The June 4th 1999 severe weather episode in San Quirino, Italy: a tornado event?

On the morning of June 4th 1999, a severe weather event took place in San Quirino, a small village of Friuli-Venezia Giulia in the northeast of Italy. This village is located near the piedmont of the Alps, 40 km west from Udine and 60 km north from Venice.Around 0900 UTC (1100 local time), a thunderstorm with an intense hail fall affected the area of San Quirino. A few minutes later (around 0920 UTC, source: a farmer), a funnel cloud from a cumulonimbus touched the ground, producing damages to houses, trees and sheds. The damaged area was quite narrow (about 300 m) and short (less than 10 km). No injuries to people were reported.In spite of the smallness of the area interested by the phenomenon, this storm is studied here starting from the synoptic scale, moving to the mesoscale and finishing with the storm scale, trying to underline its characteristics. These analyses, especially those coming from the Doppler radar images, bring us to the conclusion that the San Quirino episode was produced by a supercell storm.     

All-sky Data Assimilation of MWTS-2 and MWHS-2 in the Met Office Global NWP System.

Microwave radiances from passive polar-orbiting radiometers have been, until recently, assimilated in the Met Office global numerical weather prediction system after the scenes significantly affected by atmospheric scattering are discarded.Recent system upgrades have seen the introduction of a scattering-permitting observation operator and the development of a variable observation error using both liquid and ice water paths as proxies of scattering-induced bias. Applied to the Fengyun 3 Microwave Temperature Sounder 2(MWTS-2) and the Microwave Humidity Sounder 2(MWHS-2), this methodology increases the data usage by up to 8% at 183 GHz. It also allows for the investigation into the assimilation of MWHS-2 118 GHz channels, sensitive to temperature and lower tropospheric humidity, but whose large sensitivity to ice cloud have prevented their use thus far. While the impact on the forecast is mostly neutral with small but significant shortrange improvements, 0.3% in terms of root mean square error, for southern winds and low-level temperature, balanced by 0.2% degradations of short-range northern and tropical low-level temperature, benefits are observed in the background fit of independent instruments used in the system. The lower tropospheric temperature sounding Infrared Atmospheric Sounding Interferometer(IASI) channels see a reduction of the standard deviation in the background departure of up to 1.2%. The Advanced Microwave Sounding Unit A(AMSU-A) stratospheric sounding channels improve by up to 0.5% and the Microwave Humidity Sounder(MHS) humidity sounding channels improve by up to 0.4%.     

Soluble organic compounds in fog and cloud droplets: what have we learned over the past few years?

We have recently set up a new procedure for characterising the water soluble organic compounds (WSOC) in fog water, for which information is still rather limited. Fog samples collected during the 1998–1999 fall–winter season in the Po Valley (Italy) were analysed following this procedure, which allows a quantitative determination of three main classes of organic compounds (neutral species, mono- and di-carboxylic acids, polycarboxylic acids), together accounting for ca. 85% of the total WSOC. This procedure also provides information on the main chemical characteristics of these three classes of compounds (functional groups, aliphatic vs. aromatic character, etc.). The enhanced chemical knowledge on fog/cloud chemical composition opens new scenarios as far as chemical and microphysical processes in clouds and fogs are concerned.     

Analysis of a regional change in the sign of the SAM�Ctemperature relationship in Antarctica

This study examines regional atmospheric circulation changes associated with a reversal in the sign of the relationship between the Southern Annular Mode (SAM) and near-surface temperatures at Halley station, East Antarctica, during the 1980s. We show that the key factor affecting the regional SAM?Ctemperature relationship (STR) is the relative magnitude of two climatological low pressure centres to the west and east of the area, which determines the source region of air masses advected into the locality. The principal difference affecting the STR is shown to be a trend towards a significantly weaker climatological low (higher pressure) at ~20°E during a positive phase of the SAM. Specifically, it is variations in the phase and magnitude of the wave number three patterns of atmospheric circulation, the non-annular component of the SAM, which are the principal factors governing the regional STR. A similar reversal is observed in the sign of the correlation between the SAM and oxygen-isotope values from an ice core located some 1,200?km east of Halley. This relationship is examined throughout the 20th Century, by comparing the isotope data to SAM reconstructions, and demonstrates marked decadal variability. Thus, these data suggest that switches in the STR are more likely to reflect natural variability in the long-wave patterns over the Southern Ocean rather than the influence of an anthropogenic forcing. This finding is important when considering the potential utility of Antarctic isotope data as a proxy for the SAM.     

