软玉子料的形状规律及其应用

通过对软玉子料形状总结,发现子料多呈扁平状,其长宽比较小,磨圆好的子料形状可分为11类。这些特征可用于子料鉴别与特殊材料制作。     

碱消解-高效液相色谱-电感耦合等离子体质谱法测定生物样品中的甲基汞和乙基汞

建立了碱消解-高效液相色谱-电感耦合等离子体质谱联用系统测定生物样品中甲基汞(MeHg)与乙基汞(EtHg)的分析方法。为提高灵敏度,选用微流量的PFA雾化器,在优化的检测条件下,MeHg及EtHg检出限可达到0.036μg/L和0.03μg/L;线性范围达到4个数量级,两条工作曲线线性相关系数为1。对1.78μg/L MeHg、1.65μg/L EtHg的混合标准溶液重复测定7次,色谱峰面积的相对标准偏差(RSD)分别为1.79%和1.44%。对标准物质BCR 464(金枪鱼)的分析结果表明,测定值与标准值基本吻合,但略低于标准值;甲基汞和乙基汞的加标回收率分别为85.9%和84.5%。高效液相色谱与质谱联用技术的高灵敏度和低检出限能够满足生物样品中汞形态定量分析的要求。     

徐州土壤多环芳烃的环境地球化学迁移特征

选择江苏徐州黄棕壤进行不同深度层位多环芳烃含量的定量分析,研究并探讨了多环芳烃在土壤深度剖面中的地球化学迁移特征。研究结果显示,多环芳烃在徐州土壤剖面中主要集中在地表0~20 cm内。其中低环多环芳烃化合物的迁移能力较强,4~6环等高环化合物相对较难迁移,主要残留于地表生态系统环境中。     

激光拉曼光谱法分析多种显微组分荧光变化及其应用

利用激发488 nm激光的氩离子激光器作为RENISHAW inVia型激光拉曼光谱仪的光源,建立了多种显微组分荧光变化(FAMM)分析方法,并对镜质体反射率明显抑制的东营凹陷有效烃源岩进行了测定。结果表明,东营凹陷有效烃源岩的有机质类型越好,镜质体反射率抑制程度越高,有效烃源岩的真实成熟度应主要处于0.64%~1.30%,而不是实测镜质体反射率所反映的0.37%~1.10%。     

高效液相色谱-等离子体质谱技术在溴元素形态分析中的应用

溴是一种在自然水体中都含有的元素,通常以B r-的形式存在。目前最常用的水净化方式就是向水中通入臭氧以杀灭细菌;而臭氧分解的副产物即为B r-转换成的B rO3-,这是一种公认的致癌物质。本实验室曾使用阴离子交换高效液相色谱(HPLC)与等离子体质谱(ICP-MS)联用分析B rO3-和B r-,方法虽能有效地将这两种溴形态分离,但分析每个样品需8 m in。本文试图建立新的方法缩短分析时间,并验证该方法应用于实际水样分析时测定其他含溴化合物的能力。1实验部分1.1高效液相色谱分析条件表1列出了等度淋洗和梯度淋洗两种模式下HPLC的分析条件,完成形态的分离。等度淋洗和梯度淋洗在分析中显示出不同     

内蒙古正蓝旗羊蹄子山-磨石山钛矿区硅质岩地球化学特征及沉积环境意义

文章通过详细的野外地质调查和系统的岩石化学、稀土元素、微量元素及硅、氧同位素等研究,探讨了羊蹄子山-磨石山钛矿区无矿白色硅质岩和富钛硅质岩的成因及形成地质构造环境。研究结果表明,呈厚层状产出的无矿白色硅质岩具较高的SiO2、Al2O3含量及Al/(Al Fe Mn)、Al2O3/(Al2O3 Fe2O3)比值,稀土元素总量很低,其北美页岩标准化配分模式为向右倾的曲线,无明显铈异常和铕异常,表明其形成于受陆源影响的大陆边缘构造环境;赋矿岩系中薄层状富钛硅质岩的TiO2、Fe2O3、Cu、V含量较高,但Al/(Al Fe Mn)、Al2O3/(Al2O3 Fe2O3)比值较低,稀土元素总量较高,北美页岩标准化曲线为明显左倾型-平坦型,具弱的负铈异常,表明其形成于洋脊及附近环境。两种硅质岩的δ30Si值为变化较小的负值,与热水沉积和某些生物成因硅质岩的硅同位素组成相似,两者的δ18O值范围和平均值均相似。两类硅质岩的成因及形成构造环境不同,富钛硅质岩的地球化学特征表明,该矿床的形成与本区元古宙海底火山热液喷流作用有关。     

西藏驱龙斑岩铜钼矿床中UST石英的发现:初始岩浆流体的直接记录

单向固结结构(UST)是浅成侵位的岩浆出溶过程中形成的一种特殊结构,一般由梳状石英与细晶(斑岩)岩交互生长而成,少数产于斑岩与围岩接触部位,其内的原生包裹体被认为是初始流体出溶的可靠记录.作者在西藏驱龙铜矿床中首次发现了具有单向固结结构的石英.研究表明,驱龙UST石英存在于后期侵位的二长花岗斑岩与花岗闪长岩的接触部位,部分为高温β石英;UST石英中原生包裹体的成分主要为高盐度液相,除石盐子矿物外,还含有硬石膏等其他子矿物.阴极发光及显微测温结果表明,初始流体的出溶发生在高温(t≥573℃)、高压(P≥150～200 MPa)条件下,出溶的流体为高温、高盐度[w(NaCkeq)为44.5%～58%]流体,同时还具有较高的氧逸度.因形成压力较高,判断UST石英不可能由较浅侵位的二长花岗斑岩岩枝冷凝出溶而形成,从而推测驱龙铜矿床深部存在着孕育成矿斑岩的大型岩基.     

