Difference in petrophysical properties between foliated and dilatant fault rocks in deeply buried clastics: The case of the Grès d'Annot Formation,SW French Alps

This study describes normal fault zones formed in foreland arkosic turbidites (the Grès d'Annot Formation, SW French Alps) under deep diagenesis conditions (~200 °C) and highlights the occurrence of two markedly different fault‐rock types: (1) the foliated fault rocks of the Moutière‐Restefond area; and (2) the dilatant fault rocks of the Estrop area. The deformation of (1) is dominated by intra‐ and transgranular fracturing, pressure solution of quartz and feldspar grains and syn‐kinematic phyllosilicate precipitation resulting from feldspar alteration. The combination of these mechanisms results in a strongly anisotropic strain with intense shortening normal to the foliation (pressure solution) and extension parallel to the foliation (quartz‐ and calcite‐sealed extension veins). This deformation implies local mass transfer that may be achieved without (or with limited) volume change. The deformation of (2) is expressed as dilatant quartz‐sealed veins and breccia textures in which the main mechanisms are transgranular fracturing and quartz precipitation. Type (2) implies fault volume increase, isotropy of deformation and mass transfer at distances larger than in type (1). This study discusses the origins of (1) and (2) and shows that the permeability of (1) is anisotropic, with higher values than the host rocks parallel to the Y main deformation axis (i.e. perpendicular to the slip vector), whereas the permeability of (2) is isotropic and equivalent to that of the host rocks.     

From outwash to coastal systems in the Portneuf–Forestville deltaic complex (Québec North Shore): Anatomy of a forced regressive deglacial sequence

Deglacial sequences typically include backstepping grounding zone wedges and prevailing glaciomarine depositional facies. However, in coastal domains, deglacial sequences are dominated by depositional systems ranging from turbiditic to fluvial facies. Such deglacial sequences are strongly impacted by glacio‐isostatic rebound, the rate and amplitude of which commonly outpaces those of post‐glacial eustatic sea‐level rise. This results in a sustained relative sea‐level fall covering the entire depositional time interval. This paper examines a Late Quaternary, forced regressive, deglacial sequence located on the North Shore of the St. Lawrence Estuary (Portneuf Peninsula, Québec, Canada) and aims to decipher the main controls that governed its stratigraphic architecture. The forced regressive deglacial sequence forms a thick (>100 m) and extensive (>100 km²) multiphased deltaic complex emplaced after the retreat of the Laurentide Ice Sheet margin from the study area ca 12 500 years ago. The sedimentary succession is composed of ice‐contact, glaciomarine, turbiditic, deltaic, fluvial and coastal depositional units. A four‐stage development is recognized: (i) an early ice‐contact stage (esker, glaciomarine mud and outwash fan); (ii) an in‐valley progradational stage (fjord head or moraine‐dammed lacustrine deltas) fed by glacigenics; (iii) an open‐coast deltaic progradation, when proglacial depositional systems expanded beyond the valley outlets and merged together; and (iv) a final stage of river entrenchment and shallow marine reworking that affected the previously emplaced deltaic complex. Most of the sedimentary volume (10 to 15 km³) was emplaced during the three‐first stages over a ca 2 kyr interval. In spite of sustained high rates of relative sea‐level fall (50 to 30 mm·year^?1), delta plain accretion occurred up to the end of the proglacial open‐coast progradational stage. River entrenchment only occurred later, after a significant decrease in the relative sea‐level fall rates (<30 mm·year^?1), and was concurrent with the formation and preservation of extensive coastal deposits (raised beaches, spit platform and barrier sands). The turnaround from delta plain accretion to river entrenchment and coastal erosion is interpreted to be a consequence of the retreat of the ice margin from the river drainage basins that led to the drastic drop of sediment supply and the abrupt decrease in progradation rates. The main internal stratigraphic discontinuity within the forced regressive deglacial sequence does not reflect changes in relative sea‐level variations.     

Geological and archaeological chronology of a late Holocene coastal enclosure: The Sanguinet lake (SW France)

Sanguinet lake is separated from the Atlantic Ocean by a wide Holocene coastal dunes system in SW France. The present day lake level is 21 m above mean sea level (msl). It formed when aeolian sand closed the mouth of the small La Gourgue river which gradually became a lagoon and then a lake. Dated sub‐lacustrine archaeological remains (human settlements, canoes, and wooden architectural structures), as well as paleoenvironmental evidence (drowned tree stumps and lagoonal deposits exposed on the beach) are used to interpret the formation and chronology of lake level rise during the past 4000 years. Around 2000–1650 B.C., the river flowed into a lagoon or an estuary which connected with the ocean west of the present Sanguinet Lake. Its level was affected by the tide, which ranged between 2 m below and 3 m above msl. The accumulation of aeolian sand before 1500–1000 B.C. began to close the connection with the sea. At this time, the elevation of the surface of the lake water was approximately 5 m above msl, but it still remained connected to the ocean. Around 1000 B.C., the lake level rose quickly by 1 to 2 m during a period of renewed mobility of the coastal aeolian sand, and continued to rise slowly until about 100 A.D. when there was a gradual closure of the lake outlet. This rise forced people who were living on the lake shore and along the rivers to move to higher land along the valley. The nearby Gallo‐Roman site of Losa was settled at the end of the 1st century B.C.; then the final blocking of the outlet occurred because of spit growth as a result of north‐south littoral drift accompanied by the deposit of aeolian sand. This led to the lake level rising rapidly. Consequently, Losa was abandoned in the 3rd century A.D. and ruins of its temple (at 17 m above msl) were submerged in the 6th century. Further oscillations of the lake level probably correspond to water table fluctuations before it became stable at around 1000 A.D. The highest lake level (23.35 m) was reached during the 18th century as a consequence of modern dune formation, and thus was artificially reduced to 21 m in 1840 by construction of an overflow channel. © 2008 Wiley Periodicals, Inc.     

