Relief-rejuvenation and topographic length scales in a fluvial drainage basin, Napf area, Central Switzerland

This paper explores how, and to what extent, a phase of relief-rejuvenation modifies the mode of surface erosion in an approximately 63 km² drainage basin located at the northern border of the Swiss Alps (Luzern area). In the study area, the retreat of the Alpine glaciers at the end of the Last Glacial Maximum (LGM) caused base level to lower by approximately 80 m. The fluvial system adapted to the lowered base level by headward erosion. This is indicated by knickzones in the longitudinal stream profiles and by the continuous upstream narrowing of the width of the valley floor towards these knickzones. In the headwaters above these knickzones, processes are still to a significant extent controlled by the higher base level of the LGM. There, frequent exposure of bedrock in channels and especially on hillslopes implies that sediment flux is to a large extent limited by weathering rates. In the knickzones, however, exposure of bedrock in channels implies that sediment flux is supply-limited, and that erosion rates are controlled by stream power.The morphometric analysis reveals the existence of length scales in the topography that result from distinct geomorphic processes. Along the tributaries where the upstream sizes of the drainage basins exceed 100,000–200,000 m², the mode of sediment transport and erosion changes from predominantly hillslope processes (i.e., landsliding, creep of regolith, rock avalanches and to some extent debris flows) to processes in channels (fluvial processes and debris flows). This length scale reflects the minimum size of the contributing area for channelized processes to take over in the geomorphic development (i.e., threshold size of drainage basin). This threshold size depends on the ratio between production rates of sediment on hillslopes, and export rates of sediment by processes in channels. Consequently, in the headwaters, erosion rates and sediment flux, and hence landscape evolution rates, are to a large extent limited by weathering processes. In contrast, in the lower portion of the drainage basin that adjusts to the lowered base-level, rates of channelized erosion and relief formation are controlled mainly by stream power. Hence, this paper shows that base-level lowering, headward erosion and establishment of knickzones separate drainage basins in two segments with different controls on rates of surface erosion, sediment flux and relief formation.     

Assessing quality of volunteer crowdsourcing contributions: lessons from the Cropland Capture game

Volunteered geographic information (VGI) is the assembly of spatial information based on public input. While VGI has proliferated in recent years, assessing the quality of volunteer-contributed data has proven challenging, leading some to question the efficiency of such programs. In this paper, we compare several quality metrics for individual volunteers’ contributions. The data were the product of the ‘Cropland Capture’ game, in which several thousand volunteers assessed 165,000 images for the presence of cropland over the course of 6 months. We compared agreement between volunteer ratings and an image's majority classification with volunteer self-agreement on repeated images and expert evaluations. We also examined the impact of experience and learning on performance. Volunteer self-agreement was nearly always higher than agreement with majority classifications, and much greater than agreement with expert validations although these metrics were all positively correlated. Volunteer quality showed a broad trend toward improvement with experience, but the highest accuracies were achieved by a handful of moderately active contributors, not the most active volunteers. Our results emphasize the importance of a universal set of expert-validated tasks as a gold standard for evaluating VGI quality.     

Depositional setting,provenance, and tectonic-volcanic setting of Eocene–Recent deep-sea sediments of the oceanic Izu–Bonin forearc,northwest Pacific (IODP Expedition 352)

New biostratigraphical, geochemical, and magnetic evidence is synthesized with IODP Expedition 352 shipboard results to understand the sedimentary and tectono-magmatic development of the Izu–Bonin outer forearc region. The oceanic basement of the Izu–Bonin forearc was created by supra-subduction zone seafloor spreading during early Eocene (c. 50–51 Ma). Seafloor spreading created an irregular seafloor topography on which talus locally accumulated. Oxide-rich sediments accumulated above the igneous basement by mixing of hydrothermal and pelagic sediment. Basaltic volcanism was followed by a hiatus of up to 15 million years as a result of topographic isolation or sediment bypassing. Variably tuffaceous deep-sea sediments were deposited during Oligocene to early Miocene and from mid-Miocene to Pleistocene. The sediments ponded into extensional fault-controlled basins, whereas condensed sediments accumulated on a local basement high. Oligocene nannofossil ooze accumulated together with felsic tuff that was mainly derived from the nearby Izu–Bonin arc. Accumulation of radiolarian-bearing mud, silty clay, and hydrogenous metal oxides beneath the carbonate compensation depth (CCD) characterized the early Miocene, followed by middle Miocene–Pleistocene increased carbonate preservation, deepened CCD and tephra input from both the oceanic Izu–Bonin arc and the continental margin Honshu arc. The Izu–Bonin forearc basement formed in a near-equatorial setting, with late Mesozoic arc remnants to the west. Subduction-initiation magmatism is likely to have taken place near a pre-existing continent–oceanic crust boundary. The Izu–Bonin arc migrated northward and clockwise to collide with Honshu by early Miocene, strongly influencing regional sedimentation.     

