The Spačice eclogite: constraints on the P–T–t history of the Gföhl granulite terrane, Moldanubian Zone, Bohemian Massif

Summary In the Kutná Hora Complex, the Běstvina Formation, which is similar to Gf?hl granulite, contains eclogite that has escaped widespread retrograde recrystallization. The eclogite assemblage, garnet + omphacite + quartz + rutile ± plagioclase, yields an estimate for peak metamorphic conditions of 18–20 kbar and 835–935 °C, which is comparable to that determined from felsic granulite, 14–20 kbar and 900–1000 °C. Garnet in eclogite exhibits both prograde and retrograde compositional zoning, from which constraints on thermal history of the Gf?hl terrane can be derived by diffusion modelling. At 900 °C, a garnet grain of 800–1000 μm radius would homogenize in 7.5–11.7 million years, but the existence of compositional gradients on a length scale of 100–200 μm suggests that the duration of peak metamorphism may have been limited to ∼500,000 years. Diffusion modelling of retrograde zoning in garnet yields a cooling rate of 150–100 °C/m.y. for a radius of 800–1000 μm and initial temperature of 900 °C. The relatively brief duration of high-pressure/high-temperature metamorphism and rapid cooling and exhumation of the Gf?hl terrane may be a consequence of lithospheric delamination during Early Carboniferous collision of Bohemia (Teplá-Barrandia) and Moldanubia (Franke, 2000).     

The effect of thermal treatment on the 57Fe Mössbauer spectrum of beryl

Mössbauer spectra (MS) of blue, green and yellow beryl (ideally Be₃Al₂Si₆O₁₈) containing approximately 1% of iron were obtained at 295 and 500 K. Room temperature (RT) spectra of both blue and green samples showed the presence of an asymmetric Fe²⁺ doublet (ΔE _Q~2.7 mm/s, δ~1.1 mm/s), with a very broad low-velocity peak. There is no clear evidence for the presence of a ferric component. The MS of the yellow sample at RT consists of an intense central absorption with parameters typical for Fe³⁺ (ΔE _Q~0.4 mm/s, δ~0.29 mm/s), plus an apparently symmetrical Fe²⁺ doublet. This sample acquires a light-blue shade upon heating in air at about 620 K. Thermal treatments at high temperatures caused no significant changes in the MS, but the green and yellow beryl acquire a blue colour. All these results are interpreted in relation to the existence of channel water and the distribution of iron among the available crystallographic sites.     

Avalanche Risk During Backcountry Skiing – An Analysis of Risk Factors

Skier-triggered avalanches are the main cause of avalanche accidents in backcountry skiing. The risk of accidents during backcountry skiing was analysed statistically and related to factors such as elevation level, aspect, stability rating and the time of the year. The analysis is based on a database about terrain usage and avalanche accidents from a large heli-skiing operator in Canada, which makes it possible to study the conditional probability of accidents given the recorded pattern of terrain usage. This study shows that the historical risk of accidentally triggering an avalanche greater than size 1 depends highly on the stability rating, with the highest risk occurring during “poor” stability. The risk is greater at high elevations, and it is lower during the late season than earlier on. Skier risk does not depend as much on aspect as may be indicated from avalanche data alone. However, it is relatively high in the N–NE–E sector. These factors are not independent of each other and therefore analyses of combined factors were also performed. Questionnaires and interviews were used to gain knowledge about the terrain selection of professional mountain guides. These results indicate that when selecting terrain, guides first look at the overall shape and size of the terrain, but avalanche history of terrain and inclination are also important factors. Finally, remarks in avalanche reports were analysed, and common human factors identified.     

