华南石炭纪岩关-大塘界线期牙形石地层分带

系统采集不同沉积相区和连续沉积的剖面，即浅海台地相广西柳江龙殿山剖面、台缘缓坡相云南施甸鱼硐剖面和台内盆地相广西柳州碰冲剖面，运用数理统计方法，研究了华南岩关一大塘界线过渡期牙形石的产出丰度和相分布，在恢复生物演化序列的基础上，对各剖面首先详细分带，再进一步综合成系统的5个牙形石带，即Gnathodus typicus—G．cuneiformis带、Gnathodus typicus—Protognathodus cordiformis带、Scaliognathus anchoralis—Gnathodus pseu-dosemiglaber带、Gnathodus praebilineatus带和Paragnathodus horrtopunctatus带。以生物系统发生为标准，严格限定各带的界线，并与北美、西欧同期地层进行精确对比，为建立杜内阶一维宪阶界线的全球层型(GSSP)提供可靠依据。     

Use of microtremor measurement for assessing site effects in Northern Belgium – interpretation of the observed intensity during the MS = 5.0 June 11 1938 earthquake

To provide quantitative information on site effects in the northern part of Belgium, forty-seven H/V microtremor measurements were performed with 5 second seismometers over an area of about 15.000 km². Most of the results show a northward regular increase of the fundamental period in agreement with the augmentation of the Mesozoic and Cainozoic soft sedimentsthickness from a few meters 40 km south of Brussels to 900 m at the Netherlands-Belgium border. The measured resonance frequency values wereconsistent with theoretical computations performed at different sites onthe basis of existing information and shallow seismic experiments. At oneparticular site (Uccle) where borehole data were available, microtremor measurements using an array of four seismological stations with differentapertures allowed to obtain the low frequency part of the Rayleigh wave dispersion curve, extending the range covered by the analysis of surfacewaves artificially generated. The Vs profile derived from the surface waveinversion corroborates the 1 Hz natural frequency of the site. Comparison of these results with the macroseismic information concerning the M_S = 5.0 1938 earthquake which occurred 50 km west of Brussels,confirmed the hypothesis that the geological structure of the Brabant massifis likely to control damage distribution during such an earthquake. Comparisonbetween the intensity map of the 1938 earthquake and the resonance period ofsediments obtained by our microtremor study shows a clear relation betweenthe two parameters. During the 1938 earthquake, site effects played a prominent role due to the dimension of the source whose corner frequency wasabout 1 Hz.     

Influence of the zone of weakness on dip angle and shear heating of subducted slabs

We study the importance of the zones of weakness and the pattern of downgoing flow in steady-state models of subducting lithosphere, which interacts mechanically and thermally with the ambient mantle. The non-linear system of governing equations consists of (i) the momentum equation in stream function formulation and (ii) the steady-state heat transfer equation including conduction and advection of heat and dissipation. A finite element method has been applied to this system. We consider the viscosity to be a non-linear function of both the temperature and the stream function. In steady-state two-dimensional (2D) flow, the stream function isolines follow material trajectories. They are used to follow the top of the subducting slab, which because of its possible increase in water content, is assumed to have a lower viscosity. The zone of weakness has been thus obtained in the self-consistent fashion since the stream function as well as the temperature are the output from our modeling and no a priori assumptions about the shape of the bending lithosphere are taken into account. It was shown that several orders decrease of viscosity in the zone of weakness is required to obtain the dip angle of about 45°. If the decrease of viscosity is not sufficient enough, the subducted slab either sinks almost vertically or does not exhibit a plate-like behavior. We have also demonstrated that shear heating can unrealistically increase at the zone of weakness for fast subductions if decrease of viscosity is underestimated.     

CO2 solubility in dacitic melts equilibrated with H2O-CO2 fluids: Implications for modeling the solubility of CO2 in silicic melts

The solubility of CO₂ in dacitic melts equilibrated with H₂O-CO₂ fluids was experimentally investigated at 1250°C and 100 to 500 MPa. CO₂ is dissolved in dacitic glasses as molecular CO₂ and carbonate. The quantification of total CO₂ in the glasses by mid-infrared (MIR) spectroscopy is difficult because the weak carbonate bands at 1430 and 1530 cm⁻¹ can not be reliably separated from background features in the spectra. Furthermore, the ratio of CO_2,mol/carbonate in the quenched glasses strongly decreases with increasing water content. Due to the difficulties in quantifying CO₂ species concentrations from the MIR spectra we have measured total CO₂ contents of dacitic glasses by secondary ion mass spectrometry (SIMS).At all pressures, the dependence of CO₂ solubility in dacitic melts on x^fluid_CO2,total shows a strong positive deviation from linearity with almost constant CO₂ solubility at x_CO2fluid > 0.8 (maximum CO₂ solubility of 795 ± 41, 1376 ± 73 and 2949 ± 166 ppm at 100, 200 and 500 MPa, respectively), indicating that dissolved water strongly enhances the solubility of CO₂. A similar nonlinear variation of CO₂ solubility with x_CO2fluid has been observed for rhyolitic melts in which carbon dioxide is incorporated exclusively as molecular CO₂ (Tamic et al., 2001). We infer that water species in the melt do not only stabilize carbonate groups as has been suggested earlier but also CO₂ molecules.A thermodynamic model describing the dependence of the CO₂ solubility in hydrous rhyolitic and dacitic melts on T, P, f_CO2 and the mol fraction of water in the melt (x_water) has been developed. An exponential variation of the equilibrium constant K₁ with x_water is proposed to account for the nonlinear dependence of x_CO2,totalmelt on x_CO2fluid. The model reproduces the CO₂ solubility data for dacitic melts within ±14% relative and the data for rhyolitic melts within 10% relative in the pressure range 100-500 MPa (except for six outliers at low x_CO2fluid). Data obtained for rhyolitic melts at 75 MPa and 850°C show a stronger deviation from the model, suggesting a change in the solubility behavior of CO₂ at low pressures (a Henrian behavior of the CO₂ solubility is observed at low pressure and low H₂O concentrations in the melt). We recommend to use our model only in the pressure range 100-500 MPa and in the x_CO2fluid range 0.1-0.95. The thermodynamic modeling indicates that the partial molar volume of total CO₂ is much lower in rhyolitic melts (31.7 cm³/mol) than in dacitic melts (46.6 cm³/mol). The dissolution enthalpy for CO₂ in hydrous rhyolitic melts was found to be negligible. This result suggests that temperature is of minor importance for CO₂ solubility in silicic melts.     

