渤海湾海岸带地区~(137)Cs参考剖面——意义、方法及初步结果

海岸带地区近百年来的现代地质过程重建必须以精确的年代学研究为基础,~(137)Cs时标法和~(210)Pb_(exc)测年法是目前广泛应用的方法。由于易受到河流沉积物供给变化、潮位状况、极端天气事件等的影响,海岸带现代过程的定量研究一直是高分辨率研究的瓶颈。区域性参考剖面可以提升现代沉积物测年方法在海岸带应用中的可靠性。因此,建立区域性的~(210)Pb_(exc)和~(137)Cs比活度-深度参考剖面,将改善对海岸带及邻近海区实测数据的解释。以渤海湾海岸带为研究区,选取沉积环境相对稳定、水平搬运作用较小的地区,采用人工探坑、Eijkelkamp槽型取样器获取了2个柱状岩心,通过γ能谱仪对样品进行~(210)Pb、~(226)Ra及~(137)Cs比活度测试,绘制剖面图,结合研究区已有数据,总结出6类海岸带常见的~(210)Pb_(exc)和~(137)Cs比活度-深度剖面类型,并重建了渤海湾海岸带~(137)Cs区域性参考剖面。结果显示,~(137)Cs在渤海湾地区的最大峰值指示1963年,可以作为区域性主要参考时标。但是,最大峰值上部的次峰在不同区域指示不同的时标,S4和S5两个站位该峰值指示的并非1986年时标。     

津冀海岸线现状、变化特征及保护建议

根据覆盖全区的3期遥感影像和实地调查,以及对滨海新区和滦河口2个典型区更深入的案例研究(包括回溯至1870年、1950年的基准岸线及逐年遥感信息),对津冀沿海海岸线现状进行解译和分类,并分析岸线变化特征及成因。津冀沿海现状岸线总长度894km,可以划分为自然岸线、半开发岸线和人工岸线3类,长度分别为90km、329km和475km。1950年以前为自然因素主导的岸线变化,1950年以后变为人类活动主导的岸线向海推进,逐渐加强的人类活动至2010年达到顶峰。在全球海面上升和区域地面下沉的大背景下,海岸线的自然演化趋势应该是向陆蚀退,但是人类活动主导的岸线变化却表现为违反自然趋势的向海推进。今后,向海推进最前沿的围海造陆区将受到来自海洋越来越强烈的影响,亟需加强监测和防护。兼顾环境保护与开发两方面的长远需求,建议赋予海岸线新的定义与内涵,划定岸线保护红线,恢复部分岸线的自然属性。     

莱州湾南岸全新世相对海平面变化重建

在对莱州湾南岸8个钻孔沉积物沉积结构及有孔虫特征分析基础上,识别相关海面标志层位,辅以加速器质谱AMS14C测年,重建了全新世相对海面变化历史,并讨论了海面变化的沉积响应及控制因素。约9200cal BP以前,海面快速上升,研究区海侵时海面于-21.5m左右;9200~8400cal BP海面上升速率减缓至约2mm/a;8400~8000cal BP海面由-14m快速上升至-5.5m,速率约为33mm/a;8000~7600cal BP,海面持续数百年停滞或微弱下降;7600~7000cal BP海面由-5.5m快速上升至0m以上,速率至少约为13mm/a;7000~6000cal BP海面缓慢上升至+2~+3m位置,速率约为3mm/a;约6000cal BP以后海面缓慢下降至现今水平。约9200cal BP以前、8400~8000cal BP、7600~7000cal BP时期的3次海面快速上升,是MWP-1C融水脉冲、诱发8.2ka冷事件的融水脉冲,以及MWP-2融水脉冲的中纬度地区响应。中全新世全球冰融趋于停滞后,由于研究区沉积盆地沉降速度较慢,在冰川均衡调整效应下,使+2~+3m的相对高海面得以呈现。     

渤海湾巨葛庄贝壳堤与下伏泥层有孔虫组合的海面变化意义

根据巨葛庄贝壳堤及下伏泥层的有孔虫研究,讨论了贝壳堤底板和下伏泥层各类沉积环境的海面意义,以此作为海面标志点重建的古海面误差范围为±0.225~±0.625m。结合该贝壳堤底板和下伏泥层顶板的年龄数据,重建了3900~3300cal BP时的海面高度为-2.955~-2.715m。     

Numerical Analysis of Gravity Coring Using Coupled Eulerian-Lagrangian Method and a New Corer

The shortcomings of gravity corers in sampling marine sediments have been observed extensively in various field tests. In order to optimize the coring, this article provides an alternative numerical way to model the gravity coring and analyze the sampling effect. Based on this analysis, a new hydraulic hammer corer is devised. A coupled Eulerian-Lagrangian method with capability of simulating the problem involving extreme deformation, penetration is used to simulate the coring process. The results show that the hydrostatic pressure and deviator stress increase and reach their peak when the pile tip is slightly above or at the level of the observation point and then drop rapidly when the pile tip slides below the observation point. In addition, the stress path indicates that the soil element sustains plastic compression before yielding and then expands until recovering to the original state. The obvious “under-sampling” phenomenon is also well-captured by the finite element model.     

