Impact Compressive Creep Characteristics of Simulative Soil for Deep-Sea Sediment

The impact load (equivalent impact height) applied to deep-sea sediment by a walking mining machine was first deduced by the energy conservation principle, and the simulative soil was prepared based on the deep-sea sediment collected from the Pacific C-C mining area. The self-designed impact compressive creep tests of the simulative soil were conducted under different ground stresses and impact heights, in order to determine impact compressive creep parameters using a K-H rheological model. Test results show that the impact compressive creep curves have three similar creep stages (transient creep, unstable creep, and stable creep) to static compressive creep curves, where the transient creep deformation and total deformation at the unstable creep stage decrease with the impact load. Among the three impact compressive creep parameters (K₁, K₂, β) of the simulative soil, K₁ is first increased with impact height and finally fluctuated to a certain stable value, while K₂ and β are approximately linearly increased with impact height. The maximum subsidence of the mining machine under a specific designed ground stress and walking velocity predicted by the impact compressive creep constitutive equation can be used for safety assessment of the mining machine.     

Polycyclic aromatic hydrocarbon concentrations in urban soils representing different land use categories in Shanghai

An extensive soil survey was carried out in Shanghai to investigate the spatial distribution and possible sources of polycyclic aromatic hydrocarbons (PAHs) in urban soils. Soil samples were collected from highways, iron-smelting plants, steel-smelting plants, shipbuilding yards, coking plants, power plants, chemical plants, urban parks, university campuses and residential areas and were analyzed for 16 PAHs by gas chromatography with mass detection. High PAH concentrations were found in all locations investigated, with mean values of soil total PAH concentrations in the range 3,279–38,868 μg/kg DM, and the PAH concentrations were significantly influenced by soil organic matter content. Soil PAH profiles in all districts were dominated by PAHs with 4–6 rings. Principal components analysis and diagnostic ratios of PAHs indicate that they were mainly derived from coal combustion and petroleum but in soils from highways the PAHs were derived largely from vehicle exhaust emissions. The high concentrations of PAHs found indicate that many urban soils in Shanghai represent a potential hazard to public health.     

Aerodynamic Parameters of a UK City Derived from Morphological Data

Detailed three-dimensional building data and a morphometric model are used to estimate the aerodynamic roughness length z ₀ and displacement height d over a major UK city (Leeds). Firstly, using an adaptive grid, the city is divided into neighbourhood regions that are each of a relatively consistent geometry throughout. Secondly, for each neighbourhood, a number of geometric parameters are calculated. Finally, these are used as input into a morphometric model that considers the influence of height variability to predict aerodynamic roughness length and displacement height. Predictions are compared with estimations made using standard tables of aerodynamic parameters. The comparison suggests that the accuracy of plan-area-density based tables is likely to be limited, and that height-based tables of aerodynamic parameters may be more accurate for UK cities. The displacement heights in the standard tables are shown to be lower than the current predictions. The importance of geometric details in determining z ₀ and d is then explored. Height variability is observed to greatly increase the predicted values. However, building footprint shape only has a significant influence upon the predictions when height variability is not considered. Finally, we develop simple relations to quantify the influence of height variation upon predicted z ₀ and d via the standard deviation of building heights. The difference in these predictions compared to the more complex approach highlights the importance of considering the specific shape of the building-height distributions. Collectively, these results suggest that to accurately predict aerodynamic parameters of real urban areas, height variability must be considered in detail, but it may be acceptable to make simple assumptions about building layout and footprint shape.     

Status of Macrobenthic Community and Its Relationships to Trace Metals and Natural Sediment Characteristics

Laizhou Bay, located in the northwest of Shandong Peninsula, has complex transitional environments between terrestrial and marine ecosystems. In the present study, a total of 122, 131, and 139 species were collected in spring, summer, and autumn 2011, respectively. Species constitutions of macrobenthos were grouped into four phyla, of which annelida were the most abundant phylum, the average biomass proportion of echinodermata was the lowest, and the proportion of important species for mollusca was the highest. The structure of the macrobenthic community showed significant differences between sites, and greater divergence was observed between the third site (S03) and other stations. The ABC plots showed that the biomass curve lay below the abundance curve, and the W‐statistic value was negative. The result of the BOPA index showed that two stations had moderate ecological status in spring and that there were two heavily polluted sites and one moderately polluted site in summer. The BIO‐ENV analyses indicated that the grain‐size fractions together with trace metals (Hg, Pb, Zn, Cu, and Cr) could be considered as the major environmental variables influencing the macrobenthic patterns. The results together demonstrated that the macrobenthic communities in Laizhou Bay were negatively affected, perhaps by the tremendous impact of heavy metals in the sediments.     

