EXPANSION OF PAPER AS AFFECTING AREA

Abstract

For the sake of the junior reader we may repeat an old and simple investigation. Let us suppose that the paper on which a map is printed undergoes a regular expansion p in one direction, say the X direction, and another regular expansion q in the Y direction, perpendicular to the former; it is required to know the effect of these expansions on the area of any parcel on the map. Note that, so far as the mathematics are affected, X and Y are not necessarily parallel to the margins of the sheet; we shall take them here as axes of any rectangular coordinate system. The symbols p and q are regarded as ratios, so that 100p and 100p represent the percentage expansions; if the paper contracts instead of expanding, no more is necessary than to change the sign.     

THE TRANSVERSE MERCATOR PROJECTION

Abstract

I. Introduction.—Map projection is a branch of applied mathematics which owes much to J. H. Lambert (v. this Review, i, 2, 91). In his “Beyträge zum Gebrauche der Mathematik und deren Anwendung” (Berlin, 1772) he arrived at a form of projection whereof the Transverse Mercator is a special case, and pointed out that this special case is adapted to a country of great extent in latitude but of small longitudinal width. Germain (“Traité des Projections”, Paris, 1865) described it as the Projection cylindrique orthomorphe de Lambert, but he also introduced the name Projection de Mercator transverse or renversée; he shows that Lambert's treatment of the projection was remarkably simple.     

BOWDITCH TRAVERSE ADJUSTMENT AND A MODIFICATION: NOTES

Abstract

In the second part of the paper on this subject in the last issue (30, 483) the references to the relative angular and linear closures are rather misleading. Mr Clendinning points out that the probable angular error at a station must be considered; the mean error is clearly different.     

SOME PROBLEMS OF RESECTION AND COUNTERSECTION-I

Abstract

“A Well-Defined mountain, though miles inland and never visited by the surveyors, will often prove the very keystone of a chart which cannot be regularly and theoretically triangulated” (“Hydrographic Surveying”, by Rear-Adm. Sir Wm J. L. Wharton, K.C.B., and Rear-Adm. Mostyn Field, F.R.S. 3rd Ed. 1909, p. 128). To many the reasons prohibiting the occupation of inland stations may be unknown; it may suffice to state that, in the past, British hydrographers have mapped many coastal waters where penetration of the land was at least inadvisable. Since the charts so made were in general sold to the world, seamen of all nations have benefited from the surveys.     

Spatial-Correlation Based Persistent Scatterer Interferometric Study for Ground Deformation

Interferometric Synthetic Aperture Radar (InSAR), nowadays, is a precise technique for monitoring and detecting ground deformation at a millimetric level over large areas using multi-temporal SAR images. Persistent Scatterer Interferometric SAR (PSInSAR), an advanced version of InSAR, is an effective tool for measuring ground deformation using temporally stable reference points or persistent scatterers. We have applied both PSInSAR and Small Baseline Subset (SBAS) methods, based on the spatial correlation of interferometric phase, to estimate the ground deformation and time-series analysis. In this study, we select Las Vegas, Nevada, USA as our test area to detect the ground deformation along satellite line-of-sight (LOS) during November 1992–September 2000 using 44 C-band SAR images of the European Remote Sensing (ERS-1 and ERS-2) satellites. We observe the ground displacement rate of Las Vegas is in the range of ?19 to 8 mm/year in the same period. We also cross-compare PSInSAR and SBAS using mean LOS velocity and time-series. The comparison shows a correlation coefficient of 0.9467 in the case of mean LOS velocity. Along this study, we validate the ground deformation results from the satellite with the ground water depth of Las Vegas using time-series analysis, and the InSAR measurements show similar patterns with ground water data.     

Ionospheric and receiver DCB-constrained multi-GNSS single-frequency PPP integrated with MEMS inertial measurements

Single-frequency precise point positioning (SF-PPP) is a potential precise positioning technique due to the advantages of the high accuracy in positioning after convergence and the low cost in operation. However, there are still challenges limiting its applications at present, such as the long convergence time, the low reliability, and the poor satellite availability and continuity in kinematic applications. In recent years, the achievements in the dual-frequency PPP have confirmed that its performance can be significantly enhanced by employing the slant ionospheric delay and receiver differential code bias (DCB) constraint model, and the multi-constellation Global Navigation Satellite Systems (GNSS) data. Accordingly, we introduce the slant ionospheric delay and receiver DCB constraint model, and the multi-GNSS data in SF-PPP modular together. In order to further overcome the drawbacks of SF-PPP in terms of reliability, continuity, and accuracy in the signal easily blocking environments, the inertial measurements are also adopted in this paper. Finally, we form a new approach to tightly integrate the multi-GNSS single-frequency observations and inertial measurements together to ameliorate the performance of the ionospheric delay and receiver DCB-constrained SF-PPP. In such model, the inter-system bias between each two GNSS systems, the inter-frequency bias between each two GLONASS frequencies, the hardware errors of the inertial sensors, the slant ionospheric delays of each user-satellite pair, and the receiver DCB are estimated together with other parameters in a unique Kalman filter. To demonstrate its performance, the multi-GNSS and low-cost inertial data from a land-borne experiment are analyzed. The results indicate that visible positioning improvements in terms of accuracy, continuity, and reliability can be achieved in both open-sky and complex conditions while using the proposed model in this study compared to the conventional GPS SF-PPP.     