Trajectory Ontologies and Queries

Many real world applications today are built on analyses of movement and related features. Examples of such applications include transportation management, urban planning, tourism services, and animal migration monitoring, among others. Recent database modeling and management research prototypes have the capability to store and manipulate movement data in terms of point or region geometries that evolve over time (moving point or moving and deforming region). This captures the spatio‐temporal trace left by a moving object, but ignores its links with non‐geometric information that enable a semantic interpretation of the movement of moving objects. The concept of trajectory has been introduced to express a more semantic understanding of movement, taking it closer to the perception of applications. This article describes a framework for a semantics‐oriented structuring, modeling and querying of trajectory data. The framework relies on the definition of trajectory‐related ontologies, addressing domain‐independent and application‐specific geometric and semantic facets. Last we briefly discuss how the proposed approach has been applied for a traffic management application.     

Roughness effect on the correction factor of surface velocity for rill flows

Flow velocity is one of the most important hydrodynamic variables for both channelized (rill and gullies) and interrill erosive phenomena. The dye tracer technique to measure surface flow velocity V_s is based on the measurement of the travel time of a tracer needed to cover a known distance. The measured V_s must be corrected to obtain the mean flow velocity V using a factor α_v = V/V_s which is generally empirically deduced. The V_s measurement can be influenced by the method applied to time the travel of the dye-tracer and α_v can vary in different flow conditions. Experiments were performed by a fixed bed small flume simulating a rill channel for two roughness conditions (sieved soil, gravel). The comparison between a chronometer-based (CB) and video-based (VB) technique to measure V_s was carried out. For each slope-discharge combination, 20 measurements of V_s, characterized by a sample mean V_m, were carried out. For both techniques, the frequency distributions of V_s/V_m resulted independent of slope and discharge. For a given technique, all measurements resulted normally distributed, with a mean equal to one, and featured by a low variability. Therefore, V_m was considered representative of surface flow velocity. Regardless of roughness, the V_m values obtained by the two techniques were very close and characterized by a good measurement precision. The developed analysis on α_v highlighted that it is not correlated with Reynolds number for turbulent flow regime. Moreover, α_v is correlated neither with the Froude number nor with channel slope. However, the analysis of the empirical frequency distributions of the correction factor demonstrated a slope effect. For each technique (CB, VB)-roughness (soil, gravel) combination, a constant correction factor was statistically representative even if resulted in less accurate V estimations compared to those yielded by the slope-specific correction factor.     

A review of research on seismic behaviour of irregular building structures since 2002

The paper presents an overview of the progress in research regarding seismic response of plan and vertically irregular building structures. Three areas of research are surveyed. The first is the study of the effects of plan-irregularity by means of single-storey and multi-storey building models. The second area encompasses passive control as a strategy to mitigate torsional effects, by means of base isolation and other types of devices. Lastly, the third area concerns vertically irregular structures and setback buildings. Although fewer papers have been published in this last area with respect to the former ones, this state-of-the-art reports extensively on research efforts and progress into the seismic behaviour of irregular buildings in elevation to show the growing interest among specialists in the field.     

