Problems of soil and groundwater pollution in the disposal of “marble” slurries in NW Sicily

This work deals with disposal of slurries generated during the cutting and polishing processes of slabs of decorative sedimentary carbonate rocks in the north western Sicily. At present, they are used as fillers of dismantled quarries near the sawmills and, as a final step of reclamation, are covered with earth layers. In spite of such inexpensive solution, there is lack of knowledge about the composition of the waste. In order to assess if there is any threat for the environment and to suggest indications for alternative solutions, such as recycling or inactivation processes, the slurries were analysed by XR diffraction, simultaneous thermal analysis, ICP/MS, ionic chromatography, FTIR, UV-Vis, COD and TOC measurements, grain size analysis. Results indicate that the slurries can threaten the groundwater, because of the high chemical oxygen demand; furthermore they can modify the mechanism of groundwater recharge, because of their grain size distribution. Some laboratory tests show that, even in very aggressive conditions, the solid pollutants persist in the waste and slowly release into water the products of their degradation. The slurry therefore should be subjected to inactivation treatment before disposal or, alternatively, recycled as secondary raw material for a suitable process.     

Numerical modeling assessment of three-gate structures for capturing contaminated groundwater

This modeling study evaluated the capability of alternative funnel-and-gate structures with three gates for capturing contaminated groundwater in a hypothetical unconfined aquifer. Simulated interceptor structures were linear and 45 m wide, consisting of three gates and two funnels (walls). One gate occupied the center and two gates occupied the ends of the interceptor structures. The structures, positioned perpendicular to regional groundwater flow, traversed the entire thickness of the aquifer. A total of four structures were evaluated (numbers designate widths of end, center, and end gates, respectively, in meters): 3-3-3, 2-5-2, 1-7-1, and 4-1-4. Particle tracking and zonal water budgets identified shapes of capture zones and discharge patterns for each interceptor structure. A mass transport model, accounting for advection and hydrodynamic dispersion, tested the capability of each structure for capturing a contaminant plume. Results suggest that: time-dependent capture zones underestimate the amount of time to capture a contaminant plume, wide center gates facilitate plume capture, and wide end gates facilitate lateral containment of contaminants. Of the structures simulated, the 2-5-2 configuration was relatively efficient at processing and containing the simulated contaminant plume.     

Environmental risk evaluation of the use of mine spoils and treated sewage sludge in the ecological restoration of limestone quarries

The ecologic restoration criteria in areas degraded from extraction activities require making use of their mine spoils. These materials do not meet fertility conditions to guarantee restoration success and therefore, need the incorporation of organic amendments to obtain efficient substratum. Reducing the deficiencies in the organic material and restoration material nutrients with the contribution of treated sewage sludge is proposed in this work. This experiment was based on a controlled study using columns. The work was conducted with two mine spoils, both very rich in calcium carbonate. The first mineral, of poor quality, came from the formation of aggregates of crushed limestone (Z). The other residual material examined originated in limestone extraction, formed by the levels of interspersed non-limestone materials and the remains of stripped soils (D). Two treatments were undertaken (30,000 and 90,000 kg/ha of sewage sludge), in addition to a control treatment. The water contribution was carried out with a device that simulated either short-duration rain or a flooding irrigation system in order to cover the surface and then percolate through the soil. The collection of leached water took place 24 h after the applications. Different parameters of the leached water were determined, including pH, electrical conductivity, nitrate anions, ammonium, phosphates, sulphates and chlorides. The values obtained for each irrigation application are discussed, and the nitrate values obtained were very elevated.     

Design of shallow foundations under tensile loading for transmission line towers: An overview

Tensioned foundations are common in civil engineering applications such as transmission towers, harbors, offshore structures, basement slabs under pressure, industrial equipment, etc. Procedures for the design of tensioned foundations are discussed in this paper, including specific recommendations for more common transmission tower foundations. Starting from a distinction between shallow and deep modes of failure, the paper presents the most common failure mechanisms for shallow failure in tension, including procedures for calculation of foundation tensile capacity under vertical and inclined loading. Emphasis is given to the influence of the strength of the compacted backfill compared to the strength of the natural soil, including presentation of results of full-scale loading tests.     

