Effect of core porosity on stability and run-up of breakwaters

The commonly used formulae like Hudson's [(1959), Laboratory investigations of rubblemound breakwaters. WES report, Vicksburg], Iribarren's or Vander meer's [(1988), Rockslopes and gravel beaches under wave attack. Ph.D. thesis, Delft University of Technology, The Netherlands], do not give us the design cross section of a rubblemound breakwater for varying core porosity values. The paper presents the results of the experimental study carried out to compute the effects of core porosity on the stability and run-up characteristics of rubblemound breakwaters. Regular waves were made to attack the structure, with different core porosity values in a normal direction. The porosity of the armour and the secondary layers was neglected. It was observed that as core porosity increased the stability also increased considerably within the limits of the experimental data values. This may be due to large inflow and energy dissipation within the core of the structure. The run-up on the rubblemound slope was found to decrease with the increase in the porosity for the same reason.     

Risk of dike failure due to flow slides

Flow slides may affect the stability of dikes. A flow slide is an instability of a submerged slope caused by liquefaction of loose, (medium) fine sand. Whether a flow slide will occur depends on the properties of the sand, which are a function of its density, and the geometry of the slope, as determined by wave and current induced scour and sedimentation. The influence of sand properties and the geometry parameters on the risk of flow slides are discussed. The application of a flow slide prediction method to an example and a risk analysis is briefly discussed.     

A comparative study of some directional sea models

Current specification of the ocean wave environment for the design of offshore platforms does not adequately describe the directional nature of a real seaway. The strong wave frequency dependent nature of the directional behavior of observed seas is often over-simplified for design. A general formulation encompassing a wide range of directional sea models is presented. Parameter values used in some of the more popular directional sea models are examined. Approximate expressions for the two frequency dependent parameters in a modified Longuet-Higgins cosine wave spreading model are presented. A general procedure which allows an engineer to estimate parameters for alternate wave spreading models is discussed. To illustrate this procedure an empirically based modified cosine spreading model is used as the basis to estimate frequency dependent parameters for circular normal and wrapped Gaussian wave spreading models. A comparison of the contours of the various directional sea models and the prediction of the root-mean-square velocity distribution is presented.     

Morphodynamics of a bar-trough surf zone

A field study was made of the distinguishing morphodynamic processes operating in a surf zone which perennially exhibits accentuated bar-trough topography (the “longshore-bar-trough” and “rhytmic-bar-and-beach” states as described by Wright and Short, 1984). Characteristic features of the morphology include a shallow bar with a steep shoreward face, a deep trough, and a steep beach face. This morphology, which is favored by moderate breaker heights and small tidal ranges, strongly controls the coupled suite of hydrodynamic processes. In contrast to fully dissipative surf zones, the bar-trough surf zone is not at all saturated and oscillations at incident wave frequency remain dominant from the break point to the subaerial beach. The degree of incident wave groupiness does not change appreciably across the surf zone. Infragravity standing waves which, in dissipative surf zones, dominate the inshore energy, remain energetically secondary and occur at higher frequencies in the bar trough surf zone. Analyses of the field data combined with numerical simulations of leaky mode and edge wave nodal—antinodal positions over observed surf-zone profiles, indicate that the frequencies which prevail are favored by the resonant condition of antinodes over the bar and nodes in the trough. Standing waves which would have nodes over the bar are suppressed. Sediment resuspension in the surf zone appears to be largely attributable to the incident waves which are the main source of bed shear stress. In addition, the extra near-bottom eddy viscosity provided by the reformed, non-breaking waves traversing the trough significantly affects the vertical velocity profile of the longshore current. Whereas the bar is highly mobile in terms of onshore—offshore migration rates, the beach face and inner regions of the trough are remarkably stable over time.     

Isolation and characterisation of pristane metabolites formed in vivo by rainbow trout

Pristane (2,6,10,14 -tetramethylpentadecane) occurs ubiquitously in the marine environment. This hydrocarbon may be of biogenic or petrogenic origin.¹ Recently it has been shown that residual amounts of this branched alkane increased in marine organisms after an oil spill.^2,3 The lack of data on the fate of pristane in fish, added with the fact that this compound was considered by some authors as a non-metabolisable substance in vertebrates, including man,⁴ led us to investigate the capability of fish to metabolise pristane. In this study, urinary and fecal excretion, tissue distribution and metabolism of ³H-pristane were analysed in Salmo gairdneri R. after a single intragastric dose. In addition to unchanged hydrocarbon, various labelled compounds have been isolated and identified in liver, bile, faeces, urine and surrounding water, demonstrating that pristane was first oxidised to alcohols (pristanol and pristane-diol) and to acid (pristanic acid). The elimination of these compounds occurred in the form of conjugated products (primarily glucuronides) as well as free metabolites.     

The Amphipod Community as a Bioindicator in Algeciras Bay (Southern Iberian Peninsula) Based on a Spatio-Temporal Distribution

Abstract. The amphipod population associated with Bugula neritina (L.), a verycommon bryozoan species in Algeciras Bay (Strait of Gibraltar), was studied on a spatio-temporal scale, in order to define its role as a bioindicator. Samples were collected in December, March, June and September along a transect running from the external to the internal sampling stations.
Fifty-three species belonging to 22 families were identified; the most abundant species were Jassa marmorata H olmes , Ischyrocerus inexpectatus (R uffo ) and Phtisica marina S labber .
The spatial evolution of the amphipod community reflected the physico-chemical conditions of Algeciras Bay, yielding a clear gradient from the outer to the inner stations. The stations located at the mouth of the bay, characterised by high hydrodynamism and low sedimentation, had a higher diversity and species richness than the inner stations with low water movement and higher sedimentation. Eight species preferred for the outer stations, while another nine species were typical of the inner harbours.
The most notable aspect of the seasonal evolution was the increased dominance of the tube-builder and deposit-suspension feeder Jassa marmorota .
Structural and ordination analyses corroborate the outer-inner gradient in the bay and illustrate the importance of hydrodynamic forces and sedimentation in the amphipod community.     