Evaluation of the SEDD model for predicting sediment yield at the Sicilian experimental SPA2 basin

In this paper a spatially distributed model of the hillslope sediment delivery processes, named the sediment delivery distributed (SEDD) model, is initially reviewed; the model takes into account the sediment delivery processes due to both the hillslope sediment transport and the effects of slope curvature. Then the rainfall and sediment yield events measured at the experimental SPA2 basin, in Sicily, are used both to calibrate the SEDD model and to verify the predictive capability of the distributed sediment delivery approach at event scale. For the SPA2 basin discretized into morphological units and stream tubes, the SEDD model is calibrated at event scale using the measurements carried out at the outlet of the experimental basin in the period December 2000–January 2001. The model calibration is used to determine a relationship useful for estimating the unique coefficient β_e of the model by rainfall erosivity factor R_e at event scale. To test the predictive capability of the β_e = f(R_e) relationship, 20 events measured in the period September 2002–December 2005 are used; the comparison between measured sediment yield values and calculated ones for all monitored events shows that the sediment delivery distributed approach has a good predictive ability at event scale. The analysis also shows that estimating β_e by the relationship β_e = f(R_e) gives a better agreement between measured and calculated sediment yields than obtained with the median value β_e,m of all 27 calculated β_e values. Finally the analysis at annual scale, for the period 2000–2005, allows the estimation of the median value β_a,m representative of the annual behaviour. This analysis shows that the sediment delivery distributed approach also has a good predictive ability at annual scale. Copyright © 2006 John Wiley & Sons, Ltd.     

Recharge estimation for transient ground water modeling

Reliable ground water models require both an accurate physical representation of the system and appropriate boundary conditions. While physical attributes are generally considered static, boundary conditions, such as ground water recharge rates, can be highly variable in both space and time. A practical methodology incorporating the hydrologic model HELP3 in conjunction with a geographic information system was developed to generate a physically based and highly detailed recharge boundary condition for ground water modeling. The approach uses daily precipitation and temperature records in addition to land use/land cover and soils data. The importance of the method in transient ground water modeling is demonstrated by applying it to a MODFLOW modeling study in New Jersey. In addition to improved model calibration, the results from the study clearly indicate the importance of using a physically based and highly detailed recharge boundary condition in ground water quality modeling, where the detailed knowledge of the evolution of the ground water flowpaths is imperative. The simulated water table is within 0.5 m of the observed values using the method, while the water levels can differ by as much as 2 m using uniform recharge conditions. The results also show that the combination of temperature and precipitation plays an important role in the amount and timing of recharge in cooler climates. A sensitivity analysis further reveals that increasing the leaf area index, the evaporative zone depth, or the curve number in the model will result in decreased recharge rates over time, with the curve number having the greatest impact.     

Mechanisms of riverbank failure along the Arno River,central Italy

Riverbanks along the Arno River have been investigated with the aims of de?ning the main mechanisms of failure and retreat, their spatial distribution, and their causes. Geomorphological aspects were investigated by a reconnaissance of riverbank processes, for a number (26) of representative sites. Laboratory and in situ tests were then performed on a selected number of riverbanks (15). Based on the material characteristics, six main typologies of riverbanks have been de?ned, with homogeneous ?ne‐grained and composite banks representing the most frequent types. Slab‐type failures are the most frequent mechanism observed on ?ne‐grained banks, while cantilever failures prevail on composite banks. The role of river stage and related pore water pressure distributions in triggering the main observed mechanisms of failure has been investigated using two different types of stability analysis. The ?rst was conducted for 15 riverbanks, using the limit equilibrium method and considering simpli?ed hypotheses for pore water pressure distribution (annulment of negative pore pressures in the portion of the bank between low water stage and peak stage). Stability conditions and predicted mechanisms of failure are shown to be in reasonably good agreement with ?eld observations. Three riverbanks, representative of the main alluvial reaches of the river, were then selected for a more detailed bank stability analysis, consisting of: (a) de?nition of characteristic hydrographs of the reach with different return periods; (b) modelling of saturated and unsaturated ?ow using ?nite element seepage analysis; and (c) stability analysis with the limit equilibrium method, by adopting pore water pressure values derived from the seepage analysis. The results are compared to those obtained from the previous simpli?ed analysis, and are used to investigate the different responses, in terms of stability, to different hydrological and riverbank conditions. Copyright © 2003 John Wiley & Sons, Ltd.