浮托安装进船过程中护舷碰撞力实测研究

浮托安装法广泛应用于大型组块海上安装。导管架平台上部组块浮托安装进船过程中,风、浪、流引起的浮托驳船横向运动造成浮托驳船与导管架桩腿的碰撞,碰撞力可能会对导管架结构造成损伤。陆丰7-2上部组块浮托安装中,为了监测碰撞力大小,设计了碰撞力海上监测系统。通过在导管架外侧四个桩腿上安装光纤光栅应变传感器对碰撞过程中导管架桩腿进行应力监测,进而计算碰撞力。对碰撞过程,载荷作用位置、方向进行简化,并对载荷大小及垂向作用位置对计算的影响进行了研究。结构分析模型简化后,测点von-Mises应力与碰撞力大小成正比,对导管架整体结构建模计算并取局部结构计算比例系数,结合应力实测数据计算出进船过程中驳船对导管架桩腿碰撞力。     

塔里木盆地东南缘下—中侏罗统煤层煤岩、煤质特征分析

塔里木盆地东南缘下—中侏罗统煤层沿阿尔金山前断续分布,其煤岩、煤质与典型的西北侏罗纪煤层具有明显不同。通过对和田布雅、于田普鲁、且末红柳沟等煤矿主采煤层样品进行煤岩、煤质鉴定及煤化指标等一系列综合研究分析,结果表明,主采煤层以光亮煤、半亮煤为主,其次是半暗煤、暗淡煤;煤岩组分以镜质组为主,壳质组含量少,具中-高镜惰比。因成煤沼泽的还原程度促进了无机硫分的形成,煤中全硫含量随镜质组含量的增加呈现逐渐增高的趋势,且煤层硫分与灰分整体具有明显的负相关关系。此外,煤层挥发分受不同种类硫分的影响,亦有明显差异性变化。在民丰凹陷中-高硫煤中,硫分以无机硫为主,随着硫分的升高挥发分亦有升高趋势;瓦石峡凹陷中-低硫煤受有机硫控制,对挥发分产率的影响不明显。民丰凹陷煤层的灰分指数高于瓦石峡凹陷,可见后者的成煤沼泽环境潜水面要比前者高得多。针对上述诸多因素分析,进一步揭示塔东南地区煤岩、煤质多样性变化受断陷湖盆以及局部水体较深的还原型沼泽环境控制,最终形成了中-高挥发分、中-低灰分、中-低硫分的煤质及富镜贫惰的煤岩特征。     

Tectono–Thermal Evolution, Hydrocarbon Filling and Accumulation Phases of the Hari Sag, in the Yingen–Ejinaqi Basin, Inner Mongolia, Northern China

This work restored the erosion thickness of the top surface of each Cretaceous formations penetrated by the typical well in the Hari sag, and simulated the subsidence burial history of this well with software BasinMod. It is firstly pointed out that the tectonic subsidence evolution of the Hari sag since the Cretaceous can be divided into four phases: initial subsidence phase, rapid subsidence phase,uplift and erosion phase, and stable slow subsidence phase. A detailed reconstruction of the tectonothermal evolution and hydrocarbon generation histories of typical well was undertaken using the EASY R_0% model, which is constrained by vitrinite reflectance(R_0) and homogenization temperatures of fluid inclusions. In the rapid subsidence phase, the peak period of hydrocarbon generation was reached at c.a.105.59 Ma with the increasing thermal evolution degree. A concomitant rapid increase in paleotemperatures occurred and reached a maximum geothermal gradient of about 43-45℃/km. The main hydrocarbon generation period ensued around 105.59-80.00 Ma and the greatest buried depth of the Hari sag was reached at c.a. 80.00 Ma, when the maximum paleo-temperature was over 180℃.Subsequently, the sag entered an uplift and erosion phase followed by a stable slow subsidence phase during which the temperature gradient, thermal evolution, and hydrocarbon generation decreased gradually. The hydrocarbon accumulation period was discussed based on homogenization temperatures of inclusions and it is believed that two periods of rapid hydrocarbon accumulation events occurred during the Cretaceous rapid subsidence phase. The first accumulation period observed in the Bayingebi Formation(K_1 b) occurred primarily around 105.59-103.50 Ma with temperatures of 125-150℃. The second accumulation period observed in the Suhongtu Formation(K_1 s) occurred primarily around84.00-80.00 Ma with temperatures of 120-130℃. The second is the major accumulation period, and the accumulation mainly occurred in the Late Cretaceous. The hydrocarbon accumulation process was comprehensively controlled by tectono-thermal evolution and hydrocarbon generation history. During the rapid subsidence phase, the paleo temperature and geothermal gradient increased rapidly and resulted in increasing thermal evolution extending into the peak period of hydrocarbon generation,which is the key reason for hydrocarbon filling and accumulation.     

Isotope Geochronologic and Geochemical Constraints on the Magmatic Associations of the Collisional Orogenic Zone in the West Kunlun Orogen,China

The Jiajiwaxi pluton in the southern portion of the West Kunlun Range can be divided into two collision–related intrusive rock series, i.e., a gabbro–quartz diorite–granodiorite series that formed at 224±2.0 Ma and a monzonitic granite–syenogranite series that formed at 222±2.0 Ma. The systematic analysis of zircon U-Pb geochronology and bulk geochemistry is used to discuss the magmatic origin(material source and thermal source), tectonic setting, genesis and geotectonic implications of these rocks. The results of this analysis indicate that the parent magma of the first series, representing a transition from I-type to S-type granites, formed from thermally triggered partial melting of deep crustal components in an early island–arc–type igneous complex, similar to an I-type granite, during the continental collision orogenic stage. The parent magma of the second series, corresponding to an S-type granite, formed from the partial melting of forearc accretionary wedge sediments in a subduction zone in the late Palaeozoic–Triassic. During continued collision, the second series magma was emplaced into the first series pluton along a central fault zone in the original island arc region, forming an immiscible puncture-type complex. The deep tectonothermal events associated with the continent–continent collision during the orogenic cycle are constrained by the compositions and origins of the two series. The new information provided by this paper will aid in future research into the dynamic mechanisms affecting magmatic evolution in the West Kunlun orogenic belt.