Composition, P-T parameters, and metasomatic transformations of mafic schists of the Svyatoi Nos Peninsula, Eastern Baikal Area

The paper reports data on rock and mineral compositions from the Svyatonosskaya Formation, which is a continuation of the Ol’khon Series in the northern part of the Svyatoi Nos Peninsula, eastern shore of Lake Baikal. The pyroxene-amphibole-plagioclase schists (metagabbro) are replaced there by the garnet-biotite-quartz assemblage, which was formed, according to the data of various geothermometers and calculations by the THERMOCALC computer program, under conditions corresponding to the transition from the granulite (848–811°C) to high grades of the amphibolite (715–670°C) facies under high pressures (8.7 ±1.6 kbar). In petrogenetic grids, these conditions fall onto the line of the onset of eclogitization. In nature these rocks are a continuation of the Chernorudskaya-Barakchinskaya zone of elevated pressures in the Ol’khon area. The metasomatic rocks were formed simultaneously with strike-slip faulting, when coupled zones of relatively high-(eclogite-like) and low-pressure (quartzite-marble melange) developed at the inflow of SiO₂ and K₂O and the removal of MgO and CaO. Analogous compositional changes in gneisses and schists in tectonic extension zones in Ol’khon Island and neighboring areas occurred during the development of migmatites. The migmatization of the gneisses was likely coupled with the garnetization of mafic schists in high-pressure zones and the formation of eclogite-like rocks replacing marbles. The accompanying graphitization of this block suggests that the metasomatic fluid had a hydrocarbon-hydrogen composition.     

Experimental study of fluorine and chlorine contents in mica (biotite) and their partitioning between mica,phonolite melt,and fluid

This paper reports the results of a study of the composition of mica (biotite) crystallizing in the system of phonolite melt-Cl- and F-bearing aqueous fluid at T ～ 850°C, P = 200 MPa, and \(f_{O_2 } \) = Ni-NiO, as well as data on F and Cl partitioning between coexisting phases. It was established that Cl content in mica is significantly lower than in phonolite melt and, especially, in fluid. Fluorine shows a different behavior in this system: its content in mica is always higher than in phonolite melt but lower than in fluid. The mica-melt partition coefficients of Cl and F also behave differently. The Cl partition coefficient gradually increases from 0.17 to 0.33 with increasing Cl content in the system, whereas the partition coefficient of F sharply decreases from 3.0 to 1.0 with increasing total F content. The apparent partition coefficients of F between biotite and groundmass (melt) in various magmatic rocks are usually significantly higher than the experimental values. It was supposed that the higher ^Bt/glassD_F values in natural samples could be related to the influence of later oxidation reactions, reequilibration of biotite at continuously decreasing \(f_{H_2 O} \)/f _HF ratio, and an increase in this coefficients with decreasing total F content in the system.     

Late Palaeozoic hydrocarbon migration through the Clair field, West of Shetland, UK Atlantic margin

Geochemical analysis of bitumen- and hydrocarbon-bearing fluid inclusions from the Devonian-Carboniferous Clair field indicates that the reservoirs contain a mixture of oils from different marine and lacustrine sources. Reconstruction of the Clair field oil-charge history using fluid inclusion petrography show that oil-charging occurred at times of K-feldspar, quartz and calcite cementation. Temperature–composition–time data yielded from the integration of fluid inclusion microthermometry with high-resolution Ar–Ar dating, date hydrocarbon-bearing K-feldspar overgrowths at 247 ± 3.3 Ma. These data show that in order for oil to be trapped within primary fluid inclusions in K-feldspar overgrowths, hydrocarbon migration throughout the UK Atlantic margin must have been taking place during the Late Palaeozoic and as such, current industry oil-play models based solely on oil charging from Jurassic-Cretaceous marine sources are clearly incomplete and need revision. Apatite fission track analysis and vitrinite reflectance data were used to reconstruct thermal burial histories and assess potential oil generation from Middle Devonian lacustrine source rocks. Thermal history data from wells along The Rona Ridge adjacent to the Clair field show that the Palaeozoic section was heated to greater than 100 °C at some time between 270 and 230 Ma, confirming that Devonian source rocks were mature and expelling oil during the Late Palaeozoic at the time that authigenic K-feldspar overgrowths were growing in the Clair field.     