Stormwater harvesting in ephemeral streams: how to bypass clogging and unsaturated layers

To cope with water scarcity in drylands, stormwater is often collected in surface basins and subsequently stored in shallow aquifers via infiltration. These stormwater harvesting systems are often accompanied by high evaporation rates and hygiene problems. This is commonly a consequence of low infiltration rates, which are caused by clogging layers that form on top of the soil profile and the presence of a thick vadose zone. The present study aims to develop a conceptual solution to increase groundwater recharge rates in stormwater harvesting systems. The efficiency of vadose-zone wells and infiltration trenches is tested using analytical equations, numerical models, and sensitivity analyses. Dams built in the channel of ephemeral streams (wadis) are selected as a study case to construct the numerical simulations. The modelling demonstrated that vadose-zone wells and infiltration trenches contribute to effective bypassing of the clogging layer. By implementing these solutions, recharge begins 2250–8100% faster than via infiltration from the bed surface of the wadi reservoir. The sensitivity analysis showed that the recharge rates are especially responsive to well length and trench depth. In terms of recharge quantity, the well had the best performance; it can infiltrate up to 1642% more water than the reservoir, and between 336 and 825% more than the trench. Moreover, the well can yield the highest cumulative recharge per dollar and high recharge rates when there are limitations to the available area. The methods investigated here significantly increased recharge rates, providing practical solutions to enhance aquifer water storage in drylands.

     

Clam community composition and prey shell size impacts moon snail (Gastropod: Naticidae) drilling frequencies in South Carolina,USA

Moon snail predation on clams is a common model system of predator–prey interactions. In this system, the predator bores through the shell of its prey, leaving a distinct and identifiable hole. Some paleoecological and behavioral research on moon snails suggests a trend in predation preference directed toward clams with small shells. Rarely, however, have studies tested relative drilling frequencies across species and size ranges in natural assemblages of clam communities. We examined the clam community composition at two beaches in South Carolina, USA, and we then tested moon snail predator preferences for (a) clam prey species and (b) whether their selection is related to prey shell size. We collected a total of 1,879 clam shells, identified each shell to species and recorded their anteroposterior length. The species composition of clams differed significantly between the two beaches; Anadara ovalis was dominant at both sites, but three of ten total species were only collected at one beach. Folly Beach had nearly a 60% higher the overall drilling frequency (34.6%) versus Edisto Beach (21.8%), and this may be linked to the differences in clam community compositions at the sites. For A. ovalis and Mulinia lateralis, shells with larger lengths have lower probabilities of being bored by a moon snail. Anadara brasiliana, which generally is a thinner‐shelled clam species, had the highest total drilling frequency (77.2%), and Noetia ponderosa, a thicker‐shelled clam, had a considerably lower drilling frequency (12.0%). We conclude that both community level factors (species composition) and population characteristics (shell size distributions) may influence the local drilling frequency by moon snails.     

