Seismic evidence for pervasive deformation of oceanic sediments in the Eastern Equatorial Atlantic

Seismic reflection profiles from the equatorial Atlantic off Africa between 12°N and 1°N reveal remarkably widespread deformation of oceanic sediments in an area lacking teleseismic activity. Uplift of abyssal plain sequences has occurred along the eastern extensions of large-offset fracture zones on the Mid-Atlantic Ridge. Between the major transforms pervasive deformation is imaged in the sedimentary column. Diapirism and faulting may have been associated with extensive fluid migration and sediment mobilization. The deformation occurred during the late Cenozoic and was probably related to reactivation of Cretaceous transforms.     

Evaluation of long-term extreme response statistics of jack-up platforms

This paper is concerned with the models appropriate for the dynamic assessment of jack-ups, concentrating particularly on the long-term response due to random ocean waves and on work-hardening plasticity models used for spud-can response. A methodology for scaling of short-term statistics, calculated using a Constrained NewWave technique, is shown in a numerical experiment for an example jack-up and central North Sea location. The difference in long-term extreme response statistics due to various footing assumptions is emphasised. Results for two environmental load conditions are described (one excluding and one including wind and current effects) and the role of sea-state severity in the variation of short-term extreme response statistics is also highlighted.     

Manganese and iron distributions off central California influenced by upwelling and shelf width

In July 2002, a combination of underway mapping and discrete profiles revealed significant along-shore variability in the concentrations of manganese and iron in the vicinity of Monterey Bay, California. Both metals had lower concentrations in surface waters south of Monterey Bay, where the shelf is about 2.5 km wide, than north of Monterey Bay, where the shelf is about 10 km wide. During non-upwelling conditions over the northern broad shelf, dissolvable iron concentrations measured underway in surface waters reached 3.5 nmol L⁻¹ and dissolved manganese reached 25 nmol L⁻¹. In contrast, during non-upwelling conditions over the southern narrow shelf, dissolvable iron concentrations in surface waters were less than 1 nmol L⁻¹ and dissolved manganese concentrations were less than 5 nmol L⁻¹. A pair of vertical profiles at 1000 m water depth collected during an upwelling event showed dissolved manganese concentrations of 10 decreasing to 2 nmol L⁻¹, and dissolvable iron concentrations of 12–20 nmol L⁻¹ in the upper 100 m in the north, compared to 3.5–2 nmol L⁻¹ Mn and 0.6 nmol L⁻¹ Fe in the upper 100 m in the south, suggesting the effect of shelf width influences the chemistry of waters beyond the shelf.These observations are consistent with current understanding of the mechanism of iron supply to coastal upwelling systems: Iron from shelf sediments, predominantly associated with particles greater than 20 μm, is brought to the surface during upwelling conditions. We hypothesize that manganese oxides are brought to the surface with upwelling and are then reduced to dissolved manganese, perhaps by photoreduction, following a lag after upwelling.Greater phytoplankton biomass, primary productivity, and nutrient drawdown were observed over the broad shelf, consistent with the greater supply of iron. Incubation experiments conducted 20 km offshore in both regions, during a period of wind relaxation, confirm the potential of these sites to become limited by iron. There was no additional growth response when copper, manganese or cobalt was added in addition to iron. The growth response of surface water incubated with bottom sediment (4 nmol L⁻¹ dissolvable Fe) was slightly greater than in control incubations, but less than in the presence of 4 nmol L⁻¹ dissolved iron. This may indicate that dissolvable iron is not as bioavailable as dissolved iron, although the influence of additional inhibitory elements in the sediment cannot be ruled out.     

Cross-Calibration and Long-Term Monitoring of the Microwave Radiometers of ERS, TOPEX, GFO, Jason, and Envisat

The radiometers on board the satellites ERS-1, TOPEX/Poseidon, ERS-2, GFO, Jason-1, and Envisat measure brightness temperatures at two or three different frequencies to determine the total columnal water vapor content and wet tropospheric path delay, a major correction to the altimeter range measurements. In order to asses the long-term stability of the path delay, the radiometers are calibrated against vicarious cold and hot references, against each other, and against several atmospheric models. Four of these radiometers exhibit significant drifts in at least one of the channels, resulting in yet unmodeled errors in path delay of up to 1 mm/year, thus limiting the accuracy at which global sea level rise can be inferred from the altimeter range measurements.     

High-resolution seafloor mapping using the DSL-120 sonar system: Quantitative assessment of sidescan and phase-bathymetry data from the Lucky Strike segment of the Mid-Atlantic Ridge

High-resolution, side-looking sonar data collected near the seafloor (100 m altitude) provide important structural and topographic information for defining the geological history and current tectonic framework of seafloor terrains. DSL-120 kHz sonar data collected in the rift valley of the Lucky Strike segment of the Mid-Atlantic Ridge near 37° N provide the ability to quantitatively assess the effective resolution limits of both the sidescan imagery and the computed phase-bathymetry of this sonar system. While the theoretical, vertical and horizontal pixel resolutions of the DSL-120 system are <1 m, statistical analysis of DSL-120 sonar data collected from the Lucky Strike segment indicates that the effective spatial resolution of features is 1–2 m for sidescan imagery and 4 m for phase-bathymetry in the seafloor terrain of the Mid-Atlantic Ridge rift valley. Comparison of multibeam bathymetry data collected at the sea-surface with deep-tow DSL-120 bathymetry indicates that depth differences are on the order of the resolution of the multibeam system (10–30 m). Much of this residual can be accounted for by navigational mismatches and the higher resolving ability of the DSL-120 data, which has a bathymetric footprint on the seafloor that is 20 times smaller than that of hull-mounted multibeam at these seafloor depths (2000 m). Comparison of DSL-120 bathymetry with itself on crossing lines indicates that residual depth values are ±20 m, with much of that variation being accounted for by navigational errors. A DSL-120 survey conducted in 1998 on the Juan de Fuca Ridge with better navigation and less complex seafloor terrain had residual depth values half those of the Lucky Strike survey. The quality of the bathymetry data varies as a function of position within the swath, with poorer data directly beneath the tow vehicle and also towards the swath edges.Variations in sidescan amplitude observed across the rift valley and on Lucky Strike Seamount correlate well with changes in seafloor roughness caused by transitions from sedimented seafloor to bare rock outcrops. Distinct changes in sonar backscatter amplitude were also observed between areas covered with hydrothermal pavement that grade into lava flows and the collapsed surface of the lava lake in the summit depression of Lucky Strike Seamount. Small features on the seafloor, including volcanic constructional features (e.g., small cones, haystacks, fissures and collapse features) and hydrothermal vent chimneys or mounds taller than 2 m and greater than 9 m² in surface area, can easily be resolved and mapped using this system. These features at Lucky Strike have been confirmed visually using the submersible Alvin, the remotely operated vehicle Jason, and the towed optical/acoustic mapping system Argo II.