Validation of Sea Level Data in the East Asian Marginal Seas： Comparison between TOPEX／POSEIDON Altimeter and In-Situ Tide Gauges

In an effort to assess the reliability of satellite altimeter systems, the authors conduct a comparative analysis of sea level data that were collected from the TOPEX/POSEIDON (T/P) altimeter and 10 tide gauges (TG) near the satellite passing ground tracks. The analysis is made using datasets collected from marginal sea regions surrounding the Korean Peninsula at T/P cycles of 2 to 230, which correspond to October 1992 to December 1998. Proper treatment of tidal errors is a very critical step in data processing because the study area has very strong tide. When the T/P data are processed, the procedures of Park and Gamberoni (1995) are adapted to reduce errors associated with the tide. When the T/P data are processed in this way, the alias periods of M2, $2, and K1 constituents are found to be 62.1, 58.7, and 173 days repectively. The compatibility of the T/P and TG datasets are examined at various filtering periods.The results indicate that the low-frequency signals of the T/P data can be interpreted more safely with longer filtering periods (such as up to the maximum selected value of 200 days). When RMS errors for the 200-day low-pass filter period are compared with all 10 tidal stations, the values span the range of 2.8 to 6.7 cm. The results of a correlation analysis for this filtering period also show a strong agreement between the T/P and TG datasets across all stations investigated (e.g., p-values consistently less than 0.001). Hence according to the analysis, the conclusion is made that the analysis of surface sea level using satellite altimeter data can be made safely with reasonably extended filtering periods such as 200 days.     

Storm-influenced siliciclastic and carbonate ramp deposits, the Lower Ordovician Dumugol Formation, South Korea

The Dumugol Formation (Lower Ordovician) in the southern part of the Baegunsan syncline, South Korea, contains mixed siliciclastic and carbonate ramp deposits. The ramp sediments were frequently influenced by storm events resulting in tempestites of sandstone-mudstone couplets, bioclastic grainstones to packstones, flat-pebble conglomerates, a skeletal lag layer and laminated calcisiltites. All tempestites are characterized by an erosive to sharp base, poor grading and a transitional upper boundary. The difference in lithology of tempestites appears to have been controlled by the nature of substrates and by proximality. For example, laminated calcisiltites have developed on the shallow carbonate ramp, flat-pebble conglomerates are closely associated with nodular limestones on shallow and deep ramps, and thin skeletal lag layers from fossiliferous argillaceous sediments formed in a basinal setting. The stratigraphic succession of the Dumugol Formation represents an initial transgression followed by a regression. The vertical facies change records the transition from a shallow siliciclastic ramp to a deep carbonate ramp, to a basin, shallowing to a deep carbonate ramp, and to a shallow carbonate ramp. Storm effects are mostly well preserved in shallow to deep ramp deposits.     

TEM and XRD determination of crystallite size and lattice strain as a function of illite crystallinity in pelitic rocks