Asymmetrically zoned reaction rims: assessment of grain boundary diffusivities and growth rates related to natural diffusion-controlled mineral reactions

This study explores garnet coronas around hedenbergite, which were formed by the reaction plagioclase + hedenbergite→garnet + quartz, to derive information about diffusion paths that allowed for material redistribution during reaction progress. Whereas quartz forms disconnected single grains along the garnet/hedenbergite boundaries, garnet forms ～20‐μm‐wide continuous polycrystalline rims along former plagioclase/hedenbergite phase boundaries. Individual garnet crystals are separated by low‐angle grain boundaries, which commonly form a direct link between the reaction interfaces of the plagioclase|garnet|hedenbergite succession. Compositional variations in garnet involve: (i) an overall asymmetric compositional zoning in Ca, Fe²⁺, Fe³⁺ and Al across the garnet layer; and (ii) micron‐scale compositional variations in the near‐grain boundary regions and along plagioclase/garnet phase boundaries. These compositional variations formed during garnet rim growth. Thereby, transfer of the chemical components occurred by a combination of fast‐path diffusion along grain boundaries within the garnet rim, slow diffusion through the interior of the garnet grains, and by fast diffusion along the garnet/plagioclase and the garnet/hedenbergite phase boundaries. Numerical simulation indicates that diffusion of Ca, Al and Fe²⁺ occurred about three to four, four and six to seven orders of magnitude faster along the grain boundaries than through the interior of the garnet grains. Fast‐path diffusion along grain boundaries contributed substantially to the bulk material transfer across the growing garnet rim. Despite the contribution of fast‐path diffusion, bulk diffusion through the garnet rim was too slow to allow for chemical equilibration of the phases involved in garnet rim formation even on a micrometre scale. Based on published garnet volume diffusion data the growth interval of a 20‐μm‐wide garnet rim is estimated at ～10³–10⁴ years at the inferred reaction conditions of 760 ± 50 °C at 7.6 kbar. Using the same parameterization of the growth law, 100‐μm‐ and 1‐mm‐thick garnet rims would grow within 10⁵–10⁶ and 10⁶–10⁷ years respectively.     

Gouging abrasion test for rock abrasiveness testing

Wear parts of many mineral processing and mining equipment are often subjected to high stress loads applied at high speeds and at varying angles of incidence, where the prevalent mode of wear is high-stress gouging/sliding impact abrasion. Examples include crusher liners, wear liners in hoppers and chutes, picks on roadheaders, discs on tunnel boring machines and ground engaging tools. Abrasion under these conditions is characterised by a high material removal rate and thus has a direct bearing on wear rates and service life of the equipment concerned. However, at present there appears to be no method for rock abrasiveness assessment under these conditions. This paper describes a new Gouging Abrasion method and apparatus for testing abrasivity of rocks under high-stress gouging/sliding impact wear. A Gouging Abrasion Index (Gi) is introduced, which can be used for prediction and assessment of component life expectancy and efficiency of mineral processing and materials handling equipment. Experimental data from Gouging Abrasion testing of numerous Australian rock types are presented. It is suggested that the results of Gi testing can be used for wear rate predictions for a variety of mineral processing and materials handling equipment working under high-stress gouging/sliding impact abrasion conditions.     

SHRIMP zircon dating and Sm/Nd isotopic investigations of Neoproterozoic granitoids, Eastern Desert, Egypt

There is an increasing evidence for the involvement of pre-Neoproterozoic zircons in the Arabian–Nubian Shield, a Neoproterozoic crustal tract that is generally regarded to be juvenile. The source and significance of these xenocrystic zircons are not clear. In an effort to better understand this problem, older and younger granitoids from the Egyptian basement complex were analyzed for chemical composition, SHRIMP U–Pb zircon ages, and Sm–Nd isotopic compositions. Geochemically, the older granitoids are metaluminous and exhibit characteristics of I-type granites and most likely formed in a convergent margin (arc) tectonic environment. On the other hand, the younger granites are peraluminous and exhibit the characteristics of A-type granites; these are post-collisional granites. The U–Pb SHRIMP dating of zircons revealed the ages of magmatic crystallization as well as the presence of slightly older, presumably inherited zircon grains. The age determined for the older granodiorite is 652.5 ± 2.6 Ma, whereas the younger granitoids are 595–605 Ma. Xenocrystic zircons are found in most of the younger granitoid samples; the xenocrystic grains are all Neoproterozoic, but fall into three age ranges that correspond to the ages of other Eastern Desert igneous rocks, viz. 710–690, 675–650 and 635–610 Ma. The analyzed granitoids have (+3.8 to +6.5) and crystallization ages, which confirm previous indications that the Arabian–Nubian Shield is juvenile Neoproterozoic crust. These results nevertheless indicate that older Neoproterozoic crust contributed to the formation of especially the younger granite magmas.