Field and petrological evidence for a Late Palaeozoic (Upper Carboniferous–Permian) age of the Erfaulet orthogneiss (Gran Paradiso,western Alps)

In the Gran Paradiso massif (western Alps), the boundary between the Erfaulet orthogneiss and the overlying metasediments (Money Complex) is interpreted as a Late Palaeozoic intrusive contact. Major arguments in favour of this hypothesis are: (i) the obliquity of the sedimentary layering with respect to the contact; (ii) the presence of aplitic dykes within the Money Complex; (iii) the lack of a mylonitic zone; and (iv) rare relics of an early generation of garnet in the Money metasediments, interpreted as evidence of the contact metamorphism of the Erfaulet granite. To cite this article: B. Le Bayon, M. Ballèvre, C. R. Geoscience 336 (2004).     

The International Laser Ranging Service and its support for IGGOS

The International Laser Ranging Service (ILRS) was established in September 1998 as a service within the IAG to support programs in geodetic, geophysical, and lunar research activities and to provide data products to the International Earth Rotation Service (IERS) in support of its prime objectives. Now in operation for 5 years, the ILRS develops: (1) the standards and specifications necessary for product consistency and (2) the priorities and tracking strategies required to maximize network efficiency. The service collects, merges, analyzes, archives and distributes satellite and lunar laser ranging data to satisfy a variety of scientific, engineering, and operational needs and encourages the application of new technologies to enhance the quality, quantity, and cost effectiveness of its data products. The ILRS works with: (1) the global network to improve station performance; (2) new satellite missions in the design and building of retroreflector targets to maximize data quality and quantity and (3) science programs to optimize scientific data yield. The ILRS Central Bureau maintains a comprehensive web site as the primary vehicle for the distribution of information within the ILRS community. The site, which can be accessed at: http://ilrs.gsfc.nasa.gov is also available at mirrored sites at the Communications Research Laboratory (CRL) in Tokyo and the European Data Center (EDC) in Munich.During the last 2 years, the ILRS has addressed very important challenges: (1) data from the field stations are now submitted hourly and made available immediately through the data centers for access by the user community; (2) tracking on low satellites has been significantly improved through the sub-daily issue of predictions, drag functions, and the real-time exchange of time biases; (3) analysis products are now submitted in SINEX format for compatibility with the other space geodesy techniques; (4) the Analysis Working Group is heavily engaged in Pilot Projects as it works toward an ILRS “standard” global solution and (5) SLR has significantly increased its participation in the International Terrestrial Reference Frame (ITRF) activity, which is important to the success of IGGOS.     

From water to tillage erosion dominated landform evolution

While water and wind erosion are still considered to be the dominant soil erosion processes on agricultural land, there is growing recognition that tillage erosion plays an important role in the redistribution of soil on agricultural land. In this study, we examined soil redistribution rates and patterns for an agricultural field in the Belgian loess belt. ¹³⁷Cs derived soil erosion rates have been confronted with historical patterns of soil erosion based on soil profile truncation. This allowed an assessment of historical and contemporary landform evolution on agricultural land and its interpretation in relation to the dominant geomorphic process. The results clearly show that an important shift in the relative contribution of tillage and water erosion to total soil redistribution on agricultural land has occurred during recent decades. Historical soil redistribution is dominated by high losses on steep midslope positions and concavities as a result of water erosion, leading to landscape incision and steepening of the topography. In contrast, contemporary soil redistribution is dominated by high losses on convex upperslopes and infilling of slope and valley concavities as a result of tillage, resulting in topographic flattening. This shift must be attributed to the increased mechanization of agriculture during recent decades. This study shows that the typical topographical dependency of soil redistribution processes and their spatial interactions must be accounted for when assessing landform and soil profile evolution.     

Fabric studies within the Cascade Lake shear zone, Sierra Nevada, California

The Cascade Lake shear zone occurs on the eastern margin of the Tuolumne Intrusive Suite, Sierra Nevada Batholith, California. Foliation in the zone is NNW trending and subvertical, and lineation is moderately south plunging. Deformation is syn-tectonic with emplacement of the Cathedral Peak granodiorite. A deformation gradient exists toward the NE margin of this pluton, with higher strains and lower temperatures of deformation found near the contact. We compare fabric data collected very densely in this shear zone using several techniques: field fabrics, 3D orientation of K-feldspar megacrysts, and AMS (anisotropy of magnetic susceptibility) analysis. In general, the results from the three different methods are in agreement. Deformation in this shear zone is part of a larger pattern of deformation within the Cathedral Peak granodiorite, as recorded by AMS analysis, and dextral shearing associated within the last stage of plutonism within the Sierra Nevada magmatic arc.