Virgin rock temperatures from well logs — accuracy analysis for some advanced inversion models

Temperature data from 18 measurement series obtained during logging of the Oseberg field in the northern North Sea are presented. Because the measurement series are taken at approximately the same depth, they should give identical temperatures after depth correction, and are suitable for assessing the performance of different models used to determine virgin rock temperatures from well log information.We have used this data set to test the properties of the different models given by Shen and Beck (1986). Although these models were built to simulate closely the thermal recovery of a well and are unbiased, the uncertainties in the temperature estimates when applied to real data are found to be no less than those from simpler (biased) models. This fact confirms the conclusion of Hermanrud (1989a) who showed that physical factors other than those presently accounted for significantly influence the thermal recovery of a borehole.     

Mechanisms controlling the temporal variation of the sea ice edge in the Southern Ocean

This paper examines the mechanism controlling the short time-scale variation of sea ice cover over the Southern Ocean. Sea ice concentration and ice velocity datasets derived from images of the Defense Meteorological Satellite Program (DMSP) Special Sensor Microwave Imager (SSM/I) are employed to reveal this mechanism. The contribution of both dynamic and thermodynamic processes to the change in ice edge location is examined by comparing the meridional velocity of ice edge displacement and sea ice drift. In the winter expansion phase, the thermodynamic process of new ice production off the ice edge plays an important role in daily advances of ice cover, whereas daily retreats are mostly due to southward ice drift. On the other hand, both advance and retreat of ice edges in the spring contraction phase are mostly caused by the dynamic process of the ice drift. Based on the above mechanism and the linear relation between the degree of ice production at the ice edge and northward wind speed, the seasonal advance of ice cover can be roughly reproduced using the meridional velocity of ice drift at the ice edge.     

The Levant Slumps and the Phoenician Structures: collapse features along the continental margin of the southeastern Mediterranean Sea

Two distinct series of slumps deform the upper part of the sedimentary sequence along the continental margin of the Levant. One series is found along the base of the continental slope, where it overlies the disrupted eastern edge of the Messinian evaporites. The second series of slumps transects the continental margin from the shelf break to the Levant Basin. It seemed that the two series were triggered by two unrelated, though contemporaneous, processes. The shore-parallel slumps were initiated by basinwards flow of the Messinian salt, that carried along the overlying Plio-Quaternary sediments. Seawater that percolated along the detachment faults dissolved the underlying salt to form distinctly disrupted structures. The slope-normal slumps are located on top of large canyons that cut into the pre-Messinian sedimentary rocks. A layer of salt is found in the canyons, and the Plio-Quaternary sediments were deposited on that layer. The slumps are bounded by large, NW-trending faults where post-Messinian faulted offset was measured. We presume that the flow of the salt in the canyons also drives the slope-normal slumps. Thus thin-skinned halokynetic processes generated the composite post-Tortonian structural patterns of the Levant margin. The Phoenician Structures are a prime example of the collapse of a distal continental margin due to the dissolution of a massive salt layer.     

On the use of poorly soluble hygroscopic substances for modification of warm clouds and fogs

From analysis of the relationships between the equilibrium state of condensation nuclei and the relative humidity, a conclusion is made concerning the preferred use of poorly soluble substances for the generation of artificial condensation nuclei (ACN) designed for modification of warm clouds and fogs with the purpose of their dissipation and precipitation formation. The advantage of poorly soluble substances over commonly used soluble salts is that the finely dispersed part of the spectrum of the poorly soluble ACN does not deliquesce and so is not involved in the formation of cloud droplets. For experimental testing of the conclusions, preference was given to cement, whose main soluble substance is calcium oxide with a solubility of about 1 g/l. The spectrum of dispersed cement particles was measured and compared with the spectra of pyrotechnic flares widely used for modification at present. The process of formation of the cloud droplet spectra was simulated in the aerosol chamber of the Institute of Experimental Meteorology by decreasing the preliminarily generated excess pressure. It was found in these experiments that, compared to the spectra of particles formed on background condensation nuclei, the introduction of dispersed cement leads to the broadening of spectra and to a decrease in the concentration of droplets. Even at the early stage of condensation, droplets with radii of ∼20 μm appear. In this case, no “overseeding” phenomenon is observed, which, for soluble substances, manifests itself in an increase in the concentration of cloud droplets with a large ACN concentration. These effects indicate that, according to the existing concepts about the mechanism of warm-cloud modification with hygroscopic substances, the introduction of poorly soluble ACN (in particular, dispersed cement) below the base of cumulus clouds should stimulate coagulation processes and accelerate rain-formation processes. Considerations are given that the introduction of poorly soluble ACN into the already existing cumulus or stratocumulus clouds or fogs should also result in the acceleration of precipitation-formation processes or cloud dispersal. Comparison of cement powder with the well-known means of warm-cloud and fog modification is carried out. Original Russian Text ? N.P. Romanov, A.S. Drofa, N.S. Kim, A.V. Savchenko, G.F. Yaskevich, 2006, published in Izvestiya AN. Fizika Atmosfery i Okeana, 2006, Vol. 42, No. 1, pp. 80–91.