Mullite in Libyan Desert Glass: Evidence for high-temperature/low-pressure formation

Libyan Desert Glass (LDG) is a SiO₂-rich natural glass whose origin, formation mechanism, and target material are highly debated. We here report on the finding of a lens-shaped whitish inclusion within LDG. The object is dominantly composed of siliceous glass and separated from the surrounding LDG by numerous cristobalite grains. Within cristobalite, several regions rich in mullite often associated with ilmenite were detected. Mineral assemblage, chemical composition, and grain morphologies suggest that mullite was formed by thermal decomposition of kaolinitic clay at atmospheric pressure and T ≥ 1600 °C and also attested to high cooling rates under nonequilibrium conditions. Cristobalite contains concentric and irregular internal cracks and is intensely twinned, indicating that first crystallized β-cristobalite inverted to α-cristobalite during cooling of the SiO₂-rich melt. The accompanied volume reduction of 4% induced the high density of defects. The whitish inclusion also contains several partly molten rutile grains evidencing that at least locally the LDG melt was at T ≥ 1800 °C. Based on these observations, it is concluded that LDG was formed by high-temperature melting of kaolinitic clay-, rutile-, and ilmenite-bearing Cenozoic sandstone or sand very likely during an asteroid or comet impact onto Earth. While melting and ejection occurred at high pressures, the melt solidified quickly at atmospheric pressure.     

Effect of moderate shock waves on magnetic susceptibility and microstructure of a magnetite‐bearing ore

This study demonstrates a relationship between changes of magnetic susceptibility and microstructure developing in minerals of a magnetite‐bearing ore, experimentally shocked to pressures of 5, 10, 20, and 30 GPa. Shock‐induced effects on magnetic properties were quantified by bulk magnetic susceptibility measurements while shock‐induced microstructures were studied by high‐resolution scanning electron microscopy. Microstructural changes were compared between magnetite, quartz, amphibole, and biotite grains. In the 5 GPa sample, a sharp drop of magnetic susceptibility correlates with distinct fragmentation as well as with formation of shear bands and twins in magnetite. At 10 GPa, shear bands and twins in magnetite are accompanied by droplet‐shaped nanograins. In this shock pressure regime, quartz and amphibole still show intensive grain fragmentation. Twins in quartz and foam‐shaped, highly porous amphibole are formed at 20 and 30 GPa. The formation of porous minerals suggests that shock heating of these mineral grains resulted in localized temperature spikes. The identified shock‐induced features in magnetite strongly advise that variations in the bulk magnetic susceptibility result from cooperative grain fragmentation, plastic deformation and/or localized amorphization, and probably postshock annealing. In particular, the increasing shock heating at high pressures is assumed to be responsible for a partial defect annealing which we suggest to be responsible for the almost constant values of magnetic susceptibility above 10 GPa.     

Caribbean hydrological variability during the Holocene as reconstructed from crater lakes on the island of Grenada

Contemporary precipitation patterns in the Caribbean region are spatially variable, and the small number of Holocene paleoclimatic records may not adequately capture patterns of variation in the past. The hydrological history of Grenada was inferred from paleolimnological analyses of sediment cores from two crater lakes on the island. The basins were formed by volcanic activity some time during the Last Termination, but were dry between ca. 13 000 and ca. 7200 cal. a BP. After filling, the lakes were initially very shallow, and sedimentation was interrupted by a hiatus ca. 6300–5500 cal. a BP, followed by deposition of a thick tephra in both sites. After 5500 cal. a BP, lake level shows considerable multi‐centennial variability, superimposed upon a long‐term trend of generally higher lake level after 3200 cal. a BP. The pattern of lake‐level variation in Grenada shows some similarity with other Caribbean paleoclimatic records in terms of the timing of transitions, but differs from several classic studies in the sign of inferred precipitation change. The differences among records may reflect spatially variable precipitation patterns in the past in response to the position of the Intertropical Convergence Zone and to sea surface temperature influences on the trade winds and Caribbean low‐level jet. Copyright © 2011 John Wiley & Sons, Ltd.     

Selective feeding and grazing rates of oyster (Crassostrea virginica) larvae on natural phytoplankton assemblages

Results of laboratory feeding experiments suggest that oyster (Crassostrea virginica) larvae select small phytoplanktonic organisms (<10 μm) over larger-celled forms from natural estuarine assemblages, but that little selection occurs within the small phytoplankton fraction. Laboratory-reared larvae grazed each of five small-celled phytoplankton groups enumerated (coccoids, centrate diatoms, pennate diatoms, dinoflagellates, and flagellates) at rates proportional to phytoplankton group densities in controls (no larvae added). Larval grazing rates (number of cells removed per larva per hour) were inversely proportional to both larval density and experimental duration.