Average crystallite size and mean-square strain of illite in rock specimens and clay separates were measured independently in TEM images and by single-line Fourier (Voigt method) profile analysis of the c. 1 nm peak of XRD patterns for a prograde sequence of pelitic rocks (illite crystallinity indices=0.17–0.58°Δ2θ) from the Gaspé Peninsula, Quebec. The TEM-determined crystallite sizes in clay separates approximate those determined by Fourier profile analyses and those calculated from illite crystallinity indices by the Scherrer equation, with the exception of the diagenetic sample. The crystallite sizes and mean-square strains of illite in rock samples exhibit a trend similar to that determined by profile analyses, but the average crystallite sizes are up to five times larger than those measured for clay separates. TEM images show that all rock samples have a wide range of crystallite sizes, and the proportions of larger crystallites increase with metamorphic grade. The diagenetic illite is defect-rich, fine-grained (mean thickness by volume=c. 70 nm), 1M_d material. Anchizonal illite tends to occur as separate aggregates of small 1M_d and larger 2M₁ crystals (c. 200 nm), comprising arrays of subparallel coalescing packets. The epizone sample has thick (c. 400 nm), defect-free crystals of muscovite occurring in stacks of parallel layers, or subhedral crystals intergrown with large-angle boundaries. Cleaved crystals that are free of intracrystalline layer terminations are dominant in clay separates of all samples, having ranges of smaller sizes with volume-average thicknesses of c. 43, 43, and 81 nm (c. 14, 28, 67 nm by the Voigt method), respectively, for the three zones. The results suggest that illite crystallinity indices do not provide a direct measure of a single microstructural state of illite in rocks, although they yield consistent limits for average crystallite sizes for the anchizone (23 & 48 nm here). Therefore, they serve as a general parameter of the degree of recrystallization on a relative basis, in part because the contributions of all peak-broadening variables (mixed layering, size and strain) decrease regularly with prograde regional metamorphism of pelites. The microstructural changes caused by rock disaggregation are probably a function of those variables as well. The data collectively demonstrate a trend from metastable, defect-rich, small crystals towards a stable assemblage of larger, defect-free crystals, through dissolution of strained crystals and neocrystallization, consistent with the Ostwald step rule.     

SEDIMENT TRANSPORT CAPACITY -AN IMPROVED BAGNOLD FORMULA

This paper re-examines Bagnold’s theorem of sediment transport. Different from the stream power defined by Bagnold, i.e., τoV, this study shows that the total load of sediment-laden flow, gt, is related to near bed energy dissipation rate, i.e., τou*’. An attempt is made to explain the empirical relation. The ratio (=k) of measured total load, gt, to the product of near bed velocity, u*’, and energy dissipation rate, τou*’, is analyzed. It is found that k is independent of the Rouse number, Z, if Z is greater than 2.6, but the coefficient k decreases with the increase of Z when Z < 2.6. An empirical relation between k and Z is developed. A systematic and thorough analysis of 1,458 sets of data collected from 16 rivers and canals confirms that the proposed formula can be used to compute the total load with accuracy.     

2002年3月21—22日影响韩国的沙尘天气分析

利用气象卫星、天气形势场和NCEP/NCAR再分析资料,分析了2002年3月21—22日影响韩国沙尘天气的原因。结果表明:影响韩国沙尘天气的沙尘主要源地是蒙古国和中国内蒙古地区。沙尘天气发生在地面冷锋后部,高压伸展的前面;19日和20日沙尘暴发生后,沙尘沿着西北风输送,21日早晨影响韩国;PM10最高值达到2 778.2μg/m³,由于西北风较强,沙尘暴发生后很快影响到韩国,但在韩国持续的时间较短。     

EXPERIMENTAL STUDY OF FPS SYSTEM IN BRIDGE SEISMIC ISOLATION

An experimental study of a seismically isolated and a comparable non-isolated bridge is presented. The bridge model featured flexible piers, weighed 158kN and was tested on a shake table with an array of real and simulated seismic motions with peak acceleration in the range 0⋅1–1⋅1g. When isolated, the bridge deck was supported by four spherically shaped sliding bearings (known as Friction Pendulum System or FPS bearings) with friction coefficient under dynamic conditions in the range 0⋅07–0⋅12. The experimental results demonstrated a substantial improvement in the ability of the isolated bridge to sustain all levels of seismic excitation under elastic conditions.     

