The ‘Stained Glass Procedure’, a new method to compare classification performance of images acquired with different pixel sizes

Objective comparison of classification performance of earth observation images, acquired at different spatial resolutions (e.g. NOAA-AVHRR, IRS-MOS, IRS-WiFS, Landsat-TM, IRS-LISS), is complicated because both class definition and training site selection are hampered by the inherent scale differences. This paper presents a new, generic method to compare the information content of such a set of images, the “Stained Glass Procedure”. It overcomes the stated problems by computing the scale-dependent, internal spectral variation in an image and by using this as an indicator for land cover information. The Stained Glass Procedure creates segments in the images and calculates the internal spectral variation in a high-spatial-resolution image for each segment. For each image from the set the average variance, weighted to area, is calculated. The Stained Glass Procedure can be used to predict the performance of sensors that are not available, yet, or to roughly determine the optimal spatial resolution for the classification of a specific area.The procedure was applied to images with pixel sizes ranging from 23 to 1100 m. Classification detail of Envisat-MERIS (300 m pixel size), not included in the image set, could be predicted accurately using the Stained Glass Procedure.The Stained Glass Procedure applies one procedure to all images, without any subjective decision during the analysis, thus offering a method to compare images with different pixel sizes in terms of classification detail that is truly objective.     

Progressive development of quartz fabrics in a shear zone from Monte Mucrone,Sesia-Lanzo Zone,Italian Alps

Quartz c-axis fabrics are described from a shear zone in a jadeite — garnet bearing meta-granite from Monte Mucrone, in the Sesia-Lanzo Zone of the western Italian Alps. Quartz blebs in the meta-granitoid are progressively deformed into cigar shaped lenses, and are recrystallized. Fabrics measured from individual blebs show considerable variation resulting from an initial orientation effect, and are not very enlightening. A synoptic diagram, however, has a pole-free area which can be correlated with the extension direction, and an asymmetry which is consistent with the known sense of shear operating in the zone.Although the technique of preparing synoptic diagrams is rather painstaking, its use is advocated for complex fabric situations, as it may allow partial removal of problems associated with non-random initial orientation distributions.     

The constant temperature-sum as a basis for forecasting flowering date

Summary Hertlein's thesis is discussed and criticized on points where apparently significance is attached to results which require stronger statistical proofs.     

Crustal outgassing and LILE enrichment in major lithosphere structures,Archean Abitibi greenstone belt: evidence on the source reservoir from strontium and carbon isotope tracers

Major structural discontinuities in the Abitibi greenstone belt acted as conduits for outgassing of the Archean crust, as reflected in fixation of a select group of lithophile elements including Si, C, K, Rb, Ba, Li, Cs, B and Pb, in metasomatized faults. For two of the largest structures, the Destor-Porcupine (DP) and Kirkland Lake — Cadillac (KC) fault zones 6×10¹⁵ g Si, 3×10¹⁵ g CO₂ and 10¹⁵ g K were introduced into the faults during expulsion of an estimated 6×10¹⁸ g aqueous fluids. Strontium isotope ratios of tourmaline, piemontite, actinolite and scheelite mineral separates, characterized by Rb/Sr0.02, are concordant with respect to ⁸⁷Sr/⁸⁶Sr initial ratios over local sectors of the faults. The Sr isotope data record geographic variations which, from east to west on the KC fault is 0.7031–0.7041 (Val d'Or), 0.7008–0.7022 (Bourlemaque), 0.7017–0.7019 (Bousquet), 0.7029–0.7031 (Noranda), and 0.7013 to 0.7015 (Kirkland Lake). At Timmins, on the PD fault, ⁸⁷Sr/⁸⁶Sr initial ratios cluster at 0.7010 to 0.7020. Metasomatised fault zones are systematically more radiogenic than contiguous host lithologies, and imply a source reservoir (0.7010 to 0.7041) generally more radiogenic than the upper mantle at 2690 Ma (0.700±0.001), or contemporaneous volcanic rocks of mafic to ultramafic composition (0.700 to 0.7012). Whereas certain minerals are concordant and retentive, Rb-Sr isochrons based on suites of rocks at progressive intensities of metasomatism, have been systematically reset over an elpased time of 200 Ma after termination of outgassing, due to disturbance accompanying incremental displacements on structures.Carbon isotope compositions of ferroan dolomites in faults are tightly clustered along local fault sectors, but also display a marked provinciality: from east to west ¹³C=–6.0 to –8.5 (Malartic), –8.0 to –9.0 (Cadillac), –2.0 to –4.5 (Kirkland Lake), and –0.5 to –3.5 (Timmins). The observed provinciality of both ¹³C values and ⁸⁷Sr/⁸⁶Sr initial ratios is interpreted to reflect compositional heterogeneities in a radiogenic sialic crust and the green-stone belt supracrustal sequence, both of which supplied volatiles, magmas and lithophile elements to the fault structures during late stage transpressive tectonics.     

Do households prefer to move up or down the urban hierarchy during an economic crisis?

Journal of Geographical Systems - In this paper, we investigate the relationship between adverse economic circumstances and the desire of Dutch households to move up or down the urban hierarchy. We...     