Effect of sampling and linkage on fault length and length–displacement relationship

The power-law exponent (n) in the equation: D=cL ⁿ , with D = maximum displacement and L = fault length, would be affected by deviations of fault trace length. (1) Assuming n=1, numerical simulations on the effect of sampling and linkage on fault length and length–displacement relationship are done in this paper. The results show that: (a) uniform relative deviations, which means all faults within a dataset have the same relative deviation, do not affect the value of n; (b) deviations of the fault length due to unresolved fault tip decrease the values of n and the deviations of n increase with the increasing length deviations; (c) fault linkage and observed dimensions either increase or decrease the value of n depending on the distribution of deviations within a dataset; (d) mixed deviations of the fault lengths are either negative or positive and cause the values of n to either decrease or increase; (e) a dataset combined from two or more datasets with different values of c and orders of magnitude also cause the values of n to deviate. (2) Data including 19 datasets and spanning more than eight orders of fault length magnitudes (10⁻²–10⁵ m) collected from the published literature indicate that the values of n range from 0.55 to 1.5, the average value being 1.0813, and the peak value of n _d (double regression) is 1.0–1.1. Based on above results from the simulations and published data, we propose that the relationship between the maximum displacement and fault length in a single tectonic environment with uniform mechanical properties is linear, and the value of n deviated from 1 is mainly caused by the sampling and linkage effects.     

Geometry and accuracy of reflecting points in bistatic satellite altimetry

The analysis of the time and space distribution of specular (reflecting) points in bistatic altimetry between GPS and CHAMP satellites or SAC-C (taken as examples) is extended from Wagner and Klokočník (2003 J. Geod 77: 128–138). We demonstrate a significantly higher number and density of reflecting points in bistatic altimetry in comparison with traditional monostatic altimetry. After an outline of our older accuracy assessment for the vertical position of the reflecting point, we add a new independent derivation and compare both approaches. We account for orbit errors of both the transmitters (GPS) and receiver (CHAMP) satellites, and the measurement (delay) error. We found that the accuracy of the vertical position of the reflecting point decreases only slowly with increasing off-nadir angle and that the orbit errors must be accounted for if decimeter and better accuracy is required. In this paper, we do not study errors such as state of the ocean, technical parameters of the receiving system, and atmospheric corrections.     

Daily Meteorological Observations in Cádiz – San Fernando. Analysis of the Documentary Sources and the Instrumental Data Content (1786–1996)

Meteorological observations in the city of Cádiz are acknowledged as having been made from the middle of the 18th century onwards although they were only recorded and preserved in documentary form from 1789 onwards. Data readings were taken at the new Naval Observatory in San Fernando, ten kilometres from Cádiz, from 1797 onwards. Continuous series for temperature and atmospheric pressure at a daily resolution have been compiled and constructed from 1817 until 1996. The data series is composed of thrice daily observations made at Cádiz (1821–1880) by local observers and hourly data from Naval Observatory at San Fernando (1870–1996).     

黄骅裂谷盆地第三系水循环和渗流场形成演化的重溯

在简述盆地地质环境和含水系统、水文地质期与水压系统类型定位的基础上，通过建立数学模型，采用反演、比拟和地静压力等方法，模拟计算了各研究层在各研究时期泥岩压出水水头值（m),Es^2层的依次为2－28，2－26，2－6，2－16，0．5－3．5；Es^1层的依次为2－42，2－26，2－6，10－54，1－14；Ed层的依次为2－22，2－54，2－12；Ng层的依次为10－24，1－5；Nm层的为12－24。各研究层在各研究时期的压挤式水交替强度均小于1，累加值Es^2,Es^1,Ed层的均大于1，Ng，Nm层的小于1；Ed层渗入水交替强度为0.44。各研究层在各研究时期渗流场的高水压带位置和流动态具有相似性，并均以离心型流动型为主要特征。     

Simultaneous use of geochemical and geophysical methods to characterise abandoned landfills

. Groundwater sampling and geophysical methods determined a serious contamination problem associated with refilled exploitation sites at the Cal Dimoni area, Llobregat delta, Barcelona, Spain. To characterise this process, hydrogeochemical analyses were performed and showed the following modifications to groundwater chemical composition: increasing pH values, changing redox conditions, significant increases in total organic carbon (TOC) and certain trace elements, and high groundwater conductivity values. Major ion content accumulations were found under the refilled area. In contrast, elements involved in the oxidation–reduction processes, such as iron, manganese and nitrates, clearly diminished. Electromagnetic prospecting methods were also performed and delineated the contamination plume extent. These methods also showed separate sources of contamination, one clearly related to the groundwater–refilled zone leachate interaction, another as a consequence of the manure–accumulation surface site. Geochemical and geophysical methods have shown similar results for locating groundwater contamination sources, and for determining leachate generation mechanisms and flow paths.     

