregon, is a primary-solid-type material.Both of the metagabbros studied show positive europium anomaly.     

Determination of Molybdenum, Antimony and Tungsten at sub μg g−1 Levels in Geological Materials by ID-FI-ICP-MS

We have developed a rapid and accurate method for the determination of Mo, Sb and W in geological samples using isotope dilution inductively coupled plasma-mass spectrometry with a flow injection system (ID-FI-ICP-MS). The chemical procedure requires HF digestion of the sample with a Mo-Sb-W mixed spike, subsequent evaporation and dissolution of Mo, Sb and W from Mg and Ca fluorides with HF. Recovery yields of Mo, Sb and W in the extraction were > 94% for samples of peridotite, basalt and andesite composition, with the exception of W in samples of peridotite composition for which recovery was 81%. No matrix effects were observed in the determination of the isotope ratios of Mo, Sb and W in solutions prepared from peridotite, basalt and andesite samples down to a dilution factor of 100. Detection limits of Mo, Sb and W in silicate materials were at the several ng g⁻¹ level. Analysis of the silicate reference materials PCC-1, DTS-1, BCR-1, BHVO-1, AGV-1 from the US Geological Survey and JP-1, JB-1, -2, -3, JA-1, -2, and -3 from the Geological Survey of Japan as well as the Smithsonian reference Allende powder yielded reliable Mo, Sb and W concentrations. The repeatability in the analysis of basalts and andesites was < 9%. This technique requires only 0.2 ml sample solution, and is therefore suitable for analyzing small and/or precious samples such as meteorites, mantle peridotites and their mineral separates.     

Lunar structure and dynamics - results from the apollo passive seismic experiment

Analysis of seismic signals from man-made impacts, moonquakes, and meteoroid impacts has established the presence of a lunar crust, approximately 60 km thick in the region of the Apollo seismic network; an underlying zone of nearly constant seismic velocity extending to a depth of about 1000 km, referred to as the mantle; and a lunar core, beginning at a depth of about 1000 km, in which shear waves are highly attenuated suggesting the presence of appreciable melting. Seismic velocitites in the crust reach 7 km s^–1 beneath the lower-velocity surface zone. This velocity corresponds to that expected for the gabbroic anorthosites found to predominate in the highlands, suggesting that rock of this composition is the major constituent of the lunar crust. The upper mantle velocity of about 8 km s^–1 for compressional waves corresponds to those of terrestrial olivines, pyroxenites and peridotites. The deep zone of melting may simply represent the depth at which solidus temperatures are exceeded in the lower mantle. If a silicate interior is assumed, as seems most plausible, minimum temperatures of between 1450°C and 1600°C at a depth of 1000 km are implied. The generation of deep moonquakes, which appear to be concentrated in a zone between 600 km and 1000 km deep, may now be explained as a consequence of the presence of fluids which facilitate dislocation. The preliminary estimate of meteoroid flux, based upon the statistics of seismic signals recorded from lunar impacts, is between one and three orders of magnitude lower than previous estimates from Earth-based measurements.Paper dedicated to Professor Harold C. Urey on the occasion of his 80th birthday on 29 April, 1973.     

Effects of mass source/sink at the western boundary on the wind-driven gyres: Implications for the ventilation of the north pacific intermediate layer through convection in the Okhotsk Sea and tidal mixing at the Kuril Straits

A steady quasi-geostrophic 2.5-layer model, forced by both Ekman pumping and a mass source/sink situated at the western boundary has been constructed to investigate the effect of diapycnal transport due to convection in the Okhotsk Sea and tidal mixing at the Kuril Straits on the intermediate layer in the North Pacific. The model illustrates a combined effect of the wind-driven and mass-driven circulations. First, net mass input induces a “barotropic” mode inter-gyre flow along the western boundary through the dynamical influence of Kelvin waves. This flow creates characteristic curves (geostrophic contours) that facilitate inter-gyre communication through the western boundary layer from the location of the mass source to the subtropical gyre. Due to the effect of wind-driven circulation, the offshore part turns eastward into the interior, encircles the outer rim of the region (which would otherwise be the pool region in the absence of mass input), and then encounters the western boundary. Eventually, the water fed into the lower layer flows mostly along this path and later flows away to the equatorial region. Conversely, in the upper layer, water is fed from the equator to the subtropics, and to the subpolar interior region through the western boundary current. The water then circulates along the outer rim and is absorbed into the mass sink. The model is controlled mainly by three nondimensional parameters: (1) the ratio of net mass input rate to the maximum Sverdrup transport (Q/T _Sv ^max ), which affects the inter-gyre communication by altering the paths of geostrophic contours, (2) the ratio of a mass input rate into the lower layer to that in total (Q ₂/Q), which controls the vertical structure of the inter-gyre flow, and (3) the measure of the wind forcing effect relative to the β effect, which determines the horizontal extent of the area influenced by the mass input. The other parameter regimes with respect to Q/T _Sv ^max and Q ₂/Q are also presented.     

Variations in snowmelt energy and energy balance characteristics with larch forest density on Mt Iwate,Japan: observations and energy balance analyses

The variation in snowmelt energy and energy components were evaluated with respect to forest density. Surface snowmelt rates, surface evaporation from snow cover and meteorological elements were measured in the open and under sparse (411 trees/ha) and dense (1433 trees/ha) larch canopies. The surface snowmelt rate decreased as the forest density increased. Based on the observations and energy balance analyses, we concluded the following. (1) Albedo decreased while the bulk coefficient for latent heat increased with forest density. (2) The duration of snowmelt increased with forest density because the energy for nocturnal cooling of the snow cover decreased. (3) When comparing the open and forested sites, the changes in snowmelt energy with forest density were caused by sensible heat flux. However, the contribution of net radiation was highest in the forested sites. Therefore, the effects of forest cover on the snowmelt energy were different when comparing both the open and forested sites and the sparse and densely forested sites. (4) The ratio of net radiation to snowmelt energy increased with forest density; although both snowmelt energy and net radiation decreased with increased forest density, the snowmelt energy decreased more rapidly. Sensible heat also decreased as forest density increased. Both albedo and downward long‐wave radiation influenced net radiation. Copyright © 1999 John Wiley & Sons, Ltd.