Kinematic analysis and analogue modelling of the Passeier- and Jaufen faults: implications for crustal indentation in the Eastern Alps

Crustal deformation in front of an indenter is often affected by the indenter’s geometry, rheology, and motion path. In this context, the kinematics of the Jaufen- and Passeier faults have been studied by carrying out paleostress analysis in combination with crustal-scale analogue modelling to infer (1) their relationship during indentation of the Adriatic plate and (2) their sensitivity in terms of fault kinematics to the geometry and motion path of Adria. The field study reveals mylonites along the Jaufen fault, which formed under lower greenschist facies conditions and is associated with top-to-the-west/northwest shear with a northern block down component. In addition, a brittle reactivation of the Jaufen shear zone under NNW–SSE to NW–SE compressional and ENE–WSW tensional stress conditions was deduced from paleostress analysis. The inferred shortening direction is consistent with fission track ages portraying Neogene exhumation of the Meran-Mauls basement south of the fault. Along the Passeier fault, deformation was only brittle to semi-ductile and paleostress tensors record that the fault was subjected to E–W extension along its northern segment varying into NW–SE compression and sinistral transpression along its southern segment. In the performed analogue experiments, a rigid, triangular shaped indenter was pushed into a sand pile resulting in the formation of a Passeier-like fault sprouting from the indenter’s tip. These kinds of north-trending tip faults formed in all experiments with shortening directions towards the NW, N, or NE. Consequently, we argue that the formation of the Passeier fault strongly corresponds to the outline of the Adriatic indenter and was only little affected by the indenter’s motion path due to induced strain partitioning in front of the different indenter segments. The associated fault kinematics along the Passeier fault including both E–W extension and NNW to NW shortening, however, is most consistent with a northward advancing Adriatic indenter.     

Evidence for compressionally induced high subsidence rates in the Kurile Basin (Okhotsk Sea)

A combined volcanological, geochemical, paleo-oceanological, geochronological and geophysical study was undertaken on the Kurile Basin, in order to constrain the origin and evolution of this basin. Very high rates of subsidence were determined for the northeastern floor and margin of the Kurile Basin. Dredged volcanic samples from the Geophysicist Seamount, which were formed under subaerial or shallow water conditions but are presently located at depths in excess of 2300 m, were dated at 0.84±0.06 and 1.07±0.04 Ma with the laser ⁴⁰Ar/³⁹Ar single crystal method, yielding a minimum average subsidence rate of 1.6 mm/year for the northeast basin floor in the Quaternary. Trace element and Sr–Nd–Pb isotope data from the volcanic rocks show evidence for contamination within lower continental crust and/or the subcontinental lithospheric mantle, indicating that the basement presently at 6-km depth is likely to represent thinned continental crust. Average subsidence rates of 0.5–2.0 mm/year were estimated for the northeastern slope of the Kurile Basin during the Pliocene and Quaternary through the determination of the age and paleo-environment (depth) of formation of sediments from a canyon wall. Taken together, the data from the northeastern part of the Kurile Basin indicate that subsidence began in or prior to the Early Pliocene and that subsidence rates have increased in the Quaternary. Similar rates of subsidence have been obtained from published studies on the Sakhalin Shelf and Slope and from volcanoes in the rear of the Kurile Arc. The recent stress field of the Kurile Basin is inferred from the analysis of seismic activity, focal mechanism solutions and from the structure of the sedimentary cover and of the Alaid back-arc volcano. Integration of these results suggests that compression is responsible for the rapid subsidence of the Kurile Basin and that subsidence may be an important step in the transition from basin formation to its destruction. The compression of the Kurile Basin results from squeezing of the Okhotsk Plate between four major plates: the Pacific, North American, Eurasian and Amur. We predict that continued compression could lead to subduction of the Kurile Basin floor beneath Hokkaido and the Kurile Arc in the future and thus to basin closure.     

Effect of hematite on thiosulphate leaching of gold

Hematite, as a typical iron oxide slime in sulphide ore slurries, was artificially added into the leaching systems of pure gold and a sulphide ore respectively, in an attempt to investigate the effect of iron oxide slimes on the ammoniacal thiosulphate leaching of gold. The presence of hematite significantly reduced the dissolution of gold and this detrimental effect became more pronounced with increasing hematite concentration. Hematite formed coatings on gold surfaces, which could prevent leach solution from diffusing to the gold surfaces and hence, inhibit gold dissolution. Hematite catalysed the oxidative decomposition of thiosulphate to polythionates with oxygen present. XPS studies indicated a thin layer of iron oxide coating as well as the deposition of some copper and sulphur species on gold surfaces. SEM images revealed a lesser extent of corrosion for gold after leaching in the presence of hematite. The gold extraction from the sulphide ore was reduced with the addition of hematite and this effect became more noticeable with an addition of hematite at a higher concentration. A natural guar type surfactant (Gempolym M47) reduced the detrimental effect of hematite on gold extraction likely due to the prevention of hematite coating on gold and mineral particles and the dispersion of the mineral slurry. Gempolym M47 stabilised thiosulphate by weakening the interaction between cupric ions and thiosulphate and by minimising the catalytic effect of hematite on thiosulphate decomposition.     

Contamination of a well in a uniform background flow

In this paper we describe the transport of pollution in groundwater in the neighbourhood of a well in a uniform background flow. We compute the rate at which contaminated particles reach the well as a function of the place of the source of pollution. The motion of a particle in a dispersive flow is seen as a random walk process. The Fokker-Planck equation for the random motion of a particle is transformed using the complex potential for the advective flow field. The resulting equation is solved asymptotically after a stretching transformation. Finally, the analytical solution is compared with results from Monte Carlo simulations with the random walk model. The method can be extended to arbitrary flow fields. Then by a numerical coordinate transformation the analytical results can still be employed.