Li-Sr-Nd isotope signatures of the plume and cratonic lithospheric mantle beneath the margin of the rifted Tanzanian craton (Labait)

Lithium concentrations and isotopic compositions of olivine and ⁸⁷Sr/⁸⁶Sr and ¹⁴³Nd/¹⁴⁴Nd of coexisting clinopyroxene from peridotite xenoliths from the Quaternary Labait volcano, Tanzania, document the influence of rift-related metasomatism on the ancient cratonic mantle. Olivines show negative correlations between Fo content and both δ⁷Li and Li concentrations. Olivines in iron-rich peridotites (Fo_85–87) have high Li concentrations (3.2–4.8 ppm) and heavy δ⁷Li (+5.2 to +6.6). In contrast, olivines in ancient, refractory peridotites have lower Li concentrations (∼2 ppm) and relatively light δ⁷Li (+2.6 to +3.5). This reflects mixing between ancient, refractory cratonic lithosphere and asthenosphere-derived rift magmas. A uniquely fertile, deformed, high-temperature garnet lherzolite, interpreted to be from the base of the lithosphere, has a ⁸⁷Sr/⁸⁶Sr of 0.7029 and ¹⁴³Nd/¹⁴⁴Nd of 0.51286, similar to HIMU oceanic basalts. It provides the best estimate of the Sr–Nd isotope composition of the upwelling mantle (i.e., plume, sensu lato) underlying this portion of the East African Rift, and is slightly less radiogenic compared to previous estimates of the plume that were based on rift basalts. Although elevated δ⁷Li are not exclusive to HIMU source regions, the data collectively indicate that the plume beneath Labait has HIMU characteristics in Sr, Nd and Li isotope composition. Electronic supplementary material The online version of this article (doi:) contains supplementary material, which is available to authorized users.     

Quantitative textural analysis of packings of elongate crystals

The spatial distribution of grains in a solidifying igneous rock controls the physical properties of the crystal mush, and in turn is controlled by the rate of crystal growth and accumulation. A predominant non-spherical habit for igneous minerals brings into question the use of spherical particles in reference packings used for quantification of spatial distribution. Furthermore, variations of crystal clustering/ordering with length scale require spatial statistics which take into account the distribution of particles beyond nearest neighbours. Using random close packings of spherocylinders, we demonstrate the importance of aspect ratio for the aggregation index (usually known as R) and show that packings of spherical particles have more structure than packings of rods. The spatial distribution functions demonstrate that the plagioclase grains in the colonnade from the Holyoke basalt are clustered on a length scale of 0.5 mm. Understanding the controls on grain spatial distribution in igneous rocks will depend on the application of these techniques to well-understood environments.     

THERIA_G: a software program to numerically model prograde garnet growth

We present the software program THERIA_G, which allows for numerical simulation of garnet growth in a given volume of rock along any pressure–temperature–time (P–T–t) path. THERIA_G assumes thermodynamic equilibrium between the garnet rim and the rock matrix during growth and accounts for component fractionation associated with garnet formation as well as for intracrystalline diffusion within garnet. In addition, THERIA_G keeps track of changes in the equilibrium phase relations, which occur during garnet growth along the specified P–T–t trajectory. This is accomplished by the combination of two major modules: a Gibbs free energy minimization routine is used to calculate equilibrium phase relations including the volume and composition of successive garnet growth increments as P and T and the effective bulk rock composition change. With the second module intragranular multi-component diffusion is modelled for spherical garnet geometry. THERIA_G allows to simulate the formation of an entire garnet population, the nucleation and growth history of which is specified via the garnet crystal size frequency distribution. Garnet growth simulations with THERIA_G produce compositional profiles for the garnet porphyroblasts of each size class of a population and full information on equilibrium phase assemblages for any point along the specified P–T–t trajectory. The results of garnet growth simulation can be used to infer the P–T–t path of metamorphism from the chemical zoning of garnet porphyroblasts. With a hypothetical example of garnet growth in a pelitic rock we demonstrate that it is essential for the interpretation of the chemical zoning of garnet to account for the combined effects of the thermodynamic conditions of garnet growth, the nucleation history and intracrystalline diffusion. Electronic supplementary material  The online version of this article (doi:) contains supplementary material, which is available to authorized users.