Diel vertical migration of the copepod Calanus sinicus before and during formation of the Yellow Sea Cold Bottom Water in the Yellow Sea

To understand the effects of the Yellow Sea Cold Bottom Water(YSCBW)on the diel vertical migration(DVM)of the copepod Calanus sinicus,we surveyed vertical distribution of C.sinicus at a fixed station in the Yellow Sea before(spring)and during(summer)formation of the YSCBW.Cold water(<10 C)was observed in the bottom layer when the water column was thermally stratified in summer,but the water column was thermally well-mixed in spring 2010.Samples were collected from five different layers at 3-h intervals using an opening-closing net.Adult females(1–155 ind./m3)showed a clear normal DVM pattern throughout the entire water column in spring,whereas adult males did not migrate.DVM of copepodite V(CV)individuals was not clear,but the maximum abundance of CI–CIV occurred consistently in the upper 10–20 m layer,where there was a high concentration of chlorophyll-a(Chl-a)(0.49–1.19μg/L).In summer,weak DVM was limited to cold waters beneath the thermocline for adult females(<30 ind./m3),but not for adult males.The maximum abundance of CI–CIV also occurred consistently in the subsurface layer(20–40 m)together with high concentrations of Chl-a(0.81–2.36μg/L).CV individuals(1–272 ind./m3)moved slightly upward nocturnally to the near-surface layer(10–20 m),where the average temperature was 25.74 C,but they were not found in the surface layer(0–10 m;28.31 C).These results indicate that the existence of the YSBCW affected food availability at depth and the vertical temperature distribution,leading to variation in the amplitude and shape of stage-specific vertical distributions(CI to adults)in C.sinicus before and during the formation of cold waters in the Yellow Sea during the study period.     

High-frequency acoustic backscattering characteristics for acoustic detection of the red tide species Akashiwo sanguinea and Alexandrium affine

Harmful algal blooms(HABs),caused by the overgrowth of certain phytoplankton species,have negative effects on marine environments and coastal fisheries.In addition to cell-counting methods using phytoplankton nets,a hydroacoustic technique based on acoustic backscattering has been proposed for the detection of phytoplankton blooms.However,little is known of the acoustic properties of HAB species.In this study,as essential data to support this technique,we measured the acoustic properties of two HAB species,Akashiwo sanguinea and Alexandrium affine,which occur in the South Sea off the coast of Korea.Due to the small size of the target,we used ultrasound for the measurements.Experiments were conducted under laboratory and field conditions.In the laboratory experiment,the acoustic signal received from each species was directly proportional to the cell abundance.We derived a relationship between the cell abundance and acoustic signal received for each species.The measured signals were compared to predictions of a fluid sphere scattering model.When A.sanguinea blooms appeared at an abundance greater than 3 500 cells/mL,the acoustic signals varied with cell abundance,showing a good correlation.These results confirm that acoustic measurements can be used to detect HAB species.     

Energy Consumption and Greenhouse Gas Emission of Korean Offshore Fisheries

This paper presents the energy and greenhouse gas(GHG) emission assessments of Korean offshore fisheries. The consumption of energy by fisheries is a significant concern because of its attendant environmental effect, as well as the cost of the fuel consumed in fishing industry. With the global attention of reducing GHG emission and increasing energy efficiency of fuel, the seafood industry needs to further understand its energy use and reduce its GHG emission. In the present study, the amount of energy consumed and the GHG emission of Korean offshore fisheries in a period from 2009 to 2013 were examined. Offshore fisheries accounted for 24% of Korean production in 2013 and 60% of fuel consumption related GHG emission. Whereas the total GHG emission intensity of this sector improved slightly between 2009 and 2012; as such emission decreased by approximately 1.9%, which increased again in 2013. The average amount of total GHG emission in this five years period was 1.78 × 10~6 tons of carbon dioxide equivalent/year(tCO_2eq. y~(-1)). Active fishing gear was found to consume 20% more fuel than passive gear. However, the production from passive gear was 28%, lower than 72% from active gear. The reason for this is that less abundant stationary resources are harvested using passive gear. Furthermore, the consumption of fuel was significantly influenced by the fishing method. Implementation and development of new fishing technologies and methods are important for improving energy efficiency and reducing the climate impact on fisheries. To realize these purposes, the fishery management system needs to be established by centralizing on energy efficiency and climate effect.