Energy budget for the Sahel surface layer during the ECLATS experiment

The measurements obtained during the ECLATS experiment were used in order to determine the surface energy budget of the Sahel region (Niamey, Niger). This expedition was carried out from November 15 to December 10, 1980, during the dry period. Some data were collected by an instrumented aircraft, from which the turbulent fluxes were obtained in the boundary layer around midday; data were also collected at a surface station in order to estimate the surface energy budget continuously by the profile method. The aircraft measurements show the homogeneity of the vertical fluxes over large areas, allowing generalization to the bushy steppe of the Sahel region. The mean diurnal cycle of the energy budget is characterized by high values of ground heat flux and weak values of latent heat flux (deduced from the balance of the energy budget). This cycle is compared with that of the Koorin expedition, performed in similar conditions (tropical savanna in the dry period). We compare the three midday budgets: during Koorin; during ECLATS, at the ground station, and with the aircraft. The important differences that appear in the net radiative flux are explained by the difference in surface albedo.Ecole des Sciences, Université de Niamey, B.P. 10662 Niamey, Niger.     

Oscillations in a simple air-water system driven by a stabilizing heat flux

An air-water system coupled by heat and stress is modelled by two interacting fluid loops. When heated from above and cooled from below the system can become unstable and self-sustained oscillations develop, whereas a single fluid system is stable in the same situation. The oscillations are explained by thermal lag between the loops. The water loop oscillates stably under its restoring buoyancy torque but the coresponding air oscillations, generated by heat conduction from the water loop, lag by roughly half a period, and the air stress therefore acts to amplify rather than damp oscillations in the water loop.     

Topographic effects on solitary Rossby waves

The model for baroclinic solitary waves previously described by Flierl is developed to include effects of bottom variations.Topographic disturbances are shown to act, through their first and second derivatives, on both the phase speed correction and the maximum horizontal amplitude.The combined effects of mean shear flow steepening and bottom variations are considered; an equation is derived, showing the relative importance of each effect.     

Laboratory study of the rates and products of the phototransformations of naphthalene adsorbed on samples of titanium dioxide,ferric oxide,muscovite, and fly ash

The photodegradation of naphthalene (NPH), chosen as a model of polynuclear aromatic pollutants, has been studied in the presence of a layer of four water-insoluble inorganic solids which can be found in the troposphere (TiO₂, Fe₂O₃, muscovite, and a fly ash sample). Direct photolysis of NPH is negligible at >340 nm. Dark adsorption of NPH on TiO₂ (mainly anatase, nonporous, 50 m² g^–1) at 293 K corresponds to a surface coverage ofca. 50% at equilibrium. Under these conditions (saturated surface), the stationary-state photocatalytic degradation reaches 0.4 molecule nm^–2 h^–1 (>340 nm, radiant fluxca. 22 mW cm^–2). Dioxygen is required and its partial pressure in air is such that the degradation is zero order in O₂. Water vapor markedly increases the rate. The other particulates have also an effect, less important than that of TiO₂, however quite noticeable with respect to surface area unit for the fly ash sample which contains 3.2% Fe₂O₃. Apart from 1,4-naphthoquinone, which is the main intermediate product in all cases, 2-naphthol, phthalide, phthaldialdehyde, phthalic acid, acetophenone, benzaldehyde, benzoic acid are also formed on dry TiO₂. Depending on their volatility, these compounds are transferred to the gas phase or remain principally adsorbed on the solid particles where they are further transformed. For instance, phthalic acid (or anhydride) and benzoic acid are generated from 1,4-naphthoquinone. Degradation mechanisms are briefly discussed.     

Testing resilience thinking in a poverty context: Experience from the Niger River basin

Resilience thinking is an important addition to the range of frameworks and approaches that can be used to understand and manage complex social–ecological systems like small-scale fisheries. However, it is yet to lead to better environmental or development outcomes for fisheries stakeholders in terms of food security, improved livelihoods and ecological sustainability. This paper takes an empirical approach by focusing on the fundamentals of resilience thinking to evaluate its usefulness in developing relevant management interventions in small-scale fisheries in the Niger River Basin in West Africa. The paper presents the outputs of a participatory assessment exercise where both fishery communities and local experts were involved at two different scales. The resilience frame used was designed to facilitate the identification of socially defined thresholds that help delineate the desirability of the current system configuration and provides a diagnosis framework that tailors management solutions to problems in local context. The analysis highlights some key contributions from resilience thinking to the challenge of diagnosis in small-scale fisheries management in developing countries, as well as important contributions that emerge from taking a pragmatic and critical approach to its application.