A two-step ionospheric modeling algorithm considering the impact of GLONASS pseudo-range inter-channel biases

The Global Navigation Satellite System presents a plausible and cost-effective way of computing the total electron content (TEC). But TEC estimated value could be seriously affected by the differential code biases (DCB) of frequency-dependent satellites and receivers. Unlike GPS and other satellite systems, GLONASS adopts a frequency-division multiplexing access mode to distinguish different satellites. This strategy leads to different wavelengths and inter-frequency biases (IFBs) for both pseudo-range and carrier phase observations, whose impacts are rarely considered in ionospheric modeling. We obtained observations from four groups of co-stations to analyze the characteristics of the GLONASS receiver P1P2 pseudo-range IFB with a double-difference method. The results showed that the GLONASS P1P2 pseudo-range IFB remained stable for a period of time and could catch up to several meters, which cannot be absorbed by the receiver DCB during ionospheric modeling. Given the characteristics of the GLONASS P1P2 pseudo-range IFB, we proposed a two-step ionosphere modeling method with the priori IFB information. The experimental analysis showed that the new algorithm can effectively eliminate the adverse effects on ionospheric model and hardware delay parameters estimation in different space environments. During high solar activity period, compared to the traditional GPS + GLONASS modeling algorithm, the absolute average deviation of TEC decreased from 2.17 to 2.07 TECu (TEC unit); simultaneously, the average RMS of GPS satellite DCB decreased from 0.225 to 0.219 ns, and the average deviation of GLONASS satellite DCB decreased from 0.253 to 0.113 ns with a great improvement in over 55%.     

Tropospheric refractivity and zenith path delays from least-squares collocation of meteorological and GNSS data

Precise positioning requires an accurate a priori troposphere model to enhance the solution quality. Several empirical models are available, but they may not properly characterize the state of troposphere, especially in severe weather conditions. Another possible solution is to use regional troposphere models based on real-time or near-real time measurements. In this study, we present the total refractivity and zenith total delay (ZTD) models based on a numerical weather prediction (NWP) model, Global Navigation Satellite System (GNSS) data and ground-based meteorological observations. We reconstruct the total refractivity profiles over the western part of Switzerland and the total refractivity profiles as well as ZTDs over Poland using the least-squares collocation software COMEDIE (Collocation of Meteorological Data for Interpretation and Estimation of Tropospheric Pathdelays) developed at ETH Zürich. In these two case studies, profiles of the total refractivity and ZTDs are calculated from different data sets. For Switzerland, the data set with the best agreement with the reference radiosonde (RS) measurements is the combination of ground-based meteorological observations and GNSS ZTDs. Introducing the horizontal gradients does not improve the vertical interpolation, and results in slightly larger biases and standard deviations. For Poland, the data set based on meteorological parameters from the NWP Weather Research and Forecasting (WRF) model and from a combination of the NWP model and GNSS ZTDs shows the best agreement with the reference RS data. In terms of ZTD, the combined NWP-GNSS observations and GNSS-only data set exhibit the best accuracy with an average bias (from all stations) of 3.7 mm and average standard deviations of 17.0 mm w.r.t. the reference GNSS stations.     

Group delay variations of GPS transmitting and receiving antennas

GPS code pseudorange measurements exhibit group delay variations at the transmitting and the receiving antenna. We calibrated C1 and P2 delay variations with respect to dual-frequency carrier phase observations and obtained nadir-dependent corrections for 32 satellites of the GPS constellation in early 2015 as well as elevation-dependent corrections for 13 receiving antenna models. The combined delay variations reach up to 1.0 m (3.3 ns) in the ionosphere-free linear combination for specific pairs of satellite and receiving antennas. Applying these corrections to the code measurements improves code/carrier single-frequency precise point positioning, ambiguity fixing based on the Melbourne–Wübbena linear combination, and determination of ionospheric total electron content. It also affects fractional cycle biases and differential code biases.     

A Novel Approach of Despeckling SAR Images Using Nonlocal Means Filtering

Synthetic aperture radar (SAR) is a day and night, all weather satellite imaging technology. Inherent property of SAR image is speckle noise which produces granular patterns in the image. Speckle noise occurs due to the interference of backscattered echo from earth’s rough surface. There are various speckle reduction techniques in spatial domain and transform domain. Non local means filtering (NLMF) is the technique used for denoising which uses Gaussian weights. In NLMF algorithm, the filtering is performed by taking the weighted mean of all the pixels in a selected search area. The weight given to the pixel is based on the similarity measure calculated as the weighted Euclidean distance over the two windows. Non local means filtering smoothes out homogeneous areas but edges are not preserved. So a discontinuity adaptive weight is used in order to preserve heterogeneous areas like edges. This technique is called as discontinuity adaptive non local means filtering and is well-adapted and robust in the case of Additive White Gaussian Noise (AWGN) model. But speckle is a multiplicative random noise and hence Euclidean distance is not a good choice. This paper presents evaluation results of using different distance measures for improving the accuracy of the Non local means filtering technique. The results are verified using real and synthetic images and from the results it can be concluded that the usage of Manhattan distance improves the accuracy of NLMF technique. Non local approach is used as a preprocessing or post processing technique for many denoising algorithms. So improving NLMF technique would help improving many of the existing denoising techniques.