A Comparative Study of the Atmospheric Layers below First Lifting Condensation Level for Instantaneous Pre-Monsoon Thunderstorm Ocurence at Agartala(23°30′N,91°15′E) and Ranchi(23°14′N,85°14′E) of India

ＡＣｏｍｐａｒａｔｉｖｅＳｔｕｄｙｏｆｔｈｅＡｔｍｏｓｐｈｅｒｉｃＬａｙｅｒｓｂｅｌｏｗＦｉｒｓｔＬｉｆｔｉｎｇＣｏｎｄｅｎｓａｔｉｏｎＬｅｖｅｌｆｏｒＩｎｓｔａｎｔａｎｅｏｕｓＰｒｅ－ＭｏｎｓｏｏｎＴｈｕｎｄｅｒｓｔｏｒｍＯｃｕｒｅｎｃｅａｔＡｇａ...     

On the heat budget of the Arabian Sea

Summary The rate of oceanic heat storage of the upper 200m of the Arabian Sea is explained in terms of net air-sea heat flux (Q _F), heat change due to horizontal divergence and vertical motion (Q _V) and heat change due to lateral advection (Q _A). The analysis revealed that the heat storage of the Arabian Sea is mainly controlled byQ _V while the effect ofQ _A is much larger than expected. Parameterisation of summer cooling revealed that the depletion of energy from the mixed layer is mainly due to upwelling and horizontal advection though large amount of heat is accumulated due to net air-sea heat flux. The annual heat balance of the upper 200m of the Arabian Sea suggested large heat gain by air-sea exchange processes. About two third of this heat gain is compensated by horizontal advection and one third by vertical advection.With 4 Figures     

Hydrous pyrolysis of a Type III source: fractionation effects during primary migration in natural and artificially matured samples

A core from the Cambay Shale Formation of the Cambay Basin, containing immature Type III organic matter, was pyrolysed at 300°C for different durations of time to different maturation levels. Fractionation effects were studied employing a three-step extraction technique after removal of the expelled pyrolysate. The extractable organic matter (EOM) obtained on extraction of the whole core is assumed to be that present in open pores, while that obtained on finely crushing the sample is assumed to be that present in closed pores. The EOM obtained from 1 cm chips is termed EOM from semi-open pores. The gross composition of the pyrolysates expelled during pyrolysis is not similar to the oils reservoired in the area, and there is no significant fractionation observed between expelled pyrolysates and unexpelled EOM. Our study indicates movement of fluids between closed, semi-open and open pores. In both systems, there is a higher concentration of EOM in open pores than in semi-open and closed pores, and the fraction of EOM in open pores is much greater in the artificial system than in the natural system. Fractionation effects on n-alkane and isoprenoid hydrocarbon-based parameters were also studied. n-Alkenes are present in semi-open and closed pores of the immature core and in the core after it was pyrolysed to 300°C for 6 and 48 h, but are absent in the open pores. n-Alkenes are present in closed pores in the naturally matured core. Presence of n-alkenes in the pyrolysates expelled during the 6 and 48 h experiments, but their absence in the open pores of the core, indicates that expulsion also occurs through temporary microfractures during laboratory pyrolysis, whereas in the natural system expulsion from closed pores seems to be only via semi-open and open pores.     

Multiple episodes of tectonothermal processes in the Eastern Ghats granulite belt

A suite of rocks from Borra Carbonate Granulite Complex (BCGC) in the Eastern Ghats granulite belt displays superposed structures and overprinted mineral assemblages that reveal multiple episodes of tectonothermal reworking of the complex under granulite facies condition. Five distinct episodes of deformation (D₁, D₂, D₃, D₄ and D₅) and four phases of metamorphism (M₁, M₂, M₃ and M₄) are recorded. The signature of the earliest tectonothermal event, D₁ is a gneissic foliation (S₁) denned by segregation of peak granulite facies mineral assemblages corresponding to prograde M₁ metamorphism. M₂ metamorphic overprint represents an episode of near-isobaric cooling of the complex under a static condition. D₂ represents an episode of ductile deformation manifested by isoclinal folding (F₂) and associated extensional structures, within a broad framework of coaxial bulk deformation. The present study reveals that D₂ took place subsequent to M₂ - Subsequent deformation, D₃, produced F₃ folds and also deformations of boudins formed during D₂. M₃, which is synchronous with F₃, represents a near isothermal decompression of the BCGC. This was followed by a weak structural readjustment (D₄), producing E-W cross folds. The latter was not, however, associated with any recognizable petrological reworking. In the terminal events, deformation (D₅) and mineral reactions (M₄) were localized along narrow intersecting shear zones. The latter acted as channelways for carbonic and still later hydrous fluid infiltration. The available thermobarometric data from BCGC and other areas of the Eastern Ghats belt reveal that reworking during M₂ and M₃ ensued in a thermally perturbed regime. The high thermal regime might also have persisted during carbonic fluid infiltration related to terminal reworking (M₄).     

Electron cyclotron waves in the presence of parallel electric fields in the Earth’s auroral plasma

The electron cyclotron waves that originate at low altitudes (<0.5 R_E) and observed by ground facilities have been studied in the presence of a weak parallel electric field in auroral magnetoplasma consisting of trapped energetic auroral electrons and cold background electrons of ionospheric origin. The model distribution for auroral trapped electrons is taken as Maxwellian ring distribution. An expression for the growth rate has been obtained in the presence of parallel electric field assuming that the real frequency in the whistler mode is not affected by the presence of the electric field. The results show that waves grow (or damp) in amplitude for a parallel (or antiparallel) electric field. The influence of the electric field is more pronounced at a shorter wavelength spectrum. An increase in population of energetic electrons increases the growth rate and thus, plays a significant role in the wave excitation process in the auroral regions.     