中国对虾(Penaeus chinensis)幼体血液循环的活体观察

溞对中国对虾早期幼体的循环系统及血液流向进行了活体观察 ,描述了中国对虾早期幼体发育阶段中幼体循环系统血管的走向与分布、血液的流向及循环路径等 ,比较各期幼体循环系统的形态 ,并探讨对虾早期幼体循环系统的发育过程。     

潮流对老虎石海滩养护工程响应的数值预测

为研究老虎石海滩养护工程对老虎石浴场及周围岬湾的水动力环境的影响,利用MIKE 21建立工程区海域二维潮流数学模型,通过实测流速、流向对模型进行验证,将验证后模型参数运用到工程设计方案下潮流场的模拟,比较分析工程前后水动力环境的变化。潮流场比较结果表明,修建潜坝会使得工程及其附近的潮流场发生小幅变化,但对该海域整体的潮流动力环境影响甚微。工程后老虎石海域的潮流动力仍然很弱,对保存海滩上人工养护的泥沙是非常有利的。     

Calculation and analysis of negative skin of monopile applied for offshore wind turbine

Monopiles are considered to be as a kind of viable foundation types for offshore wind turbines. The effect of negative skin friction on pile foundation is always an important problem. There are very important theoretical and practical significance to study the distribution law of negative skin friction and the calculation method. Based on the special stratum, the stress and strain of the monopile and soil are simplified, and the improved Kezdi’s double-broken-line model is adopted. The analytical solution of negative skin friction of monopile is deduced according to the degree of skin friction. An engineering case was analyzed by the method, and the calculated results agree well with the measured data. The calculation method proposed can accurately describe the range of the monopile skin frictional distribution and the position of the neutral point, and it is simple and convenient to calculate, that is also a feasible method for calculating the negative skin friction of monopile of offshore wind turbines in practical engineering.     

Automated multi-scale classification of the terrain units of the Jiaxie Guyots and their mineral resource characteristics

Given the advances in satellite altimetry and multibeam bathymetry, benthic terrain classification based on digital bathymetric models (DBMs) has been widely used for the mapping of benthic topographies. For instance, cobalt-rich crusts (CRCs) are important mineral resources found on seamounts and guyots in the western Pacific Ocean. Thick, plate-like CRCs are known to form on the summit and slopes of seamounts at the 1 000–3 000 m depth, while the relationship between seamount topography and spatial distribution of CRCs remains unclear. The benthic terrain classification of seamounts can solve this problem, thereby, facilitating the rapid exploration of seamount CRCs. Our study used an EM122 multibeam echosounder to retrieve high-resolution bathymetry data in the CRCs contract license area of China, i.e., the Jiaxie Guyots in 2015 and 2016. Based on the DBM construted by bathymetirc data, broad- and fine-scale bathymetric position indices were utilized for quantitative classification of the terrain units of the Jiaxie Guyots on multiple scales. The classification revealed four first-order terrain units (e.g., flat, crest, slope, and depression) and eleven second-order terrain units (e.g., local crests, depressions on crests, gentle slopes, crests on slopes, and local depressions, etc.). Furthermore, the classification of the terrain and geological analysis indicated that the Weijia Guyot has a large flat summit, with local crests at the southern summit, whereas most of the guyot flanks were covered by gentle slopes. “Radial” mountain ridges have developed on the eastern side, while large-scale gravitational landslides have developed on the western and southern flanks. Additionally, landslide masses can be observed at the bottom of these slopes. The coverage of local crests on the seamount is ~1 000 km2, and the local crests on the peak and flanks of the guyots may be the areas where thick and continuous plate-like CRCs are likely to occur.     

乳品厂污水养殖螺旋藻的研究

探讨了螺旋藻在乳品厂污水中生长的生态条件及藻对污水中营养盐及有机质的去除效率。结果表明,低接种密度有利于藻的增殖。乳品厂污水需要经过一定的前处理。添另碳酸钠（ＮａＣＯ３）调节ＰＨ值并且适量添加尿素（ＣＯ（ＮＨ２）２）调节氮、磷比,最佳ＰＨ值为１０．６０,最佳氮、磷比为２１：１。在此条件下螺旋藻的蛋白质含量可达６７．３５％。污水中ＣＯＤ、ＰＯ４－Ｐ、Ｔ－Ｐ、Ｔ－Ｎ及ＮＨ４－Ｎ的去除率分别达到５４．８