Sardignaite, a new mineral, the second known bismuth molybdate: description and crystal structure

The new mineral sardignaite, a bismuth molybdate with formula BiMo₂O₇(OH)·2H₂O, occurs in quartz veins within a granitic rock at Su Senargiu, near Sarroch, Sardegna, Italy. The name is after the locality. Sardignaite occurs a thin prismatic crystals up to 1 mm in length, with pale yellow color and a white streak. It is transparent with adamantine lustre, non fluorescent, and brittle with a conchoidal fracture. It is associated with bismuthinite, bismoclite, molybdenite, ferrimolybdite, koechlinite, wulfenite, and the new mineral IMA 2009–022. Mohs hardness is ca. 3. D _calc is 4.82 g/cm³. The mineral is monoclinic, space group P2₁/m, with a 5.7797(7), b 11.567(1), c 6.3344(8) Å, β 113.360(9)°, V 388.8(1) ų. The strongest lines in the powder X-ray diffraction pattern are d(I)(hkl): 3.206(100)(031), 5.03(80)(?101), 1.992(45)(221), 3.120(32)(130). The crystal structure of sardignaite was solved to R(F) 0.056 using single-crystal X-ray diffraction data, and is characterized by edge-sharing dimers of [MoO₅(H₂O)] octahedra, linked to each other through corner-sharing to give rise to corrugated columns running along b. Such columns are held together by Bi³⁺ cations, eight-fold coordinated by 7 O + 1 (OH). Both the mineral and its name were approved by the IMA-CNMNC.     

Chemical composition of precipitation at Mt. Vesuvius and Vulcano Island,Italy: volcanological and environmental implications

Natural precipitation and water samples from passive devices were collected at Mt. Vesuvius and Vulcano Island, Italy, during the period 2004–2006, in order to investigate its possible interactions with fumarolic gases. Evidence of chemical reactions between fumarolic fluids and rain samples before and after its deposition into the sampling devices was found at Vulcano Island. Very low pH values (down to 2.5) and significant amounts of chlorine and sulfate (up to 22 mEq/l) were measured at sampling points located close to the fumarolic field. In contrast, anthropogenic contributions and/or dissolution of aerosols (both maritime and continental) influence the chemistry of rainwaters at Mt. Vesuvius, which show inter-annual variations that are highly consistent with those recorded at the coastal site at Vulcano Island. Chemistry of waters directly exposed to fumarolic fluids may then give useful information about its temporal evolution, holding the signal of the “maximum” chemical event occurred in the meanwhile. In addition, the observation of the health status of vegetation colonizing the immediate surroundings of the fumarolic fields, due to its strong dependence on the interactions with these fluids, may work as a possible biomarker of volcanic activity.     

Multi-risk governance for natural hazards in Naples and Guadeloupe

Technical and institutional capacities are strongly related and must be jointly developed to guarantee effective natural risk governance. Indeed, the available technical solutions and decision support tools influence the development of institutional frameworks and disaster policies. This paper analyses technical and institutional capacities, by providing a comparative evaluation of governance systems in Italy and France. The focus is on two case studies: Naples and Guadeloupe. Both areas are exposed to multiple hazards, including earthquakes, volcanic eruptions, landslides, floods, tsunamis, fires, cyclones, and marine inundations Cascade and conjoint effects such as seismic swarms triggered by volcanic activity have also been taken into account. The research design is based on a documentary analysis of laws and policy documents informed by semi-structured interviews and focus groups with stakeholders at the local level. This leads to the identification of three sets of governance characteristics that cover the key issues of: (1) stakeholders and governance level; (2) decision support tools and mitigation measures; and (3) stakeholder cooperation and communication. The results provide an overview of the similarities and differences as well as the strengths and weaknesses of the governance systems across risks. Both case studies have developed adequate decision support tools for most of the hazards of concern. Warning systems, and the assessment of hazards and exposure are the main strengths. While technical/scientific capacities are very well developed, the main weaknesses involve the interagency communication and cooperation, and the use and dissemination of scientific knowledge when developing policies and practices. The consequences for multi-risk governance are outlined in the discussion.     

Activity and kinematic behaviour of deep-seated landslides from PS-InSAR displacement rate measurements

Large landslides and deep-seated gravitational slope deformations (DSGSD) represent an important geo-hazard in relation to the deformation of large structures and infrastructures and to the associated secondary landslides. DSGSD movements, although slow (from a few millimetres to several centimetres per year), can continue for very long periods, producing large cumulative displacements and undergoing partial or complete reactivation. Therefore, it is important to map the activity of such phenomena at a regional scale. Ground surface displacements at DSGSD typically range close to the detection limit of monitoring equipment but are suitable for synthetic aperture radar (SAR) interferometry. In this paper, permanent scatterers (PSInSAR?) and SqueeSAR? techniques are used to analyse the activity of 133 DSGSD, in the Central Italian Alps. Statistical indicators for assigning a degree of activity to slope movements from displacement rates are discussed together with methods for analysing the movement and activity distribution within each landslide. In order to assess if a landslide is active or not, with a certain degree of reliability, three indicators are considered as optimal: the mean displacement rate, the activity index (ratio of active PS, displacement rate larger than standard deviation, overall PS) and the nearest neighbor ratio, which allows to describe the degree of clustering of the PS data. According to these criteria, 66% of the phenomena are classified as active in the monitored period 1992–2009. Finally, a new methodology for the use of SAR interferometry data to attain a classification of landslide kinematic behaviour is presented. This methodology is based on the interpretation of longitudinal ground surface displacement rate profiles in the light of numerical simulations of simplified failure geometries. The most common kinematic behaviour is rotational, amounting to 41 DSGSDs, corresponding to the 62.1% of the active phenomena.     