Seismic horizontal pullout capacity of shallow vertical anchors in sand

The concept of the equivalent free surface has been extended to determine the seismic horizontal pullout capacity of shallow vertical strip plate anchors buried in sand. The analysis has been done rigorously by using the method of stress characteristics. The results have been expressed in the form of non-dimensional charts. The pullout resistance has been found to reduce quite extensively with increase in the magnitude of horizontal earthquake acceleration. The results were compared with the previously published data, and it was seen that the computed pullout resistance with the proposed method was found to be lowest. This revised version was published online in July 2006 with corrections to the Cover Date.     

Gravity anomalies and associated tectonic features over the Indian Peninsular Shield and adjoining ocean basins

A combined gravity map over the Indian Peninsular Shield (IPS) and adjoining oceans brings out well the inter-relationships between the older tectonic features of the continent and the adjoining younger oceanic features. The NW–SE, NE–SW and N–S Precambrian trends of the IPS are reflected in the structural trends of the Arabian Sea and the Bay of Bengal suggesting their probable reactivation. The Simple Bouguer anomaly map shows consistent increase in gravity value from the continent to the deep ocean basins, which is attributed to isostatic compensation due to variations in the crustal thickness. A crustal density model computed along a profile across this region suggests a thick crust of 35–40 km under the continent, which reduces to 22/20–24 km under the Bay of Bengal with thick sediments of 8–10 km underlain by crustal layers of density 2720 and 2900/2840 kg/m³. Large crustal thickness and trends of the gravity anomalies may suggest a transitional crust in the Bay of Bengal up to 150–200 km from the east coast. The crustal thickness under the Laxmi ridge and east of it in the Arabian Sea is 20 and 14 km, respectively, with 5–6 km thick Tertiary and Mesozoic sediments separated by a thin layer of Deccan Trap. Crustal layers of densities 2750 and 2950 kg/m³ underlie sediments. The crustal density model in this part of the Arabian Sea (east of Laxmi ridge) and the structural trends similar to the Indian Peninsular Shield suggest a continent–ocean transitional crust (COTC). The COTC may represent down dropped and submerged parts of the Indian crust evolved at the time of break-up along the west coast of India and passage of Reunion hotspot over India during late Cretaceous. The crustal model under this part also shows an underplated lower crust and a low density upper mantle, extending over the continent across the west coast of India, which appears to be related to the Deccan volcanism. The crustal thickness under the western Arabian Sea (west of the Laxmi ridge) reduces to 8–9 km with crustal layers of densities 2650 and 2870 kg/m³ representing an oceanic crust.     

Mechanism of arrested charnockite formation at Nemmara, Palghat region, southern India

The formation of arrested charnockite is an excellent example of structurally controlled channellised fluid flow along specific sites accompanied by selective elemental mobility and mineralogical changes. The present paper recognises and focuses study on three types of arrested charnockite formation from Palghat region, namely, shear-controlled, foliation parallel and boudin-neck types, and address their spatio-temporal relations to regional-scale charnoenderbite. The shear-controlled and foliation parallel types post-date deformation and migmatisation. The boudin-neck type, on the contrary, is coeval with partial melting and followed the path of cooling and decreasing water activity in the gneiss. K-feldspar veining around plagioclase and quartz, symplectitic intergrowth of biotite+quartz after orthopyroxene and K-feldspar, and fluid inclusion data suggests the presence of alkalic supercritical brine and low-density CO₂-rich fluid during charnockite formation. Charnockite domains developed following the breakdown of hornblende, biotite and quartz are characterised by a more or less pronounced depletion of Fe, Ca, Mg and Ti and trace elements Y and Zr, compared to their counterpart gneiss. REE spectra indicate a subtle depletion in the HREE near the centre of the charnockite domain. Although close-pair samples of gneiss–charnockite are isochemical, on a scale of a few millimetres, bi-directional element movement, related to the formation of new mineral was noted. It is postulated that arrested charnockite formation developed in situ on local scale within the granitic domains of the hornblende-biotite gneiss, in the presence of CO₂-rich fluids and alkalic supercritical saline brine. This process post-dated the time of regional granulite (charnoenderbite) and large regional scale retrogression and migmatisation.     

Hydrography of the eastern Arabian Sea during summer monsoon 2002

Hydrographic observations in the eastern Arabian Sea (EAS) during summer monsoon 2002 (during the first phase of the Arabian Sea Monsoon Experiment (ARMEX)) include two approximately fortnight-long CTD time series. A barrier layer was observed occasionally during the two time series. These ephemeral barrier layers were caused byin situ rainfall, and by advection of low-salinity (high-salinity) waters at the surface (below the surface mixed layer). These barrier layers were advected away from the source region by the West India Coastal Current and had no discernible effect on the sea surface temperature. The three high-salinity water masses, the Arabian Sea High Salinity Water (ASHSW), Persian Gulf Water (PGW), and Red Sea Water (RSW), and the Arabian Sea Salinity Minimum also exhibited intermittency: they appeared and disappeared during the time series. The concentration of the ASHSW, PGW, and RSW decreased equatorward, and that of the RSW also decreased offshore. The observations suggest that the RSW is advected equatorward along the continental slope off the Indian west coast.