Al hematites prepared by homogeneous precipitation of oxinates: material characterization and determination of the Morin transition

A novel method for synthesis of aluminium hematites, based upon the homogeneous precipitation of Fe and Al oxinates in various proportions, is presented. The precursor precipitates are heated in air at 700?°C. X-ray diffraction, thermal analyses, BET, FTIR, optical reflection analysis, TEM and Mössbauer spectroscopy at room temperature and 80?K of the resulting products indicate that single-phase hematites are formed with structural Al substitution of up to 10 at%. Interestingly, the particle size (>100?nm) is not substantially reduced by the Al content. Although it remains difficult to obtain a homogeneously distributed Al substitution in the final hematite, this processing line offers a unique opportunity to separate the effects of grain size and Al substitution on the Morin transition temperature (T _M) of Al hematite. From the comparison between the present hematites and a series of Al-substituted hematites with lepidocrocite as precursor, it could be shown that the effect on T _M, associated with a change of a factor 10 in grain size, is about 1/3 of the effect caused by a change of 10 in the degree of substitution. Finally, it is suggested that proper thermal treatments under different conditions of the same precursors are likely to produce spinel phases.     

Anhydrite-bearing rocks from the Rožná district (Moldanubian zone,Czech Republic): high-grade metamorphosed exhalites?

Several types of anhydrite-bearing rocks have been found in the amphibolite-facies metamorphosed rocks at the north-eastern margin of the Moldanubian Zone. Anhydrite either forms monomineralic bands up to 40 cm thick, or occurs in the form of disseminated grains in surrounding calc-silicate gneiss together with feldspar, scapolite, amphibole, pyroxene, epidote and pyrite. The isotopic composition of sulphur ('³⁴S=30.6 to 32.3‰) and strontium (⁸⁷Sr/⁸⁶Sr=0.70797 to 0.70781) in anhydrite may indicate a marine source of sulphate. The isotopic ratio of strontium is in the same range as that of metamorphosed strata-bound barite-sulphide ores, which have been previously described in the same area. The '³⁴S values of coexisting pyrite range from 21.4 to 22.5‰, the (³⁴S_{anhydrite-pyrite} corresponding to the metamorphic temperature of 600 to 660 °C. In contrast to many submarine-exhalative deposits, the oxygen isotopic compositions of anhydrite ('¹⁸O=9.3 to 10.2‰) are lighter than that of barite ('¹⁸O=10.4 to 13.8‰). This indicates that the both minerals are not in isotopic equilibrium. Therefore, it is probable that anhydrite and barite from the Ro—ná district were deposited from fluids that contained different proportions of seawater and hydrothermal fluids or from hydrothermal fluids that underwent variable extent of oxygen isotope exchange with seafloor rocks. The '¹³C values in calcite ('¹³C=-17.2 to -18.7‰) from anhydrite-bearing rock are lower than those in distant marbles. As graphite is absent in anhydrite- and calcite-bearing rocks, impoverishment in the ¹³C isotope cannot be attributed to the graphite-carbonate isotopic exchange during metamorphism. It is proposed that low '¹³C values in carbonates are caused by pre-metamorphic oxidation of organic matter in course of hydrothermal processes. Anhydrite and anhydrite-bearing calc-silicate gneiss from the north-eastern part of the Moldanubian Zone are interpreted to be the high-grade metamorphosed analogue of anhydrite-rich exhalites commonly found in submarine-exhalative hydrothermal deposits.