Physicochemical properties of fine aerosols at Plan d'Aups during ESCOMPTE

The physical and chemical properties of aerosol particles were investigated at Plan d'Aups, one of the ESCOMPTE sites located in the St. Baume mountain area (700 m a.s.l.), 50 km east of Marseilles (France). The site is ideally located for assessing the vertical and horizontal extent of the pollution plume from the Marseilles–Berre area.Our study showed that polluted air masses from the Marseilles–Berre area are advected to Plan d'Aups in the early afternoon. Average daily concentration of particles reaches up to 40 μg m⁻³ while 1-h average particle number concentration is greater than 30,000 cm⁻³. Most of the particle mass is composed of SO₄²⁻ and organic carbon (OC). The chemical properties of the particles revealed that an additional source, possibly from the industrial area of Gardanne, contributes to the aerosol mass. This last source is characterised by significant emissions of elements, such as Zn, V, Al and Si.In addition to transport, we found that gas-to-particle conversion takes place at the interface between the free troposphere and the boundary layer. We estimated that on average, 30% of the particle number is accounted for by direct nucleation. This is potentially a major aerosol source to the free troposphere.     

Characteristics of the boundary layer at the bottom of a solitary wave

The results of direct numerical simulations of the boundary layer generated at the bottom of a solitary wave are described. The numerical results, which agree with the laboratory measurements of Sumer et al. (2010) show that the flow regime in the boundary layer can be laminar, laminar with coherent vortices and turbulent. The average velocity and bottom shear stress are computed and the results obtained show that the logarithmic law can approximate the velocity profile only in a restricted range of the parameters and at particular phases of the wave cycle. Moreover, the maximum value of the bottom shear stress is found to depend on the dimensionless wave height only, while the minimum (negative) value depends also on the dimensionless boundary layer thickness. Diagrams and simple formulae are proposed to evaluate the minimum and maximum bottom shear stresses and their phase shift with respect to the wave crest.     

Groundwater flow systems in turbidites of the Northern Apennines (Italy): natural discharge and high speed railway tunnel drainage

Turbidites crop out extensively in the Northern Apennine mountains (Italy). The huge amounts of groundwater drained by tunnels, built for the high speed railway connection between Bologna and Florence, demonstrate the aquifer-like behaviour of these units, up to now considered as aquitards. A conceptual model of groundwater flow systems (GFS) in fractured aquifers of turbidites is proposed, taking into account both system natural state and the perturbation induced by tunnel drainage. Analysis of hydrological data (springs, streams and tunnel discharge), collected over 10 years, was integrated with analysis of hydrochemical and isotopic data and a stream-tunnel tracer test. Hydrologic recession analysis of undisturbed conditions is a key tool in studying turbiditic aquifer hydrogeology, permitting the discrimination of GFS, the estimation of recharge relative to the upstream reach portion and the identification of springs most vulnerable to tunnel drainage impacts. The groundwater budgeting analysis provides evidence that the natural aquifer discharge was stream-focused through GFS, developed downslope or connected to main extensional tectonic lineaments intersecting stream beds; now tunnels drain mainly active recharge groundwater and so cause a relevant stream baseflow deplenishment (approximately two-thirds of the natural value), possibly resulting in adverse effects on local ecosystems.     

Application of open tools and datasets to probabilistic modeling of road traffic disruptions due to earthquake damage

The disruption of a transportation network can have a high social and economic impact on the welfare of a society, as it can significantly affect the daily routines of a community. Although many studies have focused on the estimation of physical risk in the components that compose these networks, only a limited number have analyzed their interconnections and impact in the traffic flow. The present study analyzes how earthquake damage can disrupt the road network in an urban environment, and how this will influence the ability of the population to travel. Traffic due to daily commutes is modeled for different layouts of the network, corresponding to possible disruptions caused by earthquake damage. The duration and length of each trip were calculated both for the undamaged network conditions and for the disrupted network. The increase in the median duration and length of each trip allows estimating the economic loss for each event due to drivers' delay. By combining the probability of a specific road being blocked with its number of users, the average number of affected vehicles was estimated, and the most critical segments identified. The methodology was applied to a case study concerning the road network of the area around the Italian city of Messina in Sicily. The results were calculated for both a repetition of the well-known historical event of 1908 and a set of simulated earthquakes consistent with the national probabilistic seismic hazard model of Italy.     

A calibration system for superconducting gravimeters

A new method for the calibration of a superconducting gravity meter is described, in which a 273 Kg annular mass is placed around the meter and is moved up and down. The geometry of the apparatus is easy to model and the accuracy in the computation of the gravity variation induced by the mass, 6.7µgal, is limited only by the accuracy in the knowledge of value of the gravitational constant. Measurements done in 91 and 92 for the calibration of the instrument GWR-T015 are described. The calibration factor has been determined with a precision of about 0.3%.